光致变色菌紫质薄膜的动态光学响应特性

用二能级光致变色模型,理论分析了菌紫质薄膜在570nm单光束和570nm与412nm双光束作用下光致变色的动态光学响应特性.计算表明,M态寿命越长,入射光强越大,则透过光的响应越快,入射光透过率饱和值越大.在双光束的作用下,可以用570nm的黄光调制412nm紫光的透射光强,实现以光控光操作.根据计算结果分析了bR膜在运动探测应用中的特点.     

基于菌紫质的光开关原型器件研究

本文分析和讨论了细菌视紫红质的饱和吸收特性及互补抑制特性,在此基础上进行了细菌视紫红质光开关的实验研究。研究证明了被激发到M态的细菌视紫红质分子对紫光有较大的吸收,而处于基态的分子则对黄光有较大吸收。随着入射黄光强度的增加,菌紫质对黄光的吸收呈饱和吸收特必,时菌紫质对紫光呈较大吸收,而较强的紫光照射将会使此饱和吸收阈值增加,使得菌紫质对黄光的吸收又增大,从而黄光和紫光表现出互补透射特性。利用紫光和黄光控制菌紫质分子在M态和基态上的分布,我们实现了对不同的波长光和选通或者关闭,即光开关模型。     

基于细菌视紫红质光子逻辑门的实验研究

研究了基于细菌视紫红质(简称BR或菌紫质)变种材料D96N的3种光逻辑操作.在633nm激发光照射下，菌紫质分子会被激发到M态，处于M态的菌紫质对412nm的紫光呈较大吸收，会抑制同时入射的紫光.选择合适的紫光强度，通过CCD观测被抑制的412nm检测光透射强度分布，模拟了“非”、“或非”、“与非”几种基本的光子逻辑操作. 关键词： 细菌视紫红质 光子逻辑门 互补抑制     

辅助紫光提高菌紫质全息衍射效率的实验和理论研究

由于菌紫质样品的饱和吸收特性，在全息记录中，当记录光强大于样品的饱和光强时，全息光栅透过率随记录光相位差的分布远离余弦型，因此衍射效率的稳定值很低.菌紫质样品在红光和紫光共同作用下存在着双光束互补抑制效应，紫光可以抑制红光的透过率，提高红光的饱和光强，使记录区域由非线性区移至线性区，从而使全息光栅透过率随记录光相位差的分布变为余弦型，可以有效地提高全息衍射效率.实验证明，辅助紫光大大提高了菌紫质样品全息衍射效率的稳定值.根据此原理，建立了三光束全息光存储系统，在红光记录全息图的同时加入辅助紫光，可以使全息图衍射效率及衍射像的像质得到提高. 关键词： 菌紫质 全息存储 衍射效率 饱和吸收     

光计算

研究了基于细胞视紫红质(简称BR或菌紫质)变种材料:D96N的3种光逻辑操作,在633 nm激发光照射下,菌紫质分子会被激发到M态.处于M态的菌紫质对412 nm的紫光呈较大吸收,会抑制同时人射的紫光。选择合适的紫光强度,通过CCD观测被抑制的4 12 nm检测光透射强度分布,模拟了"非"、"或非"、"与非"几种基本的光子逻辑操作。     

紫膜LB膜中的光学相位共轭研究

首次报道了在纯紫膜LB膜中实现光学相位共轭输出的实验现象,并在理论上从简化的菌紫质分子光循环模出发,导出了共轭光强度与总入射光强度之间的关系,最后用拟合方法求得这种紫膜LB膜的饱和吸收强度为0.49W/cm~2,bR分子处于中间体M(410)上的寿命为2.5ms左右.     

细菌视紫红质的动态透射特性及其应用

细菌视紫红质 (Bacteriorhodopsin,简称 b R)是由嗜盐菌中提取出的一种光敏蛋白质 ,它是一种新型的生物光子学材料。我们测量的 b R膜在黄光和蓝光束分别照射下的非线性透射特性表明 ,在光照开始阶段 ,光的透过率随时间延长而增加 ,然后逐渐达到一个稳定值。黄光和蓝光的透过特性的不同是蓝光达到最大透过率的时间比黄光短。 b R膜在黄光和蓝光双光束同时照射下的非线性透射特性的计算结果表明 ,在某一固定蓝光光强 ,蓝光的透过光强随黄光强度的增加而减小 ,甚至变为零。这说明黄光对蓝光有抑制作用 ,即黄光可以调控蓝光的透过率。这一奇异的透射特性可以用做新出现事物滤波器     

细菌视紫红质用于光子逻辑门的研究

本文对基于细菌视紫红质变种材料D96N的三种基本光逻辑操作进行了研究.随着入射黄光强度的增加,菌紫质对黄光的吸收呈饱和吸收特性,此时紫光的照射将会使此饱和吸收阈值增加.在黄光和紫光对样品的共同作用下,透射光强度会被调制,调制的程度取决于这两束光的相对强度以及被调制光波长.通过观测被调制的525nm检测光强度,我们模拟了几种基本的光子逻辑运算:“非”、“或”和“与”运算.     

非均匀输入图像对基于细菌视紫红质膜的新事物滤波器输出特性的数值模拟

研究了基于细菌视紫红质(bR)膜的新事物滤波器的非均匀输入图像对输出图像特性的影响.与具有均匀光强分布的输入图像相比，在正弦分布的输入图像情况下，输出图像的光强分布不再呈现单调变化，而是出现两个峰值，其中间有较小的光强.bR膜的M态寿命和物体运动速度对输出图像上蓝光光强的分布有一定影响.M态寿命越大，透过的蓝光光强越小，减小的幅度是随着M态寿命的增加而减小，当M态寿命τ>50s时，减小的幅度几乎为零.在相同的入射光情况下，对于输出图像的相同位置，输入图像的运动速度越大，其输出的蓝光光强越大. 关键词： 细菌视紫红质膜 新事物滤波器 非均匀输入图像 输出特性     

基于细菌视紫红质薄膜的空间光调制器实验研究

阐述了利用细菌视紫红质薄膜（BR薄膜）优良的非线性光学特性作为光寻址的空间光调制器的实验研究.BR有两个重要的光敏中间态（B态和M态），其吸收带（B态吸收峰为570nm，M态吸收峰为412nm）重叠区域较少，利用其正向（B→M）和逆向（M→B）光反应之间转化关系和B态与M态的差异吸收实现了相干光学图像到非相干光学图像的转换实验.采用经基因改性的细菌视紫红质薄膜（BRD96N）材料，使用670nm相干光作为写入光，530nm非相干光作为读出光，得到了分辨率约为200 lines/mm，对比度约为2.1∶1的 关键词： 光寻址空间光调制器 细菌视紫红质薄膜（BR薄膜） 非线性光学特性 相干光与非相干光图像相互转换     

All-optical logic gates with bacteriorhodopsin

All-optical logic gates with bacteriorhodopsin (bR) protein molecules have been demonstrated based on all-optical switching of a cw probe laser beam by multiple pulsed pump laser beams due to nonlinear intensity-induced excited-state absorption. A cw probe laser beam at 640 nm corresponding to the peak absorption of O-state in the bR photocycle is switched by a pulsed pump laser beam at 570 nm corresponding to the maximum initial B state absorption, at relatively low powers. The switching characteristics have been used to design all-optical NOT and the universal NOR and NAND logic gates and the effect of various parameters such as variation in pump pulse width, pump intensity, lifetime of O state and absorption cross-section of the B state at probe wavelength on the switching characteristics has been analyzed.     

Analysis of low power spatial light modulation characteristics of bacteriorhodopsin

We present a detailed and accurate analysis of low power spatial light modulation characteristics of bacteriorhodopsin (bR) based on nonlinear intensity induced absorption. Amplitude modulation of probe laser read beam transmissions at 410 nm and 640 nm, corresponding to the peak absorption of M^II and O states of D96N bR and WT bR respectively, by the modulation laser write beam intensity-induced population changes at 570 nm has been analyzed, considering all intermediate states with both forward and backward transitions in the respective bR photocycles, using the rate equation approach. The SLM characteristics are shown to be sensitive to the normalized small signal absorption coefficient β, rate constants of M^II and O intermediate states and the absorption cross-section of the initial B state at the probe wavelength (σ_Bp). There exists an optimum value of β for which maximum percentage modulation can be achieved. It is shown that for extended M^II state lifetime of 250 s in D96N bR and O state lifetime of 2.2 s in WT bR, with σ_Bp= 0, 100% modulation of read beam transmissions can be achieved, leading to high dynamic range and sensitivity for low laser write beam intensities of 50 μW/cm² and 4 mW/cm² at 570 nm, respectively.     

Dynamic diffraction behaviors of bacteriorhodopsin film at 532 nm

To show the relations between dynamic diffraction behaviors of two coupled waves and parameters of bacteriorhodopsin (bR) film, we presented a model of numerical simulation, in which the thermal effect is considered. Using wavelength of 532 nm, the relations between dynamic diffraction behaviors and parameters of bR film are revealed and the numerical results are in good agreement with the experimental ones. For different incident intensities, the higher the intensity, the lower the stable normalized diffraction intensity. For different bR molecular concentrations in the M state, the higher the molecular concentration, the higher the stable value of normalized diffraction intensity. For different thickness of bR film, the larger the thickness, the higher the stable value of normalized diffraction intensity. For different lifetime in the M state, the longer the lifetime of the M state, the lower the stable value of normalized diffraction intensity. The normalized diffraction intensity with low stable value corresponds to its fast rising and decaying rate.     

All-optical continuous-tunable image switch based on nonlinear photoinduced anisotropy in bacteriorhodopsin film

Using nonlinear photoinduced anisotropy in bacteriorhodopsin (bR) film, we presented and demonstrated an image switch in which the output can be tuned continuously by the intensity of a pumping beam. A laser with wavelength 532 nm was used as the pumping beam, and a He-Ne laser at wavelength 632.8 nm was used as the probe beam. Without pumping light, a little of polarized probe beam can transmit the crossed polarizers and the output is very low. With the presence of pumping light, owing to photoinduced anisotropy in the bR film, a portion of the probe beam transmits the crossed polarizers, depending on the intensity of the pumping beam. For the low-intensity probe beam (0.44 mW/cm²), the output is dependent on a wide range of pumping beam (2-30 mW/cm²). On the contrary, for the high-intensity probe beam (0.80 mW/cm²), the output is dependent on a narrow range of pumping beam (2-7 mW/cm²).     

The behaviours of optical novelty filter based on bacteriorhodopsin film

The quality of the novelty filter image is investigated at different intensities of the incident blue and yellow beams irradiating a bacteriorhodopsin (bR) film. The relationship between the transmitted blue beams and the incident yellow beams is established. The results show that the contrast of the novelty filter image depends on the lifetime of longest lived photochemical state (M state). These results enable one to identify the direction of a moving object and to improve the quality of the novel filter image by prolonging the lifetime of M state.     

细菌视紫红质膜非线性吸收特性及其光子学应用

对细菌视紫红质膜在两束非同频光照射下的非线性吸收特性进行了详细的理论分析,并讨论了细菌视紫红质膜非线性吸收特性有光子学方面的一些新应用。