An amperometric glucose oxidase biosensor based on liposome microreactor-chitosan nanocomposite-modified electrode for determination of trace mercury

Journal of Solid State Electrochemistry - A biosensor for trace mercury ions based on glucose oxidase (GOD) immobilized on liposome microreactor and chitosan (CS) nanocomposite through...     

Reduction mechanism of benzoin on a mercury electrode

The electrochemical reduction of benzoin was studied in acid media at DME. Convolution potential sweep voltammetry was applied to obtain the charge transfer rate constants. The overall reduction corresponds formally to an irreversible two-electron, two-proton transfer. Deoxybenzoin was identified as the final product of the benzoin reduction. Low-temperature bulk electrolysis experiments showed the presence of an unstable enol intermediate. This compound undergoes an enol-keto transformation, whose acid catalyzed rate constants were determined by chronoamperometry. The kinetic results indicate a stabilization of the intermediate carbocation in the presence of perchlorate.     

Berberine adsorption at a mercury electrode

The adsorption of berberine and canadine was measured by a.c. polarography. For berberine three different superficial structures were observed: the ions lying flat, the mixed layer of flat and perpendicular ions and the condensed film of perpendicular ions which incorporates anions of the supporting electrolyte. The boundaries between these structures are diffuse. The condensation is an instantaneous nucleation and two-dimensional film growth process. The adsorption of canadine is similar, but its condensed film is very stable and the exchange rate between the adsorbed canadine and the dissolved berberinium ions is very low. Different structures of the adsorbed berberine result in different faradaic square-wave responses.     

Residual photocurrent at a mercury electrode

The residual photocurrent observed at negative potentials with mercury in contact with slightly alkaline 1 M KCl solution has been reinvestigated and found to be caused partly by the reaction of e^?_aq with traces of unidentified electron acceptors and partly by reaction with the solvent. Such a solution can be freed from electron-accepting impurities by irradiation with light of shorter wavelength than 270 nm if SO^2?₃ is present at low concentration. The time constant for the homogeneous decay of e^?_aq at pH ca. 8.8 is then raised to about 400 μs. This slow decay is due to reaction with the solvent as the decay time constant can be increased considerably by raising the pH of the solution. In unsteady state experiments with purified 1 M KCl solutions of high pH containing no added scavenger for e^?_aq the current connected with electron emission and e^?_aq diffusion towards the electrode and the bulk of the solution, is cancelled out at ca. ?1.4 V vs. SCE by a thermal non-faradaic current component when 360 nm light is employed. When CO₂ is present at high concentration a similar cancellation is observed at lower pH at ca. ?1.1 V vs. SCE, suggesting a value for the diffusion coefficient of the radical-ion CO^?₂ about 3.3 times smaller than that of e^?_aq.     

Electrochemical behavior of kryptand 222 on a mercury electrode

The electrochemical behavior of kryptand 222 at the interface between a mercury electrode and an aqueous solution is studied by the impedance spectroscopy, polarography, and cyclic voltammetry methods. It is established that kryptand 222 possesses high surface activity at this interface. Adsorption parameters of kryptand 222 are found on the basis of the model of two parallel capacitors supplemented by the Frumkin isotherm by the regression analysis method. The potential dependences of the differential capacitance (C,E curves), calculated using these parameters satisfactorily agree with experiment. It is shown that the maximum in the C,E curves in the region of negative potentials is caused by catalytic process of hydrogen evolution.     

Voltammetry of resazurin at a mercury electrode

Electrochemical behavior of resazurin on HMDE in Britton-Robinson (B-R) buffers (pH 2.0–10.0) was studied using the square-wave voltammetry (SWV), square-wave adsorptive stripping voltammetry (SWAdSV), and cyclic voltammetry (CV) techniques. The voltammogram of resazurin in B-R buffer at pH < 4.0 exhibited two cathodic reduction peaks. The voltammetric peaks were obtained at −0.144 V (reversible) and −1.250 V (irreversible) at pH 3.2, and correspond to the reduction of resorufin to dihydroresorufin and to the catalytic hydrogen wave, respectively. At pH > 4.0, a new irreversible cathodic reduction peak, assigned to the protonation of N-oxide on the phenoxazin ring, was observed. Electrochemical parameters (I _p/E _p, I _p/v, I _p/pH, I _p/t _acc) of the compound were determined. From the voltammetric data, electrochemical reduction mechanisms for all peaks have been suggested. Maximum peak current for the reversible peak was obtained at pH 4.1. A linear relationship between the current and concentration was determined, and also the lowest detection limit was found as 3.25 × 10⁻⁸ mol L⁻¹ and 1.98 × 10⁻¹⁰ mol L⁻¹ for SWV and SWAdSV, respectively.     

Glycine adsorption on a mercury electrode modified by neodymium

Ranges of neodymium reduction potentials in aqueous solutions of potassium chloride at pH = 2 and in solutions containing glycine were determined by differential pulse polarography. The glycine complex with neodymium is not formed in the range of the amino acid concentration 0.001–0.12 M. Glycine adsorption on a mercury electrode and on an electrode modified with neodymium was studied by the cyclic voltammetry method.     

Adsorption of kryptates of two-charged cations on a mercury electrode

The adsorption of complexes formed by cations of calcium, strontium, and barium with a macrobiocyclic ligand (Kryptofix® 222 of composition C₁₈H₃₆N₂O₆) is studied as a function of its concentration in 0.1 M solutions of corresponding chlorides by a method of measuring the differential capacitance on a stationary mercury drop. The adsorption parameters of the kryptates studied are determined by a method of regression analysis on the basis of the model of two parallel capacitors supplemented by the Frumkin adsorption isotherm. The differential-capacitance curves, calculated on the basis of these parameters, are compared with experimental data. The determined values of adsorption parameters for kryptates of single-and two-charged cations made it possible to confirm the earlier assumption about a deep mutual relation between the behavior of complexes under study and their structure.     

Electrochemical reduction of dihydroquercetin on mercury electrode

The methods of classical and ac polarography were used to study the electrochemical behavior of dihydroquercetin on a mercury dropping electrode. This process occurs only in protonic media. The protonated and nonprotonated forms of dihydroquercetin undergo electroreduction. The amount of electrons and protons participating in electroreduction of the studied flavonoid is determined. The nature of currents measured in the processes of electrochemical reduction of dihydroquercetin is studied.     

Electrochemical studies of technetium at a mercury electrode

The electrochemistry of technetium was studied by polarography, cyclic voltammetry and coulometry in chloride and sulfate media as a function of pH in the range 1.5–13. Compounds of Tc(III) and Tc(IV) are produced by reduction of pertechnetate, and the system Tc(III)/Tc(IV) was investigated in acidic media. The potential—acidity diagram of technetium is described for two total pertechnetate concentrations. Evidence for the dismutation of Tc(III) below pH 4 is discussed.     

苯亚甲基丙二腈在汞阴极上的还原反应

本文应用了多种电化学方法(循环伏安法,微分脉冲极谱法等)及UV光谱,GC-MS手段研究了苯亚甲基丙二腈(BDMN)在汞阴极上的还原过程.在0.03mol.L^-1四乙基溴化铵(TEAB),50%二氧六环-水介质中BDMN还原的微分脉冲极谱图上有两个峰,第一个峰是此分子中的双键还原,生成苄基丙二腈引起的,峰电位在-0.98V(vs.SCE).第二个峰的峰电位在-1.55V(vs.SCE),此峰是BDMN的水解产物苯甲醛还原为苯甲醇产生的.BDMN的整个电极反应为ECEC过程.此处,对BDMN及二氧六环在汞电极上的吸附现象也进行了研究.     

Convolutive forecasting at a hanging mercury drop electrode

Convolutive forecasting is a procedure which converts a non-steady-state voltammogram into a steady-state voltammogram. The procedure was found to be successful on a range of sphericities generated by varying the size of a hanging mercury drop and the potential sweep rate in a series of cyclic voltammetric experiments. Both theoretical and experimental analyses on a reversible electrochemical system were considered. An expression establishing the relationship between the radius of a spherical electrode and the potential sweep rate was developed to define the limits of the convolutive forecasting algorithm which was used.     

Anodic stripping coulometry at a thin-film mercury electrode

Primary coulometric versions of d.c. anodic stripping voltammetry, performed in a microcell at a mercury-plated rotating glassy carbon electrode, are applied to the determination of cadmium and lead. With exhaustive preelectrolysis of the sample solution, 5–100 ng of the metal can be determined from the charge contained in the stripping signal; precision and accuracy are in the 5% range. An extrapolation procedure that requires only partial metal deposition is evaluated.     

Determination of mercury ions on a diphenylcarbazone bulk modified graphite electrode

A bulk modified electrode prepared by pressing a mixture of carbon powder and diphenylcarbazone at 15.2 MPa was used for the determination of mercury in aqueous solutions. Mercury(II) ions are concentrated by complexation with the modifier in acidic (HNO₃) solution. After exchange of the medium for 1 M HCl and 1 M CaCl₂, mercury is reduced at ?0.8 V vs. SCE. The signal is generated by anodic stripping in the differential-pulse mode. The calibration graph is linear in the range 5×10^?8?5× 10^?6 M with a relative standard deviation of 7%. After enrichment for 10 min the detection limit is 5×10^?8 M. Silver, chromate and strong complexing agents interfere. The use of the electrode to determine the labile fraction in mercury speciation is discussed.     

Electrodimerization of crotonic aldehyde in aqueous media on a mercury electrode

The electrohydrodimerization mechanism of crotonaldehyde reduction on a mercury electrode is characterized on the basis of polarographic (dc and DP) and voltammetric experiments and determination of reaction orders. The possibilities of the differential pulse polarographic technique in discriminating between the different electrodimerization processes are mentioned.     

Anodic behaviour of 2-mercaptoethanol at a mercury electrode

The anodic processes which occur at the mercury electrode in 2-mercaptoethanol solutions are studied by various polarographic techniques (d.c., a.c. and differential pulse), controlled-potential coulometry, cyclic voltammetry and differential capacity curves. Two steps are distinguished in the process: a one-electron charge transfer and a dismutation step leading to the formation of a mercury(II) mercaptide. The final product is isolated and analyzed. Differential-pulse polarography can be used to determine ?10^?4 M 2-mercaptoethanol with a limit of M.