Transition metal ions-doped polyaniline/graphene oxide nanostructure as high performance electrode for supercapacitor applications

Journal of Solid State Electrochemistry - Polyaniline/graphene oxide (PANI/GO) co-doped with Zn2+ and Fe3+ was synthesized via a simple and low cost one-step chronoamperometry method on stainless...     

KCl-assisted,chemically reduced graphene oxide for high-performance supercapacitor electrodes

Journal of Solid State Electrochemistry - Graphene with highly flaky state has been successfully prepared through chemical reduction process with the assistance of potassium chloride (KCl) to...     

石墨烯/还原氧化石墨烯/聚苯胺复合材料的制备及在超级电容器中的应用

本研究以低成本、易规模化的亲水性石墨烯/氧化石墨烯为前驱体,通过原位聚合的方法制备石墨烯/氧化石墨烯/聚苯胺复合材料,经过化学还原后制备得到石墨烯/还原氧化石墨烯/聚苯胺复合材料.采用扫描电子显微镜(SEM)、透射电子显微镜(TEM)和傅里叶红外变化光谱仪(FT-IR)对制备的材料进行了结构和形貌的表征.运用循环伏安法...     

Partially reduced graphite oxide as an electrode material for electrochemical double-layer capacitors

Partially reduced graphite oxide was prepared from graphite oxide by using synthetic graphite as precursor. The reduction of graphite oxide with a layer distance of 0.57?nm resulted in a reduction of the layer distance depending on the degree of reduction. Simultaneously the amount of oxygen functionalities in the graphite oxide was reduced, which was corroborated by elemental analysis and EDX. The electrochemical activation of the partially reduced graphite oxide was investigated for tetraethylammonium tetrafluoroborate in acetonitrile and in propylene carbonate. The activation potential depends significantly on the degree of reduction, that is, on the graphene-layer distance and on the solvent used. The activation potential decreased with increasing layer distance for both positive and negative activation. The resulting capacitance after activation was found to be affected by the layer distance, the oxygen functionalities and the used electrolyte. For a layer distance of 0.43?nm and with acetonitrile as the solvent, a differential capacitance of 220?Fg(-1) was achieved for the discharge of the positive electrode near the open-circuit potential and 195?Fg(-1) in a symmetric full-cell assembly.     

The preparation and characterization of electrochemical reduced TiO2 nanotubes/polypyrrole as supercapacitor electrode material

Journal of Solid State Electrochemistry - A hybrid material of electrochemical reduced TiO2 nanotubes/polypyrrole (r-TiO2 NTs/PPy) was successfully prepared through electrochemical reduction and...     

Synthesis of reduced graphene oxide/Co3O4 nanocomposite electrode material for sensor application

Research on Chemical Intermediates - A sensitive electrochemical sensor has been developed based on reduced graphene oxide/Co3O4 (rGO/Co3O4) nanocomposites (NCs) synthesized by a facile...     

Functionalization of graphene by electrophilic alkylation of reduced graphite

The reaction of Na/K-reduced graphite with hexyliodide represents a new, versatile and mild approach to synthesize alkylated graphene derivatives, which were characterized by a combination of Raman spectroscopy, TEM and TGA/MS analysis.     

Functionalized graphene oxide-reinforced electrospun carbon nanofibers as ultrathin supercapacitor electrode

Graphene oxide has been used widely as a starting precursor for applications that cater to the needs of tunable graphene. However, the hydrophilic characteristic limits their application, especially in a hydrophobic condition. Herein, a novel non-covalent surface modification approach towards graphene oxide was conducted via a UV-induced photo-polymerization technique that involves two major routes; a UV-sensitive initiator embedded via pi-pi interactions on the graphene planar rings, and the polymerization of hydrophobic polymeric chains along the surface. The functionalized graphene oxide successfully achieved the desired hydrophobicity as it displayed the characteristic of being readily dissolved in organic solvent. Upon its addition into a polymeric solution and subjected to an electrospinning process,non-woven random nanofibers embedded with graphene oxide sheets were obtained. The prepared polymeric nanofibers were subjected to two-step thermal treatments that eventually converted the polymeric chains into a carbon-rich conductive structure. A unique morphology was observed upon the addition of the functionalized graphene oxide, whereby the sheets were embedded and intercalated within the carbon nanofibers and formed a continuous structure. This reinforcement effectively enhanced the electrochemical performance of the carbon nanofibers by recording a specific capacitance of up to 140.10 F/g at the current density of 1 A/g, which was approximately three folds more than that of pristine nanofibers.It also retained the capacitance up to 96.2% after 1000 vigorous charge/discharge cycles. This functionalization technique opens up a new pathway in tuning the solubility nature of graphene oxide towards the synthesis of a graphene oxide-reinforced polymeric structure.     

Three-dimensional flower-like nickel oxide supported on graphene sheets as electrode material for supercapacitors

Dispersed three-dimensional (3D) flower-like nickel oxide on graphene sheets was synthesized by incorporating a facile hydrothermal process with a thermal treatment process. The possible growth mechanism of 3D flower-like NiO is discussed. When used as electrode materials for supercapacitors, the resultant composite exhibits a specific capacitance of 346F/g (1.5A/g), a good rate performance and cycle stability in 2?M KOH. NiO in the composite could provide a specific capacitance as high as 778.7F/g, compared to that of bare NiO of only 220F/g. The functional features of unique 3D flower-like NiO morphology, high conductivity of graphene sheets and its protective effect to the structure of NiO result in an improved electrochemical performance.     

Facile synthesis of layered reduced graphene oxide–copper sulfide (rGO-CuS) hybrid electrode for all solid-state symmetric supercapacitor

A straightforward process for synthesis of hybrid porous electrode material composed of reduced graphene oxide (rGO) and copper sulfide (CuS) with layered structure on the stainless steel substrate is developed. As-synthesized hybrid electrode shows hexagonal crystal structure of CuS with 77 m² gm⁻¹ specific surface area and 22 nm average pore size. The specific capacitance obtained with rGO-CuS5 hybrid electrode is 1201 F g⁻¹ at the sweep rate of 5 mV s⁻¹ in 1 M LiClO₄ aqueous electrolyte. The majority of charge stored by diffusion-controlled process indicates benefits of layered structures for solid-state energy storage. The rGO-CuS5-based hybrid symmetric supercapacitor delivers a specific capacitance (C_s) as high as 109 F g⁻¹ at a sweep rate of 5 mV s⁻¹ with polyvinyl alcohol (PVA)-LiClO₄ gel electrolyte. Also, the specific energy of 44 Wh kg⁻¹ and specific power of 1.4 kW kg⁻¹ with 87% stability after 6000 cycles at an applied current of 5 mA are obtained. The simple process of synthesis of layered hybrid electrode material for flexible supercapacitor promises its use in smart textile and wearable electronic devices.

Graphical abstract

     

Three-dimensional ZnS/reduced graphene oxide/polypyrrole composite for high-performance supercapacitors and lithium-ion battery electrode material

Journal of Solid State Electrochemistry - In this work, three-dimensional ZnS/reduced graphene oxide/polypyrrole ternary composites were synthesized. The as-prepared composites are investigated as...     

NHC-Pd complex heterogenized on graphene oxide for cross-coupling reactions and supercapacitor applications

N-heterocyclic carbene (NHC)-palladium(II) complex (GO@NHC-Pd) was synthesized on graphene oxide (GO) support via a simple and cost-effective multistep approach. The spectroscopic, microscopic, thermal, and surface analyses of GO@NHC-Pd confirmed the successful formation of the catalyst. The investigation of catalytic activity showed that GO@NHC-Pd was very effective in Suzuki–Miyaura as well as Hiyama cross-coupling. Being heterogeneous in nature, GO@NHC-Pd was recovered after each reaction cycle easily and reused for up to nine and six cycles in Suzuki–Miyaura and Hiyama cross-coupling, respectively, without significant loss of activity. Further exploration of the supercapacitor performance of GO@NHC-Pd catalyst assembled in a two-electrode cell configuration shown a maximum attained capacitance of 105.26 F/g at a current density of 0.1 A/g with good cycling stability of 96.89% over 2,500 cycles.     

Layered graphene oxide nanostructures with sandwiched conducting polymers as supercapacitor electrodes

We demonstrate a general approach to the preparation of layered graphene oxide structures with sandwiched conducting polymers of different morphologies. The approach is conceptualized on the basis of the electrostatic interactions between negatively charged graphene oxide sheets and positively charged surfactant micelles. A graphene oxide-polypyrrole composite prepared from this approach exhibited an excellent electrocapacitive performance with a high specific capacitance over 500 F g(-1). Good rate performance and cycle ability were realized by the composite electrode. The simple method described here opens up a generalized route to making a wide range of graphene oxide-based and graphene-based composite materials for applications beyond electrochemical energy storage.     

Three-dimensional paper-like graphene framework with highly orientated laminar structure as binder-free supercapacitor electrode

A free-standing paper-like three-dimensional graphene framework(3DGF) with orientated laminar structure and interconnected macropores, was obtained by the hard template-directed ordered assembly. As the sacrificial templates, polystyrene(PS) latex spheres were assembled with graphene oxide(GO) to build up a sandwich type composite film, followed by heat removal of which with a simultaneous reduction of GO. The 3DGF exhibited high specific surface area of 402.5 m2/g, controllable pores and mechanical flexibility, which was employed as the binder-free supercapacitor electrode and shows high specific gravimetric capacitance of 95 F/g at 0.5 A/g, with enhanced rate capability in 3 electrode KOH system.     

Electrochemical detection of selenium using glassy carbon electrode modified with reduced graphene oxide

In this work, a simple experimental procedure was reported for the electroanalytical determination of selenium (IV) using reduced graphene oxide (rGO) to modify glassy carbon electrode (GCE). The rGO was obtained by reduction of graphene oxide obtained via Hummer’s method. The synthesised rGO was characterised using X-ray diffraction, Raman spectroscopy, scanning electron microscope (SEM), energy-dispersive spectroscopy and transmission Electron microscopy (TEM). GCE was modified with rGO and the electrochemical properties of the bare and modified electrode were investigated using cyclic voltammetry and electrochemical impedance spectroscopy. The results obtained showed that the modified electrode exhibited more excellent electrochemical properties than the bare GCE. The optimum conditions for detection of selenium in water using square wave anodic stripping voltammetry were as follows: deposition potential ?500 mV, pH 1, pre-concentration time of 240 s and 0.1 M nitric acid was used as supporting electrolyte. The linear regression equation obtained was I (µA) = 0.8432C + 9.2359 and the detection limit was calculated to be 0.85 μg L^?1. However, Cu(II) and Cd(II) are the two cations that interfered in the analysis of selenium in water.

The sensor was also applied for real sample water analysis and the result obtained was affirmed with inductively coupled plasma optical emission spectroscopic method. It is believed that our proposed sensor hold promise for practical application.     

Preparation and electrochemical performance of the layered cobalt oxide (Co3O4) as supercapacitor electrode material

Layered Co₃O₄ composed of oriented self-assembled micrometer-length rectangular 2D flakes has been successfully synthesized by a hydrothermal method in combination with subsequent calcination process. Structural and morphological characterizations were performed using powder X-ray diffraction and field emission scanning electron microscopy. The component and thermal stability of the sample were measured by FT-IR and thermal analyses, including thermogravimetry and differential thermal analysis. The electrochemical performances of the as-prepared Co₃O₄ product were investigated by cyclic voltammetry, electrochemical impedance spectroscopy (EIS), and constant current charge/discharge techniques. The electrochemical results demonstrate that the layered Co₃O₄ product displays good capacitive behavior with a specific capacitance of 263 F?g^?1 within a potential range of ?0.4–0.55 V at a current density of 1 A?g^?1 and a large capacity retention with 89.4 % of the initial capacitance over 1,000 consecutive cycles at 3 A?g^?1, indicating that the as-prepared Co₃O₄ product can be a promising electroactive material for supercapacitor.     

Synthesis of Ni3V2O8@graphene oxide nanocomposite as an efficient electrode material for supercapacitor applications

Journal of Solid State Electrochemistry - In the present investigation, we have synthesized Ni3V2O8@GO composite by co-precipitation method and designed as a new anode material for supercapacitor...     

Mixed colloidal suspensions of reduced graphene oxide and layered metal oxide nanosheets: useful precursors for the porous nanocomposites and hybrid films of graphene/metal oxide

Homogeneously mixed colloidal suspensions of reduced graphene oxide, or RGO, and layered manganate nanosheets have been synthesized by a simple addition of the exfoliated colloid of RGO into that of layered MnO(2). The obtained mixed colloidal suspensions with the RGO/MnO(2) ratio of ≤0.3 show good colloidal stability without any phase separation and a negatively charged state with a zeta (ζ) potential of -30 to -40?mV. The flocculation of these mixed colloidal suspensions with lithium cations yields porous nanocomposites of Li/RGO-layered MnO(2) with high electrochemical activity and a markedly expanded surface area of around 70-100?m(2) g(-1). Relative to the Li/RGO and Li/layered MnO(2) nanocomposites (≈116 and ≈167?F?g(-1)), the obtained Li/RGO-layered MnO(2) nanocomposites deliver a larger capacitance of approximately 210?F?g(-1) with good cyclability of around 95-97?% up to the 1000th cycle, thus indicating the positive effect of hybridization on the electrode performances of RGO and lithium manganate. Also, an electrophoretic deposition of the mixed colloidal suspensions makes it possible to easily fabricate uniform hybrid films composed of graphene and manganese oxide. The obtained films show a distinct electrochemical activity and a homogeneous distribution of RGO and MnO(2). The present experimental findings clearly demonstrate that the utilization of the mixed colloidal suspensions as precursors provides a facile and universal methodology to synthesize various types of graphene/metal oxide hybrid materials.