Computation of the tracking force acting on a relativistic electron beam propagating in a conducting waveguide under the ohmic and ion-focused regimes

The force of interaction between a relativistic electron beam deflected by resistive hose instability and the eddy current induced in a tubular plasma channel of finite conductivity is computed. Dependences of the force on channel ohmic conductivity and current rise time in a beam pulse are studied. For a beam propagating through a perfectly conducting waveguide under the ion-focused regime, the interaction of the beam with the ion-channel electrostatic image on the waveguide wall is studied for the case when the beam and the channel are deflected from the waveguide axis as a result of ion hose instability. The dependence of the force on both deflection amplitudes is ascertained for the nonlinear phase of instability. It is demonstrated that the force under study may become comparable to the beam-channel interaction force if the deflections are large.     

Calculation of the electrostatic tracking force in the transport of relativistic electron beams in Ohmic plasma channels of low conductivity

The interaction force between a paraxial relativistic electron beam and a preformed Ohmic plasma channel of low conductivity is calculated in the electrostatic limit. The dependence of this force on the channel conductivity and the distance from the beam front is found for concrete parameters of the relativistic electron beam and various values of the beam current rise rate. Zh. Tekh. Fiz. 67, 78–80 (December 1997)     

重离子治癌引出BUMP电源控制器设计

引出凸轨(BUMP)电源是负责医用重离子加速器束流引出的关键设备,其电流上升的同步性影响束流的引出效率,而电流波形的多样性与治疗模式和治疗精度密切相关.要在凸轨磁铁(0.2～0.4 mH)上产生1～5 ms上升且精确同步的励磁电流,并确保电流的跟踪性和波形的多样性,采用了实时调整强励电压及基于特征参数的电流波形控制方法...     

BEPC横向阻尼时间的测量

 利用逐束团测量系统在BEPC储存环中跟踪单个束团得到其多圈位置振荡信息,获得BEPC储存环的横向阻尼时间与束流流强、色品、八极子和束流能量的关系,并通过分析得到了BEPC储存环辐射阻尼时间为52 ms。实验结果表明：流强越高、色品越大,阻尼率也就越大;束流流强为4.7 mA时八极子强度的变化对阻尼率没有影响;束流流强为5 mA时,阻尼率随束流能量升高而减小。     

Accurate detection of interface between SiO2 film and Si substrate

Accurate end point detection of interface for multilayers using focused ion beam (FIB) is important in nanofabrication and IC modification. Real-time end point graph shows sample absorbed current as a function of sputtering time during FIB milling process. It is found that sample absorbed current increases linearly with ion beam current for the same material and changes when ion beam is milling through a different material. Investigation by atomic force microscope (AFM) and FIB cross-sectioning shows that accurate SiO₂/Si interface occurs to where the maximum sample absorbed current occurs. Since sample absorbed current can be real-time monitored in focused ion beam machine, the paper provides a viable and simple method for accurately determining the interface during FIB milling process for widely used SiO₂/Si system.     

Simulation of the dynamics of resistive hose instability of a relativistic electron beam propagating in a resistive plasma channel with arbitrary conductivity

The spatial dynamics of the resistive hose instability of a relativistic electron beam has been studied for the case when the charge neutralization time is much longer, on the order of, or much shorter than the current compensation time. It has been found that the growth of this instability has the highest increment when the charge neutralization time is on the order of skin time.

     

Second harmonic generation of a self-focused Hermite-Gaussian laser in plasma

Second harmonic generation (SHG) using intense Hermite-Gaussian laser beam (HGLB) propagating through the plasma for mode-indices m = 0 and m = 1 is reported in the present work. Ponderomotive force induced density perturbation beats with the oscillatory velocity of electrons at incident laser frequency, generate the second harmonic nonlinear current that give rise to SHG. Using paraxial approximations, we have derived the coupled equations for the beam width parameter of HGLB and second harmonic's normalized amplitude. Resonance condition is obtained by considering wiggler magnetic field which providing an extra momentum to the second harmonic photon and this result a significant increase in the amplitude of SHG. Our analysis shows the prominent rise in normalized amplitude of second harmonic on increasing the value of the intensity of fundamental laser pulse, normalized wiggler magnetic field and normalized density of plasma. It is notified that the gain of SHG is more prominent for m = 1. Dependency of laser and plasma parameters on SHG is also reported in the current work.     

On the influence of the voltage pulse rise time and cathode geometry on the generation of a supershort avalanche electron beam

The influence of the voltage pulse rise time on the amplitude of a runaway electron beam and X-ray generation in air and nitrogen under atmospheric pressure is studied experimentally and theoretically. Generalization of the whistle criterion for the case of a nonuniform field is suggested. It is shown that the maximal energy of beam electrons and the beam current amplitude grow when the voltage pulse rise time decreases. It is found that the amplitude of the runaway electron current reaches a maximum at a certain curvature of the cathode. The maximal energy of electrons increases when the radius of curvature of the cathode exceeds the value at which the beam current amplitude is the highest. If the field is nonuniform, its critical value at which many electrons run away is more than an order of magnitude lower than in the uniform field.     

Modeling of terahertz radiation emission from a free‐electron laser

In this article, we report the generation of terahertz (THz) radiation using the interaction of a laser‐modulated relativistic electron beam (REB) with a surface plasma wave. Two laser beams propagating through the modulator interact with the REB, leading to velocity modulation of the beam. This results in pre‐bunching of the REB. The pre‐bunched beam travels through the drift space, where the velocity modulation translates into density modulation. The density‐modulated beam, on interacting with the surface plasma pump wave, acquires an oscillatory velocity that couples with the modulated beam density to give rise to a nonlinear current density which acts as an antenna to give THz radiation. By optimizing the parameters of the beam and the wiggler, we obtain power of the order of 10⁻⁴ using the current scheme.     

Beam induced vacuum measurement error in BEPC II

When the beam in BEPCII storage ring aborts suddenly, the measured pressure of cold cathode gauges and ion pumps will drop suddenly and decrease to the base pressure gradually. This shows that there is a beam induced positive error in the pressure measurement during beam operation. The error is the difference between measured and real pressures. Right after the beam aborts, the error will disappear immediately and the measured pressure will then be equal to real pressure. For one gauge, we can fit a non-linear pressure-time curve with its measured pressure data 20 seconds after a sudden beam abortion. From this negative exponential decay pumping-down curve, real pressure at the time when the beam starts aborting is extrapolated. With the data of several sudden beam abortions we have got the errors of that gauge in different beam currents and found that the error is directly proportional to the beam current, as expected. And a linear data-fitting gives the proportion coefficient of the equation, which we derived to evaluate the real pressure all the time when the beam with varied currents is on.

     

Features of the Development of Electron-Optical Systems for Pulsed Terahertz Traveling-Wave Tubes (Review)

We present an analysis of the current state and development of pulsed amplifying traveling-wave tubes for terahertz radiation operation at frequencies of at least 200 GHz, as well as the development prospects of the principles of creating electron-optical and magnetic systems. The possibility of using field emission cathodes based on carbon nanotubes for constructing an electron-optical system with the compression of a sheet beam is discussed. A numerical simulation of a field emission electron gun forming a sheet electron beam for traveling-wave tubes of the terahertz range is carried out.

     

Effect of the induced magnetic field on peristaltic flow of a couple stress fluid

We have analyzed the MHD flow of a conducting couple stress fluid in a slit channel with rhythmically contracting walls. In this analysis we are taking into account the induced magnetic field. Analytical expressions for the stream function, the magnetic force function, the axial pressure gradient, the axial induced magnetic field and the distribution of the current density across the channel are obtained using long wavelength approximation. The results for the pressure rise, the frictional force per wave length, the axial induced magnetic field and distribution of the current density across the channel have been computed numerically and the results were studied for various values of the physical parameters of interest, such as the couple stress parameter γ, the Hartmann number M, the magnetic Reynolds number Rm and the time averaged mean flow rate θ. Contour plots for the stream and magnetic force functions are obtained and the trapping phenomena for the flow field is discussed.     

Effect of an electron beam on CaF<Subscript>2</Subscript> and BaF<Subscript>2</Subscript> epitaxial layers on Si

Atomically smooth CaF₂ and BaF₂ layers have been sequentially grown on Si(111) substrates by molecular beam epitaxy. Pore macrodefects have been revealed at the points of the action of an electron beam from a diffractometer when analyzing the crystal structure of the surface during the growth with the subsequent observation using atomic force microscopy. The formation of these macrodefects is associated with the decomposition of fluorides by high-energy electrons, which is accompanied by the desorption of fluorine and the drift current of positive ions from the electron charge drains.     

Electron cooling experiments in CSR

The six species heavy ion beam was accumulated with the help of electron cooling in the main ring of Cooler Storage Ring of Heavy Ion Research Facility in Lanzhou (HIRFL-CSR). The ion beam accumulation dependence on the parameters of cooler was investigated experimentally. The 400 MeV/u ¹²C⁶⁺ and 200 MeV/u ¹²⁹Xe⁵⁴⁺ were stored and cooled in the experimental ring CSRe, and the cooling force was measured in different conditions.

     

On Transient Time Reduction of a 2.4 GHz Relativistic Traveling Wave Oscillator with a Hollow Slow Wave System

The decrease in the transient time in a relativistic microwave traveling wave oscillator, in which the interaction is carried out between the relativistic electron beam and the fundamental harmonic of the forward-traveling electromagnetic wave slowed down to the speed of light in the hollow slow wave system system, has been numerically and experimentally demonstrated. It is shown that in this mode a high beam-to-wave coupling impedance up to ≈10 Ω is achieved, which ensures reduction of the transient time. In the experiment, a microwave peak power of 210 ± 30 MW at a frequency of 2.45 GHz in a guiding magnetic field of 0.16 T was obtained. The efficiency of the oscillator to convert the power of the electron beam into microwave power was 17 ± 3%. At the beam current pulse duration of about 50 ns the microwave pulse duration was about 20 ns and the transient time was about 22 ns.

     

低能氩离子束对多孔铝阳极氧化膜表面的刻蚀效应研究

用低能氩离子束(Ar⁺)处理了多孔铝阳极氧化膜(AAO)表面.扫描电子显微镜和原 子力显微镜结果表明，Ar⁺束刻蚀不仅可以有效地去除AAO反面阻挡层，还可使A AO表面产生多种特殊的形貌，如采用倾角入射可使其表面产生波纹，倾角入射同时旋转样品 台，可实现表面抛光.并结合Bradley和Harper提出的无定形材料表面波纹的形成和演化理论 解释了AAO表面波纹的特征. 关键词： 多孔铝阳极氧化膜 离子束刻蚀     

Effect of insulating films on the current of an electron beam from gas-filled diodes exposed to voltage pulses with a nanosecond rise time

The parameters of subnanosecond electron beams generated in gas-filled diodes are studied. When the voltage pulse rise time is short (≈1 ns or less) and the electron beam is extracted from the diode through insulating films, the amplitude of the signal measured at the collector depends not on the electron beam current but on the electromagnetic radiation arising in the diode and the capacitive current from the collector. If the electron beam is extracted through thin metallic foils and fine metallic grids, the FWHM of the runaway electron pulsed beam is ≈0.1 ns and its amplitude reaches several hundreds of amperes.     

Monitoring system experiments on beam loss at SSRF injector

Experiments on beam loss by using beam loss monitoring (BLM) system were carried out at Shanghai Synchrotron Radiation Facility (SSRF) injector. This system used highly sensitive and current-integrated Si-photodiode detectors and an Ethernet data acquisition (DAQ) system. The experimental results demonstrate that the Si-photodiode detectors are a useful tool that provides dynamic information on beam loss and investigates problems of machine operation. It also shows that the Si-photodiode BLM system is suitable for pulse-radiation of high-energy accelerators.

     

Motion of an atom due to anisotropic filtering of its resonance fluorescence

The effect of the specific anisotropy of the environment on the dynamics of a resonantly fluorescing atom is analyzed in a one-dimensional model. The environmental anisotropy, which is manifested as different spectral selectivities of the absorption of spontaneous photons emitted by the atom in different directions, results in the anisotropy of the photon emission rate giving rise to a nonzero recoil force on the atom. The effect under optimal conditions can reach one-quarter of the recoil momentum per single photon emission. This force is directed toward the weaker spectral selectivity.

     

Magnetooptical compression of atomic beams

We consider the propagation of an atomic beam in a quadrupole magnetic field under transverse irradiation by a cooling laser field. The cooling laser field was chosen in the form of a two-dimensional σ⁺-σ^? configuration. We show that the sub-Doppler resonance in the radiation force can be used to reduce the diameter of the atomic beam to a value on the order of 10 mm. We establish that the simultaneous transverse cooling and compression of the atomic beam allow its phase density to be increased to values of the order of 10^?4–10^?3. The dipole interaction of an atom with the cooling and compressing laser field in a quadrupole magnetic field is analyzed in terms of a simple (3 + 5)-level model atom.