Dynamics of high-power ultrashort laser pulses in resonant media

Work supported by Russian Fund for Basic Research, Project 93-02-14271.     

Absorption of ultrashort laser pulses in strongly overdense targets

Absorption measurements on solid conducting targets have been performed in s and p polarization with ultrashort, high-contrast Ti:sapphire laser pulses at intensities up to 5x10{16}W/cm{2} and pulse duration of 8 fs. The particular relevance of the reported absorption measurements lies in the fact that the extremely short laser pulse interacts with matter close to solid density during the entire pulse duration. A pronounced increase of absorption for p polarization at increasing angles is observed reaching 77% for an incidence angle of 80 degrees . Simulations performed using a 2D particle in cell code show a very good agreement with the experimental data for a plasma profile of L/lambda approximately 0.01.     

Coherent excitation of molecular vibrational modes by high-power ultrashort infrared laser pulses

Coherent dynamics of multiphoton excitation of molecular vibrational modes by subpicosecond IR laser pulses differs greatly from that of picosecond pulse excitation. The resonance response of a molecule is primarily determined by the power broadening rather than the laser carrier frequency. Selective excitation of high vibrational levels is possible with the use of subpicosecond pulses.     

Molecular wakes for ultrashort laser pulses

The molecular wake-assisted interaction between two collinear femotosecond laser pulses is investigated in air,which leads to the generation of a controllable 1.8 mJ super-continuum pulse with an elongated self-guided channel due to the cross-phase modulation of the impulsively aligned diatomic molecules in air. For two parallel launched femtosecond laser pulses with a certain spatial separation,controllable attraction and repulsion of the pulses are observed due to the counter-balance among molecular wakes,Kerr and plasma effects,where the molecular wakes show a longer interaction distance than the others to control the propagation of the intense ultrashort laser pulses.     

Microablation with ultrashort laser pulses

This paper reports the micromachining results of different materials (Al, Si, InP and fused silica) using a Ti : sapphire laser at the wavelength of 800 and 267 nm with variable pulse lengths in the range from 100 fs to 10 ps. The hole arrays with a diameter up to a few μm through microdrilling are presented. We discussed how an effective suppression of the thermal diffusion inside the ablated materials and an effective microablation could be realized. If the laser fluence is taken only slightly above the threshold, a hole array can be drilled with diameters even smaller than the wavelength of the laser. Some examples are presented in the paper.     

Measurement of ultrashort laser pulses

A proposal for measuring the pulse shape of ultrashort laser pulses is described. The proposed method consists of a Gamo triple intensity-interferometer to measure the triple-correlation function of the light pulses. A subsequent signal processing algorithm is used to reconstruct the true shape of the light pulses out of their triple-correlation function. The suggested method is quite insensitive to noise, as shown by means of computer simulations.     

Vortices in ultrashort laser pulses

The propagation of optical vortices nested in broadband femtosecond laser beams was studied both numerically and experimentally. Based on the nonlinear Schrödinger equation, the dynamics of different multiple-vortex configurations with varying topological charge were modelled in self-focussing and self-defocussing Kerr media. We find a similar behavior in both cases regarding the vortex–vortex interaction. However, the collapsing background beam alters the propagation for a positive nonlinearity. Regimes of regular and possibly stable multiple filamentation were identified this way. Experiments include measurements on pairs of filaments generated in a vortex beam on an astigmatic Gaussian background with argon gas as the nonlinear medium. Spectral broadening of these filaments leads to a supercontinuum which spans from the visible range into the infrared. Recompression yields <19 fs pulses. Further optimization may lead to much better recompression.     

Real-time chirp diagnostic for ultrashort laser pulses

Using a real-time Fourier-transform algorithm, we present a simple technique for measuring the chirp of femtosecond laser pulses. We demonstrate significantly enhanced sensitivity compared with standard autocorrelation measurements.     

Hybrid optics for focusing ultrashort laser pulses

We present a specially designed hybrid optics comprising refraction and diffraction effects for tight spatial and temporal focusing of ultrashort laser pulses. Both aims can be put into practice by having a high numerical aperture (NA=0.45) and low internal dispersion at the same time. We are presenting what we believe is the first experimental realization of such a hybrid short plus focusing optics. The focusing properties are compared with a commonly used microscope objective (20 X, NA = 0.45) in theory and experimentally.     

On the interaction of femtosecond laser pulses with cluster targets

The heating of clusters by femtosecond laser pulses is studied theoretically and experimentally. Both the formation of a cluster target and the results of experimental studies of the cluster plasma by the methods of X-ray emission spectroscopy are considered. A numerical model of cluster formation in a supersonic gas jet is proposed. It is shown that detailed studies of two-phase gas-dynamic processes in a nozzle forming the jet give the spatial distributions of all parameters required for the correct calculation of the cluster heating by short laser pulses. Calculations of nozzles of different configurations show that in a number of cases an almost homogeneous cluster target can be formed, whereas in other cases the distributions of parameters prove to be not only inhomogeneous but also even nonmonotonic. A simple physical model of the plasma production by a femtosecond laser pulse and a picosecond prepulse is proposed. It is shown that a comparison of X-ray spectra with detailed calculations of the ion kinetics makes it possible to determine the main parameters of the plasma being produced.     

Ionization via an ultrashort high-power KrF laser

Received: 10 January 1997     

Measurement of the energy penetration depth into solid targets irradiated by ultrashort laser pulses

The energy penetration depth of a short (100 fs) Ti-sapphire laser pulse (0.8 &mgr;m) of intensity 3x10(16) W/cm(2), in solid density materials has been measured. High-Z (BaF2) and low-Z (MgF2) solid layers targets were used. The penetration depth was determined from the measurement of the x-ray emission spectra, as a function of the target thickness. The investigation of these spectra showed that in the low-Z case, solid density material to a depth of 50 nm was heated to a peak electron temperature of approximately 150 eV. For the high-Z material, the penetration depth corresponding to this temperature exceeded 100 nm. This is evidence of a larger heat penetration depth in a high-Z material in comparison to a low-Z material. A model based on electron heat conduction is used to estimate the energy penetration depth. It is suggested that the larger heat penetration in high-Z material is due to heating of the material, caused by the radiation flux, generated by the electron heat conduction.     

Generation of harmonics during the interaction of ultrashort superstrong laser pulses with solid targets

Generation of even and odd harmonics in the skin layer formed during the interaction of a short relativistic laser pulse with solid targets is considered. The complex motion of free electrons in the skin layer along the electric field vector and along the direction of propagation of a laser wave is analyzed. The Fourier expansion of the trajectory of this motion is used to obtain the components of the conductivity tensor and of the amplitude of the transverse electromagnetic field of harmonics propagating along the electric field. Even harmonics appear due to relativistic effects. The efficiency of generation of even and odd harmonics at the leading front of a laser pulse is calculated.     

Analysis of electromagnetic pulses generated from ultrashort laser irradiation of solid targets at CLAPA

Electromagnetic pulses(EMPs)produced by the interaction of a TW femtosecond laser with solid targets at the Compact Laser Plasma Accelerator(CLAPA)are measured and interpreted.The statistical results confirm that the intensities of the EMPs are closely related to both target material and thickness.The signal of the titanium target is more abundant than that of the copper target with the same thickness,and the intensity of EMP is positively correlated with the target thickness for aluminium foil.With the boosted EMP radiations,the energy of accelerated protons is also simultaneously enhanced.In addition,EMPs emitted from the front of the target exceed those from the rear,which are also pertinent to the specific target position.The resonant waveforms in the target chamber are analyzed using the fast Fourier transform,and the local resonance and the attenuation lead to changes of the frequency spectra of EMPs with variation of detecting positions,which is well supported by the modeling results.The findings are beneficial to gaining insight into the mechanism of EMP propagation in a typical target chamber and providing more information for EMP shielding design.     

Efficient generation of high-power VUV ultrashort pulses by four-wave mixing

We report the generation of ultra-short pulses in the VUV (λ = 173.5 nm) using a four-wave mixing technique in magnesium vapour. Using a mode-locked ruby laser as the original source, conversion efficiencies of up to 0.2% and powers of 0.3 MW were obtained.     

Active optical storage ring for high-power laser pulses

In an optical storage ring, a dye laser amplifier synchronously pumped by external laser pulses has been implemented and experimentally tested. The test was done at =580 nm, but the optical system can be used without limitations in a broad band of 400–700 nm. It is shown that a selected turn of the stored laser pulse can be amplified by typically a factor of 200. Power consideration gives an increase of the efficiency of the optical storage ring with a dye amplifying cell, as compared to a single passage of the laser pulse through the experimental section, by 23 times and it is shown that it can reach a factor of more than 100. PACS 42.60.Da; 42.60.Lh     

New laser crystals for the generation of ultrashort pulses

Since the beginning of the 1990s, titanium sapphire has become the crystal of choice for the development of ultrashort laser systems producing very short and powerful pulses using the Chirped Pulse Amplification technique. In parallel to these developments leading to commercial products, new laser crystals have been studied in order to reach directly other wavelength ranges and to overcome the need to develop cw or pulsed green laser to pump the titanium sapphire crystal. In order to be able to directly pump the crystals with a very efficient and high-power semiconductor laser, new crystals doped with chromium or ytterbium ions have been developed. This article will review the latest development in this research field with the best performances obtained in terms of pulse duration. To cite this article: F. Druon et al., C. R. Physique 8 (2007).     

On the keldysh ionization theory for ultrashort laser pulses

A closed analytical expression is obtained for the momentum distribution of photoelectrons from the ionization of atoms or ions by an ultrashort laser pulse. This formula is applied to analyze some models of electromagnetic pulses and the interference effect in the ionization probability.     

Micromachining of quartz with ultrashort laser pulses

Received: 6 January 1997/Accepted: 1 April 1997     

Automated spatiotemporal diffraction of ultrashort laser pulses

We exploit the close similarities between time-frequency and position-wave-vector correspondences to control the spatiotemporal diffraction pattern of ultrashort laser pulses. This approach permits novel, automated generation of sophisticated two-dimensional femtosecond waveforms. A two-dimensional space-time version of a Gerchberg-Saxton algorithm is used to iteratively determine the phase pattern in position-frequency space that produces a user-defined intensity profile in wave-vector-time space.