Thieno[3,4‐b]thiophene‐Based Organic Dyes for Dye‐Sensitized Solar Cells

New dipolar sensitizers containing an ethyl thieno[3,4‐b]thiophene‐2‐carboxylate (ETTC) entity in the conjugated spacer have been synthesized in two isomeric forms. These compounds were used as the sensitizers of n‐type dye‐sensitized solar cells (DSSCs). The best conversion efficiency (5.31 %) reaches approximately 70 % of the N719‐based (7.41 %) DSSC fabricated and measured under similar conditions. The ETTC‐containing compounds exhibit a bathochromic shift of the absorption compared to their thiophene congeners due to the quinoid effect, however, charge‐trapping at the ester group of ETTC was found to jeopardize the electron injection and lower the cell efficiency. Charge trapping is alleviated as the ester group of ETTC is replaced with a hydrogen atom, as evidenced from the theoretical computation.     

Enhanced Performance of Quasi‐Solid‐State Dye‐Sensitized Solar Cells by Branching the Linear Substituent in Sensitizers Based on Thieno[3,4‐c]pyrrole‐4,6‐dione

Thieno[3,4‐c]pyrrole‐4,6‐dione‐based organic sensitizers with triphenylamine ( FNE38 and FNE40 ) or julolidine ( FNE39 and FNE41 ) as electron‐donating unit have been designed and synthesized. A linear hexyl group or a branched alkyl chain, the 2‐ethylhexyl group, is incorporated into molecular skeleton of the dyes to minimize intermolecular interactions. The absorption, electrochemical, and photovoltaic properties for these sensitizers were then systematically investigated. It is found that the sensitizers have similar photophysical and electrochemical properties, such as absorption spectra and energy levels, owing to their close chemical structures. However, the quasi‐solid‐state dye‐sensitized solar cells (DSSCs) based on the two types of sensitizers exhibit very different performance parameters. Upon the incorporation of the short ethyl group on the hexyl moiety, enhancements in both open‐circuit voltage (V_oc) and short‐circuit current (J_sc) are achieved for the quasi‐solid‐state DSSCs. The V_oc gains originating from the suppression of charge recombination were quantitatively investigated and are in good agreement with the experimentally observed V_oc enhancements. Therefore, an enhanced solar energy conversion efficiency (η) of 6.16 %, constituting an increase by 23 %, is achieved under standard AM 1.5 sunlight without the use of coadsorbant agents for the quasi‐solid‐state DSSC based on sensitizer FNE40 , which bears the branched alkyl group, in comparison with that based on FNE38 carrying the linear alkyl group. This work presents a design concept for considering the crucial importance of the branched alkyl substituent in novel metal‐free organic sensitizers.     

Computational Design of Cyclic Nitroxides as Efficient Redox Mediators for Dye‐Sensitized Solar Cells

Cyclic nitroxide radicals represent promising alternatives to the iodine‐based redox mediator commonly used in dye‐sensitized solar cells (DSSCs). To date DSSCs with nitroxide‐based redox mediators have achieved energy conversion efficiencies of just over 5 % but efficiencies of over 15 % might be achievable, given an appropriate mediator. The efficacy of the mediator depends upon two main factors: it must reversibly undergo one‐electron oxidation and it must possess an oxidation potential in a range of 0.600–0.850 V (vs. a standard hydrogen electrode (SHE) in acetonitrile at 25 °C). Herein, we have examined the effect that structural modifications have on the value of the oxidation potential of cyclic nitroxides as well as the reversibility of the oxidation process. These included alterations to the N‐containing skeleton (pyrrolidine, piperidine, isoindoline, azaphenalene, etc.), as well as the introduction of different substituents (alkyl‐, methoxy‐, amino‐, carboxy‐, etc.) to the ring. Standard oxidation potentials were calculated using high‐level ab initio methodology that was demonstrated to be very accurate (with a mean absolute deviation from experimental values of only 16 mV). An optimal value of 1.45 for the electrostatic scaling factor for UAKS radii in acetonitrile solution was obtained. Established trends in the values of oxidation potentials were used to guide molecular design of stable nitroxides with desired ${E{{{\circ}\hfill \atop {\rm ox}\hfill}}}$ , and a number of compounds were suggested for potential use as enhanced redox mediators in DSSCs.     

A Solution‐Processable Molecule using Thieno[3,2‐b]thiophene as Building Block for Efficient Organic Solar Cells

A solution‐processed acceptor‐π‐donor‐π‐acceptor (A‐π‐D‐π‐A) type small molecule, namely DCATT, has been designed and synthesized for the application as donor material in organic solar cells. The fused aromatic unit thieno[3,2‐b]thiophene (TT) flanked with thiophene is applied as π bridge, while 4,8‐bisthienyl substituted benzodithiophene (BDT) and 2‐ethylhexyl cyanoacetate are chosen as the central building block and end group, respectively. Introduction of fused ring to the small molecule enhances the conjugation length of the main chain, and gives a strong tendency to form π–π stacking with a large overlapping area which favors to high charge carrier transport. Small‐molecule organic solar cells based on blends of DCATT and fullerene acceptor exhibit power conversion efficiencies as high as 5.20 % under the illumination of AM 1.5G, 100 mW cm^?2.     

Opp‐Dibenzoporphyrins as a Light‐Harvester for Dye‐Sensitized Solar Cells

New opp‐dibenzoporphyrins were prepared in a concise method that was based on a Pd⁰‐catalyzed cascade reaction. These porphyrins, which contained carboxylic‐acid linker groups on benzene rings that were fused to the porphyrin at their β,β′‐positions, were examined as sensitizers for dye‐sensitized solar cells for the first time. Whereas all of the porphyrins showed solar‐energy‐to‐electricity conversion, an opp‐dibenzoporphyrin with conjugated carboxylic‐acid linkers displayed the highest conversion efficiency and an exceptionally high J_sc value. Cyclic voltammetry of these porphyrins suggested that the fusion of two aromatic benzene rings onto the periphery of the porphyrin lowered the HOMO–LUMO energy gap; the incorporation of a conjugated carboxylic‐acid linker group decreased the HOMO–LUMO gap even further. These CV data are consistent with DFT calculations for these porphyrins and agree well with the UV/Vis absorption‐ and fluorescence spectra of these porphyrins.     

Peripherally and Axially Carboxylic Acid Substituted Subphthalocyanines for Dye‐Sensitized Solar Cells

A series of subphthalocyanines (SubPcs) bearing a carboxylic acid group either at the peripheral or axial position have been designed and synthesized to investigate the influence of the COOH group positions on the dye‐sensitized solar cell (DSSC) performance. The DSSC devices based on SubPcs with axially substituted carboxylic acid groups showed low photovoltaic performance, whereas peripherally substituted one exhibited higher power conversion efficiency owing to improved injection from LUMO of SubPcs to the TiO₂ conduction band.     

The Structure‐property Relationships of D‐π‐A BODIPY Dyes for Dye‐sensitized Solar Cells

BODIPY dyes have attracted considerable attention as potential photosensitizers in dye‐sensitized solar cells (DSSCs) owing to their excellent optical properties and facile structural modification. This account focuses on recent advances in the molecular design of D‐π‐A BODIPY dyes for applications in DSSCs. Special attention has been paid to the structure‐property relationships of D‐π‐A BODIPY dyes for DSSCs. The developmental process in the modified position at the BODIPY core with a donor/acceptor is described. The devices based on 2,6‐modified BODIPY dyes exhibit better photovoltaic performance over other modified BODIPY dyes. Meanwhile, the research reveals the correlation of molecular structures (various donor chromophores, extended units, molecular frameworks, and long alkyl groups) with their photophysical and electrochemical properties and relates it to their performance in DSSCs. The structure‐property relationships give valuable information and guidelines for designing new D‐π‐A BODIPY dyes for DSSCs.

     

Unsymmetric Platinum(II) Bis(aryleneethynylene) Complexes as Photosensitizers for Dye‐Sensitized Solar Cells

Four new unsymmetric platinum(II) bis(aryleneethynylene) derivatives have been designed and synthesized, which showed good light‐harvesting capabilities for application as photosensitizers in dye‐sensitized solar cells (DSSCs). The absorption, electrochemical, time‐dependent density functional theory (TD‐DFT), impedance spectroscopic, and photovoltaic properties of these platinum(II)‐based sensitizers have been fully characterized. The optical and TD‐DFT studies show that the incorporation of a strongly electron‐donating group significantly enhances the absorption abilities of the complexes. The maximum absorption wavelength of these four organometallic dyes can be tuned by various structural modifications of the triphenylamine and/or thiophene electron donor, improving the light absorption range up to 650 nm. The photovoltaic performance of these dyes as photosensitizers in mesoporous TiO₂ solar cells was investigated, and a power conversion efficiency as high as 1.57 % was achieved, with an open‐circuit voltage of 0.59 V, short‐circuit current density of 3.63 mA cm^?2, and fill factor of 0.73 under simulated AM 1.5G solar illumination.