The development of a practical framework for strategic noise mapping

There currently exist a number of commercial tools which may be used to develop strategic noise maps in an effort to satisfy the requirements of EU Directive 2002/49/EC. However, these tools may not be readily available to local authorities with limited resources. This paper investigates the possibility of developing a simplified alternative to using detailed commercial software for the creation of strategic noise maps. In-house noise prediction software was used to calculate a noise map of Dublin city centre and results were compared to those of commercial standard software. The in-house software tool was then used to assess the impact of various source-dependent action plans in a time-efficient and practical manner. Measurements were also carried out at various locations throughout the test area, which were then used to investigate the accuracy of predictions. Finally, a hybrid approach to developing a strategic noise map by integrating measurements taken on-site with predictions was developed. This approach was applied to the test area and yielded a refined noise map that presented noise levels which were more reflective of the measured levels recorded on-site. This demonstrated that the method could be used to determine noise levels that would be representative of the acoustic environment experienced on-site.     

Traffic noise spectrum analysis: Dynamic modeling vs. experimental observations

This paper compares two traffic representations for the assessment of urban noise frequency spectrum: (i) a static one, based on mean vehicle speeds and flow rates, (ii) a dynamic one, which considers vehicle interactions along the network. The two representations are compared on their suitability to match real on-field noise levels, recorded on a three lane quite busy street. Representation (i) fails in reproducing spectra envelopes that correspond to this site. In particular, it underestimates low frequencies, what can conceal the real impact of traffic flow on urban sound quality. Representation (ii) greatly improves estimation. It guarantees accurate environmental noise assessment, since it reproduces all traffic situations that are encountered in the site. Moreover, its 1s-based structure allows for the evaluation of spectra variations, with a good accuracy.     

Sound field prediction in long enclosures with branches: A combined method

The propagation of sound in long enclosures with branches has been studied theoretically and experimentally, and an efficient combined method is proposed to predict the sound field in long enclosures with branches. Based on the wave-acoustics theory, the theoretical analysis of the sound field of the long enclosures with branches is performed. This paper also investigated the sound field prediction of long enclosures with branches, by using the acoustic modeling program, ODEON. The results obtained by the theoretical analysis and the numerical simulation ODEON are compared with the experimental measurements, and the characteristics of the two methods for predicting the sound field of long enclosures with branches are analyzed. Compared with the experimental results, it is found that: (1) the results predicted by the theoretical analysis fluctuate relatively large with respect to the source-receiver distance, and the sound pressure level (SPL) attenuation obtained is smaller than that measured; and (2) the results predicted by the numerical simulation is smoother, and the calculated SPL attenuation is larger than that measured. To effectively predict the sound field of long enclosures with branches, a combined numerical method is thus proposed. The effectiveness of the proposed combined method is demonstrated by the scale-model experiments.     

Effects of urban morphology on the traffic noise distribution through noise mapping: A comparative study between UK and China

Due to the rapid urban development and massive population increase in many eastern cities, the difference in urban density and morphology between typical western and eastern cities is becoming significant. This consequently makes the noise distribution in the eastern cities rather different from typical low density European cities. In this research, two representative cities with different urban densities, Greater Manchester in the UK and Wuhan in China, were selected, which have low and high average urban density respectively, and also have considerable differences in building form and traffic pattern. In the mean time, these two cities have similar urban scale and traffic amount. In each city, based on the urban morphological analyses considering urban land-use, building and road density, and noise source distribution, a number of typical urban areas, 500 * 500 m² each, were sampled. A noise-mapping software package was then used to generate generic noise maps, based on existing digital vector maps for terrain and building, and traffic data obtained by on-site measurements. The comparison results show that the average and minimum noise level in Greater Manchester samples is generally higher than that in Wuhan samples, while the maximum noise level in Wuhan samples is mostly higher. By developing a Matlab program, correlations have been analysed between noise distributions and the urban characteristics relating to urban density, such as the road and building coverage ratio. Overall, comparisons between these two typical cities have shown significant effects of urban morphology on the traffic noise distribution.     

Noise impact assessment by utilizing noise map and GIS: A case study in the city of Chungju, Republic of Korea

In this study, a scheme to develop a noise map and noise impact assessment method using GIS has been suggested. After developing a road-traffic noise map for the city of Chungju, Republic of Korea, noise impact assessment was performed through analyzing the map. A 3-dimensional terrain model was generated using digital maps and building models were prepared using the information from draft and digital maps. To develop a noise evaluation model, a noise-source map for each road was generated. The noise levels at 25 locations close to roads were measured and compared with the expected noise levels to verify the developed noise map. An excess noise map was generated by comparing the road-traffic noise map with a noise-standard map. Using the excess noise map, the areas exceeding environmental noise standards were effectively evaluated through a GIS space analysis. The 3-dimensional facade noise map was generated to calculate the number of people exposed to a certain noise level.     

基于传声器阵列过顶测量结果的飞机起落架噪声研究

应用由111个传声器组成的平面传声器阵列对当前流行的民用客机进场着陆过程中的机体噪声源进行了实验测量,本对七架窄体客机和七架宽体客机的起落架噪声进行了分析,得到了起落架噪声的频谱特性、指向特性和声级变化。研究发现,起落架噪声的频谱是由宽频随机噪声与一些较为明显的单噪声源组成,起落架噪声的指向性类似于一个水平放置的偶极子。不同飞机起落架噪声的声级相差较大,这说明可以通过重新结构设计降低起落架噪声。     

Balanced steady-state free precession with parallel imaging gives distortion-free fMRI with high temporal resolution

Research on the functions of the human brain requires that functional magnetic resonance imaging (MRI) moves towards producing images with less distortion and higher temporal and spatial resolution. This study compares passband balanced steady-state free precession (bSSFP) acquisitions with and without parallel imaging (PI) to investigate whether combining PI with this pulse sequence is a viable option for functional MRI. Such a novel combination has the potential to offer the distortion-free advantages of bSSFP with the reduced acquisition time of PI. Scans were done on a Philips 3T Intera, using the installed bSSFP pulse sequence, both with and without the sensitivity encoding (SENSE) PI option. The task was a visual flashing checkerboard, and the viewing window covered the visual cortex. Sensitivity comparisons with and without PI were done using the same manually drawn region of interest for each time course of the subject, and comparing the z-score summary statistics: number of voxels with z>2.3, the mean of those voxels, their 90th percentile and their maximum value. We show that PI greatly improves the temporal resolution in bSSFP, reducing the volume acquisition time by more than half in this study to 0.67 s with 3-mm isotropic voxels. At the same time, a statistically significant increase was found for the maximum z-score using bSSFP with PI as compared to without it (P=.02). This improvement can be understood in terms of physiological noise, as demonstrated by noise measurements. This produces observed increases in the overall temporal signal to noise of the functional time series, giving greater sensitivity to functional activations with PI. This study demonstrates for the first time the possibility of combining PI with bSSFP to achieve distortion-free functional images without loss of sensitivity and with high temporal resolution.     

Highway traffic noise prediction using method fully compliant with ISO 9613: comparison with measurements

In this study, we introduce outdoor sound simulation that is fully compliant with ISO 9613 yet with some complementary methods that enhance its applicability; for example, calculation of sound attenuation due to undulating terrain in octave bands, geometric divergence in the near-field of the source, and short-term wind effects. Using the method, we have carried out highway traffic noise prediction and measurement for 12 sites with representative road shapes and structures. In the prediction, the sound power level for a road segment was estimated by the method suggested in ASJ Model-1998 with experimental corrections to the overall noise level and spectrum. Comparing results between predicted and measured noise levels show good correspondence at direct, diffracted and reflected sound fields within 30m from the center of the near side lane.     

A highly-sensitive automatic transient laser-induced breakdown spectroscopy system with high temporal and spatial resolution

A highly-sensitive automatic transient laser-induced breakdown spectroscopy(LIBS) system is designed and integrated.It successfully avoids the delay time selecting problem in the conventional LIBS system,and realizes the LIBS data acquisition with high spatiotemporal resolution automatically.Multiple transient spectra can be obtained in each measurement,which will provide more information for spectral research.The water-vapour and liquid-water Raman scattering spectra are captured by this system,and the comparison of experimental water-vapour Raman scattering spectrum with theoretical data verifies the reliability of the LIBS system.Based on this system,the air laser induced air breakdown spectra are captured and analysed.The system is also useful for the research on water-vapour Raman Lidar remote sensing.     

A 2-dimensional detector with high spatial and temporal resolution for metastable rare gas atoms

We describe a detector for metastable rare gas atoms which allows the investigation of transverse atomic beam distributions on the single atom level with lateral dimensions of 1 m, which occur frequently in the field of atom optics. In contrast to existing detection techniques, the conversion step from the metastable atom to an electron is separated from the charge amplification to improve spatial resolution. The conversion is performed at a metal surface, which is followed by an electron-optical system imaging the electron distribution with a proper magnification onto a single electron detection unit. The spatial resolution that we achieve with this technique is on the order of 1 m, the temporal resolution on the order of 1 s. The application of the detector for atom interferometry is discussed. Received: 22 May 1996 / Revised version: 21 June 1996     

Noise annoyance assessment of various urban road vehicle pass-by noises in isolation and combined with industrial noise: A laboratory study

Noise maps are diagnosis tools which represent the noise exposure situation using the energy-based index L_den (the day–evening–night level). Two major drawbacks may be attributed to noise maps: (1) energy-based indices only account for one acoustical factor (exposure level) that may give rise to annoyance; (2) combined exposures situations are left unframed.     

Stochastic resonance in bistable systems with nonlinear dissipation and multiplicative noise: A microscopic approach

We have studied the stochastic resonance (SR) of bistable systems coupled to a bath with a nonlinear system–bath interaction, by using the microscopic, generalized Caldeira–Leggett (CL) model. The adopted CL model yields the non-Markovian Langevin equation with nonlinear dissipation and state-dependent (multiplicative) diffusion which preserve the fluctuation–dissipation relation (FDR). Results of our simulations are given as follows: (1) the spectral power amplification (SPA) exhibits SR not only for a$a$ and b$b$ but also for τ$\tau$ while the stationary probability distribution function is independent of them where a$a$ and b$b$ denote magnitudes of multiplicative and additive noises, respectively, and τ$\tau$ expresses the relaxation time of Ornstein–Uhlenbeck (OU) colored noise; (2) the SPA for coexisting additive and multiplicative noises has a single-peak but two-peak structure as functions of a$a$, b$b$ and/or τ$\tau$. Results (1) and (2) are qualitatively different from previous ones obtained by phenomenological Langevin models where the FDR is not held or indefinite. These show an importance of the FDR in a study on SR of open bistable systems.     

Performance evaluation of IDW,Kriging and multiquadric interpolation methods in producing noise mapping: A case study at the city of Isparta,Turkey

In order to produce an accurate noise map of a city or a region, it is necessary to make noise measurements at certain locations and these measurements must be modeled with the most suitable mathematical algorithm. A homogeneous and representative distribution of the noise measurement points is the first key factor in the production of sound noise maps. The second key element is the calculation of the noise values of gridding points based on noise measurement points according to the selected mathematical calculation method and the generation of maps according to these gridding points. In this study, a noise map of the Isparta city center and its periphery was produced using inverse distance weighted (IDW), Kriging and multiquadric interpolation methods with different parameters and four grid resolution. Then, the influence of parameter selection for each method was investigated in themself by taking into account grid resolution, namely 10 ∗ 10 m, 50 ∗ 50 m, 100 ∗ 100 m and 200 ∗ 200 m, and the performance of three method with 50 ∗ 50 m grid resolution were compared with each other. In addition, the noise mapping of the city of Isparta were produced by Kriging method with respect to maximum, average and minimum noise data and they were evaluated by considering the national environmental noise thresholds.     

Stochastic phase lockings in a relaxation oscillator forced by a periodic input with additive noise: A first-passage-time approach

Noise effects on phase lockings in a system consisting of a piecewise-linear van der Pol relaxation oscillator driven by a periodic input are studied. The problem of finding the period of the oscillator is reduced to the first-passage-time problem of the Ornstein-Uhlenbeck process with time-varying boundary. The probability density functions of the first-passage time are used to define the operator which governs a transition of an input phase density after one cycle of the oscillator. Phase lockings in a stochastic sense are investigated on the basis of the density evolution by the operator.     

Multiple single-point imaging (mSPI) as a tool for capturing and characterizing MR signals and repetitive signal disturbances with high temporal resolution: The MRI scanner as a high-speed camera

In this paper we aim to lay down and demonstrate the use of multiple single-point imaging (mSPI) as a tool for capturing and characterizing steady-state MR signals and repetitive disturbances thereof with high temporal resolution.