Comparison between DF-TEQ and LCDF-TEQ in reducing CP length for long-haul direct-detection optical OFDM transmission by computational complexity and system performance

This paper presents the comparison of using Decision Feedback Time-domain Equalizer (DF-TEQ) and Low Complexity DF-TEQ (LCDF-TEQ) to reduce Cyclic Prefix (CP) length for Optical Orthogonal Frequency Division Multiplexing (O-OFDM) transmission over 1200 km of Standard Single Mode Fiber (SSMF). Both TEQs are used immediately after the fiber channel. Numerical modeling results show that they can cancel the residual Inter Symbol Interference (ISI) and Inter Carrier Interference (ICI) caused by both the Group Velocity Dispersion (GVD) and the CP length being shorter than the Channel Impulse Response (CIR). Using these TEQs allows the reduction in size of CP, and consequently leading to system performance improvement. However, each of these TEQs adds computational complexity to the system. Therefore, the aim of this paper is to compare their performance and their computational complexities while considering different CP length and tap numbers.     

Performance comparison of wavelet packet transform based and conventional coherent optical OFDM transmission system

In this work, the performance of WPT-COOFDM system is investigated and compared to that of FFT-COOFDM system over a fiber link. Simulation results show that the longer length of wavelet filters achieve a better performance, whereas the complexity is higher. For different wavelet mother functions employed in WPT-COOFDM systems, the chromatic dispersion robust of John64E wavelet outperforms that of other wavelets, and which could be a viable alternative for coherent optical OFDM to be considered in short distance transmissions. The simulation results also show that most of the developed wavelet mother functions mainly for image processing are not suitable for COOFDM transmission for its sensitivity to chromatic dispersion.     

Ultra-broadband OFDM signal generation for 1-Tb/s super-channel coherent optical OFDM transmission

A 320.6-GHz multi-band optical OFDM signal generation scheme consisting of continuous 4,104 subcarriers is demonstrated for 1-Tb/s coherent optical OFDM (CO-OFDM) transmission. The 36 uncorrelated orthogonal bands are generated using a recirculating frequency shifter (RFS) with single laser by adjusting the loop delay of RFS to be an integer multiple of OFDM symbol period. The principle and performance of this generation scheme is studied theoretically and experimentally. The 1-Tb/s CO-OFDM signal is successfully received after 600-km SSMF fiber transmission without any dispersion compensation.     

Amplification of 12 × 10 Gb/s WDM signals with negligible FWM crosstalk in a double-pumped fiber optical parametric amplifier

We report on the amplification of 12 × 10 Gb/s wavelength-division-multiplexed signals by a double-pumped fiber optic parametric amplifier (2P-FOPA). A gain of 10 dB is obtained using a 4.3 km-long conventional dispersion shifted fiber (DSF) as nonlinear medium. Our spectra show negligible generation of spurious FWM products, and we attribute this to the small variations of the zero-dispersion wavelength of the DSF. The 2P-FOPA performance is assessed through Q-factor measurements, and we show that for output powers per channel ranging from −15 to 3 dBm the power penalty is less than 0.5 dB.     

Efficient parallel interference cancellation algorithm for multiuser detection schemes in CDMA-based 20.48-Gb/s optical MIMO-OFDM system over 1200 km of SSMF

This paper presents an efficient algorithm to cancel the parallel interference for multiuser detection (MUD) schemes in code division multiple access (CDMA) based 20.48 Gb/s optical multiple input multiple output orthogonal frequency division multiplexing (O-MIMO-OFDM) system over 1200 km of standard single mode fiber (SSMF). The performance of the system is compared by simulation results using the efficient algorithm and minimum mean square error (MMSE) schemes. It shows the superior performance of efficient algorithm.     

一种基于星座恢复的相干光OFDM系统非线性抑制方法

鉴于相干光正交频分复用系统（CO-OFDM）易受非线性效应影响,严重制约系统传输性能, 提出一种基于星座恢复的降低系统峰均值功率比（PAPR）的方法。对系统模型及作用机理进行分析,仿真结果显示,以10 Gbit/s的速率通过单模光纤传输720 km,基于星座恢复的CO-OFDM系统Q值较无非线性抑制的CO-OFDM系统有3 dB提高;另外,系统最佳限幅比例系数受色度色散影响,随着色散因子的增大,星座恢复效果也逐渐减弱,在传输240 km条件下,色散因子为12 ps/nmkm较6 ps/nmkm,限幅比例系数从0.9降低至0.8。     

Tbit/s超大容量光纤通信系统的研究进展

Tbit/s超大容量光纤传输系统促进了光纤通信技术的发展。综述了采用波分复用技术(WDM)、光时分复用技术(OTDM)和WDM/OTDM混合方式的Tbit/s超大容量光传输系统的研究现状、技术实现方式及研究的最新进展。对各种传输系统的优缺点进行了评价,对Tbit/s光纤通信系统的前景作了展望。     

100 Gb/s RZ-OOK transmission through 212 km deployed SSMF using monolithically integrated ETDM receiver module

100 Gb/s on-off keying (OOK) transmission over 212 km installed standard single-mode fibers using an Indium Phosphide (InP)-based electrical clock-data-recovery (CDR) and demultiplexer module was demonstrated. 5.5 × 10^− 11 bit error rate (BER) performance was achieved and 1.1-dB optical signal-to-noise ratio (OSNR) penalty was required at 10^− 9 BER after transmission.     

Enhanced performance for 10 Gb/s long reach RSOA based WDM-PON by using power pre-emphasized OFDM signal

An extended reach 10 Gb/s wavelength division multiplexing passive optical networks (WDM-PONs) system based on reflective semiconductor optical amplifier (RSOA) is proposed by using power pre-emphasized orthogonal frequency division multiplexing (OFDM) signal. Experimental results show that the proposed technique can effectively enhance the system performance against the limited bandwidth and chirp induced fading effect from direct modulation of RSOA. The receiver sensitivity is improved by 5 dB at the limit of BER for forward error correction (FEC) code over the 60 km and 85 km fiber transmission without any dispersion compensation module.     

Enhanced performance analysis of 10 Gbit/s optical OFDM-RoF transmission links

In this paper, we have presented analysis of 10 Gbit/s optical OFDM-RoF transmissions links with distance of 50 km and reported the improved performance by usage of a square root module (SQRT).     

面向LOFAR应用的160Gbit/s OTDM试验平台

报告了一个用于低频射频天线网络LOFAR的160 Gbit/s 演示平台.文章介绍了LOFAR网络结构以及用于LOFAR长臂的OTDM/WDM系统结构,回顾并探讨了用于实现160 Gbit/s系统的关键技术,并介绍了实验室中实现该160 Gbit/s OTDM/WDM演示平台所采用的技术方案。出于经济性考虑,所有的关键系统功能都采用自己搭建方案.     

2.50 Gbit/s optical CDMA over FSO communication system

Optical CDMA over FSO communication system is very effective to provide high data rate transmission with very low bit error rate and low amount of multiple access interference. In this paper, we have presented optical CDMA over FSO communication system to the range of 8000 m. The simulative results reveal that the transmission distance is limited mainly by the multi-access interference (MAI) which arises when there are number of users in the system because of the fact that one user data becomes noisy for all other users in the channel.     

Iterative Joint Estimation Procedure of Channel and PDP for OFDM Systems

The power-delay profile (PDP) estimation of wireless channels is an important step to generate a channel correlation matrix for channel linear minimum mean square error (LMMSE) estimation. Estimated channel frequency response can be used to obtain time dispersion characteristics that can be exploited by adaptive orthogonal frequency division multiplexing (OFDM) systems. In this paper, a joint estimator for PDP and LMMSE channel estimation is proposed. For LMMSE channel estimation, we apply a candidate set of frequency-domain channel correlation functions (CCF) and select the one that best matches the current channel to construct the channel correlation matrix. The initial candidate set is generated based on the traditional CCF calculation method for different scenarios. Then, the result of channel estimation is used as an input for the PDP estimation whereas the estimated PDP is further used to update the candidate channel correlation matrix. The enhancement of LMMSE channel estimation and PDP estimation can be achieved by the iterative joint estimation procedure. Analysis and simulation results show that in different communication scenarios, the PDP estimation error of the proposed method can approach the Cramér–Rao lower bound (CRLB) after a finite number of iterations. Moreover, the mean square error of channel estimation is close to the performance of accurate PDP-assisted LMMSE.     

Notes on use of strict optical orthogonal codes to design unequal channel spacing (UCS) frequency sequences for DWDM systems with reduced FWM crosstalk

A paper [E. Mutafungwa et al., Optics Communications 198 (4) (2001) 339] reported the use of strict optical orthogonal codes (S-OOC’s) to reduce the four-wave mixing (FWM) crosstalk in dense wavelength-division multiplexing (DWDM) systems by using our S-OOC based unequal channel spacing (UCS) scheme and our special frequency sequences constructed, without referring to the original work. Some mistakes and inaccuracies are identified in the published paper regarding interpretation of S-OOC and its associated UCS scheme, which can cause the confusion of understanding the key concepts and principle about the S-OOC based UCS scheme. As a result, in this paper we present the necessary corrections and notes which deal with the major expressions and key concepts of both S-OOC’s and our proposed scheme. In doing so, the mapping of a S-OOC sequence to the UCS frequency set is appropriately interpreted, and the characteristics of S-OOC based UCS schemes are described. Moreover, the correct evaluation of optical bandwidths is presented for DWDM systems using S-OOC based UCS schemes, and the comparison of the repeated-codeword assignments with the overlapping-codeword assignments is also carried out. Furthermore, we discuss the effect of fractional-slot occupation for frequency assignments on the bandwidth expansion of UCS-DWDM systems. These in turn can lead to correctly understanding the principles of S-OOC based UCS schemes and applying them to assign the UCS frequencies to DWDM systems for the reduction of FWM crosstalk.     

The system of L-band 2 × 10 Gb/s WDM transmission over conventional single mode fibre with 600 km by chirped fibre Bragg gratings dispersion compensation

A chirped fibre Bragg grating according to ITU-T suggested L-band （2nd channel λ1 = 1570.83 nm; 80th channel λ2 = 1603.57 nm） with more than 1800 ps/nm single channel dispersion compensation is presented in this paper, of which the cladding mode loss, the delay curve ripple and the power fluctuation of the reflected spectrum are less than 0.5 dB, 50 ps and 0.25 dB, respectively. With this new FBG as dispersion compensation device, a 2 × 10 Gb/s wavelength division multiplexing （WDM） L-band transmission of 600 km based on conventional single mode fibre （G.652 fibre） is performed without forward error correction. The bit error rate （BER） is less than 10-12 and the power penalties of the 2nd and 80th channel of L-band are 1.8 dB and 2.0 dB, respectively.     

Comparative investigation and suitability of various data formats for 10 Gb/s optical soliton transmission links at different chirps

This paper presents the comparative investigation and suitability of various data formats for optical soliton transmission links at 10 Gb/s for different chirps (−0.7 to 0.7). Here the investigations focused on data formats: NRZ, RZ soliton, RZ raised cosine and RZ super Gaussian. The comparative results and suitability of data formats is based on various performance measures such as Q-factor, eye opening, BER and jitter. It has been indicated that RZ super Gaussian yields the highest value of Q (34.08 dB), good eye opening and lowest BER.     

Comparative investigation and suitability of various data formats for 10 Gb/s optical AWG multiplexer and AWG demultiplexer based transmission links

In this paper, we have analyzed the performance and feasibility for the metropolitan area network based on arrayed waveguide grating (AWG) multiplexers and arrayed waveguide grating (AWG) demultiplexers operating at the bitrate of 10 Gb/s. In the network, the data is successfully transmitted to a distance of 50 km with a very low BER of 1 × 10⁻⁴⁰ thus improving the performance over AWG star based networks. Here, we have observed that arrayed waveguide gratings based multiplexers and demultiplexers for WDM applications prove to be capable of precise multiplexing and demultiplexing of a large number of channels with relatively low losses. This paper also presents the comparative investigation and suitability of various data formats like NRZ Rectangular, NRZ Raised cosine, RZ Rectangular, RZ Raised cosine and RZ super Gaussian for optical transmission link. It has been shown that RZ Raised cosine yields the highest value of Q, good eye opening and lowest BER.