Towards a transparent boundary condition for compressible Navier–Stokes equations

A new artificial boundary condition for two‐dimensional subsonic flows governed by the compressible Navier–Stokes equations is derived. It is based on the hyperbolic part of the equations, according to the way of propagation of the characteristic waves. A reference flow, as well as a convection velocity, is used to properly discretize the terms corresponding to the entering waves. Numerical tests on various classical model problems, whose solutions are known, and comparisons with other boundary conditions (BCs), show the efficiency of the BC. Direct numerical simulations of more complex flows over a dihedral plate are simulated, without creation of acoustic waves going back in the flow. Copyright © 2001 John Wiley & Sons, Ltd.     

Implicit weighted essentially non‐oscillatory schemes for the incompressible Navier–Stokes equations

A class of lower–upper/approximate factorization (LUAF) implicit weighted essentially non‐oscillatory (ENO; WENO) schemes for solving the two‐dimensional incompressible Navier–Stokes equations in a generalized co‐ordinate system is presented. The algorithm is based on the artificial compressibility formulation, and symmetric Gauss–Seidel relaxation is used for computing steady state solutions while symmetric successive overrelaxation is used for treating time‐dependent flows. WENO spatial operators are employed for inviscid fluxes and central differencing for viscous fluxes. Internal and external viscous flow test problems are presented to verify the numerical schemes. The use of a WENO spatial operator not only enhances the accuracy of solutions but also improves the convergence rate for the steady state computation as compared with using the ENO counterpart. It is found that the present solutions compare well with exact solutions, experimental data and other numerical results. Copyright © 1999 John Wiley & Sons, Ltd.     

An overlapping control volume method for the Navier–Stokes equations on non‐staggered grids

An algorithm, based on the overlapping control volume (OCV) method, for the solution of the steady and unsteady two‐dimensional incompressible Navier–Stokes equations in complex geometry is presented. The primitive variable formulation is solved on a non‐staggered grid arrangement. The problem of pressure–velocity decoupling is circumvented by using momentum interpolation. The accuracy and effectiveness of the method is established by solving five steady state and one unsteady test problems. The numerical solutions obtained using the technique are in good agreement with the analytical and benchmark solutions available in the literature. On uniform grids, the method gives second‐order accuracy for both diffusion‐ and convection‐dominated flows. There is little loss of accuracy on grids that are moderately non‐orthogonal. Copyright © 1999 John Wiley & Sons, Ltd.     

A complete boundary integral formulation for compressible Navier–Stokes equations

A complete boundary integral formulation for compressible Navier–Stokes equations with time discretization by operator splitting is developed using the fundamental solutions of the Helmholtz operator equation with different order. The numerical results for wall pressure and wall skin friction of two‐dimensional compressible laminar viscous flow around airfoils are in good agreement with field numerical methods. Copyright © 2004 John Wiley & Sons, Ltd.     

Exact solutions of the generalized Navier– Stokes equations for benchmarking

The generalized Navier– Stokes equations for incompressible viscous flows through isotropic granular porous medium are studied. Some analytical classic solutions of the Navier– Stokes equations are generalized to the case of the considered equations. Obtained solutions of generalized equations reduce to classic ones as porosity effect disappears. Average velocity of generalized solutions is calculated and evaluated in two limiting regimes of flow. In the shallow conduit, the generalized flow rate approximates the free (without porous medium) flow rate and in the case of removed boundaries this approaches Darcy's law. The use of the derived exact solutions for benchmarking purposes is described. Copyright © 2002 John Wiley & Sons, Ltd.     

Weak imposition of boundary conditions for the Navier–Stokes equations by a penalty method

We prove convergence of the finite element method for the Navier–Stokes equations in which the no‐slip condition and no‐penetration condition on the flow boundary are imposed via a penalty method. This approach has been previously studied for the Stokes problem by Liakos (Weak imposition of boundary conditions in the Stokes problem. Ph.D. Thesis, University of Pittsburgh, 1999). Since, in most realistic applications, inertial effects dominate, it is crucial to extend the validity of the method to the nonlinear Navier–Stokes case. This report includes the analysis of this extension, as well as numerical results validating their analytical counterparts. Specifically, we show that optimal order of convergence can be achieved if the computational boundary follows the real flow boundary exactly. Copyright © 2008 John Wiley & Sons, Ltd.     

Penalty finite element method for Navier–Stokes equations with nonlinear slip boundary conditions

The penalty finite element method for Navier–Stokes equations with nonlinear slip boundary conditions is investigated in this paper. Since this class of nonlinear slip boundary conditions include the subdifferential property, the weak variational formulation is a variational inequality problem of the second kind. Using the penalty finite element approximation, we obtain optimal error estimates between the exact solution and the finite element approximation solution. Finally, we show the numerical results which are in full agreement with the theoretical results. Copyright © 2011 John Wiley & Sons, Ltd.     

Using staggered grids with characteristic boundary conditions when solving compressible reactive Navier–Stokes equations

A specific (hybrid) arrangement of variables is discussed to solve reactive compressible Navier–Stokes equations on staggered‐like grids with high‐order finite difference schemes. The objective is to improve the numerical flow solution at boundaries. Hybrid arrangement behaviour is compared with ‘pure’ colocated and staggered strategies. Classical Fourier analysis shows accuracy to be significantly improved in the hybrid case. One‐dimensional laminar flame test demonstrates increased robustness (in terms of mesh resolution), whereas computation of 1D exiting pressure wave propagation gives evidence that the method also improves accuracy in the prediction of non‐reflecting outflows, compared e.g. with the fully staggered scheme of (J. Comput. Phy. 2003). Multidimensional extension is illustrated through turbulent 2D planar and 3D expanding flames simulations. Copyright © 2011 John Wiley & Sons, Ltd.     

A high‐order scheme for the incompressible Navier–Stokes equations with open boundary condition

We present a numerical scheme to solve the incompressible Navier–Stokes equations with open boundary condition. After replacing the incompressibility constraint by the pressure Poisson equation, the key is how to give an appropriate boundary condition for the pressure Poisson equation. We propose a new boundary condition for the pressure on the open boundary. Some numerical experiments are presented to verify the accuracy and stability of scheme. Copyright © 2013 John Wiley & Sons, Ltd.     

Fourth‐order accurate compact‐difference discretization method for Helmholtz and incompressible Navier–Stokes equations

A fourth‐order accurate solution method for the three‐dimensional Helmholtz equations is described that is based on a compact finite‐difference stencil for the Laplace operator. Similar discretization methods for the Poisson equation have been presented by various researchers for Dirichlet boundary conditions. Here, the complicated issue of imposing Neumann boundary conditions is described in detail. The method is then applied to model Helmholtz problems to verify the accuracy of the discretization method. The implementation of the solution method is also described. The Helmholtz solver is used as the basis for a fourth‐order accurate solver for the incompressible Navier–Stokes equations. Numerical results obtained with this Navier–Stokes solver for the temporal evolution of a three‐dimensional instability in a counter‐rotating vortex pair are discussed. The time‐accurate Navier–Stokes simulations show the resolving properties of the developed discretization method and the correct prediction of the initial growth rate of the three‐dimensional instability in the vortex pair. Copyright © 2004 John Wiley & Sons, Ltd.     

Upwind discretization of the steady Navier–Stokes equations

A discretization method is presented for the full, steady, compressible Navier–Stokes equations. The method makes use of quadrilateral finite volumes and consists of an upwind discretization of the convective part and a central discretization of the diffusive part. In the present paper the emphasis lies on the discretization of the convective part. The solution method applied solves the steady equations directly by means of a non-linear relaxation method accelerated by multigrid. The solution method requires the discretization to be continuously differentiable. For two upwind schemes which satisfy this requirement (Osher's and van Leer's scheme), results of a quantitative error analysis are presented. Osher's scheme appears to be increasingly more accurate than van Leer's scheme with increasing Reynolds number. A suitable higher-order accurate discretization of the convection terms is derived. On the basis of this higher-order scheme, to preserve monotonicity, a new limiter is constructed. Numerical results are presented for a subsonic flat plate flow and a supersonic flat plate flow with oblique shock wave–boundary layer interaction. The results obtained agree with the predictions made. Useful properties of the discretization method are that it allows an easy check of false diffusion and that it needs no tuning of parameters.     

A projection method for the spectral solution of non‐homogeneous and incompressible Navier–Stokes equations

This paper is devoted to the development of a parallel, spectral and second‐order time‐accurate method for solving the incompressible and variable density Navier–Stokes equations. The method is well suited for finite thickness density layers and is very efficient, especially for three‐dimensional computations. It is based on an exact projection technique. To enforce incompressibility, for a non‐homogeneous fluid, the pressure is computed using an iterative algorithm. A complete study of the convergence properties of this algorithm is done for different density variations. Numerical simulations showing, qualitatively, the capabilities of the developed Navier–Stokes solver for many realistic problems are presented. The numerical procedure is also validated quantitatively by reproducing growth rates from the linear instability theory in a three‐dimensional direct numerical simulation of an unstable, non‐homogeneous, flow configuration. It is also shown that, even in a turbulent flow, the spectral accuracy is recovered. Copyright © 2012 John Wiley & Sons, Ltd.     

Fundamental solutions of the streamfunction–vorticity formulation of the Navier–Stokes equations

A new boundary element procedure is developed for the solution of the streamfunction–vorticity formulation of the Navier–Stokes equations in two dimensions. The differential equations are stated in their transient version and then discretized via finite differences with respect to time. In this discretization, the non-linear inertial terms are evaluated in a previous time step, thus making the scheme explicit with respect to them. In the resulting discretized equations, fundamental solutions that take into account the coupling between the equations are developed by treating the non-linear terms as in homogeneities. The resulting boundary integral equations are solved by the regular boundary element method, in which the singular points are placed outside the solution domain.     

Continuation of travelling‐wave solutions of the Navier–Stokes equations

An efficient way of obtaining travelling waves in a periodic fluid system is described and tested. We search for steady states in a reference frame travelling at the wave phase velocity using a first‐order pseudospectral semi‐implicit time scheme adapted to carry out the Newton's iterations. The method is compared to a standard Newton–Raphson solver and is shown to be highly efficient in performing this task, even when high‐resolution grids are used. This method is well suited to three‐dimensional calculations in cylindrical or spherical geometries. Copyright © 2006 John Wiley & Sons, Ltd.     

Schwarz domain decomposition for the incompressible Navier–Stokes equations in general co‐ordinates

This paper describes a domain decomposition method for the incompressible Navier–Stokes equations in general co‐ordinates. Domain decomposition techniques are needed for solving flow problems in complicated geometries while retaining structured grids on each of the subdomains. This is the so‐called block‐structured approach. It enables the use of fast vectorized iterative methods on the subdomains. The Navier–Stokes equations are discretized on a staggered grid using finite volumes. The pressure‐correction technique is used to solve the momentum equations together with incompressibility conditions. Schwarz domain decomposition is used to solve the momentum and pressure equations on the composite domain. Convergence of domain decomposition is accelerated by a GMRES Krylov subspace method. Computations are presented for a variety of flows. Copyright © 2000 John Wiley & Sons, Ltd.     

An implicit edge‐based ALE method for the incompressible Navier–Stokes equations

A new finite volume method for the incompressible Navier–Stokes equations, expressed in arbitrary Lagrangian–Eulerian (ALE) form, is presented. The method uses a staggered storage arrangement for the pressure and velocity variables and adopts an edge‐based data structure and assembly procedure which is valid for arbitrary n‐sided polygonal meshes. Edge formulas are presented for assembling the ALE form of the momentum and pressure equations. An implicit multi‐stage time integrator is constructed that is geometrically conservative to the precision of the arithmetic used in the computation. The method is shown to be second‐order‐accurate in time and space for general time‐dependent polygonal meshes. The method is first evaluated using several well‐known unsteady incompressible Navier–Stokes problems before being applied to a periodically forced aeroelastic problem and a transient free surface problem. Published in 2003 by John Wiley & Sons, Ltd.     

Third‐order‐accurate semi‐implicit Runge–Kutta scheme for incompressible Navier–Stokes equations

A semi‐implicit three‐step Runge–Kutta scheme for the unsteady incompressible Navier–Stokes equations with third‐order accuracy in time is presented. The higher order of accuracy as compared to the existing semi‐implicit Runge–Kutta schemes is achieved due to one additional inversion of the implicit operator I‐τγL, which requires inversion of tridiagonal matrices when using approximate factorization method. No additional solution of the pressure‐Poisson equation or evaluation of Navier–Stokes operator is needed. The scheme is supplied with a local error estimation and time‐step control algorithm. The temporal third‐order accuracy of the scheme is proved analytically and ascertained by analysing both local and global errors in a numerical example. Copyright © 2005 John Wiley & Sons, Ltd.     

A new velocity–vorticity boundary integral formulation for Navier–Stokes equations

In the present work, an indirect boundary integral method for the numerical solution of Navier–Stokes equations formulated in velocity–vorticity dependent variables is proposed. This wholly integral approach, based on Helmholtz's decomposition, deals directly with the vorticity field and gives emphasis to the establishment of appropriate boundary conditions for the vorticity transport equation. The coupling between the vorticity and the vortical velocity fields is expressed by an iterative procedure. The present analysis shows the usefulness of an integral formulation not only in providing a potentially more efficient computational tool, but also in giving a better understanding to the physics of the phenomenon. Copyright © 2000 John Wiley & Sons, Ltd.