The effect of the couple stress parameter and Prandtl number on the transient natural convection flow over a vertical cylinder

An analysis is performed to study transient free convective boundary layer flow of a couple stress fluid over a vertical cylinder, in the absence of body couples. The solution of the time-dependent non-linear and coupled governing equations is carried out with the aid of an unconditionally stable Crank-Nicolson type of numerical scheme. Numerical results for the steady-state velocity, temperature as well as the time histories of the skin-friction coefficient and Nus- selt number are presented graphically and discussed. It is seen that for all flow variables as the couple stress control parameter, Co, is amplified, the time required for reaching the temporal maximum increases but the steady-state decreases.     

The efect of the couple stress parameter and Prandtl number on the transient natural convection flow over a vertical cylinder

An analysis is performed to study transient free convective boundary layer flow of a couple stress fluid over a vertical cylinder, in the absence of body couples. The solution of the time-dependent non-linear and coupled governing equations is carried out with the aid of an unconditionally stable Crank–Nicolson type of numerical scheme. Numerical results for the steady-state velocity, temperature as well as the time histories of the skin-friction coefcient and Nusselt number are presented graphically and discussed. It is seen that for all flow variables as the couple stress control parameter, Co, is amplified, the time required for reaching the temporal maximum increases but the steady-state decreases.     

Natural convection flow of a couple stress fluid between two vertical parallel plates with Hall and ion-slip effects

The Hall and ion-slip effects on fully developed electrically conducting couple stress fluid flow between vertical parallel plates in the presence of a temperature dependent heat source are investigated. The governing non-linear partial differential equations are transformed into a system of ordinary differential equations using similarity transformations. The resulting equations are then solved using the homotopy analysis method (HAM). The effects of the magnetic parameter, Hall parameter, ion-slip parameter and couple stress fluid parameter on velocity and temperature are discussed and shown graphically.     

An analytical study of linear and non-linear double diffusive convection with Soret and Dufour effects in couple stress fluid

The onset of double diffusive convection in a two component couple stress fluid layer with Soret and Dufour effects has been studied using both linear and non-linear stability analysis. The linear theory depends on normal mode technique and non-linear analysis depends on a minimal representation of double Fourier series. The effect of couple stress parameter, the Soret and Dufour parameters, and the Prandtl number on the stationary and oscillatory convection are presented graphically. The Dufour parameter enhances the stability of the couple stress fluid system in case of both stationary and oscillatory mode. The effect of positive Soret parameter is to destabilize the system in case of stationary mode while it stabilizes the system in case of oscillatory mode. The negative Soret parameter enhances the stability in both stationary and oscillatory mode. The couple stress parameter enhances the stability of the system in both stationary and oscillatory modes. The Dufour parameter increases the heat transfer while the couple stress parameter has reverse effect. The Soret parameter has negligible influence on heat transfer. Both Dufour and Soret parameters increases the mass transfer while the couple stress parameter has dual effect depending on the value of the Rayleigh number.     

Transient analysis of diffusive chemical reactive species for couple stress fluid flow over vertical cylinder

The unsteady natural convective couple stress fluid flow over a semi-infinite vertical cylinder is analyzed for the homogeneous first-order chemical reaction effect. The couple stress fluid flow model introduces the length dependent effect based on the material constant and dynamic viscosity. Also, it introduces the biharmonic operator in the Navier-Stokes equations, which is absent in the case of Newtonian fluids. The solution to the time-dependent non-linear and coupled governing equations is carried out with an unconditionally stable Crank-Nicolson type of numerical schemes. Numerical results for the transient flow variables, the average wall shear stress, the Nusselt number, and the Sherwood number are shown graphically for both generative and destructive reactions. The time to reach the temporal maximum increases as the reaction constant K increases. The average values of the wall shear stress and the heat transfer rate decrease as K increases, while increase with the increase in the Sherwood number.     

Magnetohydrodynamic mixed convection in a vertical channel

The problem of combined free and forced convective magnetohydrodynamic flow in a vertical channel is analysed by taking into account the effect of viscous and ohmic dissipations. The channel walls are maintained at equal or at different constant temperatures. The velocity field and the temperature field are obtained analytically by perturbation series method and numerically by finite difference technique. The results are presented for various values of the Brinkman number and the ratio of Grashof number to the Reynolds number for both equal and different wall temperatures. Nusselt number at the walls is determined. It is found that the viscous dissipation enhances the flow reversal in the case of downward flow while it counters the flow in the case of upward flow. It is also found that the analytical and numerical solutions agree very well for small values of ε.     

Surface roughness effects in a short porous journal bearing with a couple stress fluid

In this paper, a theoretical study of the effect of surface roughness in hydrodynamic lubrication of a porous journal bearing with couplestress fluid as lubricant is made. The modified Reynolds equations accounting for the couple stresses and randomized surface roughness structure are mathematically derived. The Christensen stochastic theory of hydrodynamic lubrication of rough surfaces is used to study the effects of surface roughness on the static characteristics of a short porous journal bearing with couplestress fluid as lubricant. Further, it is assumed that, the roughness asperity heights are small compared to the film thickness. It is observed that, the effects of surface roughness on the bearing characteristics are more pronounced for couplestress fluids as compared to the Newtonian fluids.     

Transient non-Darcy free convection between parallel vertical plates in a fluid saturated porous medium

Transient non-Darcy free convection between two parallel vertical plates in a fluid saturated porous medium is investigated using the generalized momentum equation proposed by Vafai and Tien. The effects of porous inertia and solid boundary are considered in addition to the Darcy flow resistance. Exact solutions are found for the asymptotic states at small and large times. The large time solutions reveal that the velocity profiles are rather sensitive to the Darcy number Da when Da<1. It has also been found that boundary friction alters the velocity distribution near the wall, considerably. Finite difference calculations have also been carried out to investigate the transient behaviour at the intermediate times in which no similarity solutions are possible. This analytical and numerical study reveals that the transient free convection between the parallel plates may well be described by matching the two distinct asymptotic solutions obtained at small and large times.Nomenclature C empirical constant for the Forchheimer term - f velocity function for the small time solution - F velocity function for the large time solution - g acceleration due to gravity - Gr* micro-scale Grashof number - H a half distance between two infinite plates - K permeability - Nu Nusselt number - Pr Prandtl number - t time - T temperature - u, v Darcian velocity components - x, y Cartesian coordinates - effective thermal diffusivity - coefficient of thermal expansion - porosity - dimensionless time - similarity variable - dimensionless temperature - viscosity - kinematic viscosity - density - the ratio of heat capacities     

Unsteady natural convection Couette flow of heat generating/absorbing fluid between vertical parallel plates filled with porous material

The extended Brinkman Darcy model for momentum equations and an energy equation is used to calculate the unsteady natural convection Couette flow of a viscous incompressible heat generating/absorbing fluid in a vertical channel(formed by two infinite vertical and parallel plates) filled with the fluid-saturated porous medium.The flow is triggered by the asymmetric heating and the accelerated motion of one of the bounding plates.The governing equations are simplified by the reasonable dimensionless parameters and solved analytically by the Laplace transform techniques to obtain the closed form solutions of the velocity and temperature profiles.Then,the skin friction and the rate of heat transfer are consequently derived.It is noticed that,at different sections within the vertical channel,the fluid flow and the temperature profiles increase with time,which are both higher near the moving plate.In particular,increasing the gap between the plates increases the velocity and the temperature of the fluid,however,reduces the skin friction and the rate of heat transfer.     

Transient free convection flow of a viscoelastic fluid over vertical surface

In this paper, the viscoelsatic boundary layer flow and the heat transfer near a vertical isothermal impermeable surface and in a quiescent fluid are examined. The gov-erning equations are formulated and solved numerically using MackCormak’s technique. The results show excellent agreement with previously published results by a compari-sion. Representative results for the velocity and temperature profiles, boundary layer thicknesses, Nusselt numbers, and local skin friction coefficients are shown graphically for different values of viscoelsatic parameters. In general, it is found that the velocities increase inside the hydrodynamic boundary layers and the temperatures decrease inside the thermal boundary layers for the viscoelsatic fluid as compared with the Newtonian fluid due to favorable tensile stresses. Consequently, the coefficients of friction and heat transfer enhance for higher viscoelsatic parameters.     

Natural convection flow of a viscous incompressible fluid in a rectangular porous cavity heated from below with cold sidewalls

We consider the flow, which is induced by differential heating on the boundaries of a porous cavity heated from below. In particular we allow the sidewalls to have the same cold temperature as the upper surface, and thus the problem is a variant of the Darcy-Bénard convection problem, but one where there is flow at all non-zero Grashof numbers. Attention is focused on how the flow and heat transfer is affected by variations in the cavity aspect ratio, the Grashof number and the Darcy number. The flow becomes weaker as the Darcy number decreases from the pure fluid limit towards the Darcy-flow limit. In addition the number of cells which form in the cavity varies primarily with the aspect ratio and is always even due to the symmetry imposed by the cold sidewalls.     

Mixed convection boundary-layer flow over a vertical surface embedded in a porous medium

In this paper we have numerically investigated the existence and uniqueness of a vertically flowing fluid passed a model of a thin vertical fin in a saturated porous media. We have assumed the two-dimensional mixed convection from a fin, which is modelled as a fixed, semi-infinite vertical surface, embedded in a fluid-saturated porous media under the boundary-layer approximation. We have taken the temperature, in excess of the constant temperature in the ambient fluid on the fin, to vary as  , where is measured from the leading edge of the plate and λ is a fixed constant. The Rayleigh number is assumed to be large so that the boundary-layer approximation may be made and the fluid velocity at the edge of the boundary-layer is assumed to vary as . The problem then depends on two parameters, namely λ and , the ratio of the Rayleigh to Péclet numbers. It is found that when λ>0 (<0) there are (is) dual (unique) solution(s) when is grater than some negative values of (which depends on λ). When λ<0 there is a range of negative value of (which depends on λ) for which dual solutions exist and for both λ>0 and λ<0 there is a negative value of (which depends on λ) for which there is no solution. Finally, solutions for 0<1 and 1 have been obtained.     

Stagnation-point flow of couple stress fluid with melting heat transfer

Melting heat transfer in the boundary layer flow of a couple stress fluid over a stretching surface is investigated. The developed differential equations are solved for homotopic solutions. It is observed that the velocity and the boundary layer thickness are decreasing functions of the couple stress fluid parameter. However, the temperature and surface heat transfer increase when the values of the couple stress fluid parameter increase. The velocity and temperature fields increase with an increase in the melting process of the stretching sheet.     

Surface roughness effects on squeeze film behavior in porous circular disks with couple stress fluid

The effect of surface roughness on squeeze film behavior between two circular disks with couple stress lubricant is analyzed when the upper disk has porous facing which approaches the lower disk with uniform velocity. The modified Stochastic Reynolds equation is derived on the basis of Stokes micro-continuum theory for couple stress fluid and Christensen Stochastic theory for the rough surface. Closed form solution of the Stochastic Reynolds equation is obtained in terms of Fourier–Bessel series. The importance of roughness and couple stress on bearing characteristics are presented in terms of load carrying capacity, squeeze time, and relative percentage of the load. It is observed that, effect of couple stress fluid, and surface roughness is more pronounced compared to classical case. These predictions enable design engineers to choose suitable parameters.     

Effect of couple stresses on the flow in a constricted annulus

The flow of an incompressible couple stress fluid in an annulus with local constriction at the outer wall is considered. This configuration is intended as a simple model for studying blood flow in a stenosed artery when a catheter is inserted into it. The effects couple stress fluid parameters α and σ, height of the constriction (ε), and ratio of radii (k) on the impedance and wall shear stresses are studied graphically. Graphical results show that the resistance to the flow as well as the wall shear stress increases as the ratio of the radii increases and decreases as the couple stress fluid parameters increases.     

Mixed convection about a non-isothermal vertical surface in a porous medium

The problem of mixed convection about non-isothermal vertical surfaces in a saturated porous medium is analysed using boundary layer approximations. The analysis is made assuming that the surface temperature varies as an arbitrary function of the distance from the origin. A perturbation technique has been applied to obtain the solutions. Using the differentials of the wall temperature, which are functions of distance along the surface, as perturbation elements, universal functions are derived for various values of the governing parameter Gr/Re. Both aiding and opposing flows are considered. The universal functions obtained can be used to estimate the heat transfer and fluid velocity inside the boundary layer for any type of wall temperature variation. As a demonstration of the method, heat transfer results have been presented for the case of the wall temperature varying as a power function of the distance from the origin. The results have been studied for various combinations of the parameters Gr/Re and the power index m, taking both aiding and opposing flows into consideration. On comparing these results with those obtained by a similarity analysis, the agreement is found to be good.     

Mathematical model of micropolar fluid in two-phase immiscible fluid flow through porous channel

This paper is concerned with the flow of two immiscible fluids through a porous horizontal channel. The fluid in the upper region is the micropolar fluid/the Eringen fluid, and the fluid in the lower region is the Newtonian viscous fluid. The flow is driven by a constant pressure gradient. The presence of micropolar fluids introduces additional rotational parameters. Also, the porous material considered in both regions has two different permeabilities. A direct method is used to obtain the analytical solution of the concerned problem. In the present problem, the effects of the couple stress, the micropolarity parameter, the viscosity ratio, and the permeability on the velocity profile and the microrotational velocity are discussed. It is found that all the physical parameters play an important role in controlling the translational velocity profile and the microrotational velocity. In addition, numerical values of the different flow parameters are computed. The effects of the different flow parameters on the flow rate and the wall shear stress are also discussed graphically.     

Electrorheological Rayleigh-Taylor instability at the interface between a porous layer and thin shell with poorly conducting couple stress fluid

This paper is concerned with the study of the Electrorheological Rayleigh-Taylor instability (ERTI) at the interface between a densely packed saturated poorly conducting couple stress porous layer accelerated by a lighter poorly conducting couple stress fluid in a thin shell in the presence of a transverse electric field and laser radiation. A simple theory based on fully developed flow approximations is used to derive the dispersion relation for the growth rate of ERTI. The cutoff and the maximum wave numbers and the corresponding maximum frequencies are obtained. It is shown that the effects of couple stress parameter and the electric field reduce the growth rate considerably compared to a non-conducting fluid in the absence of an electric field. These are favorable to control the surface instabilities in many practical applications discussed in this paper.