Synthesis of poly(γ-methoxypropylmethylsilylene) and poly(γ-methoxypropylmethylsilylene-co-di-n-hexylsilylene)

The synthesis of γ;-methoxypropylmethyldichlorosilane, and its subsequent polymerization and copolymerization with di;-n;-hexyldichlorosilane through the reductive coupling with sodium has been accomplished. The resulting polymers contain methyl ether side groups that allow further synthetic transformations on the polysilane backbone. For poly (γ;-methoxypropylmethylsilylene) these groups impart solubility characteristics different than typical alkyl and aryl substituted polysilanes. These new polymers and copolymers have been characterized by GPC and ¹H-, ¹³C-, and ²⁹Si-NMR. © 1994 John Wiley & Sons, Inc.     

Heat capacity and vibrational dynamics of α poly(β-benzyl-L-aspartate)

Poly(β-benzyl-L-aspartate) (PBLA) is an unusual polypeptide, which is capable of going into four different conformations, namely, left-handed α helix, right-handed α helix, ω helix, and β pleated sheet. The present work is a complete study of normal modes and their dispersion in the unusual left-handed α form. A special feature of some of the dispersion curves is their tendency to bunch in the neighborhood of helix angle. This is attributed to the presence of strong intramolecular interactions. Crossing and repulsion between the dispersion curves is also observed. The N-deuterated analogue of PBLA has been studied to check the validity of assignments and force field (Urey Bradley). Specific heat has been obtained from dispersion curves via density of states. A comparative study of left-handed and right-handed forms is presented. © 1996 John Wiley & Sons, Inc.     

Conformational transitions of poly(β-benzyl L-aspartate)

Conditions that affect the conformation of poly(β-benzyl L-aspartate) in films have been studied. A slow transition from the left-handed to the right-handed α-helical form is observed under certain conditions in half-dried film cast from chloroform solutions and after exposure of amorphous films of the left-handed β-helical form to chloroform vapor. This transition is caused by adsorption of moisture. Thermal transitions of these films were examined by differential scanning calorimetry and infrared spectroscopy. The right-handed α-helices change to left-handed ω-helices around 140°C, and sharp exothermic peak is observed in this region for some films.     

The dielectric β-relaxation of poly(bis-benzimidazobenzisoquinolinones)

The dielectric relaxation of poly(bis-benzimidazobenzisoquinolinones) has been studied in the frequency range from 10¹ to 10⁵ Hz and at temperatures from ?150 to +80°C. The data show that the relaxation is due mainly to diffusion of water in the polymer with simultaneous reorientation of water dipoles.     

Dielectric γ relaxation in poly(2-hydroxyethyl methacrylate)

The dielectric constant and loss were measured for poly(2-hydroxyethyl methacrylate) from ?90 to 34°C over the frequency range 30 to 3 × 10⁵ Hz in the γ relaxation region. The relaxation was also characterized using activation energies.     

Nonisothermal crystallization kinetics of poly(β-hydroxybutyrate)

Kinetics of nonisothermal crystallization of poly(β-hydroxybutyrate) from melt and glassy states were performed by differential scanning calorimetry under various heating and cooling rates. Several different analysis methods were used to describe the process of nonisothermal crystallization. The results showed that both Avrami treatment and a new method developed by combining the Avrami equation and Ozawa equation could describe this system very well. However, Ozawa analysis failed. By using an evaluation method, proposed by Kissinger, activation energies have been evaluated to be 92.6 kJ/mol and 64.6 kJ/mol for crystallization from the glassy and melt state, respectively. © 1998 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 36: 1305–1312, 1998     

Nuclear magnetic relaxation of α-13C nuclei of helical poly(γ-hexyl-L-glutamate) and poly(γ-benzyl-L-glutamate)

Spin-lattice relaxation times (T₁), spin-spin relaxation times (T₂), and nuclear Overhauser enhancements (NOE), at 75.5 MHz are reported for α-¹³C nuclei of poly (γ-benzyl-L -glutamate) in deuterated dimethylformamide at 60°C and of poly(γ-hexyl-L -glutamate) in cyclohexanone at 48 and 79°C. It is shown that for molecular weights above 10⁵, the polypeptides cannot be considered as essentially rigid helices with internal librational motions; additional backbone flexing motions contribute to the relaxation behavior.     

NMR study of poly(vinyl chloride)-β,β-d2

The high-resolution NMR spectra at 60 and 100 Mcps of poly(vinyl chloride)-β,β-d₂ in o-dichlorobenzene, pyridine, and C₂HCl₅ solutions are reported. The use of low molecular weight samples and of {D} spin-decoupling experiments, which yield higher resolution spectra, results in the observation of a number of additional resonances for the α-proton. These can be interpreted in terms of pentad configurational sequences of monomer units. It is found that, whereas the S syndiotactic pentads cannot be resolved, two components of the H heterotactic and all of the possible I isotactic pentads are clearly discernible. From the tacticity values of polymers prepared at +40, 0, and ?40°C, enthalpy and entropy of activation for isotactic and syndiotactic monomer placement are found to be 630 cal/mole and 1.5 eu, respectively.     

Synthesis and characterization of poly(β‐hydroxybutyrate) and poly(ϵ‐caprolactone) copolyester by transesterification

To synthesize the copolyester of poly(β‐hydroxybutyrate) (PHB) and poly(?‐caprolactone) (PCL), the transesterification of PHB and PCL was carried out in the liquid phase with stannous octoate as the catalyzer. The effects of reaction conditions on the transesterification, including catalyzer concentration, reaction temperature, and reaction time, were investigated. The results showed that both rising reaction temperature and increasing reaction time were advantageous to the transesterification. The sequence distribution, thermal behavior, and thermal stability of the copolyesters were investigated by ¹³C NMR, Fourier transform infrared spectroscopy, differential scanning calorimetry, wide‐angle X‐ray diffraction, optical microscopy, and thermogravimetric analysis. The transesterification of PHB and PCL was confirmed to produce the block copolymers. With an increasing PCL content in the copolyesters, the thermal behavior of the copolyesters changed evidently. However, the introduction of PCL segments into PHB chains did not affect its crystalline structure. Moreover, thermal stability of the copolyesters was little improved in air as compared with that of pure PHB. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1893–1903, 2002     

Piezoelectric relaxation in poly(γ-benzyl-glutamate)

The piezoelectric d- and e-constants, together with the elastic constant and the dielectric constant, were measured for oriented poly(γ-benzyl-glutamate) (PBG) films with various elongation ratios as a function of frequency and temperature, using an apparatus developed by us. The results are discussed in terms of a general theory of piezoelectricity for inhomogeneous systems, in particular for a disperse two-phase system. The piezoelectricity of PBG film is proved to originate from the piezoelectric and optically active symmetry of PBG crystallities and their orientation distribution by three findings: (1) the d₁₄ component of the piezoelectric matrix, which is the only component for a uniaxially or uniplanarly oriented system, is observed; (2) d₁₄ > 0 for PBDG and d₁₄ < 0 for PBLG; (3) d₁₄ is proportional to the degree of orientation F_c of PBG crystallites, as determined by x-ray diffraction. By extrapolating to perfect orientation, d₁₄ is determined to be 5 × 10^?8 cgs esu, if the side chains of PBG are rigid. The piezoelectric relaxation of PBG due to thermal motion of the side chains has a dual character: it is relaxational at lower frequencies and retardational at higher frequencies. On the assumption that the α-helical main chains surrounded by the bulky side chains are responsible for the origin of the piezoelectricity, such relaxation phenomena are interpreted in terms of the relaxation of the local elastic field in the main chains. An equivalent model having the same frequency characteristics is proposed to include the higher order structure of the PBG film.     

High resolution electron microscopy of β‐poly(ethylene naphthoate)

The β phase of poly(ethylene naphthoate) is suggested by high resolution electron microscopy and electron diffraction data to be monoclinic, with a = 1.320 nm, b = 0.962 nm, c = 1.300 nm, α = 131.50°, β = 90°, and γ = 90° and space group P2₁/n 1 1. A model structure has been presented which accounts quantitatively for the observed intensities of the hk0 reflections and provides qualitative agreement with the hkl data.     

On the isomorphism of poly(β‐hydroxybutyrate‐co‐β‐hydroxyvalerate) random copolymers

The defect Gibbs energy of hydroxyvalerate comonomer inclusions into the crystals made up by random copolymers of poly(β‐hydroxybutyrate‐co‐β‐hydroxyvalerate) (PHB/HV) is calculated by means of the thermodynamic integration approach. The result obtained for a single inclusion is in excellent agreement with those obtained by fitting experimental melting temperature and cocrystal composition data. Lattice model calculations that cover the whole range of copolymer composition were carried out based on calculations of double inclusion, which revealed a decrease of the average defect Gibbs energy in adjacent defects. On decomposing the Gibbs energy, it is found that the configurational entropy contributes the dominant part of the defect Gibbs energy.     

Electrospun poly(ε‐caprolactone)‐based composites using synthesized β‐tricalcium phosphate

Non‐woven hybrid membranes based on poly(ε‐caprolactone) (PCL) and as‐synthesized β‐tricalcium phosphate (β‐TCP) were obtained by the electrospinning technique. A wide range of composition was investigated, the filler content spanning between 2 and 60 wt%. The synthesis of the β‐TCP powder was accomplished by titration of calcium hydroxide with phosphoric acid followed by calcination of the resulting precipitate at 1100°C. The as‐dried calcium phosphate was characterized by Inductive Coupled Plasma (AES‐ICP), thermal analysis (TG‐DTA), Fourier Transform Infrared Spectroscopy (FT‐IR), Scanning Electron Microscopy (SEM), and high temperature X‐ray diffraction analysis (HT‐XRD). The specific surface area (SSA) was evaluated by N₂ adsorption. Microstructure of PCL/TCP membranes was investigated by SEM, energy dispersion spectroscopy (EDS), XRD analysis, and SSA measurements. The average fiber diameter ranged between 1 and 2 µm, the porosity was 80–90%, and the SSA 16 m²/g. Mechanical properties were determined by uniaxial tensile test. A remarkable enhancement of the tensile modulus was observed for composites containing up to 4 wt% β‐TCP. The ultimate tensile strength ranged between 2 and 3 MPa for samples loaded up to 8 wt%. For most of the samples, the elongation at break was in the range 100–150%. Copyright © 2010 John Wiley & Sons, Ltd.