Relevance of sonochemistry or ultrasound (US) as a proficient means for the synthesis of fused heterocycles

Medicinal chemistry has been benefited by combinatorial chemistry and high throughput parallel synthesis. The use of sonochemistry under controlled conditions has been proved beneficial for medicinal chemistry and drug discovery process since it dramatically reduces reaction times, from days or hours to minutes. In addition, sonochemistry synthesis provides higher yields, lower cost, easy workups and greater purity as compared to lower yields, tedious workups, longer reaction times, lesser purity and termination of many by-products in the conventional thermal methods.     

Study of inspection on metal sheet with subsurface defects using linear frequency modulated ultrasound excitation thermal-wave imaging (LFM-UTWI)

The linear frequency modulated ultrasound excitation thermal wave imaging (LFM-UTWI) was investigated on detection of subsurface defects of metal sheet. A numerical finite element analysis is carried out to calculate thermal wave signal dependence of time by linear frequency modulated ultrasonic wave excitation. Cross-correlation operation in time domain and frequency domain are used to extract the main peak value and the corresponding delay time, respectively. Fourier transform (FT) is applied to calculate the amplitude and phase angle of harmonic component of thermal wave. Experimental results show that various deep subsurface defects are readily detected using LFM-UTWI with once excitation, and LFM-UTWI has an advantage of better defect detectability compared to ultrasound lock-in thermography (ULIT).     

Properties and characteristics of P(VDF/TrFE) transducers manufactured by a solution casting method for use in the MHz-range ultrasound in air

Highly effective piezoelectric polymer transducers operating in air at high frequencies have been successfully made by casting a solution of ferroelectric poly(vinylidene fluoride-co-trifluoroethylene) P(VDF/TrFE) directly on a backing metal plate, and their performance has been evaluated. By utilizing this method, it has been possible to develop the three kinds of transducers that operate respectively at 4, 6 and 10 MHz in air. For precise evaluation of the performance of the P(VDF/TrFE) transducers, the absorption loss in air was measured up to 10 MHz. It was confirmed that the empirical formula obtained from the measured absorption values in air at high frequencies was in alignment with its theoretical value. In addition, a high lateral resolution acoustic image of a ROM-Chip (amplitude-image) at 6 MHz in air was successfully displayed using an air coupled concave type P(VDF/TrFE) transducer by bonding an epoxy adhesive.     

Role of H2O2 in the fluctuating patterns of COD (chemical oxygen demand) during the treatment of palm oil mill effluent (POME) using pilot scale triple frequency ultrasound cavitation reactor

Palm oil mill effluent (POME) is a highly contaminating wastewater due to its high chemical oxygen demand (COD) and biochemical oxygen demand (BOD). Conventional treatment methods require longer residence time (10–15 days) and higher operating cost. Owing to this, finding a suitable and efficient method for the treatment of POME is crucial. In this investigation, ultrasound cavitation technology has been used as an alternative technique to treat POME. Cavitation is the phenomenon of formation, growth and collapse of bubbles in a liquid. The end process of collapse leads to intense conditions of temperature and pressure and shock waves which assist various physical and chemical transformations. Two different ultrasound systems i.e. ultrasonic bath (37 kHz) and a hexagonal triple frequency ultrasonic reactor (28, 40 and 70 kHz) of 15 L have been used. The results showed a fluctuating COD pattern (in between 45,000 and 60,000 mg/L) while using ultrasound bath alone, whereas a non-fluctuating COD pattern with a final COD of 27,000 mg/L was achieved when hydrogen peroxide was introduced. Similarly for the triple frequency ultrasound reactor, coupling all the three frequencies resulted into a final COD of 41,300 mg/L compared to any other individual or combination of two frequencies. With the possibility of larger and continuous ultrasonic cavitational reactors, it is believed that this could be a promising and a fruitful green process engineering technique for the treatment of POME.     

Poly(4-vinylpyridinium)hydrogen sulfate: a novel and efficient catalyst for the synthesis of 14-aryl-14H-dibenzo[a,j]xanthenes under conventional heating and ultrasound irradiation

A simple and convenient procedure for the synthesis of 14-aryl-14H-dibenzo[a,j]xanthenes is described through a one-pot condensation of 2-naphthol with aryl aldehydes in the presence of poly(4-vinylpyridinium)hydrogen sulfate as an efficient, cheap, readily synthesized and eco-friendly catalyst in a solvent free media using conventional heating and ultrasound irradiation.     

Investigation on damage of DNA molecules under irradiation of low frequency ultrasound in the presence of hematoporphyrin-gallium (HP-Ga) complex

The interaction of deoxyribonucleic acid (DNA) and hematoporphyrin–gallium (HP–Ga) complex and the damage of DNA under ultrasonic irradiation in the presence of HP–Ga complex were studied by means of UV–vis spectrum, fluorescence spectrum and gelatin electrophoresis. In addition, some influence factors such as ultrasonic irradiation time, HP–Ga complex concentration, ionic strength and solution acidity on the damage of DNA were also considered. Under a certain condition, the damage degree of DNA was enhanced with increasing ultrasonic irradiation time, HP–Ga complex concentration and ionic strength. Whether the pH value was too high or too low, it would be disadvantage to the damage of DNA. Perhaps, these results would be significant for driving sonodynamic treatment (SDT) to the clinic application in the future.     

Ex-situ prepared films of 4-aminothiophenol on Au(1 1 1): photoemission, NEXAFS and STM measurements

Ex-situ prepared films of 4-aminothiophenol (4-ATP) on Au(1 1 1) have been studied by core-level photoemission using synchrotron radiation, ultra-high-vacuum scanning tunneling microscopy and spectroscopy (UHV-STM, STS), and X-ray absorption (NEXAFS). Photoemission measurements suggest that the film contains a relatively low percentage of 4-ATP bonded to the Au surface, with the presence of free 4-ATP, with oxidised and possibly dimerised molecules also present. We find a lower oxide content than has previously been observed, with well-resolved STM images. These images show a disruption of the long range order of the Au(1 1 1)-(22 × √3) reconstruction, with local nucleation of the reconstruction apparently induced by the 4-ATP, and bias-dependent contrast images. This latter effect, together with the asymmetry observed in STS, is ascribed to the presence of oriented molecular dipole layers between the metal and the organic material. NEXAFS data suggest a broadly upright geometry, with, however, considerable uncertainties.     

Nd:Ca4ReO(BO3)3(Re=Gd,Y)晶体最佳激光、最佳倍频及最佳自倍频方向的确定

介绍了Nd:Ca4ReO(BO3)3(Re=Gd,Y)晶体最佳激光方向、最佳倍频方向的确定.综合考虑激光受激发射截面、抽运光吸收系数、有效非线性系数的各向异性,分析了自倍频性质的空间分布,并就此确定出最佳自倍频方向 关键词： Nd:Ca4ReO(BO3)3(Re=Gd Y)晶体 激光发射 倍频 自倍频     

含氮氟化类金刚石(FN-DLC)薄膜的研究：(Ⅱ)射频功率对薄膜光学带隙的影响

以CF₄,CH₄和N₂为源气体，采用射频等离子体增强化学气相沉积法，在不同射频功率下制备了含氮氟化类金刚石薄膜样品.原子力显微形貌显示，低功率下沉积样品表面致密均匀.拉曼及傅里叶变换红外光谱分析显示，随着射频功率的改变，薄膜的结构和组分也随之变化.紫外-可见光透射光谱证明薄膜具有紫外强吸收特性，通过计算得到其光学带隙在1.89—2.29 eV之间.结果表明，射频功率增加，薄膜内sp²C含量增加，或者说C=C交联相对浓度增加、F的相对浓度降低，导致薄膜内π-π^*带边态密度增大，光学带隙减小. 关键词： 含氮氟化类金刚石薄膜 射频功率 光学带隙