Validation of thermal-transport modeling with direct-drive, planar-foil acceleration experiments on OMEGA

We present for the first time the experimental validation of the nonlocal thermal-transport model for a National Ignition Facility relevant laser intensity of approximately 10(15) W/cm(2) on OMEGA. The measured thin target trajectories are in good agreement with predictions based on the nonlocal model over the full range of laser intensities from 2 x 10(14) to 10(15) W/cm(2}) The standard local thermal-transport model with a constant flux limiter of 0.06 disagrees with experimental measurements at a high intensity of approximately 10(15) W/cm(2) but agrees at lower intensities. These results show the significance of nonlocal effects for direct-drive ignition designs.     

Comparative extreme ultraviolet emission measurements for lithium and tin laser plasmas

Detailed spectroscopic studies on extreme UV emission from laser plasmas using tin and lithium planar solid targets were completed. At 13.5 nm, the best conversion efficiency (CE) for lithium was found to be 2.2% at intensities near 7 x 10(10) W/cm(2). The highest CE measured for tin was near 5.0% at an intensity close to 1 x 10(11) W/cm(2).     

Harmonic emission from the rear side of thin overdense foils irradiated with intense ultrashort laser pulses

The harmonic emission from thin solid carbon and aluminum foils, irradiated by 150 fs long frequency-doubled Ti:sapphire laser pulses at lambda=395 nm and peak intensities of a few 10(18) W/cm(2), has been studied. In addition to the harmonics emitted from the front side in the specular direction, we observe harmonics up to the 10th order, including the fundamental from the rear side in the direction of the incident beam, while the foil is still strongly overdense. The experimental observations are well reproduced by particle-in-cell simulations. They reveal that strong coupling between the laser-irradiated side and the rear side occurs via the nonlocal electron current driven by the laser light.     

Photonuclear physics when a multiterawatt laser pulse interacts with solid targets

When a laser pulse of intensity 10(19) W cm(-2) interacts with solid targets, electrons of energies of some tens of MeV are produced. In a tantalum target, the electrons generate an intense highly directional gamma-ray beam that can be used to carry out photonuclear reactions. The isotopes 11C, 38K, (62,64)Cu, 63Zn, 106Ag, 140Pr, and 180Ta have been produced by (gamma,n) reactions using the VULCAN laser beam. In addition, laser-induced nuclear fission in 238U has been demonstrated, a process which was theoretically predicted at such laser intensities more than ten years ago. The ratio of the 11C and the 62Cu beta(+) activities yields shot-by-shot temperatures of the suprathermal electrons at laser intensities of approximately 10(19) W cm(-2).     

Rayleigh-Taylor growth stabilization in direct-drive plastic targets at laser intensities of approximately 1 x 10(15) W/cm2

Direct-drive, planar-target Rayleigh-Taylor growth experiments were performed for the first time to test fundamental physics in hydrocodes at peak drive intensities of ignition designs. The unstable modulation growth at a drive intensity of approximately 1 x 10(15) W/cm2 was strongly stabilized compared to the growth at an intensity of approximately 5 x 10(14) W/cm2. The experiments demonstrate that standard simulations based on a local model of electron thermal transport break down at peak intensities of ignition designs (although they work well at lower intensities). The preheating effects by nonlocal electron transport and hot electrons were identified as some of the stabilizing mechanisms.     

Generation and characterization of the highest laser intensities (10(22) W/cm2)

We generated a record peak intensity of 0.7 x 10(22) W/cm2 by focusing a 45-TW laser beam with an f/0.6 off-axis paraboloid. The aberrations of the paraboloid and the low-energy reference laser beam were measured and corrected, and a focal spot size of 0.8 microm was achieved. It is shown that the peak intensity can be increased to 1.0 x 10(22) W/cm2 by correction of the wave front of a 45-TW beam relative to the reference beam. The phase and amplitude measurement provides for an efficient full characterization of the focal field.     

Peak intensity measurement of relativistic lasers via nonlinear Thomson scattering

The measurement of peak laser intensities exceeding 10(20) W/cm(2) is in general a very challenging task. We suggest a simple method to accurately measure such high intensities up to about 10(23) W/cm(2), by colliding a beam of ultrarelativistic electrons with the laser pulse. The method exploits the high directionality of the radiation emitted by ultrarelativistic electrons via nonlinear Thomson scattering. Initial electron energies well within the reach of laser wake-field accelerators are required, allowing in principle for an all-optical setup. Accuracies of the order of 10% are theoretically envisaged.     

Studies of plastic-ablator compressibility for direct-drive inertial confinement fusion on OMEGA

The compression of planar plastic targets was studied with x-ray radiography in the range of laser intensities of I approximately 0.5 to 1.5x10(15) W/cm2 using square (low-compression) and shaped (high-compression) pulses. Two-dimensional simulations with the radiative hydrocode DRACO show good agreement with measurements at laser intensities up to I approximately 10(15) W/cm2. These results provide the first experimental evidence for low-entropy, adiabatic compression of plastic shells in the laser intensity regime relevant to direct-drive inertial confinement fusion. A density reduction near the end of the drive at a high intensity of I approximately 1.5x10(15) W/cm2 has been correlated with the hard x-ray signal caused by hot electrons from two-plasmon-decay instability.     

Dynamic polarization in the strong-field ionization of small metal clusters

We report on the strong field ionization of small transition metal clusters (nickel, Ni(n) n=1-36) within the quasistatic regime at an infrared wavelength of 1.5 microm and at intensities up to 2 x 10(14) W/cm(2). From ion yields in a constant axial intensity beam, we obtained saturation intensities for the individual Ni(n) clusters. As compared to quasistatic, single active electron calculations, a dramatic suppression of ionization was observed. Dynamic polarization in the laser field likely leads to strong multielectron screening of the "active" electron. Representing the metal clusters as classical conducting spheres, we obtained, via a barrier suppression calculation, the classical ionization rates. Agreement was obtained for larger clusters with n>10 when the dynamic polarization was taken into account, emphasizing the multielectron nature of the ionization suppression.     

Raman gain measurement in solid parahydrogen

We report a steady-state Raman gain measurement of the Q(1)(0) transition (v = 1 ? 0, J = 0 ? 0) in solid parahydrogen. We carry out measurements by pumping with a continuous-wave frequency-doubled YAG laser at 532 nm and observing the direct amplification of a probe-laser beam for the first Stokes transition at 683 nm. A large single-pass amplification coefficient of 2.3 +/- 0.2 is obtained at a pump intensity of 46 kW/cm(2), with an interaction length of 1 cm, giving a steady-state Raman gain coefficient of 18 +/- 3 cm/MW.     

High-order harmonics from solid targets as a probe for high-density plasmas

The interaction of 100-fs Ti:sapphire laser pulses with thin foil targets was experimentally investigated at intensities exceeding 10(18) W/cm(2). High harmonics were observed in transmission through an overdense plasma in the direction of the incident beam. From the cutoff frequency of the harmonics an electron density of 1 x 10(24) cm(-3) is inferred, indicating a compression of the plasma by the ponderomotive force of the laser pulse.     

Probing nonequilibrium electron distributions in gold by use of second-harmonic generation

Second-harmonic radiation is generated at a gold surface by use of a laser pulse that is varied in duration from 14 to 29 fs and in intensity from 10(9) to 10(11)W/cm(2) . At laser intensities below 10(10)W/cm(2) , the second-harmonic signal has the expected quadratic dependence on pump-laser intensity; however, at higher intensities, the dependence is supraquadratic. This difference arises because the leading edge of the laser pulse interacts significantly with the gold electrons to create a nonequilibrium, photoexcited distribution. The second-harmonic generation process occurs before electron-electron or electron-phonon collisions can equilibrate the distribution and therefore serves as a probe of the nonequilibrium distribution.     

Vacuum ultraviolet frequency combs generated by a femtosecond enhancement cavity in the visible

We present the first (to our best knowledge) femtosecond enhancement cavity in the visible wavelength range for ultraviolet frequency comb generation. The cavity is seeded at 518 nm by a frequency-doubled Yb fiber laser and operates at a peak intensity of 1.2×10(13) W/cm(2). High harmonics of up to the ninth order (~57 nm) are generated in an intracavity xenon gas jet. Intracavity high harmonic powers of several milliwatts for the third harmonic order and microwatts for the fifth harmonic order prove the potential of the "green cavity" as an efficient ultraviolet frequency comb source for future spectroscopic experiments. A limiting degradation effect of the cavity mirrors is avoided by operating at a constant oxygen background pressure.     

Thomson scattering measurements of saturated ion waves in laser fusion plasmas

We have measured the characteristics of saturated ion-acoustic waves in inertial confinement fusion plasmas. A 263-nm probe laser has been applied to simultaneous Thomson scatter on both ion-acoustic waves excited by thermal electrostatic fluctuations and by stimulated Brillouin scattering of a kilojoule laser beam of varying intensity. The Thomson scattering spectra show saturated ion-wave amplitudes for intensities above 5x10(14) W cm(-2) consistent with three dimensional nonlinear wave modeling.     

Recoil-Ion momentum distributions for single and double ionization of helium in strong laser fields

We have measured the momentum distributions of singly and doubly charged helium ions created in the focus of 220 fs, 800 nm laser pulses at intensities of (2.9-6.6)x10(14) W/cm(2). All ions are emitted strongly aligned along the direction of polarization of the light. We find the typical momenta of the He2+ ions to be 5-10 times larger than those of the He1+ ions and a two peak structure at the highest intensity.     

Measurement of high intensity focused ultrasound fields by a fiber optic probe hydrophone

The acoustic fields of a high intensity focused ultrasound (HIFU) transducer operating either at its fundamental (1.1 MHz) or third harmonic (3.3 MHz) frequency were measured by a fiber optic probe hydrophone (FOPH). At 1.1 MHz when the electric power applied to the transducer was increased from 1.6 to 125 W, the peak positive/negative pressures at the focus were measured to be p(+) = 1.7-23.3 MPa and p(-) = -1.2(-) -10.0 MPa. The corresponding spatial-peak pulse-average (I(SPPA)) and spatial-average pulse-average (I(SAPA)) intensities were I(SPPA) =77-6000 W/cm2 and I(SAPA) = 35-4365 W/cm2. Nonlinear propagation with harmonics generation was dominant at high intensities, leading to a reduced -6 dB beam size (L x W) of the compressional wave (11.5 x 1.8-8.8 1.04 mm) but an increased beam size of the rarefactional wave (12.5 x 1.6-13.2 x 2.0 mm). Enhancement ratio of absorbed power density in water increased from 1.0 to 3.0. In comparison, the HIFU transducer working at 3.3 MHz produced higher peak pressures (p(+) = 3.0-35.1 MPa and p(-) = -2.5(-) - 13.8 MPa) with smaller beam size (0.5 x 4 mm). Overall, FOPH was found to be a convenient and reliable tool for HIFU exposimetry measurement.     

The onset of coulomb explosions in polyatomic molecules

With the development of high intensity femtosecond lasers, the ionisation and dissociation dynamics of molecules has become an area of considerable interest. Using the technique of femtosecond laser mass spectrometry (FLMS), the molecules carbon disulphide, pyrimidine, toluene, cyclohexanone and benzaldehyde are studied with pulse widths of 50 fs in the near infrared (IR) wavelength region (790 nm). Results are presented and contrasted for laser beam intensities around 10(15) and 10(16) W cm(-2). For the lower intensities, the mass spectra yield dominant singly charged parent ions. Additionally, the appearance of doubly charged parent ions is evident for carbon disulphide, toluene and benzaldehyde with envelopes of doubly charged satellite species existing in these local regions. Carbon disulphide also reveals a small triply charged component. Such atomic-like features are thought to be a strong fingerprint of FLMS at these intensities. However, upon increasing the laser intensity to approximately 10(16) W cm(-2), parent ion dominance decreases and the appearance of multiply charged atomic species occurs, particularly carbon. This phenomenon has been attributed to Coulomb explosions in which the fast absorption of many photons may produce transient highly ionised parent species which can subsequently blow apart. Copyright 1999 John Wiley & Sons, Ltd.     

Focusing of a tabletop soft-x-ray laser beam and laser ablation

We focused the beam of a high-repetition-rate capillary-discharge tabletop laser operating at a wavelength of 46.9 nm, using a spherical Si/Sc multilayer mirror. The energy densities significantly exceeded the thresholds for the ablation of metals. Single-shot laser ablation patterns were used in combination with ray-tracing computations to characterize the focused beam. The radiation intensity within the 2-mum -diameter central region of the focal spot was estimated to be approximately 10(11)W/cm(2), with a corresponding energy density of ~100 J/cm(2).     

High-throughput, high-damage-threshold broadband beam splitter for high-order harmonics in the extreme-ultraviolet region

We demonstrate a high-throughput and high-damage-threshold beam splitter for high-order harmonics in the soft-x-ray region that uses Si and (or) SiC plates set at Brewster's angle with respect to the pump wavelength. The beam splitters are guaranteed to have a damage threshold of at least 0.8 TW/cm2 (average power density, 0.25 W/cm2) and an attenuation rate of 10(-4)-10(-5) for a 30-fs pump pulse. The measured reflection efficiency at the 27th harmonic (29.6 nm) was 0.56 for Si and 0.45 for SiC. These beam splitters are useful not only for high harmonics but also for longitudinally pumped x-ray lasers.     

光折变晶体中二波耦合光强依赖皮秒光脉冲整形

波长为532nm、主脉冲脉宽为55ps、重复频率为82MHz的激光脉冲列在掺Ce的KNSBN晶体中进行二波耦合.当探测脉冲(倒空脉冲)相对于泵浦脉冲有一定时间延迟时,泵浦脉冲发生整形.整形效果随入射总光强的增大而变得越来越明显.实验结果与理论符合很好.