Highly Enantioselective Synthesis of Propargyl Amide with Vicinal Stereocenters through Ir‐Catalyzed Hydroalkynylation

Chiral propargyl amines are valuable synthetic intermediates for the preparation of biologically active compounds and functionalized amines. Catalytic methods to access propargyl amines containing vicinal stereocenters with high diastereoselectivity are particularly rare. We report an unprecedented strategy for the synthesis of enantioenriched propargyl amines with two stereogenic centres. An iridium complex, ligated by a phosphoramidite ligand, catalyzes the hydroalkynylation of β,β‐disubstituted enamides to afford propargyl amides in a highly regio‐, diastereo‐, and enantioselective fashion. Stereodivergent synthesis of all four possible stereoisomers was achieved using this strategy.     

One‐Pot Three‐Component Synthesis of Vicinal Diamines via In Situ Aminal Formation and Carboamination

A synthesis of vicinal diamines via in situ aminal formation and carboamination of allyl amines is reported. Employing highly electron‐poor trifluoromethyl aldimines in their stable hemiaminal form was key to enable both a fast and complete aminal formation as well as the palladium‐catalyzed carboamination step. The conditions developed allow the introduction of a wide variety of alkynyl, vinyl, aryl, and hetereoaryl groups with complete regioselectivity and high diastereoselectivity. The reaction exhibits a high functional‐group tolerance. Importantly, either nitrogen atom of the imidazolidine products can be selectively deprotected, while removal of the aminal tether can be achieved in a single step under mild conditions to reveal the free diamine. We expect that this work will promote the further use of mixed aminal tethers in organic synthesis.     

Titanium Binolate Catalyzed Aminolysis of meso Aziridines: A Highly Enantioselective and Direct Access to 1,2‐Diamines

It's as simple as that : An in situ prepared chiral catalyst from the commercially available compounds Ti(OiPr)₄ and (R)‐binol catalyzes the highly enantioselective ring‐opening of meso‐aziridines 1 with anilines 2 and furnishes valuable chiral 1,2‐diamines 3 in high yields and up to 99 % ee.(R)‐binol=(R)‐2,2′‐dihydroxy‐1,1′‐binaphthyl.

     

Highly Enantioselective Iridium‐Catalyzed Hydrogenation of α,β‐Unsaturated Esters

α,β‐Unsaturated esters have been employed as substrates in iridium‐catalyzed asymmetric hydrogenation. Full conversions and good to excellent enantioselectivities (up to 99 % ee) were obtained for a broad range of substrates with both aromatic‐ and aliphatic substituents on the prochiral carbon. The hydrogenated products are highly useful as building blocks in the synthesis of a variety of natural products and pharmaceuticals.     

Dehydrogenative Synthesis of 2,2′‐Bipyridyls through Regioselective Pyridine Dimerization

2,2′‐Bipyridyls have been utilized as indispensable ligands in metal‐catalyzed reactions. The most streamlined approach for the synthesis of 2,2′‐bipyridyls is the dehydrogenative dimerization of unfunctionalized pyridine. Herein, we report on the palladium‐catalyzed dehydrogenative synthesis of 2,2′‐bipyridyl derivatives. The Pd catalysis effectively works with an Ag^I salt as the oxidant in the presence of pivalic acid. A variety of pyridines regioselectively react at the C2‐positions. This dimerization method is applicable for challenging substrates such as sterically hindered 3‐substituted pyridines, where the pyridines regioselectively react at the C2‐position. This reaction enables the concise synthesis of twisted 3,3′‐disubstituted‐2,2′‐bipyridyls as an underdeveloped class of ligands.     

New Chiral Ligand N—Toluenesulfony1—2,2‘—dimethoxy—6,6’—di—aminobiphenyl for Catalytic Asymmetric Transfer Hydrogenation of Ketones

A new chiral ligand N‐p‐toluenesulfonyl‐2,2′‐dimethoxy‐6,6′‐diaminobiphenyl (Ts‐DMBDPPA) was prepared from 2,2′‐dimethoxy‐6,6′‐diaminobiphenyl via N‐tosylation. Its Ru(II) complex was effective catalysts for catalytic asymmetric transfer hydrogenation of aromatic ketones (with ee's up to 69.3%).     

Nickel‐Catalyzed Asymmetric Hydrogenation of 2‐Amidoacrylates

Earth‐abundant nickel, coordinated with a suitable chiral bisphosphine ligand, was found to be an efficient catalyst for the asymmetric hydrogenation of 2‐amidoacrylates, affording the chiral α‐amino acid esters in quantitative yields and excellent enantioselectivity (up to 96 % ee). The active catalyst component was studied by NMR and HRMS, which helped us to realize high catalytic efficiency on a gram scale with a low catalyst loading (S/C=2000). The hydrogenated products could be simply converted into chiral α‐amino acids, β‐amino alcohols, and their bioactive derivatives. Furthermore, the catalytic mechanism was investigated using deuterium‐labeling experiments and computational calculations.     

Synthesis,Crystal Structures and Fluorescent Properties of Two 2,2′‐Biquinoline‐4,4′‐dicarboxylate‐based Cadmium(II) and Cobalt(II) Complexes

Two metal‐organic coordination polymers with one‐dimensional infinite chain motif, [Cd(bqdc)(phen)₂]_n ( 1 ) and [Co(bqdc)(phen)(H₂O)₂]_n ( 2 ) (H₂bqdc = 2,2′‐biquinoline‐4,4′‐dicarboxylic acid, phen = 1,10‐phenanthroline), have been synthesized under similar solv/hydrothermal conditions and fully structural characterized by elemental analysis, IR, and single‐crystal X‐ray crystallography. Their thermal stability and photoluminescence properties were further investigated by TG‐DTA and fluorescence spectra. In both complexes, the adjacent metal ions (Cd^II for 1 and Co^II for 2 ) are linked together by dicarboxylate groups of bqdc dianions in chelating bidentate and monodentate modes, respectively, generating a zigzag chain for 1 and linear chain for 2 . The relatively higher thermal stability up to 324 °C for 1 and strong fluorescence emissions jointly suggest that they are good candidates for luminescent materials.     

Synthesis and properties of novel polyimides derived from 2,2′,3,3′‐benzophenonetetracarboxylic dianhydride

A new synthetic route to 2,2′,3,3′‐BTDA (where BTDA is benzophenonetetracarboxylic dianhydride), an isomer of 2,3′,3′,4′‐BTDA and 3,3′,4,4′‐BTDA, is described. Single‐crystal X‐ray diffraction analysis of 2,2′,3,3′‐BTDA has shown that this dianhydride has a bent and noncoplanar structure. The polymerizations of 2,2′,3,3′‐BTDA with 4,4′‐oxydianiline (ODA) and 4,4′‐bis(4‐aminophenoxy)benzene (TPEQ) have been investigated with a conventional two‐step process. A trend of cyclic oligomers forming in the reaction of 2,2′,3,3′‐BTDA and ODA has been found and characterized with IR, NMR, matrix‐assisted laser desorption/ionization time‐of‐flight mass spectrometry, and elemental analyses. Films based on 2,2′,3,3′‐BTDA/TPEQ can only be obtained from corresponding polyimide (PI) solutions prepared by chemical imidization because those from their polyamic acids by thermal imidization are brittle. PIs from 2,2′,3,3′‐BTDA have lower inherent viscosities and worse thermal and mechanical properties than the corresponding 2,3′,3′,4′‐BTDA‐ and 3,3′,4,4′‐BTDA‐based PIs. PIs from 2,2′,3,3′‐BTDA and 2,3′,3′,4′‐BTDA are amorphous, whereas those from 3,3′,4,4′‐BTDA have some crystallinity, according to wide‐angle X‐ray diffraction. Furthermore, PIs from 2,2′,3,3′‐BTDA have better solubility, higher glass‐transition temperatures, and higher melt viscosity than those from 2,3′,3′,4′‐BTDA and 3,3′,4,4′‐BTDA. Model compounds have been prepared to explain the order of the glass‐transition temperatures found in the isomeric PI series. The isomer effects on the PI properties are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2130–2144, 2004     

Building Functionality into 4′‐Hydrazone Derivatives of 2,2′: 6′,2″‐Terpyridine

The syntheses of the five 2,2′: 6′,2″‐terpyridine (tpy) ligands 5 – 9 functionalized in the 4′‐position with a hydrazone substituent RR′C?N? NH (R=R′=Me; R=H, R′=4‐BrC₆H₄, 4‐O₂NC₆H₄, 4‐MeOC₆H₄, or 3,5‐(MeO)₂C₆H₃) are described. Protonation of the tpy domain of the ligands is facile. Solution behaviour has been studied by NMR and electronic spectroscopies. Representative structural data are presented for neutral and monoprotonated ligands, and illustrate that H‐bonding involving the formal amine NH unit is a dominant structural motif in all cases.     

Ir‐SpinPHOX Catalyzed Enantioselective Hydrogenation of 3‐Ylidenephthalides

The first asymmetric hydrogenation of 3‐ylidenephthalides has been developed using the Ir^I complex of a spiro[4,4]‐1,6‐nonadiene‐based phosphine‐oxazoline ligand (SpinPHOX) as the catalyst, affording a wide variety of chiral 3‐substituted phthalides in excellent enantiomeric excesses (up to 98 % ee). The utility of the protocol has been demonstrated in the asymmetric synthesis of chiral drugs NBP and BZP precursor, as well as the natural products chuangxinol and typhaphthalide.     

Axially Dissymmetric Chiral (R)‐N,W‐Bis(2‐hydroxy‐3,5‐ditert‐butyl‐arylmethyl)‐1, 1′‐binaphthalene‐2,2′‐diamine as Chiral Ligands in the Reaction of Diethylzinc to Aldehydes†

Chiral ligand (A)‐N,N′‐Bis(2‐hydroxy‐3,5‐di‐tert‐butyl‐arylmethyl)‐1,1′‐binaphthalene‐2,2′‐diamine derived from the reduction of Schiff base (R)‐2,2′‐bis (3,5‐di‐tert‐butyl‐2‐hydroxybenzylideneamino)‐1, 1′‐binaphthyl with LiAlH₄, is fairly effective in the asymmetric addition reaction of diethylzinc to aldehydes by which good yields (46%‐94%) of the corresponding sec‐alcohols can be obtained in moderate ee (51%‐79%) with R configuration for a variety of aldehydes.     

Masking of Lewis acidity trends in the solid‐state structures of trichlorido‐ and tribromido(2,2′:6′,2′′‐terpyridine‐κ3N,N′,N′′)gallium(III)

The molecular structures of trichlorido(2,2′:6′,2′′‐terpyridine‐κ³N,N′,N′′)gallium(III), [GaCl₃(C₁₅H₁₁N₃)], and tribromido(2,2′:6′,2′′‐terpyridine‐κ³N,N′,N′′)gallium(III), [GaBr₃(C₁₅H₁₁N₃)], are isostructural, with the Ga^III atom displaying an octahedral geometry. It is shown that the Ga—N distances in the two complexes are the same within experimental error, in contrast to expected bond lengthening in the bromide complex due to the lower Lewis acidity of GaBr₃. Thus, masking of the Lewis acidity trends in the solid state is observed not only for complexes of group 13 metal halides with monodentate ligands but for complexes with the polydentate 2,2′:6′,2′′‐terpyridine donor as well.     

Poly(3,3′-dimethoxy-2,2′-bithiophene): Synthesis and comparison with poly(3-methoxythiophene)

A new electroactive polymer, namely poly(3,3′-dimethoxy-2,2′-bithiophene) has been prepared by voltammetric polymerization of 3,3′-dimethoxy-2,2′-bithiophene. Due to a different coupling pattern (equivalent to “head-to-head,” and “tail-to-tail” coupled alkoxythiophene rings), poly(3,3′-dimethoxy-2,2′-bithiophene) exhibits different voltammetric properties than the corresponding “head-to-tail” coupled polymer, i.e., poly(3-methoxythiophene). Poly(3,3′-dimethoxy-2,2′-bithiophene) gives very sharp oxidation and reduction peaks indicating an abrupt insulator to conductor transition. This hypothesis was corroborated by the studies of relative resistance as a function of electrode potential. Sharper and better-defined redox peaks may indicate better stereoregularity of poly(3,3′-dimethoxy-2,2′-bithiophene) as compared to poly(3-methoxythiophene) since in this compound the 5,5′-coupling positions are geometrically equivalent and no coupling defects are expected. © 1992 John Wiley & Sons, Inc.