共查询到20条相似文献,搜索用时 46 毫秒
1.
2.
3.
用密度泛函理论(DFT)方法在B3LYP/6-31G*水平上研究了苯甲醛肟与炔丙醇加成反应的微观机制和热力学、动力学行为. 结果表明, 在苯甲醛肟与炔丙醇加成反应过程中, 8个可能反应通道的过渡态中均形成非平面五元环结构, 其中苯甲醛肟的Z、E构型特征得到了部分保留, 但主要部分的键长、键角均发生了变化, 电荷也进行了重新分布. 苯甲醛肟以羟基型参与反应的4个反应通道均为吸热反应和热力学非自发过程, 它们均具有较高的反应势垒、较慢的反应速率和较小的平衡常数; 而以离子型参与反应的四个反应通道均为放热反应和热力学自发过程, 它们的反应势垒较低, 反应速度较快, 平衡常数也较大, 故苯甲醛肟应主要以离子型参与反应. 炔丙醇的两种取向对应着加成反应的两种产物, 反应达到平衡后, 3-羟甲基二氢异噁唑为主要产物. 相似文献
4.
There are two different views on the definition of reaction molecularity in physical chemistry textbooks and related literatures so far. We give a deep discussion about this conception herein. Starting with the development of chemical kinetics and the definition of elementary reaction and state-state reaction, we clarify that elementary reaction and state-state reaction are the conceptions belonging to macro-and micro-systems, respectively, and reaction molecularity is also belonging to micro-conception. Based on this conclusion, we think that the more reasonable definition of reaction molecularity should be "the number of chemical particles that take part in a state-state reaction (or an elementary chemi-physical reaction) as a reactant". 相似文献
5.
固体聚合物电解质在肉桂醇电解氧化中的应用(II)——后续化学反应在电催化反应中的地位及其影响因素 总被引:4,自引:0,他引:4
对影响肉桂醇电极氧化的各种因素作了进一步的讨论. 实验结果表明固体聚合物电解质内水的含量、pH 以及浸入离子交换膜中的二价锰离子的浓度均对该电极反应的电位以及后续化学反应的速度有很大的影响, 在较高的温度下反应时, 有利手提高生成肉桂醛的电流效率. 相似文献
6.
7.
8.
以聚甲醛为羟甲基化试剂,研究了碱的种类、反应温度和反应时间等因素对芴与聚甲醛发生羟甲基化反应产物类型的影响。 结果表明,提高碱的强度有利于生成9,9-双羟甲基芴,升高温度和延长反应时间则有利于生成9,9′-亚甲基双芴。 通过控制反应条件,有可能优先生成9-芴甲醇或9,9-双羟甲基芴或联产这2个化合物。 相似文献
9.
10.
The hydroboration reaction of methyl cyanide has been investigated by the MNDO method. It has been shown that the reaction requires an activation energy of 25.3 kcal/mol and involves a four-center-like transition state in the rate-determining step. This reaction has been compared with the corresponding reaction of hydrogen cyanide, and the effect of methyl substitution on the reaction has been discussed. The charge-transfer effects accompanying the reaction have also been studied. 相似文献
11.
The thermodynamics and mechanism of the reaction of elemental mercury with ozone has been studied computationally. The effect of water and water dimer molecules on the reaction has also been investigated. For dry reaction, we obtained two pathways and geometry optimization, atoms in molecules analysis and vibrational frequencies of all component of reaction have been used for confirming of reaction mechanism. Thermodynamic variable of reaction has been calculated. For the reaction in the presence of the water, our studies focus on ozone‐mercury complex reaction with water and water dimer and obtained the mechanism of reactions. Comparison of wet and dry reaction shows the energy profile of reaction decreases with water molecule correspond to experimental prediction. Calculated thermodynamic variable of all reaction shows the Gibbs free energy of reaction decreases with the number of water molecule. 相似文献
12.
Direct dynamics within the framework of DFT was used to study the long-time puzzling mechanism of the reaction between F2 and ethylene. Three types of reactions are widely accepted : F atom elimination reaction, HF elimination reaction and the addition reaction. Several reaction mechanisms have been proposed, but only the radical mechanism can reasonably explain the initial reaction at low temperature. In this article, our calculations support the radical mechanism and the reaction mechanisms of the three reactions, and they are described in detail by trajectory simulation. The reactions in a cryogenic matrix with the reaction mechanism were also discussed. 相似文献
13.
M. Jabłoński 《Journal of Thermal Analysis and Calorimetry》2008,93(3):717-720
The reaction of sulphuric acid with titanium raw materials runs violently with simultaneous emission of gases. Such run of
reaction creates danger of explosion. This process is very complicated from the reason of complexity of reactions and variety
of compounds in reaction mixture. To determine safe conditions of reaction with high efficiency, it is necessary to investigate
phase composition products of reaction.
Products of reaction were investigated by using X-ray diffraction. However reaction products show high amorphy and this is
the reason of difficulties to determine all phases. For this reason also was used additional method — ‘drop’ calorimeter.
This method is used for determination of average specific heat of liquid or solid samples. In this case, this method was used
for verification of phase composition of products of reaction.
On the basis of investigation the phase composition of reaction product is following: titanyl sulfate, iron(III) sulfate,
monohydrated iron(II) sulfate, magnesium sulfate and unreacted remainders of ilmenite and magnesium silicate. 相似文献
14.
15.
苯胺与氨基甲酸甲酯合成苯氨基甲酸甲酯反应研究 总被引:8,自引:0,他引:8
以无水氯化锌为催化剂,考察了温度、时间、催化剂含量及原料配比等条件对合成反应的影响,确定了最优化反应条件,并初步探讨了反应机理.最佳反应条件下MPC收率可达89.90%,选择性为99.76%. 相似文献
16.
叔丁胺是一种重要的有机化工中间体,广泛应用于制备橡胶促进剂,医药,农药,着色剂等诸多下游产物.目前,叔丁胺主要的生产方法,如叔丁脲水解法,异丁烯-氢氰酸法(Ritter法),卤代烃胺化法等存在产品收率较低,涉及强酸/强碱的使用,对设备腐蚀和环境污染严重等问题.异丁烯直接胺化生产叔丁胺,原子利用率100%,是典型的绿色化学反应.20世纪末,BASF公司以β沸石为催化剂,率先实现了异丁烯胺化技术的工业应用.但是,其反应条件苛刻,压力达28 MPa,生产过程能耗大,对设备材质要求高.目前,关于异丁烯直接胺化的文献较少,且相关研究多在远离工业应用的常压条件下进行.同时,对于异丁烯直接胺化反应过程的热力学,特别是缓和反应条件下的热力学尚待进一步系统和深入地研究分析,以期指导低温低压条件下高性能胺化催化剂的研发和工艺条件优化.我们计算了473?573 K间,异丁烯胺化制备叔丁胺反应的ΔrH,ΔrG,Kp等热力学数据.在此基础上,分析了反应温度,压力和氨烯比(摩尔比)对异丁烯平衡转化率(叔丁胺选择性>99%,未予考虑)的影响.结果表明,异丁烯胺化是中等强度的放热反应,升高反应温度会急剧降低异丁烯的平衡转化率,如在5 MPa,氨烯比1的条件下,反应温度从473 K提高到573 K,异丁烯平衡转化率从40.6%降到6.9%.但从动力学角度而言,升温可提高胺化反应速率,因此在特定的反应条件下和催化剂上,必然存在最佳反应温度.提高反应压力和氨烯比有利于提高异丁烯的热力学平衡转化率.开发在低温和相对较低的压力下具有较高胺化活性的催化剂是提高该过程经济性和实用性的关键.在较缓和的反应条件下(523 K,5 MPa,氨烯比4及异丁烯空速0.5 h?1),考察了ZSM-5(R=50和R=412,R为硅铝比,下同),ZSM-11(R=48),MOR(R=10),SAPO-11(摩尔组成,1.6Al2O3:1.0SiO2:1.4P2O5)等不同拓扑结构分子筛以及氧化铝在异丁烯胺化反应中的性能.结果表明,空白试验中,无叔丁胺产物生成.在ZSM-11上的获得最高的异丁烯胺化转化率,为14.2%(达到平衡转化率的52.2%),在ZSM-5(R=50),ZSM-5(R=412)和MOR上,异丁烯转化率分别为13.9%,6.4%和2.9%,叔丁胺选择性均大于99.8%.而SAPO-11和氧化铝未呈现出胺化反应活性.关联氨气程序升温脱附,吡啶吸附红外表征结果及分子筛孔结构特点,表明分子筛胺化活性与其孔径及Br?nsted酸的酸量和酸强度密切相关.为了进一步验证实际反应体系中反应条件对异丁烯胺化反应过程的影响规律,我们在ZSM-11催化剂上,系统考察了反应温度,压力,氨烯比和异丁烯空速对催化剂胺化反应性能的影响及变化规律.结果表明,在其他条件不变的情况下,异丁烯转化率随着温度的升高呈现出先增大后减小的趋势.适当提高原料中氨烯比和反应压力,以及采用较低异丁烯空速有利于促进异丁烯的转化.上述规律与热力学计算结果呈现出较好的一致性.在ZSM-11催化剂上,异丁烯直接胺化反应的较佳反应条件为523 K,5 MPa,氨烯比4,异丁烯空速0.5 h?1.上述结果可为异丁烯直接胺化合成叔丁胺过程新型高效催化剂的研发和反应工艺条件优化提供参考和指导. 相似文献
17.
18.
A new reduction ring-opening reaction of 2-imidazoline with sodium borohydride is reported, and the effect of reaction condition on the yield, reaction mechanism and the use of the new reaction in synthesis of ethylenediamine derivatives are discussed. A new method for the preparation of unsymmetrical substituted ethylenediamine via the reduction ring-opening reaction of imidazoline is provided. 相似文献
19.
20.
Volkan TADEMR 《Turkish Journal of Chemistry》2021,45(5):1639
In this study, nine different C-2 aroyl imidazole derivatives were synthesized in a one pot reaction with two steps, and the reduction reactions of these derivatives with NaBH4 were carried out under mild conditions. Substitution reaction of obtained imidazo methanol derivatives with chloroacetylchloride reagent and ring reaction of substitution products were investigated. It was determined that 1,4-imidazoxazinone derivative was obtained as a result of the cyclization reaction. The intermediate products obtained during the cyclization reaction were isolated, and the path of the reaction under different conditions was discussed. 相似文献