Excimers and excimer lasers

The development of excimers and excimer lasers are reviewed. The excimers of the noble gases (Xe ₂ ^* , Kr ₂ ^* , Ar ₂ ^* ) and of the noble gas halides (e.g. KrF, XeCl) which, respectively, radiate in the vacuum ultra-violet and ultra-violet regions of the spectrum are described in terms of their structure, spectroscopy and formation kinetics and the methods of pumping, operational characteristics and applications of the lasers are discussed.     

Single picosecond UV pulse generation by mode-locking of an excimer laser-pumped dye laser

A single picosecond ultraviolet pulse has been generated based on mode-locking of a dye laser pumped by a long pulse XeCl laser to serve as the input source for a high-power ps KrF laser system. A short-pulse uv dye laser (BBQ) pumped by an additional XeCl laser was used to selectively amplify a single pulse from a mode-locked pulse train with the pulse separation of 3.2 ns. The amplified single pulse was frequency-doubled to 248 nm with the pulse duration of 20 ps.     

Subpicosecond pulse generation in synchronously pumped and hybrid ring dye lasers

Subpicosecond pulse generation has been examined in synchronously pumped mode-locked ring dye laser systems. These include hybrid and composite absorber/gain media arrangements as well as a simple synchronous cavity. The shortest pulses recorded were 0.3 ps for the hybrid system, and this has been shown to be critically dependent on the positioning of the absorber jet in the centre of the cavity to better than 50 m. Stable operation for subpicosecond pulse generation has been achieved in the ring configuration with greater wavelength tunability and higher average power conversion efficiency than with conventional cavity arrangements.     

Injection locking of ArF excimer lasers

Injection-locking characteristics of an ArF excimer oscillator-amplifier laser are described including the use of stable-unstable optical cavities. Output intensities of 1 MW cm^–2 have been produced with 3 mJ output energy, a spectral linewidth better than 5×10^–3 nm and an injection locking efficiency of 0.9.     

Solid-state active media of tunable organic- compound lasers pumped with a laser. II. A copper vapor laser

The lasing properties of organic compounds in a polymethylmethacrylate matrix pumped by a copper vapor laser are studied. The results demonstrate that the transverse pumping scheme of solid-state laser-active media with the copper vapor laser is promising compared to the longitudinal pumping scheme from the viewpoint of the lifetime parameters. Received: 6 February 2002 / Published online: 2 May 2002     

Operation of KrF and ArF tunable excimer lasers without Cassegrain optics

A commercial tunable excimer laser consists of an oscillator-amplifier combination. The oscillator produces high-quality light that is sent to the amplifier and is distributed throughout the amplifier cavity via Cassegrain optics. We describe here two alternative approaches, a single-pass configuration for use with KrF and a triple-pass configuration with ArF, both of which do away with the Cassegrain optics. In each approach, the beam energy is the same as with Cassegrain optics. For KrF, the changes provide better locking, a higher degree of linear polarization, and a better spatial beam homogeneity, but a poorer beam divergence. For ArF, there is also better beam homogeneity, but the locking efficiency and divergence are not as good as with Cassegrain optics.     

Production of intensities of ∼ 1019 W/cm2 by a table-top KrF laser

We report on the generation of intensities of 10¹⁹ W/cm^–2 by focusing the output beam of a table-top hybrid dye-excimer laser system operating at 248 nm. The laser system uses a pulsed dye laser and a single, commercially available excimer gain module. Considerations and optical arrangements for the optimization of the phase-front and the beam homogeneity of ultraviolet excimer amplifiers are presented.Prof. F.P. Schäfer on the occasion of his 65th birthday.     

Infrared recombination lasers pumped by low energy Nd: YAG and excimer lasers

24 infrared laser lines on atomic and ionic transitions have been observed in recombining plasmas by vaporizing and ionizing Cd, Pb, Sn, Zn, and Mg with low energy Nd:YAG or excimer pump-lasers. For operation and optimization of the recombination lasers separated plasma spots and a plasma confinement have been used. The operation of shorter wavelength systems by isoelectronic scaling is discussed.     

Multi-megawatt superradiant emissions from coumarin-doped sol-gel derived silica

Fluorescence and lasing properties of coumarindoped silica samples prepared by sol-gel process were investigated. Superradiant emissions at peak power as high as 7MW were measured at around 535 nm when the silica samples were excited by a XeF laser. The energy of the superradiant pulse was 89 mJ, corresponding to a conversion efficiency of 36.6%.     

Tunable sub-100 femtosecond dye-laser pulses generated with a nanosecond pulsed pumping

Subpicosecond pulses at a fixed wavelength produced with a low-Q cavity dye laser pumped by a single, nanosecond laser (Q-switched Nd:YAG) are converted into tunable high-power sub-100 femtosecond pulses by generation, spectral selection, amplification and compression of a supercontinuum. The tunable, chirped, high-energy pulses obtained are compressed with a prism pair. Energies up to 50 J in sub-100 fs pulses were obtained in the 540 to 650 nm range using 40 mJ of the Nd: YAG-laser pumping pulses at 532 nm. The whole sub-100 fs system including the low-Q dye laser uses only one Nd:YAG laser as a pump source.     

Highly efficient synchronous amplification of a picosecond dye laser at a kHz repetition rate

A short pulse, high energy, high repetition rate dye amplifier with superior conversion efficiency is reported. The dye amplifier is composed of three single-pass dye cells, longitudinally pumped by a frequency doubled 1 kHz Nd: YLF regenerative amplifier. The dye amplifier yields 3.5 ps, 150 J pulses at 595 nm, corresponding to a 12% conversion efficiency. The ASE is 1% or less, and the transverse mode quality is near-Gaussian.In absentia from the Department of Chemistry, Princeton University, Princeton, NJ 08544, USA     

Subpicosecond UV pulse generation for a multiterawatt KrF laser

A 180-fs UV pulse has been generated based on a hybrid synchronously pumped mode-locked dye laser for a multiterawatt KrF laser system. The pulse width was measured by the single shot autocorrelation technique with the three-photon fluorescence of the XeF C-A transition. The pulse width broadening due to dispersive media was investigated. The results show that the observed pulse width broadening from 210 fs to 390 fs through the entire system is explained mostly by the linear dispersion of the optical elements for near-transform-limited input pulses.     

300 Femtosecond pulses at 497 nanometer generated by an excimer laser pumped cascade of distributed feedback dye lasers

The setup is a cascade of 3 lasers: A competing cavity dye laser pumped by a XeCl excimer laser, followed by two distributed feedback dye lasers. The typical durations of the pulses from the lasers are 100 ps, 5 ps, and 300 fs, respectively. The output pulses at 497 nm are amplified up to 500 MW. The shortest pulse duration obtained was 198 fs.     

Efficient amplification of sub-picosecond pulses of a non-CW dye laser

Efficient amplification in a dye laser amplifier is investigated theoretically and experimentally. A five-level rate equation approach is considered including rotational relaxation of the dye molecules. The effects of the pump pulse duration and of the parameters of the input pulse are discussed. The results are compared with experimental data for 0.5 ps pulses of a pulsed dye laser. Conversion efficiencies >10% are achieved for a single pass amplifier using Nd:YAG pump pulses of 2 ns while an effective fluorescence lifetime of 1.7±0.2 ns is determined for the gain medium rhodamine 6G. The triple pass amplifier stage of the laser system achieves an energy conversion of 4% with 40 J output pulses.     

Tunable picosecond pulse generation from the passively mode-locked coumarin 6 dye laser

Using the saturable absorber 2-(p-Dimethylaminostyryl)-benzothiazolylethyl iodide, coumarin 6 has been passively mode-locked for the first time to give fully modulated trains of pulses of 4 ps duration and with peak powers of 3 MW tunable over the spectral range 526–547 nm.     

Enhanced efficiency and extended wavelength range of dye lasers operated with DCM

It is observed that the efficiency of the DCM dye dissolved in ethylene glycol benzyl alcohol can be enhanced if the dye is preheated at a temperature of 150 °C. Peak powers as high as 1.5 W have been achieved with a single-mode ring dye laser at 640 nm when pumped by 9 W (all lines) from an argon-ion laser. The wavelength region has been also extended beyond both ends of the tuning curve compared to a conventionally prepared DCM dye. Received: 3 September 1999 / Revised version: 9 December 1999 / Published online: 23 February 2000     

Photoacoustic analysis of stimulated emission in pulsed dye lasers

Stimulated emission in pulsed dye lasers was characterized in several experimental conditions by analyzing the changes in the acoustic signals generated in a dye solution, with the dye laser cavity either active or inhibited (i.e., by blocking the optical path or misaligning of the optical components). Pump energy threshold, optimum dye concentration, tuning range and maximum-emission wavelength of a rhodamine 6G dye laser were measured by this method. An approximate model for the photoacoustic signal generation consistent with the experiments is presented.Member of CONICET     

Two-wavelength self-seeded pulsed tunable laser

A compact self-seeded pulsed tunable laser is described. Its optical cavity comprises a diffraction grating, operating at a grazing angle of incidence as a spectral selector and narrow-band spectral gate. The grating couples two partially overlapping laser channels: a highly selective master laser and a nonselective slave laser. Due to the implemented efficient intracavity self-seeding the laser emits spectrally pure single-longitudinal-mode radiation at two independently tunable wavelengths, with an efficiency and output energy that are typical for nonselective lasers. Results of the experimental investigation of the laser’s output characteristics are presented. Received: 12 March 2001 / Revised version: 10 December 2001 / Published online: 7 February 2002     

A novel double grazing-incidence single-mode dye laser

Using only one grating and plane parallel glass plate in a novel double-grazing incidence configuration, twice higher dispersion is obtained, resulting in twofold narrowing of the single-pass linewidth, compared to the single grazing-incidence scheme. This laser cavity design features several-times improved signal-to-noise ratio and enhanced stability. Single-mode operation of 210±50 MHz is demonstrated.