4,4′,4″-Tris(5-nonyl)-2,2′ : 6′,2″-terpyridine as ligand in atom transfer radical polymerization (ATRP)

The bulk atom transfer radical polymerization (ATRP) of styrene or methyl acrylate was carried out in the presence of CuCl or CuBr complexed by equimolar amounts of 2,2′: 6′,2″-terpyridines (tpy) as ligands. Uncontrolled reactions were observed in the presence of unsubstituted ligands whereas relatively fast but controlled polymerization of styrene and methyl acrylate was observed for CuCl and CuBr complexed by tpy with three 5-nonyl substituents (tNtpy). Molecular weights evolved linearly with conversion and polymers with relatively low polydispersities were formed (M_w/M_n < 1.2).     

Metal(II) 4,4′,4″,4′″-phthalocyanine tetramines as curing agents for heat resistant epoxy formulations

Pure metal(II) 4,4′,4″,4′″-phthalocyanine tetraamines (MPTA) have been used to cure epoxy resins in a homogeneous reaction. Infrared spectroscopy, differential scanning calorimetry, and thermogravimetric analytical studies were used to characterize these materials and to evaluate the optimum curing conditions. Considerable improvement in the heat resistance of the epoxy resin cured with MPTA over those cured with other commonly used curing agents was observed. This was expected from the highly aromatic structure of the phthalocyanines. A noteworthy feature of these cured materials is their high anaerobic char yield, 73.5–75%, higher than in any heretofore known cured epoxy systems. Preliminary mass spectral studies on the cured polymers are presented.     

Curing of epoxy resins with metal(II)4,4′,4″,4‴-tetraamino phthalocyanines-modification with elastomers

The use of metal phthalocyanine tetraamines in curing epoxy resins to form high-temperature-resistant matrix polymers for composites has been reported earlier. The effect of adding carboxy-terminated butadiene-acrylonitrile (CTBN) elastomer is now described; preliminary measurements of tensile, flexural, and short-beam shear strengths, dynamic moduli, resin content, and moisture absorption are presented, and the results of dynamic thermogravimetric analyses are given. In addition to their high char yield (86–87.5% at 800°C in a nitrogen atmosphere) and limiting oxygen index (48.3–50.3), the laminates showed good mechanical properties.     

Phthalocyanine polymers. I. Poly[2,2′-(4,4′,4″-,4‴-metal phthalocyanino)-5,5′-bibenzimidazoles] as new high temperature resistant polymers

A novel class of poly(metal phthalocyanino) benzimidazoles were prepared by the condensation reaction between metal (Cu, Co, and Zn), 4,4′,4″,4?-tetracarboxyphthalocyanine, and 3,3′-diaminobenzidine. The reaction was investigated by melt and solution condensation methods. These polymers showed excellent thermal and thermooxidative stability and are noteworthy for their high char yield (86–90%) at 800°C in an anerobic atmosphere. Elemental analyses, spectra, and TGA studies were used to characterize these materials. Isothermal gravimetric analyses were carried out to determine their long-term thermal stability.     

Angiotensin-II Analogues. I: Synthesis and incorporation of the halogenated amino acids 3-(4′-iodophenyl)alanine, 3-(3′,5′-dibromo-4′-chlorophenyl)alanine, 3-(3′,4′,5′-tribromophenyl)alanine,and 3-(2′,3′,4′,5′,6′-pentabromophenyl)alanine

The synthesis of the polyhalogenated phenylalanines Phe(3′,4′,5′-Br₃) ( 3 ), Phe(3′,5′-Br₂-4′-Cl) ( 4 ) and DL -Phe (2′,3′,4′,5′,6′-Br₅) ( 9 ) is described. The trihalogenated phenylalanines 3 and 4 are obtained stereospecifically from Phe(4′-NH₂) by electrophilic bromination followed by Sandmeyer reaction. The most hydrophobic amino acid 9 is synthesized from pentabromobenzyl bromide and a glycine analogue by phase-transfer catalysis. With the amino acids 4, 9 , Phe(4′-I) and D -Phe, analogues of [1-sarcosin]angiotensin II ([Sar¹]AT) are produced for structure-activity studies and tritium incorporation. The diastereomeric pentabromo peptides L - and D - 13 are separated by HPLC. and identified by catalytic dehalogenation and comparison to [Sar¹]AT ( 10 ) and [Sar¹, D -Phe⁸]AT ( 14 ).     

Phase transfer Pd(0)/Cu(I) catalysed polymerization reactions 7. Synthesis and thermotropic behaviour of 1,4-bis[2-(3',3'-difluoro-4',4'-di-n-alkyloxyphenyl)-ethynyl]benzene dimers

The symmetrically difluorinated aryl-acetylene dimers, 1,4-bis[2-(3',3'-difluoro-4',4'-di-n-alkyloxyphenyl)ethynyl]benzenes (n = 7-12), were prepared by a one pot phase transfer. Pd(0)/Cu(I) catalysed, three step coupling of 1,4-diiodobenzene with 2-methyl-3-butyn-2-ol and the appropriate 1-bromo-3-fluoro-(4-n-alkyloxy)benzene. All members of the series display enantiotropic nematic and smectic C phases as well as an additional smectic mesophase in the sequence C-S-S_C-N-I. The textures observed by polarized optical microscopy strongly support identification of the second smectic phase as a S_E mesophase. The S_C temperature window increases as the length of the n-alkyloxy substituent increases, whereas the stability of the nematic and S_E temperature windows decrease. In these fluorinated dimers, destabilization of mesomorphic behaviour by lateral fluorine substitution is compensated by stabilization due to the large length to breadth ratio of the mesogen, such that melting and crystallization are depressed more than isotropization when compared to the non-fluorinated dimers.     

Synthesis of symmetrical 2,2′,4,4′-tetrasubstituted[4,4′-bioxazole]-5,5′(4H,4′H)-diones and their reactions with some nucleophiles

Several symmetrical 2,2′,4,4′-tetrasubstituted[4,4′-bioxazole]-5,5′(4H,4′H)-diones 1a-f were obtained by dehydrodimerization of 5(4H)-oxazolones 2a-f . The configurations of four were established; one by X-ray crystallography rac- 1c , and three rac- 1a , meso- 1a and rac- 1b by ¹H nmr spectroscopy of their derivatives. Upon being heated, the bioxazolones isomerized, presumably by breakage of the 4,4′-carbon? carbon bond to form free radicals followed by their recombination. The results of a crossover experiment were consistent with a radical nature for this isomerization reaction. Treatment of three of the bioxazolones rac- 1a , meso- 1a and rac- 1c with methanol and amine nucleophiles led to ester and amide derivatives 7–11 of α,α'-dehydrodimeric amino acids.     

Chemical behaviours of 3-[1′-chloro-3′-(2″-phenyl-1″,3″-oxazol-5″-one=4″-ylidene)propen-1′-yl]coumarin towards some nucleophilic reagents

The chemical behaviours of 3-[1′-chloro-3′-(2″-phenyl-1″,3″-oxasol-5″-one-4″-ylidene)-propen-1′-yl]coumarin towards nucleophilic reagents (such as hydrolysis, aminolysis, hydroxyl-aminolysis, methanolysis and hydrazinolysis) were described.     

Microwave induced one-pot synthesis of fluorenespiro[9.3′]-(4′-aryl)pyrrolidine/pyrrolizidine/tetrahydropyrrolo[1,2-c]thiazolespiro[2′.2″]indan-1″,3″-dione derivatives

A versatile one-pot method for the synthesis of new dispiro heterocycles is described using an intermolecular [3+2] cycloaddition reaction. The reaction gives excellent yields when carried out under solvent-free microwave irradiation.     

Polyimidines. XI. Polyimidines from 3,3′,4,4′-benzophenonetetracarboxylic dianhydride and 4,4′-(hexafluoroisopropylidene) diphthalic anhydride

Two new bis(benzylidenephthalide)monomers were synthesized by melt condensation of phenylacetic acid with 3,3′,4,4′-benzophenonetetracarboxylic dianhydride (BTDA) and with 4,4′-(hexafluoroisopropylidene)diphthalic anhydride (6FDA). A mixture of three isomers for each monomer was obtained and polymerized with diamines to produce new polyimidines. Polymerizations were conducted with m-xylylenediamine (MXDA) or 4,4′-oxydianiline (ODA) in quantitative yields for the undehydrated intermediate. Inherent viscosities ranged from 0.17 to 0.35 dL/g in N,N-dimethylformamide (DMF) or N-methyl-2-pyrrolidone (NMP). These intermediate poly(hydroxylactams) were thermally dehydrated to polyimidines which exhibited a 10% weight loss, as high as 546°C in nitrogen. Inherent viscosities of the dehydrated (cured) polyimidines ranged from 0.14 to 0.20 dL/g in NMP. Brittle films could be cast from NMP solutions.     

1,2-Epoxycarotinoide. 4. Mitteilung. Synthese, 1H-NMR- und CD-Studien von (S)-1,2-Epoxy-1,2-dihydrolycopin und (S)-1′,2′-Epoxy-1′,2′-dihydro-γ-carotin

1,2-Epoxycarotenoids: Synthesis, ¹H-NMR and CD Studies of (S)-1,2-Epoxy-1,2-dihydrolycopene and (S)-1′,2′-Epoxy-1′, 2′ -dihydro-γ-carotene The synthesis of (S)-1,2-epoxy-1,2-dihydrolycopene (^(S)- 1 ) and (S)-1′, 2′ -epoxy- 1′, 2′ -dihydro-γ-carotene ((S)- 2 ) are described. The CD spectra of the (all-E)-isomers and of the isomers (7Z, S)- 1 and (7′Z, S)- 2 are discussed. The comparison of the CD spectra of the synthetic (S)- 1 and the compound isolated from the tomatoes proves the (S)-configuration of the natural product.     

Aquachlorobis(4,4′,4′′‐tri‐tert‐butyl‐2,2′;6′,2′′‐terpyridine‐κ3N)terbium(III) diperchlorate ethanol disolvate

In the title compound, [TbCl(C₂₇H₃₅N₃)₂(H₂O)](ClO₄)₂·2C₂H₆O, the Tb^III ion has a coordination number of eight, composed of two tridentate substituted‐ter­pyridine ligands, a water mol­ecule and a bound Cl^? anion. The first coordination shell can be described as a distorted bicapped trigonal prism. The dihedral angles between pyridine rings belonging to the same tpy ligand range from 5.2 (5) to 16.8 (5)°.     

5-(α-Fluorovinyl)tryptamines and 5-(α-Fluorovinyl)-3-(N-methyl-1′,2′,5′,6′,-tetrahydropyridin-3′- and -4′-yl)indoles—5-(α-Fluorovinyl)tryptamines

5-(α-Fluorovinyl)tryptamines 4a, 4b and 5-(α-fluorovinyl)-3-(N-methyl-1′,2′,5′,6′-tetrahydropyridin-3′- and -4′-yl) indoles 5a, 5b were synthesized using 5-(α-fluorovinyl)indole ( 7 ). The target compounds are bioisosteres of 5-carboxyamido substituted tryptamines and their tetrahydropyridyl analogs.     

Atomic Absorption Spectrophotometric Determination of Copper (I) after Adsorption of its 4′-(p-Methoxyphenyl)-2, 2′:6′, 2″-Terpyridine Tetraphenylborate Ion-Associated Complex on Microcrystalline Naphthalene

A new atomic absorption spectrophotometric method has been developed for the trace determination of copper after adsorption of its 4′-(p-methoxyphenyl)-2, 2′:6′,2″-terpyridine tetraphenylborate ion-associated complex on microcrystalline naphthalene. This complex is adsorbed on microcrystalline naphthalene in the pH range 0.5-11.0 by shaking for a few seconds. The solid mass so formed is separated by filtration, dissolved in dimethylformamide and the absorbance is measured at 324.7 nm. Beer's law is obeyed in the concentration range 5.0-60.0 μg of copper in 10 ml of the final dimethylformamide solution. The replicate determinations of a sample containing 30 μg of copper gave a mean absorbance of 0.171 with a standard deviation of 0.0019 and a relative standard deviation of 1.11%. The method has been applied to the determination of copper in certain standard reference materials.