Fabrication and Characterization of Mg-Doped GaN Nanowires

Mg-doped GaN nanowires have been synthesized by ammoniating Ga2O3 films doped with Mg under flowing ammonia atmosphere at 850℃. The Mg-doped GaN nanowires are characterized by x-ray diffraction （XRD）, scanning electron microscope （SEM）, high-resolution transmission electron microscopy （HRTEM） and photoluminescence （PL）. The results demonstrate that the nanowires are single crystalline with hexagonal wurzite structure. The diameters of the nanowires are 20-30nto and the lengths are 50-100μm. The GaN nanowires show three emission bands with well-defined PL peak at 3.45 eV, 3.26 eV, 2.95 eV, respectively. The large distinct blueshift of the bandgap emission can be attributed to the Burstein-Moss effect. The peak at 3.26 eV represents the transition from the conduction-band edge to the acceptor level AM （acceptor Mg）. The growth mechanism of crystalline GaN nanowires is discussed briefly.     

Room Temperature Ferromagnetism and Optical Tunability in Cu Doped GaN Nanowires

GaN nanowires doped with 2at.% and 6at.% Cu ions are synthesized by chemical vapour deposition method. Structural and compositional analyses demonstrate that the as-grown nanowires are of single crystal wurtzite GaN structure. Magnetic characterizations reveal that the doped GaN nanowires exhibit room temperature ferromagnetism. The measured saturation magnetic moments are 0.37ug and 0.47ug per Cu atom at 300 K for Cu 2 at. % and 6 at. %, respectively. The photoluminescence spectra show that Cu dopant can tune the band gap of the GaN, which leads to a red shift of band-edge emission with increasing dopant concentration.     

Synthesis and room-temperature NO_2 gas sensing properties of a WO_3 nanowires/porous silicon hybrid structure

We report on the fabrication and performance of a room-temperature NO2 gas sensor based on a WO3 nanowires/porous silicon hybrid structure. The W18O49 nanowires are synthesized directly from a sputtered tungsten film on a porous silicon （PS） layer under heating in an argon atmosphere. After a carefully controlled annealing treatment, WO3 nanowires are obtained on the PS layer without losing the morphology. The morphology, phase structure, and crystallinity of the nanowires are investigated by using field emission scanning electron microscopy （FESEM）, X-ray diffractometer （XRD）, and high-resolution transmission electron microscopy （HRTEM）. Comparative gas sensing results indicate that the sensor based on the WO3 nanowires exhibits a much higher sensitivity than that based on the PS and pure WO3 nanowires in detecting NO2 gas at room temperature. The mechanism of the WO3 nanowires/PS hybrid structure in the NO2 sensing is explained in detail.     

Structure and magnetic properties of Fe96−x Zr x B4 nanowire arrays

Fe96-xZrx B4(1相似文献   

Transformation from β-Ga2O3 to GaN Nanowires via Nitridation

Element doping is an important way to modify the properties of semiconductor materials. In our previous work, it was found that nitrogen-doping in β-Ga2O3 nanowires can induce a novel luminescence emission （around 740 nm） caused by generation of acceptor levels at the middle of the band gap of the β-Ga2O3 nanowires. Here we report that further heavy doping of nitrogen can transform the β-Ga2O3 nanowires completely into wurtzite structured GaN nanowires. Transmission electron microscopy （TEM）, x-ray diffraction （XRD） and Raman spectrum are used to evaluate the transition process. Both XRD and Raman analysis reveal that the monoclinic β-Ga2O3 nanowires start phase transformation at a temperature around 850℃ towards wurtzite structured GaN. Our results will be very helpful to profound our understanding of the doping induced effects and phase transformation in semiconductor compounds.     

Comparison of the photoemission behaviour between negative electron affinity GaAs and GaN photocathodes

In view of the important application of GaAs and GaN photocathodes in electron sources, differences in photoemission behaviour, namely the activation process and quantum yield decay, between the two typical types of III-V compound photocathodes have been investigated using a multi-information measurement system. The activation experiment shows that a surface negative electron affinity state for the GaAs photocathode can be achieved by the necessary Cs-O two-step activation and by Cs activation alone for the GaN photocathode. In addition, a quantum yield decay experiment shows that the GaN photocathode exhibits better stability and a longer lifetime in a demountable vacuum system than the GaAs photocathode. The results mean that GaN photocathodes are more promising candidates for electron source emitter use in comparison with GaAs photocathodes.     

Probing Field Emission from Boron Carbide Nanowires

High density boron carbide nanowires are grown by an improved carbon thermal reduction technique. Transmission electron microscopy and electron energy lose spectroscopy of the sample show that the synthesized nanowires are B4 C with good crystallization. The field emission measurement for an individual boron nanowire is performed by using a Pt tip installed in the focused ion beam system. A field emission current with enhancement factor of 10^6 is observed and the evolution process during emission is also carefully studied. Furthermore, a two-step field emission with stable emission current density is found from the high-density nanowire film. Our results together suggest that boron carbide nanowires are promising candidates for electron emission nanodevices.     

Synthesis of flower-shape clustering GaN nanorods by ammoniating Ga2O3 films

Flower-shape clustering GaN nanorods are successfully synthesized on Si（111） substrates through ammoniating Ga2O3/ZnO films at 950℃. The as-grown products are characterized by x-ray diffraction （XRD）, scanning electron microscope （SEM）, field-emission transmission electron microscope （FETEM）, Fourier transform infrared spectrum （FTIR） and fluorescence spectrophotometer. The SEM images demonstrate that the products consist of flower-shape clustering GaN nanorods. The XRD indicates that the reflections of the samples can be indexed to the hexagonal GaN phase and HRTEM shows that the nanorods are of pure hexagonal GaN single crystal. The photoluminescence （PL） spectrum indicates that the GaN nanorods have a good emission property. The growth mechanism is also briefly discussed.     

Refit Silver Nanostructures Using a Convergent Electron Beam

Using a superionic conductor AgI thin film and a direct current electric field, we synthesize silver nanowires in diameter of about lOOnm. In order to refit the prepared nanowires, the samples are irradiated by a convergent electron beam （200 k V） inside a transmission electron microscope to prepare new small silver nanostructures. The new nanostructures are investigated in situ by high-resolution transmission electron microscope. This electron- induced crystal growth method is useful for technical applications in fabrication of nanodevices.     

High-temperature current conduction through three kinds of Schottky diodes

Fundamentals of the Schottky contacts and the high-temperature current conduction through three kinds of Schottky diodes are studied. N-Si Schottky diodes, GaN Schottky diodes and AlGaN/GaN Schottky diodes are investigated by I--V--T measurements ranging from 300 to 523~K. For these Schottky diodes, a rise in temperature is accompanied with an increase in barrier height and a reduction in ideality factor. Mechanisms are suggested, including thermionic emission, field emission, trap-assisted tunnelling and so on. The most remarkable finding in the present paper is that these three kinds of Schottky diodes are revealed to have different behaviours of high-temperature reverse currents. For the n-Si Schottky diode, a rise in temperature is accompanied by an increase in reverse current. The reverse current of the GaN Schottky diode decreases first and then increases with rising temperature. The AlGaN/GaN Schottky diode has a trend opposite to that of the GaN Schottky diode, and the dominant mechanisms are the effects of the piezoelectric polarization field and variation of two-dimensional electron gas charge density.     

Synthesis and characterization of GaN nanowires by ammoniating Ga2O3/Cr thin films deposited on Si(1 1 1) substrates

GaN nanowires have been successfully synthesized on Si(1 1 1) substrates by magnetron sputtering through ammoniating Ga₂O₃/Cr thin films at 950 °C. X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), FT-IR spectrophotometer, scanning electron microscopy (SEM), high-resolution transmission electron microscopy (TEM), and photoluminescence (PL) spectrum were carried out to characterize the microstructure, morphology, and optical properties of GaN samples. The results demonstrate that the nanowires are single-crystal GaN with hexagonal wurtzite structure and high-quality crystalline, have the size of 30-80 nm in diameter and several tens of microns in length with good emission properties. The growth direction of GaN nanowires is perpendicular to the fringe of (1 0 1) plane. The growth mechanism of GaN nanowires is also discussed in detail.     

Fabrication and characterization of GaN/amorphous Ga2O3 nanocables through thermal oxidation

In an effort to obtain one-dimensional core/shell nanostructures, thermal oxidation behavior of GaN nanowires in O₂ with N₂ ambients was investigated by x-ray diffraction, transmission electron microscopy, and x-ray photoelectron spectroscopy. Crystallinity and chemical bonding states of the oxidized surface in the GaN nanowires were strongly dependent on the oxidation temperature. Chemical oxidation reaction occurred upon increasing the temperature, accompanied by the formation of an amorphous Ga₂O₃ layer at the GaN nanowire surface at 900 ^°C. The XPS analyses provided further evidence supporting the change in the chemical bonding states with increasing oxidation temperature.     

Fabrication, morphology, and photoluminescence properties of GaN nanowires and nanorods by ammoniating Ga2O3/V films on Si(1 1 1)

GaN nanowires and nanorods have been successfully synthesized on Si(1 1 1) substrates by magnetron sputtering through ammoniating Ga₂O₃/V films at 900 °C in a quartz tube. X-ray diffraction (XRD), scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), and photoluminescence (PL) spectrum were carried out to characterize the structure, morphology, and photoluminescence properties of GaN sample. The results show that the GaN nanowires and nanorods with pure hexagonal wurtzite structure have good emission properties. The growth direction of nanostructures is perpendicular to the fringes of (1 0 1) plane. The growth mechanism is also briefly discussed.     

Synthesis of GaN nanowires by Tb catalysis

Rare earth metal seed Tb was employed as catalyst for the growth of GaN wires. GaN nanowires were synthesized successfully through ammoniating Ga₂O₃/Tb films sputtered on Si(1 1 1) substrates. The samples characterization by X-ray diffraction and Fourier transform infrared indicated that the nanowires are constituted of hexagonal wurtzite GaN. Scanning electron microscopy, transmission electron microscopy, and high-resolution transmission electron microscopy showed that the samples are single-crystal GaN nanowire structures. The growth mechanism of the GaN nanowires is discussed.     

Synthesis of GaN nanowires on gold-coated SiC substrates by novel pulsed electron deposition technique

A two-step approach for macro-synthesis of GaN nanowires was developed in this study. GaN nanoparticles were firstly synthesized through a facile solid-state reaction using an organic reagent dicyandiamide (C₂N₄H₄) and Ga₂O₃ as precursors. Subsequently, single-crystalline wurtzite GaN nanowires were grown on gold-coated 6H-SiC substrates via novel pulsed electron deposition (PED) technique using the as-prepared GaN nanoparticles as target, which provides a new route employing nanoparticles as precursors to fabricate GaN nanowires. It is found that pulsed electron ablation induced Ga and N plasma directly towards the gold-coated substrate to initialize the vapor-liquid-solid (VLS) growth processes. The morphological and structural properties were investigated in detail and Raman scattering spectrum of these nanowires presented some new features.     

Synthesis and characterization of GaN nanowires

In this work, GaN nanowires were fabricated on Si substrates coated with NiCl₂ thin films using chemical vapor deposition (CVD) method by evaporating Ga₂O₃ powder at 1100 °C in ammonia gas flow. X-ray diffraction (XRD), scanning electron microscopy (SEM), high-resolution transmission electron microscope (HRTEM) and photoluminescence (PL) spectrum are used to characterize the samples. The results demonstrate that the nanowires are single-crystal GaN with hexagonal wurtzite structure. The growth mechanism of GaN nanowires is also discussed.     

Growth and characterization of high-quality GaN nanowires by ammonification technique

GaN nanowires were successfully synthesized at high quality and large yield on Si (1 1 1) substrate through ammoniating Ga₂O₃/BN films deposited by radio frequency (RF) magnetron sputtering system. X-ray diffraction (XRD), Fourier transformed infrared spectra (FTIR) and selected-area electron diffraction (SAED) confirm that the as-synthesized nanowires are of a hexagonal GaN with wurtzite structure. Scanning electron microscopy (SEM) and high-resolution transmission electron microscopy (HRTEM) reveal that the nanowires have a straight and smooth curved structure with extremely uniform diameter of about 60 nm, which is helpful to the application of GaN nanowires. The present results demonstrate that the BN is a very important intermedium in the growth of GaN nanowires by this method.     

High-quality GaN nanowires synthesized using a CVD approach

High-quality GaN nanowires were synthesized on a large-area Si substrate by direct reaction of gallium with ammonia using InCl₃ as a catalyst. The morphology and microstructure of the resulting products were characterized using a field-emission scanning electron microscope (SEM), a high-resolution transmission electron microscope, and X-ray diffraction (XRD). XRD and electron diffraction revealed that the nanowires are of a hexagonal GaN phase with the wurtzite structure. The SEM study showed that the nanowires are straight and have a smooth morphology with lengths up to 500 μm. The present results reveal that InCl₃ is an optimal catalyst in GaN nanowire production. Received: 2 April 2002 / Accepted: 12 April 2002 / Published online: 19 July 2002     

Alumina template-assisted electrodeposition of Bi2Te2.7Se0.3 nanowire arrays

Bi₂Te_2.7Se_0.3 nanowire arrays have been fabricated by electrodeposition into the pores of an anodic aluminum oxide (AAO) template followed by annealing at 300 °C under Ar atmosphere. The as-prepared nanowires were characterized by X-ray diffraction, field emission scanning electron microscopy, transmission electron microscopy and energy dispersive X-ray spectroscopy. The nanowires are uniform single crystalline with diameter of ∼14 nm.