The transmission performance of the single sideband optical millimeter-wave with BPSK signal in the duplex radio-over-fiber link

This paper has investigated the transmission performance of the single sideband (SSB) optical millimeter (mm)-wave with signal carried by the sideband in BPSK format in duplex radio-over-fiber (RoF) system theoretically and numerically. The SSB optical mm-wave signal is generated by a LiNbO₃ Mach–Zehnder modulator and there exists an optimal modulation index to generate the SSB optical mm-wave with a maximal RF photocurrent. The SSB optical mm-wave is much suitable for the duplex ROF link with the uplink lightwave recovered from the downlink because the optical carrier carries no signal. In such a duplex RoF link, although there are the spurs on the optical carrier, they have little influence on the downlink and the uplink signal even if the modulation index is large.     

Performance limits of pico-cell systems using radio-over-fiber techniques with an electroabsorption modulator

We investigate the performance limits of a pico-cell system using the radio- over-fiber technique with an electroabsorption modulator (EAM) in a 2.4 GHz wireless local area network (WLAN) environment. To understand the performance limits of the system using an EAM as the optical transceiver, we vary the optical modulation index (OMI) of the transmitter for different bias voltages to the EAM. Power margins in the links are found to estimate a possible service range, and packet loss rates (PLRs) in the pico-cell system are measured to evaluate the transmission performance. The total service range can be extended up to 3 m by adjusting the OMI of the transmitter for different applied bias voltages to the EAM.     

Simulative investigation the impact of optical amplification techniques on single- and dual-electrode MZM and direct modulator's in single-tone RoF system

Since the introduction of erbium-doped fiber amplifier (EDFA) in optical fiber communication systems at 1550 nm, the fiber loss is no longer considered as the limiting factor but the fiber dispersion and chirp parameters play an important role in degrading the performance of optical communication systems. Further, the invention of external modulators of Mach-Zehnder (MS) type minimizes the transmission power penalty due to fiber chromatic dispersion as these modulators are consider almost chirp-free modulators. Also, better suppression of nonlinear distortions consists of harmonic distortions (HDs) and intermodulation distortions (IMDs) were achieved by using Mach-Zehnder external modulator [8]. In this work, a simulation comparison of external- and direct-modulation schemes using different optical amplifiers; SOA and EDFA in single-tone RoF system is reported. A single-tone channel of 20 GHz is transmitted over single-mode fiber (SMF) either externally modulated by using single-electrode (SEMZM) - and dual-electrode (DEMZM) - Mach-Zehnder modulator or by direct-modulation scheme. Better improvements in the measurement of received RF power of a 20 km linked single-tone RoF system are achieved by using SEMZM with EDFA, which means maximum optical link is achieved between Central Office (CO) and Base Station (BS). Further, this scheme provides better BER as compare to other schemes discussed in this paper.     

Simulative investigation of the impact of EDFA and SOA over BER of a single-tone RoF system

In this paper, we investigate the impact of EDFA and SOA amplifiers over BER and Q-parameter of a Radio-over-Fiber (Rof) system consisting of two different system set-ups using direct- and external-laser modulation techniques. In this work, we also measured and compared the electric Rf power at receiver at different modulating Rf frequencies up to 20 GHz using two different optical amplifiers, i.e. EDFA and SOA. Further, we also compared the received electric Rf power at different optical powers without and with different optical amplifiers. An improvement of −11 dB (approx.) of received Rf power was observed using EDFA with the external modulation technique, on comparing with direct modulation.     

A novel approach for simultaneous millimeter wave generation and high bit rate data transmission for Radio over Fiber (RoF) systems

We propose a novel method for simultaneous transmission of OC-192 (9.95328 Gbps) digital data and 60 GHz RF generation in a Standard Single Mode Fiber (SSMF) link utilizing Stimulated Brillouin Scattering (SBS). The system comprises of a 1550 nm DFB Laser diode, Mach Zehnder modulator (MZM), 50 km SSMF and Optical receiver. The receiver includes laser diode for optical pump, a regenerator for data retrieval and a RF bandpass filter for RF generation. This system requires minimum number of RF and optical components for the generation of 60 GHz RF. The remotely generated 60 GHz RF signal may be used for wireless transmission of data. The entire link is simulated in Optisystem software to analyze the system performance.     

Generation and transmission of the double-sideband optical millimeter-wave with signal carried only by optical carrier

In this paper, we have proposed a new scheme to generate double-sideband (DSB) optical millimeter-wave (mm-wave) with signal carried only by optical carrier, and its transmission performance is investigated. The theoretical and numerical results show that the DSB optical mm-wave signal generated by our scheme suffers only from the fading effect, the time shift of the sidebands has little influence on its transmission performance. The signal demodulated from the harmonic photocurrent shows a clear and open eye diagram and has good performance even if the transmission distance is very close to but not just at the fading nodes. The theoretical results are in good agreement with our numerical simulation.     

Generation of optical carrier suppression millimeter-wave signal using one dual-parallel MZM to overcome chromatic dispersion

In this paper, we have proposed a novel approach to generate optical carrier suppression (OCS) mm-wave with signal only carried by one first-order sideband using a dual-parallel MZM in radio-over-fiber (RoF) system, and the transmission performance was also investigated. As the optical mm-wave signal is transmitted along the fiber, there is no time shift of the data symbols resulting from the group velocity dispersion in the fiber because the signal is only modulated on one sideband. The simulation results showed that the eye diagram keeps open and clear even when the optical mm-wave signals are transmitted over 96-km and the power penalty is about 1-dB after fiber transmission distance of 60-km, which is quite consistent with our theoretical analysis. Furthermore, the proposed OCS optical mm-wave generation approach is also used in a full-duplex RoF link based on wavelength reuse at the base station for the uplink due to another pure sideband without carrying data. The bidirectional 2.5-Gbit/s data is successfully transmitted over 40-km standard single mode fiber with less than 0.5-dB power penalty in the simulation. Both the unidirectional RoF downlink and the full-duplex RoF system have good performance.     

Simulative analysis of soliton-based DPSK transmission system

The effectiveness of the conventional dispersion compensation techniques: DCF, FBG and OPC to use with soliton transmission is presented. The frequency shifts of solitons induced by collisions between different channels in a soliton WDM system can be reduced by dispersion compensation. The reduction mechanism applied is the cancellation of the shifts generated in both normal and anomalous dispersion regimes. It is analyzed that phase jitter can be reduced by the use of midway spectral inversion.     

Analysis of multitone microwave signals on optical fiber system using external laser modulation

In this paper, we Analyze multitone microwave signals on optical fiber with different tone signals and utilizing various possibilities of regeneration and amplification by different means. We compare out the performance analysis of Erbium doped fiber amplifiers (EDFAs) and Semi-conductor Optical Amplifiers (SOA). One tone's frequency varies from 1 to 20 GHz through parametric runs and other has fixed frequency of 5 GHz and third harmonic tones may be monitored.     

A model to characterize the effect of cross phase modulation on polarization in an optical fiber transmission system

This paper presents a model that described the process of inter-influence between cross phase modulation (XPM) and polarization effects such as polarization mode dispersion (PMD) and polarization dependant loss (PDL) in an optical fiber communication system. Previous papers have discussed PMD-PDL and PMD-XPM effects in separate models, but in this work we developed a model that is capable of characterizing and evaluating PMD, PDL and XPM simultaneously. From the model, we found that PMD and PDL can be affected by XPM. The presence of XPM changed the vector directions of PMD and PDL in Stokes space.     

Analytical investigation of response of birefringent fiber Bragg grating sensors in distributed monitoring system based on optical frequency domain reflectometry

When Fiber Bragg gratings (FBGs) are used as strain sensors, both longitudinal and lateral strain can be applied uniformly or non-uniformly over the length of the FBGs. In order for the demodulation of such FBG signal, this paper investigates the response of birefringent FBGs which are monitored by distributed measurement system based on optical frequency domain reflectometry. A numerical model of the distributed measurement system is built based on piece-wise uniform approach, which considers polarization states of propagating lights. The numerical model simulates analytical response of birefringent FBGs especially when birefringence induces power fluctuations in the distributed spectra, which can be noise or new opportunity for sensitive monitoring of birefringence. Simulation results show the relationships between the power fluctuations and the polarization states of the propagating lights. Consequently, appropriate methods of polarization control for sensitive distributed birefringent FBG monitoring are discussed.     

The effects of different dispersion compensation ratios on nonlinear single channel and WDM systems

The effects of the compensation ratio with dispersion post-compensation on nonlinear single channel and WDM systems with 10 Gb/s per channel are numerically investigated. When the transmission signal per channel is 10 Gb/s RZ pulse and the amplifier span is 50 km, proper undercompensation can enhance the performance of the nonlinear single channel system and the nonlinear WDM system. But the enhanced distance of the nonlinear WDM system is not as obvious as that of the single channel system, because the cross-phase-modulation effect plays an important role in the nonlinear WDM system.