Controlled introduction of allylic group to chlorosilanes

Allylation of chlorosilanes has been achieved with allylsamarium bromide, especially in a controlled manner. Thus allylation of trisubstituted chlorosilanes (R₃SiCl) afforded a variety of aryl, aralkyl, and alkenyl substituted allylsilanes. Dichlorosilanes (R₂SiCl₂) can either afford monoallylated silanes or diallylated silanes depending on the amount of allylsamarium bromide used. Similarly, trichlorosilanes (RSiCl₃) can selectively afford mono-, di-, and tri-allylation products. Finally, perchlorosilane (SiCl₄) was allylated stepwise and the corresponding silanes containing one, two, three or four allylic groups, respectively, were obtained in satisfactory yields.     

Allylation of epoxides with allylic indium reagents

Allylindium sesquihalide reacts with epoxide to give homoallyl alcohol via a 1,2-shift reaction. In contrast, allylindate gives the ring-opening product without rearrangement.     

Efficient access to fluorinated homoallylic alcohols through an indium promoted fluoroallylation reaction

Herein, an efficient access to fluorinated homoallylic alcohol is reported. The fluorinated alcohols were obtained in good to excellent yield using indium and halo-fluorinated allylic derivatives. The developed methodology using γ-substituted halo-fluorinated allylic derivatives gave the corresponding α-substituted fluorinated homoallylic alcohol in good yields and good diastereoselectivities up to 86:14.     

Reaction pathways of zirconocene-catalyzed silylation of alkenes with chlorosilanes

Reaction pathways as well as stereochemistries and stoichiometries of zirconocene-catalyzed silylation of olefins with chlorosilanes in the presence of ⁿBuMgCl were studied and discussed in detail. Rate determining steps were examined by kinetic studies and labeling experiments.     

Titanocene-catalyzed double silylation of dienes and aryl alkenes with chlorosilanes

Double silylation of 1,3-butadienes with chlorosilanes was found to proceed by using titanocene dichloride as the catalyst in the presence of ⁿBuMgCl, giving rise to 1,4-disilylated 2-butenes in good yields. Aryl substituted alkenes also afforded 1,2-disilylated products under similar conditions.     

Liquid-liquid extraction and recovery of indium using Cyanex 923

The extraction of In(III) from HCl, H₂SO₄, and HNO₃ media using a 0.20 mol l⁻¹ Cyanex 923 solution in toluene is investigated. In(III) is quantitatively extracted over a fairly wide range of HCl molarity while from H₂SO₄ and HNO₃ media the extraction is quantitative at low acid concentration. The extracted metal ion has been recovered by stripping with 1.0 mol l⁻¹ H₂SO₄. The stoichiometry of the In(III): Cyanex 923 complex is observed to be 1:2. The extraction of In(III) is insignificantly changed in diluents namely toluene, n-hexane, kerosene (160-200 °C), cyclohexane, and xylene having more or less the same dielectric constants, whereas, it decreases with increasing polarity of diluents such as cyclohexanone and chloroform. The extractant is stable towards prolonged acid contact and there is a negligible loss in its extraction efficiency even after recycling for 20 times. The extraction behavior of some commonly associated metal ions namely V(IV), Ti(IV), Al(III), Cr(III), Fe(III), Ga(III), Sb(III), Tl(III), Mn(II), Fe(II), Cu(II), Zn(II), Cd(II), Pb(II), and Tl(I) has also been investigated. Based on the partition data the conditions have been identified for attaining some binary separations of In(III). These conditions are extended for the recovery of pure indium from zinc blend, zinc plating mud, and galena. The recovery of the metal ions is around 95% with purity approximately 99%.     

Hexachloroethane: a highly efficient reagent for the synthesis of chlorosilanes from hydrosilanes

A new and efficient chlorination protocol is presented for the preparation of chlorosilanes from hydrosilanes. A variety of chlorinating agents in combination with palladium(II) chloride as the catalyst are examined. Among them, hexachloroethane is found to be the best choice, furnishing the desired product in good to quantitative yields under mild conditions. Various hydrosilanes are used as starting materials to explore the scope of this reaction.     

A practical and efficient procedure for the cleavage of acylals to aldehydes catalyzed by indium tribromide in water

Indium tribromide (10 mol %) is an efficient catalyst for chemoselective cleavage of aryl acylals in refluxing water. A variety of acylals have been deprotected to give the corresponding parent aldehydes in high yield. The procedure presented is operationally simple, practical, and compatible with other sensitive functionalities such as methoxy, methyleneioxy, and benzyloxy groups present in the substrates.     

Effect of operating variables on rejection of indium using nanofiltration membranes

Indium and its compounds exhibit excellent semiconductor properties however they are suspected carcinogenic to human beings. For the first time, we applied nanofiltration (NF) technology to the separation of indium from a synthetic wastewater as a literature review revealed little information on the treatment of such a waste. In this research, three types of nanofiltration membranes, NTR7450, ES10 and ES10C, were employed to compare their performances under various operating conditions. With increasing indium concentration in the feed solution, the rejection rates decreased in all the membranes, which could be ascribed to concentration polarization and ion-shielding effects. The changes of indium concentration in the permeate (C_p) were then correlated to the concentration factor (CF) during nanofiltration of the feed solution. The experimental results were well predicted by the theoretical analysis. Increase of operating pressure enhanced their rejection rates of indium, which might be attributed to the “dilute effect”. The real rejection (f_r) of indium by nanofiltration was found permeate flux dependent. Based on the results obtained, the nanofiltration mechanisms of multivalent cations such as In³⁺ were delineated and discussed. It was found that most of the models developed from nanofiltration of univalent and divalent cations were still valid for the nanofiltration process of trivalent cations. However, the strong chemical potential of trivalent cations to form complexes in the solution around neutral pH exerted a significant impact on indium rejection rates of the NF membranes. The experimental results suggest a stable performance of nanofiltration when applied to the semiconductor wastewater, however, acidic conditions should be avoided.     

Indium-mediated allenylation of arylacyl bromides in a route for the synthesis of substituted furans

A three-step, single purification procedure has been developed for the concise synthesis of substituted furans from arylacyl bromides.     

Synthesis of 4-allylquinazolines from N-(2-cyanoaryl)amides via the In-mediated allylation of nitrile and dehydrative cyclization cascade

The reaction of allylindium reagents and N-(2-cyanoaryl)amides afforded 2-substituted-4-allylquinazolines in good yields via the indium-mediated Barbier-type allylation of nitrile and the following dehydrative cyclization cascade.     

Rate acceleration and diastereoselectivity in chelation-controlled indium-promoted Barbier allylation of pyridine-2- and quinoline-2-imines in aqueous solvents

The imines generated in situ from 2-pyridinecarboxaldehyde/2-quinolinecarboxaldehyde and aryl amines undergo indium-mediated Barbier allylation in aqueous media to provide homoallylic amines. Crotyl and cinnamyl bromides lead to diastereoselective allylation with d.r. up to 98:2.     

Highly selective catalytic Friedel-Crafts acylation and sulfonylation of activated aromatic compounds using indium metal

The Friedel-Crafts acylation of activated benzenes with various aromatic and aliphatic acid chlorides was studied in the presence of indium metal. The reaction was accomplished in high isolated yields under solvent or solvent-less conditions. The method is also applicable for preparing diaryl sulfones from aromatic compounds and aryl sulfonyl chlorides.     

Indium-mediated allylation of aryl trichloromethyl ketones in aqueous media

It is described that indium-mediated allylation of trichloromethyl ketones could afford the corresponding homoallylic alcohols smoothly in aqueous media.     

Synthesis of fully-substituted alkenylimidazoles from N-(cyanoalkyl)amides via the In-mediated allylation of nitrile and dehydrative cyclization cascade

The reaction of allylindium reagents and N-(cyanoalkyl)amides afforded fully-substituted 4-alkenylimidazoles in moderate yields via the In-mediated Barbier-type allylation of nitrile and the following dehydrative cyclization cascade.     

Regioselective cross-coupling of allylindium reagents with activated benzylic bromides—a simple and efficient procedure for the synthesis of terminal alkenes

Allylindium reagents undergo facile and highly regioselective cross-coupling with benzylic and cinnamyl bromides in THF at room temperature without any catalyst producing terminal alkenes in high yields. The addition is highly regioselective and is found to provide γ-adducts in all reactions.     

Detection of trace elements in pure indium by flame,Zeeman graphite furnace and hydride generation atomic absorption spectrometry

An atomic absorption spectrometric method for the chemical characterization of very pure indium metal is described that permits the determination of 21 elements, usually present at trace levels, without matrix removal, preliminary analyte separation or concentration. For each element the detection limit obtained is reported.     

Photochemical and radical initiator-induced reaction of allylic indium compounds

Intramolecular cyclization of allylic radicals generated from allylindium compounds both by photolysis or by the reaction of radical initiators was examined. The photolysis of allylic indium compounds, prepared from 8-bromo- or 8-iodooct-1,6-dienes and powdered indium metal, led to the formation of the 5-exo-trig products. Benzoyl peroxide as a radical initiator was also effective for the cyclization. In contrast, the radical initiators with oxidizing nature, such as tert-butyl hypochlorite, induced iodocyclization producing iodomethylcyclopentane via an oxidation of the iodide on the indium atom.     

New indium selenite-oxalate and indium oxalate with two- and three-dimensional structures

Two new indium(III) compounds with extended structures, [In₂(SeO₃)₂(C₂O₄)(H₂O)₂]·2H₂O (I) and [NH₃(CH₂)₂NH₃][In(C₂O₄)₂]₂·5H₂O (II), have been prepared under mild hydrothermal conditions and structurally characterized by single-crystal X-ray diffraction, thermogravimetric analysis and infrared spectroscopy. Compound I crystallizes in the triclinic system, space group P-1, with a=5.2596(11) Å, b=6.8649(14) Å, c=9.3289(19) Å, α=101.78(3)°, β=102.03(3)°, γ=104.52(3)°, while compound II crystallizes in the orthorhombic system, space group Fdd2, with a=15.856(3) Å, b=31.183(6) Å, c=8.6688(17) Å. In compound I, indium-selenite chains are bridged by oxalate units to form two-dimensional (2D) In₂(SeO₃)₂C₂O₄ layers, separated by non-coordinating water molecules. In compound II, the indium atoms are connected through the oxalate units to generate a 3D open framework containing cross-linked 12- and 8-membered channels.     

The development of N-aryl trifluoroacetimidate-based benzyl and allyl protecting group reagents

An exploration of the role of para-substituents on the balance between stability and reactivity of N-phenyl trifluoroacetimidates prompted the discovery of new reagents for the addition of allyl and benzyl protecting groups, namely O-allyl and O-benzyl N-(p-nitrophenyl)trifluoroimidates. These compounds are stable and crystalline at ambient temperature, making them ideal alternatives to existing benzylating and allylating reagents used under acidic conditions.