Electrogenerated chemiluminescence of lucigenin in aqueous alkaline solutions at a platinum electrode

Lucigenin is shown to emit light during electrolysis in aqueous alkaline solutions at a platinum electrode. In the mechanism proposed, lucigenin is initially reduced at —0.30 V vs. Ag/AgCl and subsequently the reaction product reacts either with oxygen or a reduction product of oxygen. Previous evidence on this phenomenon is contradictory.     

Electrogenerated chemiluminescence from CdS nanotubes and its sensing application in aqueous solution

Electrogenerated chemiluminescence (ECL) of CdS nanotubes in aqueous solution and its sensing application were studied by entrapping the CdS nanotubes in carbon paste electrode. Two ECL peaks were observed at −0.9 V (ECL-1) and −1.2 V (ECL-2), respectively, when the potential was cycled between 0 and −1.6 V. The electrochemically reduced nanocrystal species of CdS nanotubes could collide with the oxidized species in an annihilation process to produce the peak of ECL-1. The electron-transfer reaction between the reduced CdS nanocrystal species and oxidant coreactants such as S₂O₈²⁻, H₂O₂, and reduced dissolved oxygen led to the appearance of the ECL-2 peak. Based on the enhancing effect of H₂O₂ on ECL-2 intensity, a novel CdS ECL sensor was developed for H₂O₂ detection. The sensor exhibited a detection limit of 0.1 μM and a linear range from 0.5 μM to 0.01 mM. The relative standard deviations of five replicate determinations of 5 μM H₂O₂ was 2.6%. In addition, the ECL spectrum in aqueous solution also exhibited two peaks at 500 and 640 nm, respectively.     

Electrogenerated chemiluminescence from Au nanoclusters

Electrogenerated chemiluminescence (ECL) of Au clusters is observed for the first time using triethyamine (TEA) as the coreactant. The potential application of ECL Au clusters in analytical chemistry is also demonstrated using Pb(2+) as an example.     

Electrogenerated chemiluminescence for potentiometric sensors

We report here on a generic approach to read out potentiometric sensors with electrogenerated chemiluminescence (ECL). In a first example, a potassium ion-selective electrode acts as the reference electrode and is placed in contact with the sample solution. The working electrode of the three-electrode cell is responsible for ECL generation and placed in a detection solution containing tris(2,2'-bipyridyl)ruthenium(II) [Ru(bpy)(3)(2+)] and the coreactant 2-(dibutylamino)ethanol (DBAE), physically separated from the sample by a bridge. Changes in the sample potassium concentration directly modulate the potential at the working electrode, and hence the ECL output, when a constant-potential pulse is applied between the two electrodes. A linear response of the ECL intensity to the logarithmic potassium concentration between 10 μm and 10 mM was found.     

Electrogenerated chemiluminescence from thiol-capped CdTe quantum dots and its sensing application in aqueous solution

In this paper, the electrogenerated chemiluminescence (ECL) from thiol-capped CdTe quantum dots (QDs) was reported. The ECL emission was occurred at −1.1 V and reached a maximum value at −2.4 V when the potential was cycled between 0.0 and −2.5 V. The reduced species of CdTe QDs could react with the coreactants to produce the ECL emission. The CdTe QD concentration (6.64 × 10⁻⁷ mol L⁻¹) of ECL is lower than that (1.0 × 10⁻³ mol L⁻¹) of chemiluminescence (CL). Based on the enhancement of light emission from thiol-capped CdTe QDs by H₂O₂ in the negative electrode potential, a novel method for the determination of H₂O₂ was developed. The light intensity was linearly proportional to the concentration of H₂O₂ between 2.0 × 10⁻⁷ and 1.0 × 10⁻⁵ mol L⁻¹ with a detection limit of 6.0 × 10⁻⁸ mol L⁻¹. Compared with most of previous reports, the proposed method has higher sensitivity for the determination of H₂O₂. In addition, the ECL spectrum of thiol-capped CdTe QDs exhibited a peak at around 620 nm, which was substantially red shifted from the photoluminescence (PL) spectrum, suggesting the surface states play an important role in this ECL process.     

Electrogenerated chemiluminescence detection of single entities

Electrogenerated chemiluminescence, also known as electrochemiluminescence (ECL), is an electrochemically induced production of light by excited luminophores generated during redox reactions. It can be used to sense the charge transfer and related processes at electrodes via a simple visual readout; hence, ECL is an outstanding tool in analytical sensing. The traditional ECL approach measures averaged electrochemical quantities of a large ensemble of individual entities, including molecules, microstructures and ions. However, as a real system is usually heterogeneous, the study of single entities holds great potential in elucidating new truths of nature which are averaged out in ensemble assays or hidden in complex systems. We would like to review the development of ECL intensity and imaging based single entity detection and place emphasis on the assays of small entities including single molecules, micro/nanoparticles and cells. The current challenges for and perspectives on ECL detection of single entities are also discussed.

We summarize the history and recent development that has been made in the ECL detection of single entities.     

电化学发光法测定盐酸普鲁卡因

基于盐酸普鲁卡因对鲁米诺在中性介质中铂电极上电化学发光的催化增敏作用 ,建立了测定盐酸普鲁卡因电化学发光新方法。电化学发光强度与盐酸普鲁卡因质量浓度在 4 .0× 1 0 -7～6 .0× 1 0 -6g mL范围内有良好的线性关系 ,检测限为 2 .0× 1 0 -7g mL,相对标准偏差为 4 .4 %。该方法已用于针剂中盐酸普鲁卡因的测定     

Electrogenerated chemiluminescence in an electrodeposited redox hydrogel

We report the electrodeposition, under physiological conditions, of an electrochemiluminescent (ECL) Ru^2+/3+ complex-containing redox hydrogel. The ECL-hydrogels were formed by potential cycling of a solution of [poly(4-vinylpyridine)Ru(2,2′-bipyridine)²Cl^?]^+/2+, its un-coordinated backbone pyridines partially quaternized with bromoethylamine for solubility in water and for swelling to a hydrogel after crosslinking. The polymer was electrosorbed on plasma-oxidized graphite in the anodic half of the cycle and irreversibly crosslinked, to form a swelling but insoluble film, in the cathodic half cycle. The ECL resulted of the chemical reaction of electro-oxidatively produced tri-n-propylamine-radical with the hydrogel’s Ru²⁺ centers. The emission spectra of the photo-excited films and their ECL spectra were identical. The ECL-emission increased one thousand-fold, linearly with the tri-n-propylamine (TPrA) concentration, between 100 nM and 0.1 mM.     

Electrogenerated chemiluminescence induced by sequential hot electron and hole injection into aqueous electrolyte solution

Hole injection into aqueous electrolyte solution is proposed to occur when oxide-coated aluminum electrode is anodically pulse-polarized by a voltage pulse train containing sufficiently high-voltage anodic pulses. The effects of anodic pulses are studied by using an aromatic Tb(III) chelate as a probe known to produce intensive hot electron-induced electrochemiluminescence (HECL) with plain cathodic pulses and preoxidized electrodes. The presently studied system allows injection of hot electrons and holes successively into aqueous electrolyte solutions and can be utilized in detecting electrochemiluminescent labels in fully aqueous solutions, and actually, the system is suggested to be quite close to a pulse radiolysis system providing hydrated electrons and hydroxyl radicals as the primary radicals in aqueous solution without the problems and hazards of ionizing radiation. The analytical power of the present excitation waveforms are that they allow detection of electrochemiluminescent labels at very low detection limits in bioaffinity assays such as in immunoassays or DNA probe assays. The two important properties of the present waveforms are: (i) they provide in situ oxidation of the electrode surface resulting in the desired oxide film thickness and (ii) they can provide one-electron oxidants for the system by hole injection either via F- and F⁺-center band of the oxide or by direct hole injection to valence band of water at highly anodic pulse amplitudes.     

Electrogenerated chemiluminescence of single conjugated polymer nanoparticles

We demonstrate a novel and powerful method to study electrogenerated chemiluminescence (ECL) of single nanoparticles (NPs) (r = 25 +/- 15 nm) of a conjugated polymer, F8BT, on an ITO electrode in the presence of a co-reactant, such as tri-n-propylamine (TPrAH) in acetonitrile solution. The results reveal that the maximum formation rate of ECL of individual NPs is achieved after a long "build-up" time (10-40 s after pulse application). The high number of detected ECL photons from individual NPs (1500 photons during 100 s) highlights the potential of this technique as a very sensitive analytical method. Additionally, TPrAH acts as a very efficient protecting agent against irreversible electrochemical processes occurring in F8BT, as found in photoluminescence studies. This protection mechanism probably involves the neutralization of holes at the particle surface via electron transfer by both TPrAH and TPrA radical (TPrA*).     

The mechanism of the electrogenerated chemiluminescence of luminol in aqueous alkaline solution

The mechanism of the electrogenerated chemiluminescence of luminol in aqueous alkaline solution based on the rotating ring—disc electrode system is discussed. The disc electrode is maintained at a negative potential and the ring electrode at a symmetrically changing double-step potential. Hydrogen peroxide generated at the disc electrode by the reduction of oxygen is immediately transported to the ring electrode because of electrode rotation. Hydrogen peroxide and luminol are oxidized at the ring electrode during the positive pulse of the double-step potential. These oxidation processes generate a superoxide radical and a luminol radical as intermediates. The luminol radical reacts with the superoxide radical (or oxygen) emitting light.     

The autoreduction of pertechnetate in aqueous,alkaline solutions

Summary The autoreduction of pertechnetate (⁹⁹TcO₄^-) to Tc(IV/V) alkoxide complexes in aqueous, alkaline, solutions is described. Solutions of sodium pertechnetate (0.01M) reacted with nitrogen and oxygen donor ligands (1.0M) in 2M sodium hydroxide. Solutions containing nitrogen donor ligands (e.g., EDTA) showed the initial formation of lightly colored complexes followed by rapid decomposition in air. In contrast, stable, reduced complexes were formed within minutes of mixing pertechnetate with mono- and disaccharides in strong base, as indicated by a persistent color change. Chemical yields of these reactions were determined by thin layer chromatography or paper chromatography and radiochemically assayed with a Bioscan imaging scanner. Analysis by UV-vis spectroscopy suggested that Tc(IV) or Tc(V) complexes were produced, with the oxidation state dependent on the reducing ligand. These experiments may help explain the reduction of pertechnetate to the soluble complexes that have been found in the Hanford nuclear waste tanks.     

Electrogenerated chemiluminescence of triazole-modified deoxycytidine analogues in N,N-dimethylformamide

Triazole-modified deoxycytidines have been prepared for incorporation into single-stranded deoxyribonucleic acid (ssDNA). Electrochemical responses and electrogenerated chemiluminescence (ECL) of these deoxycytidine (dC) analogues, 1-4, were investigated as the monomers. Cyclic voltammetry and differential pulse voltammetry techniques were used to determine the oxidation and reduction potentials of 1-4, along with the reversibility of their electrochemical reactions. The dC analogues, in N,N-dimethylformamide containing 0.1 M tetra-n-butylammonium perchlorate as electrolyte, exhibited weak relative ECL efficiencies following the annihilation mechanism, while these efficiencies were enhanced with the use of benzoyl peroxide following the coreactant mechanism. It was shown that these nucleosides could generate excited monomers, and excimers as seen by the red-shifted ECL maxima relative to their corresponding photoluminescence peak wavelengths.     

Ionic equilibria in alkaline aqueous solutions of metal complex salts

A thermodynamic analysis of the formation conditions of metal hydroxides was performed. The areas of stable formation of metal hydroxide precipitates in the coordinates pH-metal concentration, including also solutions containing various kinds of complexing agents, were evaluated. With the precipitation of cadmium hydroxide as example, X-ray phase analysis confirmed the formation of metal hydroxide in the chemical composition areas where its formation is predicted by a thermodynamic analysis.     

Electrogenerated chemiluminescence aptamer-based biosensor for the determination of cocaine

A novel electrogenerated chemiluminescence aptamer-based (ECL-AB) biosensor for the determination of a small molecule drug is designed employing cocaine-binding aptamer as molecular recognition element for cocaine as a model analyte and ruthenium complex served as an ECL label. A 5′-terminal cocaine-binding aptamer with the ECL label at 3′-terminal of the aptamer was utilized as an ECL probe. The ECL-AB biosensors were fabricated by immobilizing the ECL probe onto a gold electrode surface via thiol-Au interactions. An enhanced ECL signal is generated upon recognition of the target cocaine, attributed to a change in the conformation of the ECL probe from random coil-like configuration on the probe-modified film to three-way junction structure, in close proximity to the sensor interface. The integrated ECL intensity versus the concentration of cocaine was linear in the range from 5.0 × 10⁻⁹ to 3.0 × 10⁻⁷ M. The detection limit was 1.0 × 10⁻⁹ M. This work demonstrates that the combination of a highly binding aptamer to analyte with a highly sensitive ECL technique to design ECL-AB biosensor is a great promising approach for the determination of small molecule drugs.     

Electrogenerated chemiluminescence at bare glassy carbon electrode in basic media

Electrogenerated chemiluminescence (ECL) with three peaks at bare glassy carbon electrode (GCE) was observed as potential scanning between 0 and 2.6 V vs. Ag/AgCl in basic media. The peak potentials were seated at ca. 1.36 V, 1.72 V and 2.34 V in the positive sweeping, denoted as from ECL-I to ECL-III, respectively. Mechanisms of such ECL phenomena were proposed. For ECL-I peaked at 1.36 V, it might attribute to the oxidation of surface functional groups that analogy to alcoholic hydroxyl connected to the skeleton of GCE (S–R–CH₂OH), and the following ECL-II at 1.72 V, to the further oxidation of their products (S–R–CHO) to carbonyl compound (S–R–COO⁻). While for ECL-III at a high positive potential ca. 2.34 V, it was supposed to be related to the formation of singlet O₂ and its further conversion to triplet state.