台肥储存环高频系统的调整

讨论了合肥光源高频系统参数对束流流强的影响。在合肥储存环闭轨校正实验中，发现束流轨道有较大的变化，为此对高频系统的频率、腔温等参数进行了必要的调整。此项工作对二期工程高频系统改造也具有指导意义。     

合肥光源慢加速过程中高频系统的调节

 合肥光源是一台专用同步辐射光源，它在低能注入积累束流，然后同步地把束流加速到高能并在储存环中稳定运行。在加速过程中，粒子的同步辐射能量损失迅速增加，束流负载效应发生变化，需要相应地调节高频系统参数保持束流稳定。讨论了合肥光源加速过程中高频系统可能的两种高频系统调节方式以及高能情况下高频系统的最佳运行状态。     

合肥光源逐束团测量和横向束流反馈系统设计

 介绍了在合肥光源开展逐束团测量（横向和纵向）和横向束流反馈系统研究和研制的重要性,同时还介绍了设计思想。合肥光源高频频率为204 MHz,因此,系统至少需要100 MHz的带宽。还较详细地介绍了宽带部件和系统参数的选择原则。该系统不仅可用于研究由于高频腔中的高阶模和真空室的阻抗壁效应所引起的耦合束团不稳定性,而且还能抑制耦合束团不稳定性振荡、快速束流离子不稳定性和注入大幅度振荡等,从而将提高机器的运行性能。     

合肥储存环电子束流寿命分析

 电子束流寿命是个很重要的指标,直接影响合肥光源的正常运行,为此研究了影响束流寿命的因素,测量了高频腔压、耦合度以及束团长度对电子束流寿命的影响,研究显示合肥储存环的电子束流真空寿命和托歇克寿命相当;并且利用束损系统测量了因托歇克寿命的变化而造成束流损失的相对变化;通过增加耦合度增加束流的垂直发射度,有效地提高了束流的寿命,保证了合肥光源的正常运行。     

合肥光源上采用干涉方法测量束流截面

 束流截面尺寸测量对优化系统参数、确保光源运行至关重要。采用干涉法测量合肥同步辐射光源束流截面垂直方向的尺寸。基于Cittert-Zernike 定理,利用双缝干涉条纹的对比度得出相干度和束流截面尺寸。测量系统由干涉成像与图像处理系统组成。进行了5组试验,试验结果证明了干涉法测量合肥同步辐射束流截面尺寸的可行性。     

储存环束流Robinson不稳定性的分析和测量

 探讨了储存环束流的Robinson不稳定性问题,提出用“等效失谐角大于零”取代“失谐角大于零”作为束流稳定的基本条件。在合肥光源电子储存环200 MeV注入状态下,对束流不稳定性与高频腔失谐之间的关系进行了实验测量。结果表明：当束流稳定条件不满足时,如果高频腔大失谐,束流将全部丢失;小失谐时束流容易部分丢失;当高频腔处于负失谐状态,束流流强将限制在较低水平。     

高频环行器打火原因的分析

合肥光源(HLS)储存环高频系统环行器在工作中出现了两种形式的打火——谐波打火和束流丢失打火. 谐波打火的原因已经找到并予以解决, 但丢束打火的机制尚未明确. 文中描述了丢束后高频系统的响应过程, 分析了一些可能造成环行器打火的因素. 为了防止环行器打火受损, 建立了快速联锁保护电路, 该电路在历次打火中成功地保护了环行器.     

国内首次超导高频系统束流调试及高功率试验

2004-2007年BEPC高频系统从常温腔改建到超导腔,逐渐解决了改频的物理问题和超导技术的工程难题,实现了与国际先进技术接轨,并按期保质完成了工程、调束任务.高频系统是BEPCⅡ工程首个吸收国外超导技术、自主完成集成和调试成功的大型装置;2006年7月国内首次超导高频大功率试验成功;2006年11月完成系统联调,按期投入BEPCⅡ首轮调束;同年12月首次投入同步辐射运行;2007年2至5月,东、西两套超导高频系统在1MV以上的加速电压均已实现正/负电子1.89GeV注入积累和110/114mA对撞;在同步辐射运行中,逐渐达到2.5GeV/250mA、束流功率100kw,接近国外同类机器水平;束流试验证明两套高频系统的各类参数标定和测量值与理论设计吻合.10个月运行表明系统可靠.本文对BEPCⅡ高频系统的束流联调和高功率试验做简要描述.     

合肥光源利用电阻分流法的基于束流准直系统的研制

 介绍了合肥光源基于束流准直系统的研制,该系统利用可开关的电阻分流法构成,并采用固态继电器进行四极铁分流控制。利用该系统可以测量束流位置检测器的电中心相对相邻四极铁磁中心的位置偏移。给出了合肥光源基于束流准直系统的一些测量结果。     

HLS储存环高频调制实验

在合肥光源(HLS)储存环上进行了高频调制实验, 结果表明采用调制频率接近同步振荡频率f_s的高频幅度或相位调制, 可以提高束流寿命. 而通常采用的是2f_s的调制方式. 实验测量了最佳调制频率和合适的调制度, 以及不同流强下调制引起寿命增长的程度. 同时观察到束流频谱中高次分量的降低, 这有利于抑制多束团耦合不稳定性.     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.