Temperature-Dependent Defect-Induced New Emission in ZnSe Crystal

The temperature-dependent photoluminescence behaviour of chemical vapour transport （CVT）-grown ZnSe crystal is investigated. A new emission band appears when temperature is reduced to 155K. It is shown that the new emission band is strongly related to defect emission peaked at around 2.1 eV. The emergence of the new emission band is accompanied by decreasing emission intensity of free exciton, as well as redshiR of defect emission with temperature decreases. The activated energy of the defect state is estimated to be 60.6 meV, which is approximately equal to the energy difference between the new emission and the free exciton emission at 155K.     

Ultraviolet Luminescence Depending on Zn Interstitial in ZnO Polycrystalline Films

The ultraviolet emission line at 3.315eV is observed at 8K in ZnO polycrystalline films and investigated by temperature-dependent photolumineseence spectra and cathodoluminescence spatial image. The relative intensity of 3.315 eV emission line depends strongly on growth and annealing conditions. The cathodoluminescence image shows that the 3.315 eV emission localizes on the surface and ridge of ZnO grain. These results suggest that the 3.315 eV emission attributes to Zn interstitials at the grain surface and ridge. This emission is stable in the range from 8 K to 300 K and contributes to the room temperature ultraviolet band.     

Probing Field Emission from Boron Carbide Nanowires

High density boron carbide nanowires are grown by an improved carbon thermal reduction technique. Transmission electron microscopy and electron energy lose spectroscopy of the sample show that the synthesized nanowires are B4 C with good crystallization. The field emission measurement for an individual boron nanowire is performed by using a Pt tip installed in the focused ion beam system. A field emission current with enhancement factor of 10^6 is observed and the evolution process during emission is also carefully studied. Furthermore, a two-step field emission with stable emission current density is found from the high-density nanowire film. Our results together suggest that boron carbide nanowires are promising candidates for electron emission nanodevices.     

Deep level emission of ZnO nanoparticles deposited inside UV opal

The temperature-dependent photoluminescence spectra of zinc oxide (ZnO) nanocrystals deposited inside the ultraviolet (UV) opal were studied. ZnO was grown in the voids between FCC packed SiO₂ spheres using spray pyrolysis under ultrasonic vibration in the solution containing a zinc nitrate precursor. The ZnO nanoparticles inside opal matrix with UV photonic band-gap exhibit suppression of the excitonic emission and enhancement of the deep level emission. Suppression of the excitonic lines is due to the inhibition of spontaneous emission, while enhancement and broadening of the DL emission in the green spectral region is due to Purcell effect. The infiltration of ZnO nanoparticles inside the photonic crystal may be a useful technique to increase its emission efficiency in the selected spectral region.     

Two modes of electroluminescence from single‐walled carbon nanotubes

The electroluminescence from single‐walled carbon nanotube field effect transistors is spectrally resolved, and shows two distinct modes of light emission. The vast majority of nanotubes have spectrally broad emission consistent with the spectrum of blackbody radiation. Much more rarely, superposed on the broad emission is a single narrow (<50 meV) peak which is consistent with expectation for electron–hole recombination. The narrow emission is strong even at lower biases and in general has greater peak intensity than the broadband emission. (© 2009 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Dislocation emission from an elliptically blunted crack tip with surface effects

The explicit expressions for critical stress intensity factors are derived for edge dislocation emission from an elliptically blunt crack with surface effects under mode I and mode II loadings. The influence of surface effects on dislocation emission criterion is analyzed. The result indicates the impact of the surface stress becomes remarkable for nanoscale blunted cracks and some particular materials, which cannot only affect the value of the critical stress intensity factors for dislocation emission, but also alter the emission angle.     

Photon emission from adsorbed C60 molecules with sub-nanometer lateral resolution

We present the first experimental demonstration of spatially resolved photon emission of individual molecules on a surface. A scanning tunneling microscope (STM) was used as a local electron source to excite photon emission from hexagonal arrays of C₆₀ molecules on Au(110) surfaces. Specifically, we show that in maps of photon emission intensities, C₆₀ fullerenes appear as arrays of individual light emitters 4 Å in diameter and separated by 10 Å. Comparison with simultaneously recorded STM images reveals, that most intense emission is detected when the STM tip is centered above a molecule. The results demonstrate the highest spatial resolution of light emission to date using a scanning probe technique.     

Fine-structured field emission images originating from coherently scattering of electrons within a multi-walled carbon nanotube

High resolution field emission image of a single multi-walled carbon nanotube was studied by field emission microscopy. The images contain patterns consisting of rather ordered bright fringes. We propose a model based on coherent electron scattering to explain the observed field emission image. The emitted electrons will undergo coherent scattering within the cap region of a multi-wall carbon nanotube, which may be viewed as elastic scattering by a polycrystalline structure with an infinite size. This study is helpful for understanding the physical mechanism of field emission of carbon nanotube.     

Temperature Dependence of Photoluminescence from Single and Ensemble InAs/GaAs Quantum Dots

We investigate the temperature dependence of photoluminescence from single and ensemble InAs/GaAs quantum dots systematically. As temperature increases, the exciton emission peak for single quantum dot shows broadening and redshift. For ensemble quantum dots, however, the exciton emission peak shows narrowing and fast redshift. We use a simple steady-state rate equation model to simulate the experimental data of photoluminescence spectra. It is confirmed that carrier-phonon scattering gives the broadening of the exciton emission peak in single quantum dots while the effects of carrier thermal escape and retrapping play an important role in the narrowing and fast redshift of the exciton emission peak in ensemble quantum dots.     

A new photoluminescence emission peak of ZnO-SiO2 nanocomposites and its energy transfer to Eu ions

This work reports a new photoluminescence (PL) emission peak at about 402 nm from amorphous ZnO nanoparticles in a silica matrix, and the energy transfer from it to Eu³⁺ ions. The amorphous ZnO-SiO₂ nanocomposites were prepared by the sol-gel method, which is verified by X-ray diffraction (XRD) profiles and FT-IR spectra. The luminescence emission spectra are fitted by four Gauss profiles, two of which at longer wavelength are due to the defects of the material and the others to amorphous ZnO nanoparticles and the Zn-O-Si interface state. With the reduction of Zn/Si ratio and diethanolamine, the relative intensities of visible emission decrease. The weak visible emission is due to the reduction of defects after calcined at high temperature. The new energy state at the Zn-O-Si interface results in strong emission at about 402 nm. When Eu³⁺ ions are co-doped, weak energy transfer from ZnO-SiO₂ nanocomposites to Eu³⁺ emission are observed in the excitation spectra.     

Temperature-dependent photoluminescence of Mg-doped CdS nanowires

Sixfold symmetrical Mg-doped CdS nanowires have been fabricated through high temperature vapor-solid deposition process. The experimental study of the temperature-dependent photoluminescence properties of the Mg-doped CdS nanowires from 10 K to 300 K was reported. The Mg-doped CdS nanowires show intensive cyan-color light emission properties from 10 K to 200 K. The results indicate that there are two strong peaks situated at the green emission (at 528 nm) and red emission (at 655-695 nm), and two weak UV emission peaks at 378 nm and 417 nm, respectively. The ratio of green to red emission was decreased with temperature increased. When the temperature is above 200 K, the orange-color light was observed from the Mg-doped CdS nanowires. Therefore, the intensive emission properties of the Mg-doped CdS nanowires have a great potential for use as nanoscaled optoelectronic intensive light emitters under different temperature.     

Effect of ion impinging on the microstructure and field emission of carbon nanotubes

Effects of ion impinging on the microstructure and field electron emission properties of screen-printed carbon nanotube films were investigated. We observed that the plasma treatment modified the microstructure of CNTs along with the remarkable increase of emission site density. With the prolongation of ion impinging time, the emission current falls down first, and then rises up to higher than that of the untreated films. It is proposed that the change of emission characteristics is due to the different emission mechanisms. After the treatment, electrons are emitted predominantly from the nano-nodes on the tube wall instead from the nanotube tips.     

Field emission from nano-patterned amorphous carbon

Electron emission from nano-patterned amorphous carbon is realized in this paper. The patterned carbon consists of islands with size of tens of nanometers, and is formed by etching uniform carbon film in oxygen plasma using a bismuth island-like film as the mask. Uniform and stable electron emission is reproducibly obtained, and the emission efficiency is above 2% at an anode voltage of 3 kV. Small carbon particles between large islands are supposed to be necessary for stable electron emission.     

Modified spontaneous emission spectra of a three-level V-type atom in photonic crystals

We introduce a modified density of modes to investigate the spontaneous emission spectrum of a three-level V-type atom in photonic crystal using Laplace transform. The atom’s steady state behavior of spontaneous emission is treated for different locations of the upper band-edge frequency. Furthermore; the influence of quantum interference between the two decay channels on spontaneous emission is discussed.     

Characteristics of Nd：GdVO4 Laser with Different Nd-Doping Concentrations

We report the properties of a compact diode-pumped continuous-wave Nd：GdV04 laser with a linear cavity and different Nd-doped laser crystals. In a 0.2at.% Nd-doped Nd：GdVO4 laser, 1.54 W output laser power is achieved at 912nm wavelength with a slope efficiency of 24.8% at an absorbed pump power of 9.4W. With 0.3at.% Nd-doping concentration, we can obtain the either single-wavelength emission at 1064nm or 912nm or the dual-wavelength emission at 1064nm and 912nm by controlling the incident pump power. From an incident pump power of 11.6 W, the 1064nm emission between ^4Fa/2 and ^4I11/2 is suppressed completely by the 912nm emission between ^4Fa/2 and ^4I9/2. We obtain 670 mW output of the 912nm single-wavelength laser emission with a slope efficiency of 5.5% by taking an incident pump power of 18.4 W. Using a Nd：GdV04 laser with 0.4at.% Nd-doping concentration, we obtain either the single-wavelength emission at 1064nm or the dual-wavelength emission at both 1064nm and 912nm by increasing the incident pump power. We observe a strong competition process in the dualavelength laser.     

Fluorescence Emission Centres and the Corresponding Infrared Fluorescence Saturation in a Bismuth-Doped Silica Fibre

We investigate the fluorescence characteristics of bismuth doped silica fibres with and without A1 co-dopant which are fabricated by means of modified chemical vapour deposition （MCVD） technique, and find that the fluorescences in the red region （centred around 750nm） and in the infrared region （centred around llOOnm） may originate from different emission sites in the fibre. Strong upconversion phenomena are observed in both Al-codoped and non A1 codoped bismuth fibres when the fibres are excited by an acoustic-optic Q-switched Nd：YVO4 laser. Both the aspects indicate that the upper energy level absorption reported in the work of the bismuth doped silica fibre lasers may result from the fluorescence emission sites that are not responsible for the infrared emission. It is thus expected that optimizing the compositions and the fabrication conditions of the fibre and then transferring more fluorescence emission centres are helpful for the infrared emission.     

Polarization Properties of Quantum-Dot-Based Single Photon Sources

Polarization properties of single photons emitted by optical pumping from a single quantum dot （ QD） are studied by using a four-level system model. The model is capable of explaining the polarization uncertainty observed in single photon emission experiments. It is found that the dependence of photon emission efficiency and polarization visibility on pump power are opposite in general cases. By employing QDs with small size and strong carrier confinement, the photon polarization visibility under high pump power can be improved. In addition, embedding a QD into a well designed microcavity is also found to be favourable, whereas the trade-off between high polarization visibility and multi-photon emission is noted.     

Hydrogen passivation effect on the yellow-green emission band and bound exciton in n - ZnO

Photoluminescence (PL) measurements performed on as-grown, hydrogenated, and annealed n-type ZnO bulk samples investigated the origins of their yellow (2.10 eV) and green (2.43 eV) emission bands. After hydrogenation, the defect-related peak at 2.10 eV was no longer present in the room temperature PL spectrum, the peak intensity at 2.43 eV was unchanged, and the intensity of the emission peak at 3.27 eV increased significantly. These results indicate that yellow band emission is due to oxygen vacancies, as the emission peak at 2.10 eV disappears when hydrogen atoms passivate these vacancies. The emission peak at 2.43 eV originates from complexes between oxygen vacancies and other crystal defects. We discuss the shallow donor impurities arising due to these hydrogen atoms in the ZnO bulk sample.     

Influence of CH3COO on the room temperature photoluminescence of ZnO films prepared by CVD

ZnO films with strong c-axis-preferred orientation have been prepared by a single source chemical vapor deposition technique using zinc acetate as source material at the growth temperature of 230 °C. The strong UV and blue emissions were observed in the photoluminescence spectra of as-grown films. A small quantity of residual zinc acetate was reserved on the surface of as-grown ZnO films and the emission mechanism of blue luminescence was nearly related to the CH₃COO^- of unidentate type. The blue emission disappeared and the green emission appeared after annealing treatment. The green emission is related to the singly ionized oxygen vacancies.