Investigation of alumina/(+)-catechin system properties. Part I: a study of the system by FTIR-UV–Vis spectroscopy

Catechin belongs to a group of flavonoids, which are present in many fruits and plants. Catechin is often employed in model investigations on antioxidant behavior of flavonoids. Recently also some anti-disease properties of flavonoids were reported. In this paper investigations were carried out on alumina/(+)-catechin solution system. FTIR spectra were taken for the catechin samples retaken from its aqueous solutions at pH 3, 5.5 (natural) and 10.5. In other series, the solutions were contacted with an alumina powder during 20 days. Also UV–Vis spectra were taken for similar solutions incubated for 1, 7, 20, 50 and 70 days with and without contact with alumina. It appeared that the alumina essentially accelerated the autooxidation processes occurring in the solutions. The results show that the processes have completed between day 20 and 50, because the UV–Vis spectra for day 50 and 70 overlapped. Moreover, it looks that this is a specific property of alumina, which behaves as a catalyst. Similar experiments with silica showed that during 50 days, this oxide affected the processes only slightly.     

微生物燃料电池

结合最近几年来微生物燃料电池研究进展情况,对微生物燃料电池的电子转移机理,影响电子转移的主要因素和解决方法,以及微生物燃料电池实用化过程中所面临的问题和应用前景进行了综述。     

In situ scanning electrochemical microscopy (SECM) detection of metal dissolution during zinc corrosion by means of mercury sphere-cap microelectrode tips

This work presents a scanning electrochemical microscopy (SECM)-based in situ corrosion probing methodology that is capable of monitoring the release of zinc species in corrosion processes. It is based on the use of Hg-coated Pt microelectrodes as SECM tips, which offer a wider negative potential range than bare platinum or other noble-metal tips. This allows for the reduction of zinc ions at the tip to be investigated with low interference from hydrogen evolution and oxygen reduction from aqueous solutions. The processes involved in the corrosion of zinc during its immersion in chloride-containing solutions were successfully monitored by scanning the SECM tip, set at an adequate potential, across the sample either in one direction or in the X-Y plane parallel to its surface. In this way, it was possible to detect the anodic and cathodic sites at which the dissolution of zinc and the reduction of oxygen occurred, respectively. Additionally, cyclic voltammetry (CV) or constant potential measurements were used to monitor the release of zinc species collected at the tip during an SECM scan.     

An unexpected symmetry of the coulomb potential in the debye-smoluchowski equation

Generalised diffusion processes are discussed using the theory of stochastic processes and several elementary results are proved for the survival probability of a pair of particles with an arbitrary potential. The reaction probability conditioned on reaction ultimately occurring is considered and its backward equation is determined. In the case of the Coulomb potential the probability is shown analytically to be identical in both the attractive and repulsive cases for a given absolute value of r_c. The utility of this result in numerical solutions of the Debye—Smoluchowski equation is discussed.     

Riboflavin Interactions with Oxygen—A Survey from the Photochemical Perspective

In this short review we provide some insights to the main processes that riboflavin is involved in upon absorption of a photon. We describe riboflavin properties in its interactions with oxygen, comparing them to the properties of some other singlet oxygen sensitizers. Data are provided on riboflavin photosensitizing properties in vivo and in vitro, and its properties as an endogenous singlet oxygen sensitizer are discussed. We additionally report flavin catalytic role in organic synthesis and photochemical reactivity in solutions of riboflavin and some of its derivatives.     

European chemical industry's contribution to sustainable development

Chemical research and innovation is a key enabling factor in achieving a sustainable and equitable global society. The European chemical sector is a key player in the global chemical and pharmaceutical market and has been working to improve its own sustainability for many decades. Initiatives such as the European Technology Platform for Sustainable Chemistry are developing new solutions that will further reduce the environmental impact of the sector, while boosting its energy and resource efficiency, and introducing new materials and processes based on renewable resources for use by society. These innovative solutions catalyse sustainability in other sectors and value chains and will help realise concepts such as a truly circular economy. To effectively implement such solutions requires close cooperation between government, industry and research bodies.     

Cytosol-mimetic chemistry: kinetics of the trypsin-catalyzed hydrolysis of p-nitrophenyl acetate upon addition of polyethylene glycol and N-tert-butyl acetoacetamide

The sensitivity of an enzyme to its environment has provoked much interest both for its immediate relevance to biochemistry and for the use of enzymes in chemical synthesis. The intercellular or extracellular environment in which an enzyme naturally operates is crowded with macromolecular, small-molecule, and ionic solutes and hence is markedly different from the dilute aqueous buffer solutions commonly cited for comparisons of biochemical processes. We report the results of a kinetic study into the effects of such a crowded solution on the rate of an enzyme-mediated process-the trypsin-catalyzed hydrolysis of a nonnatural substrate ester. The catalytic rate constant decreases linearly with solvent polarity, but substrate binding is independent of the concentration of added crowding agent up to 395 g/L.     

Supercritical water as a solvent

Water is not restricted to moderate temperatures and low pressures, but can exist up to very high temperatures, far above its critical point at 647 K. In this supercritical regime, water can be gradually compressed from gas-like to liquid-like densities. The resulting dense supercritical states have extraordinary properties which can be tuned by temperature and pressure, and form the basis for innovative technologies. This Review covers the current knowledge of the major properties of supercritical water and its solutions with nonpolar, polar, and ionic compounds, and of the underlying molecular processes.     

Education and training of laboratory staff as a part of laboratory competence

Competence of laboratory staff is an important part of the technical competence of each laboratory. Because the speed at which knowledge goes out of date is increasing, maintaining laboratory staff competence at an appropriate level can be a very demanding requirement, especially for laboratories operating in a free market with little or no financial help from the state or from the larger organisation they possibly belong to. In order to manage staff competence effectively and efficiently, a laboratory must first define its services and the processes needed for realisation of these services. Responsibility for each step in these processes can then be assigned and gap analysis of current competence can be performed. This article analyses the requirements of ISO/IEC 17025 standard and gives some practical advice and solutions how to organize and manage staff competence.     

The Phototransformations of trans-Stilbene and Its Derivatives on Laser Excitation

The photostability of solutions of trans-stilbene and its derivatives on excitation with an XeCl excimer laser was studied. The quantum yield of phototransformations was found to depend on the intensity of exciting light; namely, the compounds had higher photostability in more intense excitation fields. This fact was explained by competition between the processes of photoisomerization and stimulated emission.     

Destruction of sulfonol in its aqueous solutions by contact glow discharge treatment: 2. Mechanisms and kinetic simulation

A mechanism for the degradation of Sulfonol in its aqueous solutions acting as a liquid cathode of atmospheric-pressure dc discharge in air and for the formation of the products has been proposed, and the chemical kinetics of the degradation processes has been numerically simulated.     

Corrosion behaviour of an Mg–Y–RE alloy used in biomedical applications studied by electrochemical techniques

Magnesium, due to its biocompatibility, a necessity in metabolic processes, and better mechanical properties than polymer, is an ideal candidate for biodegradable implants. The main actual limitation for the use of magnesium alloys is its too fast degradation rate in the physiological environment. The corrosion behaviour of an Mg–Y–RE magnesium alloy in two different physiological solutions (artificial plasma (AP) and simulated body fluid (SBF)) was investigated, using electrochemical impedance spectroscopy (EIS).The investigation showed that SBF is significantly more aggressive than AP with regard to the polished surface. A large difference in the corrosion rate and mechanisms (uniform or localized corrosion) is observed as a function of the buffer capacity of the media, but also of the carbonate and chloride content. For temporary surface protection, the formation of an approximately 350–400 nm dense hydroxide layer is obtained by electrochemical anodising. An increase of the corrosion resistance of the treated alloy for both physiological solutions is obtained, and this is especially noticeable for a long immersion time in AP.     

Scaling invariance of the von Smoluchowski rate law

The kinetics of flocculation for colloidal suspensions that occur in natural environments have often been studied in terms of the von Smoluchowski rate law. Recent theoretical studies have analyzed scale-invariant flocculation processes leading to the formation of fractal structures which, in turn, have been observed in experiments on synthetic colloids. In this paper, these processes are described in terms of the scaling invariance of the von Smoluchowski equation itself and are shown to be consistent with asymptotic limits of two of its well known exact solutions, corresponding to transport- or reaction-controlled flocculation. The resulting self-similar forms of these solutions and the associated fractal properties of the floccules are discussed in the context of proposed universality classes. The results are applied to the characterization of heterogeneous colloids found in natural aqueous systems.     

A study of kinetic molecular exchange processes in the medium frequency range by surface SHG on an oscillating bubble

The dilatational properties of fluid surfaces and interfaces have been comprehensively investigated in recent years. For example, an improved oscillating bubble device provided experimental results that allow for critical testing of established surface models, such as the Lucassen/van den Tempel (LvdT) model. The comparison of the LvdT model with the oscillating bubble experiments demonstrates a mismatch between the model parameters. For example, near the CMC or the limit of solubility the calculated parameters of surfactant solutions become unrealistically large. The deviation can be explained by the introduction of more detailed surface models, in particular by the modification of the effective thickness of the surface layer, its internal structure and the molecular exchange processes between these structures. For the verification of such processes an experimental setup was realized which allows for an independent determination of the instantaneous adsorption state at the surface of an oscillating bubble inside a surfactant solution. The setup utilizes the Second Harmonic Generation (SHG)--effect at the air-solution interface generated by the light of a pulsed LASER. The set-up is described in detail, and the results of a first experimental series are presented and discussed in this paper. As system, aqueous solutions of the fluortenside F381 were used.     

Low-Cost Potentiometric Sensor for Chloride Measurement in Continuous Industrial Process Control

Recently, the new updates in legislation about drinking water control and human health have increased the demand for novel electrochemical low-cost sensors, such as potentiometric ones. Nowadays, the determination of chloride ion in aqueous solutions has attracted great attention in several fields, from industrial processes to drinking water control. Indeed, chloride plays a crucial role in corrosion, also influencing the final taste of beverages, especially coffee. The main goal is to obtain devices suitable for continuous and real-time analysis. For these reasons, we investigated the possibility to develop an easy, low-cost potentiometric chloride sensor, able to perform analysis in aqueous mediums for long immersion time and reducing the need of periodic calibration. We realized a chloride ion selective electrode made of Ag/AgCl sintered pellet and we tested its response in model solutions compatible with drinking water. The sensor was able to produce a stable, reproducible, and accurate quantification of chloride in 900 s, without the need for a preliminary calibration test. This opens the route to potential applications of this sensor in continuous, in situ, and real time measurement of chloride ions in industrial processes, with a reduced need for periodic maintenance.     

Copper hydrometallugry and extraction from chloride media

The development of copper hydrometallurgy is presented and various processes proposed for copper recovery from sulphide concentrates are discussed. Leaching, extraction and stripping are considered, including reagents and processes. The extraction of copper from chloride solutions is discussed. Various extractants are presented and their use for copper transfer from chloride solutions to the organic phase and back to chloride and to sulphate solutions is discussed.     

Synthesis of Poly(acrylic acid) Nanogels and Application in Loading and Release of an Oligothiophene Fluorophore and Its Bovine Serum Albumin Conjugate

Summary: Nanometer-sized poly(acrylic acid) (PAA) hydrogels were synthesized by emulsion polymerization of methyl acrylate and subsequent acid hydrolysis, and their pH-dependent swelling behaviour was studied by dynamic light scattering. To determine the suitability of PAA nanogels as pH-sensitive carriers for biomedical applications, loading and release of an oligothiophene fluorophore and its albumin conjugate onto the PAA nanogels were investigated as a function of pH by absorption and photoluminescence measurements. It was observed that loading and release processes of both the oligothiophene and its conjugate could be controlled by changing pH of their solutions.     

Photochemical and Photophysical Processes of N-Deacetyllappaconitine and Its Monohydrobromide in Aqueous Solutions

Chemistry of Natural Compounds - The photophysical and photochemical processes of N-deacetyllappaconitine (DAL) and its hydrobromide (DAL·HBr) in aqueous solutions were investigated. Their...     

The Kinetics of Plasma-Induced Degradation of Organic Pollutants in Sewage Water

The processes of treatment of actual surface water and model solutions in a low-temperature dielectric-barrier discharge (DBD) plasma were studied. The general evaluation of the efficiency of the plasma treatment procedure for sewage purification was made, and a conclusion on the reasonability of its use in combination with conventional treatment methods was drawn. Schemes of conversion processes for organic compounds upon DBD treatment of surface water were proposed, and the effective rate constants of corresponding reactions were estimated (for phenol, k = 0.46 × 10^–5 s^–1). It was found that the reaction of oxidation of pollutants in solutions modeling surface runoff occurs in the diffusion region.     

Mechanism of anodic oxidation of tungsten in neutral sulphate-fluoride solutions

The anodic oxidation of tungsten has been studied in 1 M Na₂SO₄ solutions containing 0–0.25 M NaF. Steady-state currents measured in the passivation and passivity ranges increase significantly with increasing fluoride concentration, indicating enhanced dissolution of the oxide film. The electrochemical impedance response is dominated by the processes in the barrier layer and at its interface with the electrolyte. The presence of a pseudo-inductive loop in the impedance spectra at intermediate frequencies indicates point defect interaction during film growth and dissolution processes. A kinetic model including the recombination reaction between oppositely charged point defects at the film/solution interface as well as a kinetic scheme for tungsten dissolution through the film mediated by cation vacancies is proposed. It is found to reproduce satisfactorily the steady-state currents and the impedance spectra in the potential range 0.2–2 V. Such a model for the conduction mechanism in the barrier layer is believed to be an essential part of a modelling approach to the formation of a nanoporous overlayer on tungsten in fluoride-containing solutions.