Direct determination of bulk etching rate for LR-115-II solid state nuclear track detectors

The thickness of the removed layer of the LR-115-II solid state nuclear track detector during etching is measured directly with a rather precise instrument. Dependence of bulk etching rate on temperature of the etching solution is investigated. It has been found that the bulk etching rate is 3.2 μm/h at 60°C in 2.5 N NaOH of water solution. It is also found that the track density in detectors exposed to soil samples increases linearly with the removed layer.     

Calibration of CR-39 solid state nuclear track detector

Nowadays there are increasing uses of SSNTD on scientific works in Thailand. Currently we are using SSNTD as an important tool for confirming active fault zones in a province in which a new nuclear research reactor has been proposed to come up. Soil gas radon was measured by both active and passive methods. In the latter case CR-39 SSNTD was installed in a PVC tube of 50 cm long by 5 cm in diameter. The tubes were placed in 50-cm deep holes lining perpendicular to the faults’ trace for one week. In this paper we describe the method and the results on calibrating these detectors using a radon chamber and a NIST-traceable radium-226 standard source.      

Measurement of radon and thoron concentration by using LR-115 type-II plastic track detectors in the environ of Brahmaputra Valley, Assam, India

Radon/thoron and their progeny concentrations were measured in different types of dwellings at different locations around industrial areas, cities and rural areas of Brahmaputra Valley of Assam by using LR-115 (type-II) plastic detector. Radon levels of different dwellings were analysed with reference to the nature of building materials, ventilation patterns and the types of underlying soil. The results were discussed under the light of exposure limits set by ICRP. The average concentrations of indoor radon and thoron varied from 39.5 to 215.2 Bqm⁻³ and 12.9 to 37.6 Bqm⁻³, respectively. The estimated inhalation dose due to radon, thoron and their daughter products in the study areas varied from 0.53 to 1.00 μSvh⁻¹.     

Comparison of responses of LR-115A, CR-39 and PM-355 track detectors to pulsed low-energy proton streams

The paper concerns applications of LR-115A, CR-39 and PM-355 solid-state nuclear-track detectors (SSNTDs) for investigation of pulsed fluxes of protons below 300 keV. The proton streams were generated by the RPI-IBIS device operated with hydrogen puffing [Baranowski et al. 2000. Studies of hydrogen discharges in RPI-type devices with different electrode configurations. Czech. J. Phys. 50 (Suppl. S3), 101–107]. To perform ion mass- and energy-analysis, a Thomson mass-spectrometer equipped with a special input system and exchangeable detectors was used. A quantitative analysis of proton tracks upon Thomson parabolas was performed by means of an optical microscope equipped with a CCD camera. It made possible to measure proton tracks and to determine their statistics. The paper presents proton energy spectra recorded with the selected detectors, and responses of these detectors to protons of energy from about 30 to 300 keV. The results are important for verification of detector characteristics and for measurements of protons at different experimental conditions.     

A new method to measure track density and to differentiate nuclear tracks in CR-39 detectors

An alternative method to count and differentiate nuclear tracks in SSNTD is described. The method is based on the analysis of Fraunhofer diffraction pattern of coherent light produced by tracks of an etched SSNT detector. The diffraction pattern was also simulated by applying computational Fourier Optics. The comparison between results obtained by simulation and by the theoretical model gave satisfactory concordance. The proposed method is capable of differentiating tracks in CR-39 by their diameter and energies. The diameter resolution ranged between 8% and 25%, while the counting error was less than 15%. The discriminating ability to distinguish genuine etched tracks from defects and background anomalies is demonstrated. The incidence angle did not influence significantly the total count and the track parameter measuring capability. Errors due to track overlapping are only significant for track densities higher than 3×10⁵ cm⁻².     

General expression of the calibration curve for the CR-39 radon track detectors

The CR-39 detectors are widely used as passive radon dosimeters, as well as in physics laboratories or for industrial applications. For what concerns radon monitoring, the calibration curve which is usually adopted corresponds to a linear relation between the actual etched track density and the track density counted by an automatic acquisition system. This linear calibration provides very accurate radon exposure assessments in a restricted range of etched track density, however it neglects the effect of the tracks overlapping that becomes as relevant as the track density increases. In the present work the mathematical expression of the area covered by a set of uniformly distributed tracks is deduced. This result allows then to infer the probability that the system acquires the right track density, providing a general calibration curve for a solid state radon track detector. The process of track production and reading routine is also simulated adopting a Monte Carlo approach, showing that the obtained results are in agreement with the function proposed as calibration curve. Moreover, a linear dependence between the track average area and the rate parameter of the calibration curve has been observed. Finally a semi-empirical correlation based on the previous results is proposed.     

The calibration of the solid state nuclear track detector LR 115 for radon measurements

An experimental calibration of indoor room and outdoor soil detector devices which are based on LR 115 as sensitive element has taken place at the Swedish Radiation Protection Institute in Stockholm (Sweden) in 1994 and 1996, at the Physikalisch-Technischen Bundesanstalt in Braunschweig (Germany) in 1997 and at the Umweltforschungszentrum Leipzig-Halle (Germany) in 1997. Special properties of the used solid state nuclear track detector (SSNTD) material LR 115^* have been measured to define the application of the experimental calibration.     

Measurement of indoor radon levels in Erbil capital by using solid state nuclear track detectors

Radon alpha activity concentration has been measured in 28 homes in the Erbil Capital-Iraqi Kurdistan region during the autumn season by using time-integrated passive radon dosimeters containing CR-39 solid state nuclear track detectors “SSNTDs”. The radon activity concentrations in these homes range from (10.33–90.34) with an average of . The average absorption effective dose equivalent for a person living in homes for which the investigation were done was found to be , obtained by using an equilibrium factor of 0.5 and an occupancy factor of 0.8. The average lung cancer cases per year per 10⁶ person was found to be 23±12.     

用20—1020 keV单能质子刻度CR-39固体核径迹探测器

用北京师范大学2×1.7MV串列加速器和400 kV高压倍加器产生的20—1020 keV单能质子束对CR-39固体核径迹探测器进行了刻度.为了保证质子的单能性和固体核径迹探测器上径迹密度不能超过10⁶/cm²的要求,对两台加速器分别采用了不同方法控制质子辐照数量.在串列加速器上采用了狭缝加转盘的方法,在高压倍加器上采用了100 ns单次高压脉冲扫描束流的方法,既保持了质子的单色性,又达到了质子注量小于10⁶/cm²的 关键词： 单能质子 固体核径迹探测器 CR-39     

Use of CR-39 solid state nuclear track detector in neutron personnel monitoring

Neutron sources like ²⁴¹Am–Be, ²³⁹Pu–Be, ²⁵²Cf and 14.6 MeV neutron generator are being used in oil exploration industries as well as in research institutions. While handling these neutron sources, personnel may be exposed to neutrons. Also personnel working in reactors, accelerators may receive dose from neutrons. These exposed individuals need to be monitored regularly for measurement of neutron doses. The individual neutron doses can be estimated by using Kodak NTA films and CR-39 Solid State Nuclear Track Detector with a polyethylene radiator to increase sensitivity in front in holder. Nearly 1450 personnel are being monitored regularly throughout the country on a quarterly basis. In India, the monitoring system adopted for individual neutron dose estimation having energy from 100 keV and above is described in this paper. Background counts of 0.20 mSv could be measured with CR-39 SSNTD foil system and it has been successfully introduced for Fast Neutron Personnel Monitoring for the country.     

Study of semiconductors using solid state nuclear track detectors

Uranium trace characterization of crystalline GeS, sputtered thin films of GeS and amorphous SiH on quartz substrates, and crystalline p-type Si using the technique of solid state nuclear track detectors is reported. Concentration and distribution of uranium in these materials studied are presented. Using uranium as microprobe, it is observed that uranium prefers to be in the cleavage planes of GeS crystals. There seems to be a link between uranium concentration and the thermally induced defects in Si.     

Single-sheet identification method of heavy charged particles using solid state nuclear track detectors

The theoretical and experimental investigations of the penetration of charged particles in matter played a very important role in the development of modern physics. Solid state nuclear track detectors have become one of the most important tools for many branches of science and technology. An attempt has been made to examine the suitability of the single-sheet particle identification technique in CR-39 and CN-85 polycarbonate by plotting track cone length vs. residual range for different heavy ions in these detectors. So, the maximum etchable ranges of heavy ions such as ⁹³Nb, ⁸⁶Kr and ⁴He in CR-39 and ⁴He and ¹³²Xe in CN-85 polycarbonate have been determined. The ranges of these ions in these detectors have also been computed theoretically using the Henke-Benton program. A reasonably good agreement has been observed between the experimentally and theoretically computed values.      

Uranium analysis by neutron induced fissionography method using solid state nuclear track detectors

In this study total twenty samples (eight reference materials and twelve sediment samples) were analysed for their uranium content which is in the range of 1–17 μg/g, by neutron induced fissionography (NIF) method using solid state nuclear track detectors (SSNTDs) in comparison with the results of neutron activation analysis (NAA), delayed neutron counting (DNC) technique or fluorometric method. It is found that NIF method using SSNTDs is very sensitive for analysis of uranium.     

Radon exhalation studies in building materials using solid-state nuclear track detectors

Indoor radon has been recognized as one of the health hazards for mankind. Building materials constitute the second most important source of radon in dwellings. The common building materials used in the construction of dwellings are studied for radon exhalation rate. The ‘Can’ technique using LR-115 type-II solid-state nuclear track detector has been used for these measurements. The radon exhalation rate in these samples varies from 4.75 m Bq m⁻² h⁻¹ (0.14 m Bq kg⁻¹ h⁻¹) for limestone to 506.76 m Bq m⁻² h⁻¹ (15.24 m Bq kg⁻¹ h⁻¹) for soil.     

Influence of intense soft X-ray radiation on the parameters of tracks induced in CR-39 and PM-355 solid state nuclear track detectors

This paper presents the results of the influence of soft X-ray radiation on craters induced in SSNTDs by energetic α particles and protons of energy in the MeV range. We checked two detectors of the PM-355 and CR-39 types in order to verify and compare their resistance to the harsh conditions of high-temperature plasma experiments. To determine this effect some detector samples were first irradiated with α particles emitted from natural α particle sources and protons delivered by a particle accelerator. After that these samples were exposed to soft X ray radiation emitted from an X ray tube and also from the PF-1000 Plasma Focus facility. Doses during X ray irradiations varied from 0 up to tens of kGy. The irradiated samples were then etched in steps and track diameters were determined versus the absorbed dose and etching time and compared with those measured in samples not exposed to X ray radiation.     

Study of the weekly irrigation cycle of a cultivated field in a semi-arid area (Marrakech region,Morocco) by using CR-39 and LR-115 II track detectors and radon as a natural tracer

Uranium (²³⁸U) and thorium (²³²Th) concentrations were measured in the soil of a cultivated field situated in a semi-arid area (Marrakech, Morocco) by using CR-39 and LR-115 type II solid state nuclear track detectors (SSNTDs). The same track detectors were used for measuring alpha- and beta-activities due to radon and thoron gases emanating from the soil of the studied irrigated agricultural field. The influence of the humidity (soil water content), soil depth and climate conditions on the weekly irrigation cycle of the studied cultivated field was investigated by exploiting radon measurements.     

The effect of post-exposure annealing on the track registeration characteristics of CR-39 nuclear track detectors

The effect of post exposure annealing on the track registeration characteristics of CR-39 (Pershore) Solid State Nuclear Track Detectors has been studied. The changes introduced in the bulk etch rates, track diameter, and the track density have been observed. The results indicate that the bulk etch rate of the detectors and the size of the tracks are considerably changed due to annealing. Variations in the track density are, however, not serious in the presently studied temperature range.     

Comparison of seasonal and yearly average indoor radon levels using CR-39 detectors

In order to assess the effect of long term exposure, CR-39 based radon dosimeters were exposed to indoor radon in the drawing rooms (living room) of 200 selected houses of the districts of Swabi, Mardan and Charsadda in the North West Frontier Province (NWFP) as well as in the Mohmand and Bajuar Agencies of the federally administered tribal areas (FATA), Pakistan. Dosimeters were exposed to the indoor radon during each season as well as throughout the year. From the measured indoor radon data it was observed that seasonal yearly average value were higher than that of the 12 months average indoor radon concentration values. The overall seasonal average was found to be 13% higher than that of the 12 months exposed CR-39 based dosimeters. However after the removal of the worst differences, seasonal average remains only 8 % higher than the 12 months averaged value.     

Estimation of indoor radon, thoron and their progeny using twin cup dosemeters with solid-state nuclear track detectors in Digboi of Upper Assam

The seasonal variations of indoor radon, thoron and their progeny levels were studied in 20 houses situated in the oil-rich areas of Digboi of Upper Assam. Solid-state nuclear track detectors LR-115 type II were exposed using plastic twin chamber dosemeters to record tracks formed by the two gases and their progeny. Inhalation doses were found out using extracted equilibrium factors and ventilation rates. The random (counting) errors in track densities were determined.     

Investigation of uranium dioxide distribution dissolved in silicate compositions using solid state nuclear track detectors

The method of solid state nuclear track detectors (SSNTD) has been used for the determination of uranium dioxide distribution in silicate compositions. The method of -radiography based on registration of - particles at the contact of SSNTD CR-39 with the specimen has been used here. An initial uranium dioxide applied for studying the dissolving process used as the standard. The results of the measurements of distribution of uranium dioxide concentration obtained with the help of this technique have been used for the estimation of diffusion and solubility of UO₂ in silicate melts.