顺序注射氢化物发生-原子荧光光谱法测定化肥中砷、汞、锑和硒

本文建立了一种顺序注射氢化物发生 -原子荧光光谱法测定化肥中 As、Hg、Sb、Se含量的方法。在最佳条件下 ,As、Hg、Sb和 Se的检出限分别为 0 .1 5μg/ L、0 .0 6 1μg/ L、0 .0 4 6μg/ L、0 .2 5μg/ L。测定化肥中 As、Hg、Sb和 Se,回收率均在 94 .6 7%— 1 0 6 .81 %之间。该方法用于检测化肥中 As、Hg、Sb和 Se具有很好的可行性和实用性。     

免疫亲和柱HPLC荧光检测酒中黄曲霉毒素B_1、B_2、G_1、G_2

采用单克隆抗体免疫亲和技术作为直接从样品中分离提纯黄曲霉毒素的特效手段 ,提取液挥发干后 ,经衍生用 HPLC荧光检测器测定。本法在样品中添加 2 .5μg/ kg黄曲霉毒素时进行 10次测定 ,平均回收率分别为 G173.8%、B197.3%、G2 6 1.7%、B2 90 .5% ;2 .5μg / kg 10次测定的精密度分别为 :G14.50 %、B13.80 %、G2 3.6 8%、B2 4 .77% ,本方法在 2 5— 12 50 pg范围内呈线性 ,相关系数分别为 G1:r=0 .9990、B1:r=0 .9994、G2 :r=0 .9995、B2 :r=0 .9992。测定的最低检出限为 6 .2 5pg     

ICP-AES测定中药黄连中微量元素

以HNO3-H2O2体系湿法消解黄连,在确定的ICP-AES条件下测定其中的Ca、Cu、Fe、Mg、Mn、Zn元素含量.结果表明该方法相对标准偏差为2.4%-6.6%,回收率在92.5%-103.9%之间.湿法消解和ICP-AES测定黄连中6种微量元素,方法简便可靠.     

微波消解/ICP-MS法测定中草药中痕量元素的研究

研究了微波消解 / ICP- MS测定中草药中痕量元素的新方法。方法的检出限为 0 .0 0 6—0 .0 37ng·m L-1;精密度为 0 .6 %— 4 .5% ;回收率为 88.2 %— 10 8%。该方法简单、快速、准确 ,结果令人满意。     

萃取色层分离测定含铀腐蚀液中6种元素的方法研究——ICP-AES

采用萃取色层分离电感耦合等离子体-原子发射光谱法(ICP-AES)测定含铀腐蚀液中Cr、Te、Sr、Ru、Rh、Ce 6种元素,腐蚀液试样中铀用HNO3转化为硝酸铀酰后,经过CL-TBP萃淋树脂分离,一次性使基体铀与待测元素分离,测定铀化合物样品中6种元素的质量分数.并对影响测定的各种因素进行了较详细的试验研究,确定了测定的最佳条件.方法平均回收率在84.8%-112.6%之间,相对标准偏差(RSD,n=6)优于士10%.     

流动注射氢化物发生原子吸收法测定趾甲中硒

本文建立了一种以气动稳流取代蠕动泵的流动注射氢化物发生原子吸收测定趾甲中硒的方法。此方法自动化程度高、操作简便、清洗和测定过程一次完成、具有良好的精密度和准确度 ,相对标准偏差为2 .7% ,回收率为 93.90 %— 1 0 6 .0 0 %。     

火焰原子吸收光谱法测定栽培甘草中6种金属元素

浓硝酸 -高氯酸 (V∶V=4∶ 1 )常压微沸条件下消解甘草样品 ,火焰原子吸收法 (FAAS)测定甘草中的金属元素 Ca、Mg、Fe、Cu、Zn、Pb的含量 ,研究了测定不同元素的仪器最佳工作条件及溶液介质对测定结果的影响及方法的准确性和精密度研究。栽培甘草中 Ca、Mg、Fe、Cu、Zn的含量分别为 4 0 4 5 .5、71 5 .4、2 79.8、1 2 .6、1 0 .4 μg/g,Pb未检出。方法的加标回收率为 99.38%— 1 0 2 .30 %,相对标准偏差 (n=9)为0 .4 1 %— 1 .6 8%。本法简单易行 ,方便快捷 ,结果可靠。     

微波消解-火焰原子吸收光谱法测定甜叶菊中6种金属元素

用浓硝酸微波消解样品,火焰原子吸收光谱法直接测定了甜叶菊样品中Fe、Cu、Mg、Ca、Mn、zn 6种金属元素.测定的甜叶菊中含有丰富的人体必需金属元素,方法回收率在92.80%-103.00%之间.本方法简单、准确,结果令人满意.     

非水溶液滴定法测定普卢利沙星的含量

以0.1mol.L-1高氯酸为滴定液,结晶紫为指示剂,用非水滴定法测定普卢利沙星。重复测定普卢利沙星含量平均值为99.4%(n=6),相对标准偏差为0.1%。该方法准确简便、重复性好,可作为普卢利沙星含量测定的有效方法。     

火焰原子吸收光谱法测定红豆杉中6种金属元素

用浓硝酸微波消解样品,火焰原子吸收光谱法直接测定了红豆杉中Fe、Cu、Mg、Ca、Mn、Zn 6种金属元素的含量.所测定的红豆杉中含有丰富的人体必需金属元素,采用此方法回收率在95.0%-104.0%之间.本方法简单、准确,结果令人满意.     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.