电镀锌钢硅烷-有机膦酸复合钝化膜的制备及性能表征

利用N-(β-氨乙基)-γ-氨丙基三甲氧基硅烷(AAPTMS)、γ-(2,3-环氧丙氧基)丙基三甲氧基硅烷(GPTMS)和1-羟基亚乙基-1,1-二膦酸(HEDP),在电镀锌钢基体上制备了一种新型硅烷-有机膦酸复合钝化膜.X射线光电子能谱、傅立叶变换红外光谱以及中性盐雾试验、动电位极化曲线和电化学阻抗谱测试表明:该复合钝化膜主体结构由Si—O—Si、Si—O—P等组成;120 h中性盐雾试验后白锈面积小于5%,达到铬酸盐彩色钝化膜水平;且其腐蚀反应呈现更为明显的阳极扩散控制特征,属于物理阻挡机制.     

Multiply Nitrated High‐Energy Dense Oxidizers Derived from the Simple Amino Acid Glycine

Various energetic polynitro esters, carbamates, and nitrocarbamates that were derived from the amino acid glycine were fully characterized by single‐crystal X‐ray diffraction, vibrational spectroscopy (IR and Raman), multinuclear NMR spectroscopy, elemental analysis, and differential scanning calorimetry (DSC). Owing to their positive oxygen balance, the suitability of these compounds as potential oxidizers in energetic formulations was investigated and discussed. In addition, the heats of formation of the products were calculated by using the Gaussian 09 program package at the CBS‐4M level of theory. From these values and the calculated densities (from the X‐ray data), several detonation parameters, such as detonation pressure, velocity, energy, and temperature, were computed by using the EXPLO5 code. Furthermore, their sensitivities towards impact, friction, and electrostatic discharge were tested by using a drop hammer, a friction tester (both BAM certified), and a small‐scale electrical‐discharge device, respectively.     

多孔硅表面钝化对其发光性能的影响

报道多孔硅（PS）的表面钝化对其光致发光（PL）和电致发光（EL）的影响。PL和EL谱表明,经钝化处理的PS的PL和EL强度明显增强,且发光峰位较大蓝移;存放实验表明,经钝化处理的PS的PL和EL发光强度和发光峰位具有较好的稳定性;I～V曲线显示,经钝化处理的PS发光器件具有较低的启动电压。这些结果表明：用钝化处理的方法是提高PS的PL和EL强度和稳定性及改善其器件性能的有效途径。     

Changes in the surface structure of Pd/Ta2O5 by oxygen and CO studied using X‐ray Photoelectron Spectroscopy (XPS)

Behaviors of Pd structures with different thicknesses supported by Ta₂O₅/Ta in the reaction with oxygen and CO were studied by XPS and SEM. For the samples with a Pd thickness of 3 nm, a new low‐binding‐energy component appeared in the Pd 3d level upon O₂ exposure at ～200 °C and was reduced in intensity after a subsequent CO exposure at 150 and 200 °C. The change in the Ta 4f state could also be found upon oxygen and CO exposure, indicating that both Pd and the Ta‐oxide substrate participate in the chemical reactions. For the sample with a higher Pd thickness, a positive shift in the Pd 3d level due to the oxidation of Pd was observed after exposure to O₂ at a higher temperature (280 °C). A subsequent CO exposure at ～150 °C could not reduce Pd‐oxide layers, as confirmed by the unchanged Pd 3d spectra after CO treatment, i.e. Pd‐oxide was not reactive for CO oxidation. Copyright © 2010 John Wiley & Sons, Ltd.     

Report on the 47th IUVSTA Workshop ‘Angle‐Resolved XPS: the current status and future prospects for angle‐resolved XPS of nano and subnano films’

A summary of the workshop entitled ‘Angle‐Resolved XPS: The Current Status and Future Prospects for Angle‐resolved XPS of Nano and Subnano Films’ is given, which was held at the Riviera Maya, Mexico, 26–30 March 2007, under the main sponsorship of the International Union for Vacuum Science, Technique and Applications (IUVSTA). Angle‐resolved X‐ray photoelectron spectroscopy (ARXPS) can provide detailed chemical as well as depth profile information about the near‐surface composition of materials and thin films. This workshop was held to review the present status and level of understanding of Angle‐resolved XPS, and to stimulate discussions leading to a deeper understanding of current problems and new solutions. The main goal of the workshop was to find better ways to perform experiments and, very importantly, better ways to extract information from the experimental data. This report contains summaries of presentations and discussions that were held in sessions entitled ‘Basics and Present Limits of ARXPS’, the Analysis of ARXPS Data, Applications of ARXPS, Equipment for ARXPS, and Future Developments in ARXPS'. There were 33 participants at the workshop. Copyright © 2009 John Wiley & Sons, Ltd.     

X射线荧光光谱分析

本文是“分析试验室”定期评述中“Ｘ射线荧光光谱法”学科的第六篇评述，它收集了国内学者１９９４年７月到１９９６年６月期间发表的在国内外刊物上的１４９篇文章，并对此期间我国Ｘ射线荧光光谱分析的概况和发展进行评述，内容包括ＸＲＦ仪器，同步辐射ＸＲＦ，全反射ＸＲＦ，粒子激发Ｘ射线发射光谱，定量，定性和化学态分析方法，制样技术，以及在各个科学和工业领域中的应用。     

Influence of Substituents and Functional Groups on the Surface Composition of Ionic Liquids

We have performed a systematic study addressing the surface behavior of a variety of functionalized and non‐functionalized ionic liquids (ILs). From angle‐resolved X‐ray photoelectron spectroscopy, detailed conclusions on the surface enrichment of the functional groups and the molecular orientation of the cations and anions is derived. The systems include imidazolium‐based ILs methylated at the C2 position, a phenyl‐functionalized IL, an alkoxysilane‐functionalized IL, halo‐functionalized ILs, thioether‐functionalized ILs, and amine‐functionalized ILs. The results are compared with the results for corresponding non‐functionalized ILs where available. Generally, enrichment of the functional group at the surface is only observed for systems that have very weak interaction between the functional group and the ionic head groups.     

Chemical Speciation and Bond Lengths of Organic Solutes by Core‐Level Spectroscopy: pH and Solvent Influence on p‐Aminobenzoic Acid

Through X‐ray absorption and emission spectroscopies, the chemical, electronic and structural properties of organic species in solution can be observed. Near‐edge X‐ray absorption fine structure (NEXAFS) and resonant inelastic X‐ray scattering (RIXS) measurements at the nitrogen K‐edge of para‐aminobenzoic acid reveal both pH‐ and solvent‐dependent variations in the ionisation potential (IP), 1s→π* resonances and HOMO–LUMO gap. These changes unequivocally identify the chemical species (neutral, cationic or anionic) present in solution. It is shown how this incisive chemical state sensitivity is further enhanced by the possibility of quantitative bond length determination, based on the analysis of chemical shifts in IPs and σ* shape resonances in the NEXAFS spectra. This provides experimental access to detecting even minor variations in the molecular structure of solutes in solution, thereby providing an avenue to examining computational predictions of solute properties and solute–solvent interactions.     

钝化与过钝化状态下304不锈钢的点蚀行为研究

为了进一步了解不锈钢钝化膜与过钝化膜的性质,本文对比研究了在不同电位下极化处理后304不锈钢样品的点蚀及表面膜性质,发现空白对照组样品的点蚀电位和1.1 V过钝化处理后样品的点蚀电位相近,而0.5 V钝化处理后样品的点蚀电位较高. 扫描Kelvin探针（SKP）实验结果也验证了这一现象. 扫描电子显微镜（SEM）结果显示,空白对照组样品表面只呈现一般样品抛光后形貌;0.5 V钝化处理后的样品表面被颗粒状钝化膜所覆盖,该膜层决定了样品具有较好的耐蚀性;而1.1 V过钝化处理后的样品表面出现裂缝,导致不锈钢基体继续发生严重的局部腐蚀,可能成为过钝化膜保护性变差的主要原因.     

镀锡层上钛-磷复合体系钝化膜的制备与表征

通过钛盐与磷酸盐体系复配的方法,在镀锡层表面得到了一种钛-磷复合体系钝化膜. 利用扫描电子显微镜(SEM)、X射线光电子能谱 (XPS)、盐雾试验、Tafel极化曲线和EIS交流阻抗谱测试等方法,研究了所得钝化膜的表面形貌、组成与耐蚀性能. 结果表明,得到的钝化膜层的主要组成成分为Ti₃(PO₄)₄nH₂O和TiO₂,在镀锡层表面结晶细致并有封孔的作用,因此有很好的耐蚀性能.     

Sheet AA2024‐T3: a new investigation of microstructure and composition

Sheet AA2024‐T3 is probably one of the most studied aluminium alloys in the corrosion field, because, with copper as an alloying addition, it is one of the most corrosion‐prone aluminium alloys. This paper reports new findings on the composition and distribution of intermetallic (IM) particles in AA2024‐T3 through the examination of over 80 000 compositional domains in nearly 18 000 IM particles. This work was achieved by using an electron microprobe to map out 2 × 2 mm² at a step size of 400 nm. This study revealed that the composition of individual particles can vary considerably from ‘accepted’ compositions. Domains within particles were extensive across the surface. Because such a large area was mapped, it was possible to subdivide this area and to look at the variation of particle statistics from region to region, providing some information on the statistical variation for small electrodes. Copyright © 2010 John Wiley & Sons, Ltd.     

Dibutylsilylene Derivatives of Tartaric Acid

Crystals of the bis(tert‐butyl)silylene (DTBS) derivatives of the tartaric acids were synthesized from D ‐, L ‐, rac‐, and meso‐tartaric acid and DTBS bis(trifluoromethanesulfonate): two polymorphs of Si₂tBu₄(L ‐Tart1,2;3,4H_–4) (L ‐ 1a and L ‐ 1b ), the mirror image of the denser modification (D ‐ 1b ) as well as the racemate ( 2 ), and the meso analogue Si₂tBu₄(meso‐Tart1,3;2,4H_–4) ( 3 ). The structures were determined by single‐crystal X‐ray diffraction. The threo‐configured D ‐ and L ‐ (and rac‐) tartrates were coordinated by two tBu₂Si units forming five‐membered chelate rings, whereas the erythro‐configured meso‐tartrate formed six‐membered chelate rings. The new compounds were analyzed by NMR techniques, including ²⁹Si NMR spectroscopy, and single‐crystal X‐ray crystallography.     

Electron Density of Two Bioactive Oligocyclic Indole and Oxindole Derivatives Obtained from Low‐Order X‐Ray Data and Invariom Application

For two indole and oxindole bioactive molecules, low‐order room‐temperature X‐ray data were used to generate aspherical electron density (ED) distributions by application of the invariom formalism. An analysis of the ED using the quantum theory of atoms in molecules (QTAIM) was carried out, which allowed for quantitatively examining bond orders and charge separations in various parts of the molecules. The inspection of electrostatic potentials (ESPs) and Hirshfeld surfaces provided additional information on the intermolecular interactions. Thus, reactive regions of the molecules could be identified, covalent and electrostatic contributions to interactions could be visualized, and the forces causing the crystal packing scheme could be rationalized. As the used invariom formalism needs no extra experimental effort compared to routine X‐ray analysis, its wide application is recommended because it delivers information far beyond the normally obtained steric properties. In this way, complementary contributions to drug design can be given as is demonstrated for indoles in this study, which are involved in the metabolism of plants and animals as well as in cancer therapy.     

Shape‐Dependent Catalytic Activity of Silver Nanoparticles for the Oxidation of Styrene

Metal nanoparticles with different shapes have different crystallographic faces. It is therefore of interest to study the effect of the shape of metal nanoparticles on their catalytic activity in various organic and inorganic reactions. Truncated triangular silver nanoplates with well‐defined planes were synthesized by a simple solvothermal approach. The activity of these truncated triangular silver nanoparticles was compared with that of cubic and near‐spherical silver nanoparticles in the oxidation of styrene in colloidal solution. It was found that the crystal faces of silver nanoparticles play an essential role in determining the catalytic oxidation properties. The silver nanocubes had the {100} crystal faces as the basal plane, whereas truncated triangular nanoplates and near‐spherical nanoparticles predominantly exposed the most‐stable {111} crystal faces. As a result, the rate of the reaction over the nanocubes was more than 14 times higher than that on nanoplates and four times higher than that on near‐spherical nanoparticles.