高电离态离子束箔光谱学研究

利用束箔技术研究电重离子加速器提供的47MeV能量的氖离子和94MeV能量的氩离子，分别和不同材料，不同厚度碳箔（39μg/cm^2）和铝箔（3.4mg/cm^2）相互作用，产生高电离态的氖和氩离子，并测量了这些离子的激发江谱和某些能级寿命。     

高离化态氖的类H,类He离子激光光谱的研究

利用束箔技术研究由重离子加速器提供的４７ＭｅＶ能量的Ｎｅ离子，穿过厚度为３９μｇ／ｃｍ＾２，的碳箔而产生高离化态类Ｈ（ＮｅＸ）类Ｈｅ（ＮｅⅨ）离子激发谱的情况。     

高离化态氖的类H、类He离子激发光谱的研究

利用束箔技术研究由重离子加速器提供的４７ＭｅＶ能量的Ｎｅ离子，穿过厚度为３９μｇ／ｃｍ２的碳箔而产生高离化态类Ｈ（ＮｅＸ）、类Ｈｅ（ＮｅⅨ）离子激发谱的情况。     

高离化类铜离子4s—4p跃迁的理论计算与量子电动力学效应

采用相对论多组态从头计算方法，系统计算了高离化类铜离子等电子序列Ｉｎ２０－Ｕ６３＋（Ｚ＝４９～９２）４ｓ－４ｐ跃迁波长和能级间隔，计算结果与文献的实验值和计算值作了比较。结果表明，在高离化类铜离子体系中存在更显著的量子电子动力学效应。     

产生惰性气体高价离子的新方法

此文介绍了一种产生惰性气体高价离子的新方法。在飞行时间质谱仪（ＴＯＦ－ＭＳ）上，把聚焦后的３０８ｎｍ激光掠射到不锈钢栅网上，产生超短脉冲的电子束，利用这种电子束来轰击惰性气体（Ｈｅ，Ｎｅ，Ａｒ，Ｋｒ，Ｘｅ），产生高价离子，并给出了这些离子的飞行时间质谱。这些高价离子可能是电子逐次电离气体原子产生的。这种方法可作为飞行时间质谱的一种理想的“软电离”的“点”离子源     

类钴氙离子入射Ni表面激发的红外光谱线和X射线谱

当高电荷态类钴氙离子（cobalt like -Xe, Xe²⁷⁺）入射金属Ni表面过程中,共振电子俘获释放势能完成中性化,形成多激发态的Xe原子,其外壳层电子退激辐射红外光谱线.入射离子特殊的势能释放方式、离子动能和金属表面引起离子增益的能量在极短的时间（飞秒量级）沉积靶平方纳米尺度的空间范围,引起靶表面原子激发和电离,形成复杂组态之间的跃迁,特别是偶极禁戒跃迁（电四极跃迁、磁偶极跃）和X射线发射.单离子X射线产额随入射离子的动能增加而增加. 关键词： 高电荷态离子 红外光谱线 X射线 禁戒跃迁     

高电离态Ti原子光谱的测量

在加速器上利用束箔光谱方法，测量了Ti离子的高电离态光谱。     

空心原子的K-x射线谱

报道了利用兰州重离子加速器国家实验室ECR离子源首次引出的全裸Ar离子和类氢、类氦、类锂Ar离子与Be固体表面相互作用形成的空心原子x射线实验测量结果.结果发现，同样条件下，由于K壳层电子的剥离，Ar的K-x射线单离子发射产额增加了5个量级，约为36×10-3每原子；而当L壳层存在电子时，Ar的K-x射线几乎观测不到. 关键词： 高电荷态离子 空心原子 x射线 单离子产额     

高电荷态Xe离子与He原子碰撞中的电子转移过程研究

采用位置灵敏探测和飞行时间技术研究了高电荷态Xe离子（q=15，17，19，21，23）与He原子碰撞中双电子转移截面与单电子转移截面比随入射离子电荷态的变化规律.提出一步过程假定，对扩展的经典过垒（ECB）模型进行了修正，利用修正模型计算得到的单、双电子转移绝对截面与Andersson等人和Selberg等人的实验结果很好符合，所得截面比与本实验得到的双电子转移截面与单电子俘获截面比较好符合. 关键词： 离子 原子碰撞 电荷转移 一步过程     

激光金等离子体的电子离子碰撞电离速率系数

电子离子碰撞电离过程在超组态碰撞辐射(SCROLL)模型中真实模拟非局域热动力学平衡(non-LTE)高Z材料Au激光等离子体M带谱5f-3d跃迁中各种复杂离子的电离态特性,诸如离子的平均电离度和电荷态分布是一个主要过程.基于准相对论扭曲波玻恩交换近似,采用组态平均的方法,从头计算了金M带类铁金离子-类锗金离子的电子离子碰撞电离速率系数,其中电离截面的高能行为由Bethe系数决定.结果表明:在"神光Ⅱ"实验装置诊断的电子温度～2keV,电子密度～6×1021cm-3范围内,这些参数有利于使用超组态碰撞辐射模型拟Au的激光等离子体M带细致谱5f-3d跃迁的平均电离度和电荷态分布.     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.