Determination of elemental levels in radiopharmaceuticals by instrumental neutron activation analysis

Instrumental neutron activation analysis (INAA) was applied to thedetermination of the concentration levels of Na, Mg, Al, Cl, K, Sc, Ti, V,Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Se, Br, Rb, Sr, Zr, Mo, Ag, Cd, Sb, I, Cs,Ba, La, Ce, Nd, Sm, Eu, Tb, Dy, Yb, Lu, Hf, Ta, Hg, Th and U in three radiopharmaceuticals.The irradiation of the samples was carried out in a 0.5 kW Bariloche RA-6Research Nuclear Reactor and the induced gamma-activity was measured by gamma-spectrometry.INAA proves to be an accurate and precise technique to obtain a quick informationon the concentration levels of several minor and trace components in radiopharmaceuticals.The quantification of heavy toxic elements is required for the registrationof radiopharmaceuticals.     

Determination of thorium concentrations in soil and sand samples using instrumental neutron activation analysis

Thorium along with its daughter products present in the soil is one of the major contributors to the external gamma dose in the environment. To establish the dose levels, quantification of thorium contents in soil samples is very important. As a part of pre-operational environmental radiological surveillance, a total of 23 soil and six sand samples were collected from different locations around the proposed nuclear power plant site of Jaitapur, Maharashtra. Thorium concentrations in these samples were determined by instrumental neutron activation analysis (INAA). Samples were irradiated with neutrons in Apsara reactor at a neutron flux of?~5?×?10¹¹ cm^?2 s^?1 and radioactive assay was carried out using high resolution gamma ray spectrometry. Relative method of INAA was used for quantification of thorium utilizing 311.9?keV gamma ray of ²³³Pa, the daughter product of ²³³Th. The concentrations of thorium in the soil and sand samples were in the ranges of 4.0?C18.8 and 1.2?C6.2?mg?kg^?1 respectively.     

Intercomparison and determination of environmental standard samples by instrumental neutron activation analysis

To identify and improve the analytical technique for air pollution research, four kinds of environmental standard samples, i.e., airbome particulate matter, coal flyash, soil and pine needle supplied from the NIST and the IAEA were analyzed using thermal and epithermal neutron activation techniques. Sample irradiation was done at the irradiation facilities (neutron flux, 1 · 10¹³ n·cm^–2·s^–1) of the TRIGA MARK-III Research Reactor in the Korea Atomic Energy Research Institute. The accuracy and precision for the analysis of 40 trace and toxic elements in the samples were compared with the certified and reported values, respectively. In the analytical results of all standard reference materials, the relative standard deviation were within the 15% except for 11 elements and the relative error were agreed within the 10–20% except for 13 elements. The benefit of epithermal activation was investigated and the optimum analytical condition is reported.     

Determination of 22 elements in geological samples by instrumental neutron activation analysis

An instrumental neutron activation analysis (INAA) method has been developed for multi-element determination in geological samples. The INAA method consists of irradiation of samples for 90 sec at a flux of 1.0·10¹² n·cm⁻²·sec⁻¹ and determination of 12 elements by using their short-lived nuclides. Samples have been re-irradiated for 3 hrs for measuring concentrations of another 10 elements. Precision and accuracy of the INAA method have been evaluated by analysing samples and USGS standard reference materials. Precision and accuracy are within±15% and ±10%, respectively.     

Determination of elemental levels in medicinally important Indian leaves by instrumental neutron activation analysis

Levels of As, Ba, Br, Ca, Ce, Cl, Cr, Cs, Eu, Fe, Hg, I, K, La, Mg, Mn, Na, Ni, Rb, Sb, Sc, Sm, Sr, Th, Zn, and U have been determined in ten leaves widely used in ayurvedic medicine by instrumental neutron activation analysis (INAA). The neutron irradiations were performed with a 100 kW Triga nuclear reactor and the induced activity was counted with a gamma-ray spectrometer. Based on elemental levels obtained the utility of these leaves in medicine are discussed.     

Rare-earth elemental analysis of banded iron-formations by instrumental neutron activation analysis

Representative banded iron-formations (BIFs) from various locations of the eastern Indian geological belt were investigated by instrumental neutron activation analysis (INAA). After pre-concentration, irradiation was carried out using a neutron flux of 5.1·10¹⁶ m⁻²·s⁻¹, 1.0·10¹⁵ m⁻²·s⁻¹ and 3.7·10¹⁵ m⁻²s⁻¹, with thermal, epi-thermal and fast neutrons, respectively. The activities in these samples were measured by a HPGe detector. Ten rare-earth elements, such as La, Ce, Nd, Sm, Eu, Tb, Ho, Tm, Yb and Lu, have been qualitatively identified and quantitatively estimated in these samples. The present investigation is an example of employing a pre-concentration method for high iron-containing ores prior to neutron activation analysis.     

Determination of trace elements in carbonate reference samples by instrumental neutron activation analysis

Twenty elements (Sm, U, As, Sb, La, Ce, Yb, Th, Cr, Eu, Hf, Ba, Cs, Tb, Sc, Rb, Fe, Zn, Ta, Co) have been determined by instrumental neutron activation analysis in GSJ/AIST carbonate reference samples, JCp-1 (Coral) and JCt-1 (Giant Clam), together with JLk-1 (Lake Sediment), JDo-1 (Dolomite) and JLs-1 (Limestone) reference samples.     

Determination of aluminium contents in selected food samples by instrumental neutron activation analysis

Food and food products are the main sources of Aluminium entering the human body. In order to know aluminium contents in food and food products, selected 26 samples from local market were analyzed by instrumental neutron activation analysis (INAA) using reactor neutrons and high resolution gamma-ray spectrometry. INAA using 1,779 keV γ-ray of ²⁸Al (2.24 min) was used for aluminium concentrations in the range of 33–529 mg kg^?1. Two NIST standard reference materials (SRMs) and two IAEA reference materials (RMs) were analyzed by INAA for quantification of aluminium as a part of method validation.     

Determination of the elemental distribution in cigarette components and smoke by instrumental neutron activation analysis

Cigarette smoking is a major source of particles released in indoor environments. A comprehensive study of the elemental distribution in cigarettes and cigarette smoke has been completed. Specifically, concentrations of thirty elements have been determined for the components of 15 types of cigarettes. Components include tobacco, ash, butts, filters, and cigarette paper. In addition, particulate matter from mainstream smoke (MS) and sidestream smoke (SS) were analyzed. The technique of elemental determination used in the study is instrumental neutron activation analysis. The results show that certain heavy metals, such as As, Cd, K, Sb and Zn, are released into the MS and SS. These metals may then be part of the health risk of exposure to smoke. Other elements are retained, for the most part, in cigarette ash and butts. The elemental distribution among the cigarette components and smoke changes for different smoking conditions.     

Evaluation of soil to tea plant elemental correlation using instrumental neutron activation analysis

Instrumental neutron activation analysis using relative and k ₀-based internal monostandard methods were employed for determination of concentrations of 12 elements in soil and tea plants collected from three different tea producing regions in India namely Assam, Darjeeling and Kangra. A total of 17 tea leaf samples along with corresponding soil samples were analyzed for elemental content. The obtained concentration data was used for the soil–plant elemental correlation studies. Positive correlation was observed between elemental concentrations of tea plants and the associated soil with Pearson correlation coefficient values in the range 0.6–0.9 for ten elements. Variations in transfer factor values were also observed according to the geo-chemical variation.     

Determination of lithium by instrumental neutron activation analysis

The fast transfer system in the DR 2 reactor for irradiation at a thermal neutron flux density of 10¹³ n·cm⁻²·sec⁻¹ was used for the determination of lithium by the⁷Li(n, γ)⁸Li reaction. β-counting with a large perspex Cerenkov detector begun at 0.3 s after the end of irradiation, and multi-scaler data was accumulated in 300 channels at 0.1 s per channel. With a suitable choice of discrimination level only¹⁶N and background interfere, and the 0.84 s half-life of⁸Li was resolved by the method of weighted least squares. Results are presented for 36 international geochemical reference materials, and for a few biological samples, including BOWEN's kale and the NBS Standard Reference Material 1571 Orchard Leaves.     

Determination of trace element concentrations of indian cigarette tobacco by instrumental neutron activation analysis

Lung cancer and smoking are associated. Epidemiological studies show that not only lung cancer but other chest diseases have causative relationship with smoking. Cigarette tobacco and smoke contains many carcinogens. Inorganic and metallic constituents of cigarette tobacco and smoke have not been studied as extensively as the organic compounds. Since some of the metals are highly toxic and also carcinogenic, authors have attempted to measure the levels of some of the trace elements of Indian tobacco by instrumental neutron activation analysis, and compared the results with the tobacco of America, Germany, Iran and New Zealand.     

Rapid determination of antimony in biological and environmental samples using instrumental neutron activation analysis

A rapid non-destructive activation analysis method has been developed for the determination of antimony. A high resolution low energy Ge detector is used to measure the 61.6 keV γ-ray from^122mSb (T=4.2 min). Sensitivities and detection limits for biological and environmental samples activated with thermal and epithermal neutrons are listed. The time required for the anlaysis is about 12 min per sample using thermal activation and 22 minutes using epithermal activation analysis.     

Determination of picogram amounts of technetium in environmental samples by neutron activation analysis

A procedure for the determination of trace amounts of ⁹⁹Tc in filter paper and vegetation samples by neutron activation analysis has been developed. The procedure consists of the following major steps: (a) pre-irradiation separation of technetium from the sample and purification of the technetium fraction; (b) thermal neutron irradiation of the ⁹⁹Tc fraction to produce ¹⁰⁰Tc ; (c) post-irradiation separation and purification of ¹⁰⁰Tc from other activated nuclides: (d) counting of the 16-sec ¹⁰⁰Tc in a low-background β-counter.

The estimated detection limits for ⁹⁹Tc by this procedure with irradiations at a thermal neutron flux of about 5.10¹³ n cm^-2 sec^-1 are: 5.lO^-12g ⁹⁹Tc in filter paper samples, and 9. 10^-12 g ⁹⁹Tc in vegetation samples.     

Determination of aluminium in lutetium by instrumental neutron activation analysis

In lutetium metal 45 ppm aluminium have been determined by instrumental neutron activation analysis. Interference from the very intensive γ-radiation of^176mLu was eliminated by application of lead filters. The determination limit of the method was estimated to be 0.7 μg or 3 ppm Al.     

Determination of the elemental contents in stream sediments collected from Cheongju city by instrumental neutron activation analysis

Sediment samples were collected from seven locations of the MeeHo stream in Cheongju city, strained out by a sieve, dried by an oven and pulverized by an agate mortar. Instrumental neutron activation analysis (INAA) was applied for the determination of the elemental contents in the sediment samples by using the NAA #1 and #2 irradiation holes of the HANARO research reactor and HPGe gamma-ray spectrometers. Twenty-five elements were determined by a relative method with NIST SRM 2711-Montan Soil and the ranges of the elemental contents for the seven locations were identified. The contamination levels for elements such as As, Ba, Cr, Mn, Fe and Zn were compared with the guidelines of USEPA. The detection limits and combined uncertainties for the hazardous elements such as As, Ba, Cr, Mn, Sb, V and Zn were estimated under the given analytical conditions.     

Determination of the total amount of organically bound chlorine,bromine and iodine in environmental samples by instrumental neutron activation analysis

The determination of chlorine, bromine and iodine present as non-polar, hydrophobic hydrocarbons in environmental samples is reported. The organohalogen compounds are separated from water into an organic phase by on-site liquid—liquid extraction, and from biological material by procedures based on lipid phase extraction and codistillation. After removal of inorganic halides by washing with water and concentration of the sample by evaporation of the solvent, the resulting extracts are analyzed for their chlorine, bromine and iodine contents by instrumental neutron activation analysis. Strict attention is paid to the possibility of contamination in every step of the procedure. Background values in routine analysis are approximately 100–200 ng of chlorine, <5 ng of bromine and <3 ng of iodine.     

Determination of phosphorus by instrumental neutron activation and bremsstrahlung measurement in bone samples

The application of charge plate technique in studying the recoil reactions of¹²⁸I species originating from iodoform following neutron capture in pyridine medium is discussed emphasis being placed on the problem of reactions of energetic iodine species with the radiolytically generated quasi-free electrons. Ag/AgI electrodes, under a potential gradient of 83 V·cm^–1 are employed in collecting the nucleogenic iodine species from the irradiated iodoform-pyridine mixtures. It is observed that only¹²⁸I^– species are deposited on the anode plate showing a fairly high order of radioactivity. Collected activities are increased with increasing concentration of iodoform in the system, however, no¹²⁸I^– species are deposited on cathode surface and the activities are found nil upto the concentration range studied. It could be deduced that the recoil reactions taking place in pure iodoform are specifically influenced by the chemical reactivity of pyridine thereby govems the electrode deposition pattem in iodoform-pyridine molecular liquid mixtures.Part III:M. R. Zaman, S. P. Mishra, J. Chem. Soc. Pakistan, 16 (1994) 163.Work done in the Department of Chemistry, Banaras Hindu University, India, while holding a Fellowship of the Department of Human Resource Development, Govemment of India.