Second-order kinetics of enthalpy recovery in polystyrene

Second-order kinetics were found applicable to the isothermal enthalpy release after quenching from a high temperature. The kinetic behavior was unaffected by different amounts of initial excess enthalpy. The activation enthalpy obtained from the temperature dependence of the second order rate constant was 200 kcal/mol or 837 kJ/mol which could be compared with 736 kJ/mol for volume recovery in a similar temperature range relative to T_g.     

Configurational effects on polystyrene rejection from microporous membranes

Dilute solutions of polystyrene in chloroform were filtered through track-etched mica membranes. The pores of each membrane were smaller than the mean unperturbed dimension of the polymer molecules. Three configurations of polystyrene were used: linear, comb-branched, and star-branched. The data for the linear polystyrenes show that the reflection coefficient σ decreases with solvent flow rate per pore q in a manner independent of molecular weight. At low flow rates the rejection is quantitatively described by 1 ? σ ～ q^1.69. Comparisons among the three configurations show that as the extent of branching increases, σ increases at given solvent flow rate. It is concluded that filtration studies with well-defined porous membranes can provide a relative measure of deformability among various configurations of polymeric species.     

Effect of temperature and molecular weight on enthalpy relaxation in polystyrene

Isothermal enthalpy relaxation in polystyrene was measured as a function of temperature and molecular weight on a differential scanning calorimeter. Relaxation spectra were derived from the data and expressed as a distribution of relaxation times. For a given molecular weight the relaxation spectra at different temperatures could not be superimposed by a shift in time. The relaxation curves of samples of different molecular weights could be superimposed only when the difference between the temperature at which the relaxation was monitored (T_a) and their respective T_g was the same. The relaxation spectrum at any temperature for a given molecular weight was also expressed as a distribution of energies. The average energy represented by this distribution was associated with an activation energy required for the motion of a chemical repeat unit. The activation energy extracted from the temperature shift in the relaxation spectra corresponded to the motion of a statistical unit (Kuhn's segment) in polystyrene.     

Configurational stability of chlorophosphines

The configurational stability of chlorophosphines is investigated. Several mechanisms involving chlorophosphine monomer, dimers, and adducts with HCl are evaluated by density functional theory calculations. The presence of HCl in the medium is found to catalyze the P-center chiral inversion at room temperature. The reaction involves a two-step mechanism with low transition states (10 kcal.mol-1) and a stabilized achiral intermediate (-2.6 kcal.mol-1). Further calculations and experiments on the halogen exchange with HBr corroborate this mechanism, with bromophosphines being formed instantaneously. Finally, to avoid the racemization, the borane is found to be a very promising protecting group for the configurational stability of the P-chirogenic chlorophosphines.     

Configurational Isomerism in Polyoxovanadates

A water‐soluble derivative of the polyoxovanadate {V₁₅E₆O₄₂} (E=semimetal) archetype enables the study of cluster shell rearrangements driven by supramolecular interactions. A reaction unique to E=Sb, induced exclusively by ligand metathesis in peripheral [Ni(ethylenediamine)₃]²⁺ counterions, results in the formation of the metastable α₁* configurational isomer of the {V₁₄Sb₈O₄₂} cluster type. Contrary to all other polyoxovanadate shell architectures, this isomer comprises an inward‐oriented vanadyl group and is ca. 50 and 12 kJ mol^?1 higher in energy than the previously isolated α and β isomers, respectively. We discuss this unexpected reaction in light of supramolecular Sb?O???V and Sb?O???Sb contacts manifested in {V₁₄Sb₈O₄₂}₂ dimers detected in the solid state. ESI MS experiments confirm the stability of these dimers also in solution and in the gas phase. DFT calculations indicate that other, as of yet elusive isomers of {V₁₄Sb₈}, might be accessible as well.     

Configurational statistics of polyamide chains

The statistical mechanical treatment of polymeric chains in terms of the largest eigenvalue of the product of statistical weight matrices for the rotational interactions of skeletal bonds of the repeat unit becomes excessively complicated if the repeat unit spans more than three or four skeletal bonds. Moreover, such treatment is necessarily limited to chains in which the number of repeat units is indefinitely large. Newer methods are readily applicable to chains of any degree of polymerization comprising repeat units of any realizable length. If interdependence of neighboring bond rotations is confined to bond pairs within a given unit, rotations about a pair of bonds belonging to neighboring units being mutually independent, further simplifications may be introduced without sacrifice of rigor. Polyamides, in which rotation about bonds on opposite sides of the amide group are independent, are polymers of this type. Adherence of the amide group to the planar trans conformation favors a more extended configuration of the chain, but this effect is dominated by the smaller steric repulsions affecting rotations about bonds which are first, second, and third neighbors of the amide group. It is for this reason that the characteristic ratio 〈r²〉₀〉/nl² for poly(hexamethylene adipamide), ca. 6.0 according to experimental results of Saunders, is less than the value, 8.0, for polymethylene at 25°C. The characteristic ratios and molecular dipole moments are computed as functions of the degree of polymerization. The poly(εaminocaproamide) chain also is treated.     

Configurational assignment of N-arylsulfonylimines of alpha-polychloroaldehydes

Configurational assignment of seven synthesized N-arylsulfonylimines of alpha-polychloroaldehydes has been carried out by means of experimental measurements and high-level ab initio calculations of their (13)C--(13)C, (13)C--(1)H and (15)N--(1)H spin-spin coupling constants. The title compounds were shown to exist in solution solely in the form of E isomers, in line with thermodynamic reasoning.     

Configurational constant pressure molecular dynamics

We propose two new algorithms for generating isothermal-isobaric molecular dynamics. The algorithms are based on an extended phase space dynamics where two extra degrees of freedom, representing the thermostat and the barostat, are included. These new methods adopt a totally different approach towards molecular dynamics simulation in the isothermal-isobaric ensemble. They are fully configurational in the sense that only the particle positions are required in the control of the system temperature and pressure. Following on from the works of Delhommelle and Evans [Mol. Phys., 99, 1825 (2001)] and of Braga and Travis [J. Chem. Phys., 123, 134101 (2005)] concerning configurational canonical dynamics, these new algorithms can be seen as a natural extension to the isothermal-isobaric ensemble. We have validated both of our new configurational isothermal-isobaric schemes by conducting molecular dynamics simulations of a Lennard-Jones fluid and comparing the static and dynamic properties for a single state point. We find that both schemes generate similar results compared with schemes which use kinetic temperature and pressure control. We have also monitored the response of the system to a series of isothermal compressions and isobaric quenches. We find that the configurational schemes performed at least as well as the kinetic based scheme in bringing the system temperature and pressure into line with the set point values of these variables. These new methods will potentially play a significant role in simulations where the calculation of the kinetic temperature and pressure can be problematic. A well known example resides in the field of nonequilibrium simulations where the kinetic temperature and pressure require a knowledge of the streaming velocity of the fluid in order to calculate the true peculiar velocities (or momenta) that enter into their definitions. These are completely avoided by using our configurational thermostats and barostats, since these are independent of momenta. By extending the analysis of Kusnezov et al. [Ann. Phys., 204, 155 (1990)] in order to derive a set of generalized Nose-Hoover equations of motion which can generate isothermal-isobaric dynamics in a number of different ways, we are able to show that both of our new configurational barostats and Hoover's kinetic isothermal-isobaric scheme are special cases of this more general set of equations. This generalization can be very powerful in generating constant pressure dynamics for a variety of systems.     

Size-dependent enthalpy of condensation

A thermodynamic model for the size dependence of enthalpy of condensation, DeltaH(con), is discussed. The model is valid over a range of radii where the arrangement of surface layer and surface tension remain invariable; it provides a way of calculating enthalpy and entropy changes and equilibrium vapor pressures. The difference between DeltaH(con) for two liquid bodies of the same chemical nature is equal to the variation of the autoadsorption energies on their surfaces.     

模型高分子环形链的构象统计理论

模型高分子环形链的构象统计理论吴大诚，杜鹏，康健（成都科技大学纺织工学院，成都，６１００６５）关键词高分子构象，环形链，随机行走在前文中［１，２］我们曾较系统地讨论过模型高分子尾形链的构象统计学，假定高分子链的两端都被某一界面物理吸附或化学结合，所形...     

Configurational analysis of 16-methyl-androstene-5 derivatives

The four possible isomers of 16-hydroxymethyl-androst-5-ene-3β,17-diol were converted into the corresponding 16-methyl analogues characterized by ¹³C-NMR and ¹H-NMR spectra. This made possible the configurational correlation of 16-methylandrost-5-ene derivatives described in the literature.     

Configurational assignment of several 1,4-substituted adamantanes

The configurations of several 1,4- (= 2,5-) disubstituted adamantanes have been determined by means of X-ray diffraction. Since these compounds have rigid skeletons and since there is almost no difference in stability or steric requirements between the geometric isomers, these epimers are expected to be very useful for stereochemical studies.     

Size-dependent formation enthalpy of nanocompounds

A quantitative thermodynamic model for the size-dependent formation enthalpy of nanocompounds is proposed. The model reveals that the thermal stability of nanocompounds decreases because of the size dependence of formation enthalpy when the size of these nanostructures decreases. This stability loss is related to some general phenomena such as interface alloying of immiscible systems and phase segregation of miscible systems with reducing system sizes. The predictions from the model are in agreement with the results from density function theory calculation for MgH2, the experimental measurement of SnTe nanoparticles, and quantum chemistry consideration.     

11-氯代青蒿素的合成及其构型的确定

１１－氯代青蒿素的合成及其构型的确定陆德文,李英（中国科学院上海药物研究所,上海,２０００３１）关键词１１－氯代青蒿素,合成,构型青蒿素（Ａｒｔｅｍｉｓｉｎｉｎ,ＱＨＳ）是从中药青蒿中分离到的一种含过氧基团的新型倍半萜内酯,具有强抗疟作用。它的结构测...     

Free enthalpy landscape of SrO

Trying to predict thermodynamically stable and metastable solid compounds as function of pressure and temperature requires the global exploration of the enthalpy landscapes of chemical systems and the subsequent construction of their free enthalpy landscapes. In this work, we present a general approach to the determination of a free energy landscape. As an example, we construct the free enthalpy landscape of SrO for two different pressures on the empirical potential level and also compute various thermodynamic and elastic properties of SrO in the NaCl-, CsCl-, NiAs-, NbS-, TiP-, beta-BeO, sphalerite-, and wurtzite-structure type on an ab initio level. We employ density functional theory within the hybrid B3LYP approximation. The results show good agreement with experimental and theoretical data.