The azoles: effective catalysts for Baylis-Hillman reaction in basic water solution

The azoles, which were inactive in neutral aqueous media, could be activated in alkaline solution and effectively catalyze the Baylis-Hillman reaction involving cyclic enones.     

Acylation of aromatic ethers over solid acid catalysts: scope of the reaction with more complex acylating agents

Acylation of anisole with 2-phenylbutanoic acid derivatives, over zeolite catalysts, gives the corresponding 4-acyl derivatives with high regioselectivity. In an analogous way, 2,3-dihydrobenzofuran reacts with acid anhydrides or chlorides in the presence of catalytic quantities of zeolites to give the corresponding 5-acyl-2,3-dihydrobenzofurans. The zeolite can be recovered, regenerated and used again to give almost the same yield as with fresh zeolite. The reaction has been applied to the synthesis of ethyl (2,3-dihydrobenzofuran-5-yl)glyoxylate.     

An unexpected inversion of enantioselectivity in the proline catalyzed intramolecular Baylis-Hillman reaction

A highly enantioselective proline catalyzed intramolecular Baylis-Hillman reaction of hept-2-enedial is reported. Addition of imidazole to the mixture results in an unusual inversion of enantioselectivity.     

Selenide ions as catalysts for homo- and crossed-Tishchenko reactions of expanded scope

Selenide ions have been shown to catalyze the Tishchenko reaction for the first time. These catalysts are superior to previously reported thiolate analogues and promote the disproportionation of aldehydes with increased reaction rates and broader scope at lower catalyst loadings and temperatures. Significantly improved catalyst performance was also observed in the aryl selenide mediated crossed intermolecular Tishchenko reaction.     

Correlation between pK(a) and reactivity of quinuclidine-based catalysts in the Baylis-Hillman reaction: discovery of quinuclidine as optimum catalyst leading to substantial enhancement of scope

The reactivity of a variety of quinuclidine-based catalysts in the Baylis-Hillman reaction has been examined, and a straightforward correlation between the basicity of the base and reactivity has been established, without exception. The following order of reactivity was established with pK(a)'s of the conjugate acids (measured in water) given in parentheses: quinuclidine (11.3), 3-hydroxyquinuclidine (9.9), DABCO (8.7), 3-acetoxyquinuclidine (9.3), 3-chloroquinuclidine (8.9), and quinuclidinone (7.2). The higher than expected reactivity of DABCO, based on its pK(a), was analyzed by comparing the relative basicity of DABCO and 3-acetoxyquinuclidine in DMSO. It was found that in aprotic solvent, DABCO was 0.6 pK(a) units more basic than 3-acetoxyquinuclidine, thus establishing a direct link between pK(a) of the amine and its reactivity. In contrast to previous literature work that reported the contrary, quinuclidine, which has the highest pK(a), was found to be the most active catalyst. The reaction profile with quinuclidine showed significant autocatalysis, which suggested that the presence of proton donors might further enhance rates. Thus, a series of additives bearing polar X-H bonds were investigated and it was found that methanol, triethanolamine, formamide, and water all provided additional acceleration. Methanol was found to be optimum, and the powerful combination of quinuclidine with methanol was tested with a host of aldehydes and Michael acceptors. Not only were the reactions more efficient and faster than previously reported, but now new substrates that were previously unreactive could be employed. Notable examples include the use of acetylenic aldehydes and the employment of vinyl sulfones, acrylamides, delta-lactones, and even alpha,beta-unsaturated esters bearing a beta-substituent.     

Remarkable rate acceleration of imidazole-promoted Baylis-Hillman reaction involving cyclic enones in basic water solution

The Baylis-Hillman reaction of cyclic enones was greatly accelerated in basic water solution with imidazoles as catalysts, which resulted in short reaction time, high yields, and expanding substrate scopes. Bicarbonate solution was shown to be the optimal reaction medium for the reaction in this study. The apparent "enhanced basicity" of imidazoles accounted for the rate increase in alkaline solution.     

Catalysis in competing isocyanate reactions. I. Effect of organotin–tertiary amine catalysts on phenyl isocyanate and N-butanol reaction

An analytical method based on high performance liquid chromatography (HPLC) has been developed to investigate the competing isocyanate reactions under the influence of various catalysts. The kinetics of the model reaction between phenyl isocyanate and n-butanol was studied in acetonitrile at 50°C. Effects of various catalysts such as an organotin compound, dibutyltin dilaurate, and tertiary amines, 1,4-diazabicyclo-(2,2,2)octane,N,N′,N″-pentamethyldiprophylene triamine,N,N′N″-tris(3-dimethyl-aminopropyl)-3-hexahydrotriazine, and N,N,N′-trimethylaminoethyl-ethanolamine on the reaction rate and the formation of reaction products were investigated. The reactions were followed by determining the NCO disappearance using the standard di-n-butylamine back-titration method as well as measuring the formation of various reaction products using the HPLC method. The relative specificity of a catalyst in isocyanate reactions can thus be determined from the profile of the model reaction which depends upon the structure of the catalyst employed.     

Second generation fluorous DEAD reagents have expanded scope in the Mitsunobu reaction and retain convenient separation features

First generation fluorous DEAD reagent bis(perfluorohexylethyl)azo dicarboxylate (C(6)F(13)(CH(2))(2)O(2)CN=NCO(2)(CH(2))(2)C(6)F(13), F-DEAD-1) has been shown to underperform relative to diisopropylazodicarboxylate in difficult Mitsunobu reactions involving hindered alcohols or less acidic pronucleophiles (phenols). Two new second generation fluorous reagents bearing propylene spacers instead of the ethylene spacers show expanded reaction scope while retaining the easy fluorous separation features. Byproducts from "half fluorous" reagent perfluorooctylpropyl tert-butyl azo dicarboxylate (C(8)F(17)(CH(2))(3)O(2)CN=NCO2(t)Bu, F-DEAD-2) can be removed by fluorous flash chromatography, and byproducts from bis(perfluorohexylpropyl)azo dicarboxylate (C(6)F(13)(CH(2))(3)O(2)CN=NCO(2)(CH(2))(3)C(6)F(13), F-DEAD-3) can be removed by fluorous solid-phase extraction. The new reagents promise to provide general and complementary solutions for separation problems in Mitsunobu reactions without restricting reaction scope.     

Aminocatalysis of the Baylis-Hillman reaction: an important solvent effect

Examination of the aminocatalytic Baylis-Hillman reaction in the presence of proline and imidazole has revealed that water plays a crucial role in the acceleration of the reaction, allowing for excellent yields of the adduct between methyl vinyl ketone and a variety of aldehydes.     

Water-gas-shift reaction over nickel catalysts: DFT studies and kinetic modeling

Structural Chemistry - Density functional theory (DFT) calculations were used to study the mechanism of water gas shift (WGS) reaction on Ni (111) surfaces. Three sets of elementary reactions based...     

The kinetics of oxirane reaction with alkanethiols in the presence of basic catalysts

Rate constants for the reactions of oxirane with alkanethiols in the presence of basic catalyst were studied at the temperature range of 20–50°C. A mechanism of these reactions has been proposed and appropriate kinetic equation has been presented.     

Direct sulfonylation of Baylis-Hillman alcohols and diarylmethanols with TosMIC in ionic liquid-[Hmim]HSO4: an unexpected reaction

A Brønsted acidic ionic liquid-[Hmim]HSO₄ promoted unexpected reaction of Baylis-Hillman alcohols and diarylmethanols with p-toluenesulfonylmethyl isocyanide (TosMIC) affording the corresponding sulfone derivatives instead of N-tosylmethyl amides is reported. After isolation of the product, the ionic liquid [Hmim]HSO₄ was easily recycled for further use.     

叔胺类环钯化合物在催化Heck反应的应用

首次报道了叔胺类环钯化合物1～4在催化Heck反应中的应用。实验表明该类化合物能高效地催化Heck反应;其中催化剂4的TON值(产品摩尔数与钯摩尔数的比值)和TOF值(产品摩尔数与钯摩尔数以及反应时间的比值)分别高达9.6×10^6和8.7×10^5)。这上迄今为止催化Heck反应的最好结果。     

Toward understanding the scope of Baylis-Hillman reaction: synthesis of 3-(2- hydroxyphenyl)indolin-2-ones and polycyclic fused furans

A facile one-pot synthesis of 3-(2-hydroxyphenyl)indolin-2-ones has been developed via the TiCl₄-mediated Baylis-Hillman (B-H) reaction of N-substituted isatins and cyclohex-2-enone, followed by treatment of the in situ generated B-H alcohols with aq HBr. Baylis-Hillman reaction of aromatic cyclic 1,2-diones with cycloalk-2-enones under the influence of TiCl₄ has been successfully performed and the resulting Baylis-Hillman adducts have been conveniently transformed into pentacyclic and hexacyclic fused furan derivatives.     

特定碱性MgO纳米晶暴露晶面上铁基催化剂及其费-托合成反应的研究

本研究采用等量浸渍法、化学沉淀法和超声浸渍法合成了一系列具有良好外露晶面的Fe/MgO催化剂。采用X射线粉末衍射、高分辨透射电子显微镜、CO₂程序升温脱附、H₂程序升温还原、X射线光谱学和N₂物理吸附等物理化学方法对催化剂进行了表征。MgO纳米晶载体的碱性会影响费-托合成产物的选择性。在超声浸渍过程中,MgO纳米晶载体的碱性得到了保持。研究结果显示,Fe/MgO催化剂的碱性会提高CO解离速率和产物中烯烃的选择性。此外,相比于MgO（100）晶面,MgO（111）晶面负载铁基催化剂具有更高的活性（TOF）和烯烃选择性。MgO（111）晶面上更有利于CO的吸附,抑制二次加氢反应,提高产物中烯烃的收率。     

The study of esterifying reaction between epoxy resins and carboxyl acrylic polymers in the presence of tertiary amine

In this article, the fixed gel/nongel point and critical gel point experiments are designed for formulating the regulation of esterification reaction between epoxy resin and carboxyl acrylic polymer in the presence of tertiary amine in organic solvent. Ternary diagrams are employed to illustrate experimental results. It is disclosed that some factors, such as mole ratio of the ternary reactants, molecular weight of epoxy resin, even the hydrophilic solvent content of system, play important roles in the gelling effect of esterification reaction. In order to explain these experimental results, a suggested reaction process is put forward and, subsequently, a critical gel equation is derived from Carothers gelation theory. The equation provides an explicit connection between the critical gel composition and the relevant parameters of the reaction system such as average carboxyl functionality of acrylic resin, average molecular weight of epoxy resin, the base intensity of tertiary amine, and the solid content of system. The regressive critical gel curve based on the equation is well consistent with the experiment data. It expresses that the suggested reaction process is reasonable. Finally, based on the critical gel equation, the important factors that influence the esterification result are discussed qualitatively. All the achievements are beneficial to understanding the reaction process and avoiding useless gelation in preparing the water-reducible compositions.     

Copper(II) carboxylate promoted intramolecular diamination of terminal alkenes: improved reaction conditions and expanded substrate scope

The copper(II) carboxylate promoted diamination reaction has been improved by the use of the organic soluble copper(II) neodecanoate [Cu(ND)2]. Cu(ND)2 allowed the less-polar solvent dichloroethane (DCE) to be used, and as a consequence, decomposition of less-reactive substrates could be avoided. High diastereoselectivity was observed in the synthesis of 2,5-disubstituted pyrrolidines. Ureas, bis(anilines), and alpha-amido pyrroles derived from 2-allylaniline could also participate in the diamination reaction.