A 300-/spl mu/W 1.9-GHz CMOS oscillator utilizing micromachined resonators

A low-power low-phase-noise 1.9-GHz RF oscillator is presented. The oscillator employs a single thin-film bulk acoustic wave resonator and was implemented in a standard 0.18-/spl mu/m CMOS process. This paper addresses design issues involved in codesigning micromachined resonators with CMOS circuitry to realize ultralow-power RF transceiver components. The oscillator achieves a phase-noise performance of -100 dBc/Hz at 10-kHz offset, -120 dBc/Hz at 100-kHz offset, and -140 dBc/Hz at 1-MHz offset. The startup time of the oscillator is less than 1 /spl mu/s. The oscillator core consumes 300 /spl mu/A from a 1-V supply.     

1.31-1.55-/spl mu/m phased-array demultiplexer on InP

The first demultiplexers on InP at 1.31-1.55 /spl mu/m based on low-order waveguide arrays have been fabricated and characterized. We show the calculated and measured spectral responses of two devices with 6 and 10 waveguides in the grating. The on-chip loss of the devices is 4.5 dB and the crosstalks are down to -25 dB. Thanks to their large bandwidth, the devices are polarization insensitive and no strong influence of the temperature is seen.     

Singlemode 1.55 /spl mu/m VCSELs with low threshold and high output power

The continuous-wave room-temperature operation of an electrically pumped 1.55 /spl mu/m wavelength vertical-cavity surface-emitting laser (VCSEL) with up to 1.7 mW output power is reported. The laser comprises an optimised multi-quantum-well active region and an improved mirror design for reduced optical losses.     

50-GHz optically injection-locked 1.55-/spl mu/m VCSELs

High-speed directly modulated diode lasers are important for optical communications and optical interconnects. In this work, we demonstrate greatly enhanced resonance frequency for vertical-cavity surface-emitting lasers, from 7 to 50 GHz, under ultrahigh injection-locking conditions. In addition, a 20-dB gain is achieved for small signal modulation below resonance frequency.     

A 10-/spl mu/W standby power 256K CMOS SRAM

A 32K/spl times/8-bit CMOS static RAM using titanium polycide technology has been developed. The RAM has a standby power of 10 /spl mu/W, an active power of 175 mW, and an access time of 55 ns. The standby power has been achieved by an optimization of polysilicon resistors in a memory cell. A digit line circuit controlled by three internal clocks contributes to reduction of active power. The cell size has been reduced to 89.5 /spl mu/m/SUP 2/ by using both a buried isolation and a polycide GND line. Furthermore a simplified address-transition detection circuit and a single data bus configuration result in a small layout area, thus offering a 40.7 mm/SUP 2/ die size.     

16 W continuous-wave output power from 100 /spl mu/m-aperture laser with quantum well asymmetric heterostructure

16 W continuous-wave room temperature front facet output optical power and 74% wallplug efficiency were attained in 100 /spl mu/m-aperture 1.06 /spl mu/m-emitting laser diodes with 2-3 mm cavity length. The lasers are based on AlGaAs/GaAs/InGaAs quantum well asymmetric heterostructures with 1.7 /spl mu/m-thick waveguide having 0.34 cm/sup -1/ internal optical loss.     

1.55-/spl mu/m AlGaInAs-InP laterally coupled distributed feedback laser

A novel 1.55-/spl mu/m AlGaInAs-InP laterally coupled (LC) distributed feedback (DFB) semiconductor laser is presented. Longitudinal feedback and lateral optical confinement are realized simultaneously by incorporating deep gratings etched with inductively coupled plasma technique. Stable single-mode operation with a sidemode suppression ratio over 45 dB has been demonstrated for the fabricated LC-DFB laser.     

Low-chirp and high-power 1.55-/spl mu/m strained-quantum-well complex-coupled DFB laser

High-power, low-chirp, and low-threshold current characteristics of 1.55 /spl mu/m complex-coupled compressively strained InGaAsP quantum-well DFB laser with a loss grating are presented. Kink-free light-current characteristics with single-mode power over 40 mW are demonstrated for uncoated devices. A relatively low threshold current of 10 mA and a high slope efficiency of 0.23 W/A have been obtained even with the loss grating employed. Stable single-mode emission was demonstrated with a side mode suppression ratio up to 54 dB, a low chirp of less than 0.3 nm under 1 Gb/s pseudorandom digital modulation and a spectral linewidth of 8 MHz.     

All-active tapered 1.55-/spl mu/m InGaAsP BH-DFB laser with continuously chirped grating

We demonstrate the first realization of all-active tapered index coupled 1.55-/spl mu/m InGaAsP buried-heterostructure distributed feedback lasers involving chirped gratings. The variation of the effective refractive index along the tapered active stripe is compensated using an optimized continuously chirped grating. The grating has been formed using a novel direct-write electron-beam lithography technique. Lasers with an antireflection/cleaved cavity show stable single-mode operation and high optical output power up to 60 mW. The yield of lasers with a sidemode suppression ration > 40 dB is more than 70%. The -3-dB farfield angles (full-width at half-maximum) amount to 14/spl deg/ and 20/spl deg/ in lateral and vertical direction, respectively.     

30-GHz bandwidth 1.55-/spl mu/m strain-compensated InGaAlAs-InGaAsP MQW laser

High-speed 1.55 /spl mu/m laser diodes with a 3-dB modulation bandwidths of 30 GHz were fabricated by using short-cavity mushroom structures with undoped, strain-compensated InGaAlAs-InGaAsP twenty-quantum-well active regions. The bandwidths were achieved at low bias current of 100 mA. The laser exhibited a high differential gain of 1.54/spl times/10/sup -15/ cm/sup 2/ and a small K factor of 0.135 ns. These results were achieved by using an In/sub 0.386/Ga/sub 0.465/AlAs barrier with 0.83% tensile strain to reduce the thermal emission time of holes from wells and hence the hole transport time.     

A 20-/spl mu/W precision operational amplifier

A precision operational amplifier is described which draws 12 /spl mu/A of quiescent current and can operate from a 1.6-V supply while requiring no external components such as the usual biasing resistor. The amplifier has DC characteristics comparable to the industry standard OP-07 and AC characteristics as good as currently available micropower devices. The circuit has an input voltage range and an output swing which include the negative supply to facilitate its use in battery-powered and other single-supply applications.     

A CMOS V-I converter with 75-dB SFDR and 360-/spl mu/W power consumption

This work describes a method for analysis of voltage-to-current converters (V-I converters or transconductors) and a novel V- I converter circuit with significantly improved linearity. The new circuit utilizes a combination of cross-coupling and local resistive feedback for a significant, simultaneous suppression of the third- and fifth-order harmonic distortion components in the transconductor characteristics. An evaluation of the optimal circuit dimensioning is shown. Simple and robust design rules are derived for the chosen operation conditions. The transistor implementation is presented and a prototype V- I converter is realized in a digital 0.18-/spl mu/m CMOS technology. The measured spurious-free dynamic range is 75 dB in a frequency band of 10 MHz. The circuit occupies less than 0.02 mm/sup 2/ and dissipates 360 /spl mu/W.     

1.55-/spl mu/m spot-size converter integrated laser diode with conventional buried-heterostructure laser process

A 1.55-/spl mu/m spot-size converter integrated laser diode is demonstrated with conventional buried-heterostructure laser process. For the spot-size converter, we employed a double-waveguide structure in which a ridge-based passive waveguide was incorporated. The passive waveguide was optically combined with a laterally tapered active waveguide to control mode size. The threshold current was measured to be 5 mA together with high slope efficiency of 0.45 W/A. The beam divergence angles in the horizontal and vertical directions were as small as 9.0/spl deg/ and 7.8/spl deg/, respectively.     

1.55-/spl mu/m optically pumped wafer-fused tunable VCSELs with 32-nm tuning range

We demonstrate widely tunable InAlGaAs-InP-AlGaAs-GaAs optically pumped vertical-cavity surface-emitting lasers operating in the 1.55-/spl mu/m waveband. The tuning range of 32 nm is achieved by applying a low tuning voltage of 4 V. Maximum single-mode output power of 2 mW with less than 1.5-dB power variation over the whole tuning range and side-mode suppression ratio in excess of 30 dB have been obtained.     

Dispersion-induced ultrafast pulse reshaping in 1.55-/spl mu/m InGaAs-InGaAsP optical amplifiers

Using the Foreman effective mass Hamiltonian, the electronic structure of the valence band and the interband dipole matrix elements in In/sub x/Ga/sub 1-x/As-In/sub y/Ga/sub 1-y/As/sub z/P/sub 1-z/ quantum-well optical amplifiers are calculated, taking into account the valence band mixing and the biaxial strain. The optical field of the amplified pulse is calculated by solving the wave equation with the computed polarization as a source term. A novel wavelet transform is introduced in analyzing the pulse chirp imposed by the optical amplifier. In the linear propagation regime, the spectrum of the amplified pulse can be either red-shifted or blue-shifted with respect to its initial center frequency, depending on the local gain dispersion spanned by the pulse spectrum. The output pulse shape can be retarded or advanced, depending on the local gain and group velocity dispersion. Furthermore, an initially unchirped pulse centered in the tail of the gain spectrum is significantly reshaped after propagating 600 /spl mu/m, and its spectrum is broadened and distorted considerably. In the spectral region where both gain and group velocity change rapidly, the frequency chirp for a linearly chirped input pulse is significantly weakened after propagation.     

Fully integrated passive UHF RFID transponder IC with 16.7-/spl mu/W minimum RF input power

This paper presents a novel fully integrated passive transponder IC with 4.5- or 9.25-m reading distance at 500-mW ERP or 4-W EIRP base-station transmit power, respectively, operating in the 868/915-MHz ISM band with an antenna gain less than -0.5 dB. Apart from the printed antenna, there are no external components. The IC is implemented in a 0.5-/spl mu/m digital two-poly two-metal digital CMOS technology with EEPROM and Schottky diodes. The IC's power supply is taken from the energy of the received RF electromagnetic field with help of a Schottky diode voltage multiplier. The IC includes dc power supply generation, phase shift keying backscatter modulator, pulse width modulation demodulator, EEPROM, and logic circuitry including some finite state machines handling the protocol used for wireless write and read access to the IC's EEPROM and for the anticollision procedure. The IC outperforms other reported radio-frequency identification ICs by a factor of three in terms of required receive power level for a given base-station transmit power and tag antenna gain.     

Linewidth of InP-based 1.55 /spl mu/m VCSELs with buried tunnel junction

Spectral linewidth measurements of 1.55 /spl mu/m InGaAlAs/InP vertical-cavity surface-emitting lasers (VCSELs) employing a buried tunnel junction are reported. A narrow linewidth around 28 MHz was obtained at a power level of 0.5 mW using the self-heterodyne method, and an estimation for the linewidth enhancement factor is given.     

Strongly sub-Poissonian electrical noise in 1.55-/spl mu/m DBR tunable laser diodes

We report terminal electrical noise measurements on 1.55-/spl mu/m DBR tunable laser diodes in the 1 Hz-1 MHz frequency range, performed using an electrical correlation method. These measurements are compared with a comprehensive electrical model based on rate equation formalism. Taking into account diffusion phenomenon and structural parameters, we obtain a complete agreement between the model and the measurements above threshold and a quite similar tendency below threshold. The influence of Bragg section bias is also discussed.     

2.5-mW single-mode operation of 1.55-/spl mu/m buried tunnel junction VCSELs

We present 1.55-/spl mu/m wavelength buried tunnel junction InGaAlAs-InP vertical-cavity surface-emitting lasers with low threshold current and high efficiency. An improved mirror design is accomplished with high-reflective low-loss epitaxial InGaAlAs-InAlAs and hybrid dielectric CaF/sub 2/-ZnS-Au layer stacks, respectively. Lasers with aperture diameters of only around 5 /spl mu/m exhibit continuous-wave single-mode output powers at room temperature well beyond 2 mW. Threshold voltages and series resistances as low as 0.9 V and 30-40 /spl Omega/ have been measured. The spectral behavior shows excellent performance over the relevant current and temperature range.