Longitudinal phase-space coating of beam in a storage ring

In this Letter, I report on a novel scheme for beam stacking without any beam emittance dilution using a barrier rf system in synchrotrons. The general principle of the scheme called longitudinal phase-space coating, validation of the concept via multi-particle beam dynamics simulations applied to the Fermilab Recycler, and its experimental demonstration are presented. In addition, it has been shown and illustrated that the rf gymnastics involved in this scheme can be used in measuring the incoherent synchrotron tune spectrum of the beam in barrier buckets and in producing a clean hollow beam in longitudinal phase space. The method of beam stacking in synchrotrons presented here is the first of its kind.     

合肥储存环电子束流寿命分析

 电子束流寿命是个很重要的指标,直接影响合肥光源的正常运行,为此研究了影响束流寿命的因素,测量了高频腔压、耦合度以及束团长度对电子束流寿命的影响,研究显示合肥储存环的电子束流真空寿命和托歇克寿命相当;并且利用束损系统测量了因托歇克寿命的变化而造成束流损失的相对变化;通过增加耦合度增加束流的垂直发射度,有效地提高了束流的寿命,保证了合肥光源的正常运行。     

利用具有轨道角动量的光束实现微粒的旋转

采用扭转柱面镜光学系统将半导体激光抽运固体激光器产生的厄米高斯光束变换成为具有轨道角动量的扭转对称光束.利用该光束具有的轨道角动量特性研制成功了“光学扳手”， 利用“光学扳手”实现了对微米量级微粒的俘获和旋转. 关键词： 轨道角动量 扭转对称光束 光学扳手 光束变换     

合肥储存环电子束流寿命分析

电子束流寿命是个很重要的指标,直接影响合肥光源的正常运行,为此研究了影响束流寿命的因素,测量了高频腔压、耦合度以及束团长度对电子束流寿命的影响,研究显示合肥储存环的电子束流真空寿命和托歇克寿命相当;并且利用束损系统测量了因托歇克寿命的变化而造成束流损失的相对变化;通过增加耦合度增加束流的垂直发射度,有效地提高了束流的寿命,保证了合肥光源的正常运行。     

Tight focusing of double ring shaped radially polarized beam with high NA lens axicon

A method is presented for generation of a sub wavelength (0.45λ) longitudinally polarized beam, which propagates without divergence over lengths of about 8λ in free space. This is achieved by tight focusing of double ring shaped radially polarized beam with a high NA lens axicon that utilizes spherical aberration to duplicate the performance of an axicon and to create an extended focal line. The intensity distributions were calculated based on the vector diffraction theory and it was observed that in the case of high numerical aperture (NA) lens axicon, the distribution of the total intensity near the focus had little effect on the degree of truncation of the incident beam by the pupil.     

基于MATLAB的合肥光源储存环束流轨道校正系统

 闭轨畸变对合肥同步光源的束流质量产生负面影响,因此必须对闭轨畸变进行校正。本文介绍了基于MATLAB的合肥光源储存环束流轨道校正系统的工作原理、开发过程及测试结果。该系统由束流轨道测量系统、校正铁系统和控制系统组成,基于MATLAB开发的束流轨道校正程序运行于操作员界面工作站上。首先对获取的束流轨道数据进行分析和计算,然后通过控制系统改变校正铁电源的电流以改变校正铁磁场强度,从而实现轨道校正。测试结果表明：束流轨道的最大畸变由校正前的4.468 mm下降到校正后的0.299 mm;标准方差（SDEV）由校正前的2.986 mm下降到校正后的0.087 mm。该系统达到了设计目标。     

Shaping the beam profile of a partially coherent beam by a phase aperture

By use of a tensor method, an analytical formula for a partially coherent Gaussian Schell-model (GSM) beam truncated by a circular phase aperture propagating through a paraxial ABCD optical system is derived. The propagation properties of a GSM beam truncated by a circular phase aperture in free space are studied numerically. It is found that the circular phase aperture can be used to shape the beam profile of a GSM beam and generate partially coherent dark hollow or flat-topped beam, which is useful in many applications, e.g., optical trapping, free-space optical communication, and material thermal processing. The propagation factor of a GSM beam truncated by a circular phase aperture is also analyzed.     

Beam propagation of a higher-order cosh-Gaussian beam

On the basis of the second-order moment, the beam propagation of a higher-order cosh-Gaussian beam has been investigated. Two analytical expressions of the M² factor have been derived, which corresponds to the parity of the beam order n. The M² factor is determined by the beam order n and the parameter δ. The influences of the beam order n and the parameter δ on the M² factor are illustrated with numerical examples. The analytical kurtosis parameter has also been presented. The analytical formula is further simplified in the source plane and the far field, respectively. With given appropriate values of n and δ, the kurtosis parameter in the far field is smaller than 3. This research is helpful to the practical applications of a higher-order cosh-Gaussian beam.     

Optics for the lattice of the compact storage ring for a Compton X-ray source

We present two types of optics for the lattice of a compact storage ring for a Compton X-ray source. The optics design for different operation modes of the storage ring are discussed in detail. For the pulse mode optics, an IBS-suppression scheme is applied to optimize the optics for lower IBS emittance growth rate; as for the steady mode, the method to control momentum compact factor is adopted [Gladkikh P, Phys. Rev. ST Accel. Beams 8, 050702] to obtain stability of the electron beam.     

一维晶化束的辐射能损与束流冷却

 用Jacobian椭圆函数求解了一维晶化束的非线性动力学方程，并用第一类全椭圆积分表示了粒子振动周期。在经典物理学框架内，讨论了储存环中作相对论运动的带电粒子的辐射能损，以及由于辐射能损导致的束流冷却。结果表明, 由于辐射损失束流将进一步冷却。     

Optics for the lattice of the compact storage ring for a Compton X-ray source

We present two types of optics for the lattice of a compact storage ring for a Compton X-ray source. The optics design for different operation modes of the storage ring are discussed in detail. For the pulse mode optics, an IBS-suppression scheme is applied to optimize the optics for lower IBS emittance growth rate; as for the steady mode, the method to control momentum compact factor is adopted [Gladkikh P, Phys. Rev. ST Accel. Beams 8, 050702] to     

Beam combination of a radial laser array: Flat-topped beam

An analytical expression of a radial laser array for flat-topped beam is derived based on the generalized Collins formula. The intensity distribution of the resulting beam focused by a lens at the focus plane, for phase-locked and nonphase-locked cases, is studied numerically. The effect of the Fresnel number and normalized radius on intensity distribution for phase-locked and nonphase-locked cases is also presented. It is found that intensity distribution for nonphase-locked case is much less sensible to the Fresnel number and normalized radius than that of phase-locked case.     

基于MATLAB的合肥光源储存环束流轨道校正系统

闭轨畸变对合肥同步光源的束流质量产生负面影响,因此必须对闭轨畸变进行校正。本文介绍了基于MATLAB的合肥光源储存环束流轨道校正系统的工作原理、开发过程及测试结果。该系统由束流轨道测量系统、校正铁系统和控制系统组成,基于MATLAB开发的束流轨道校正程序运行于操作员界面工作站上。首先对获取的束流轨道数据进行分析和计算,然后通过控制系统改变校正铁电源的电流以改变校正铁磁场强度,从而实现轨道校正。测试结果表明：束流轨道的最大畸变由校正前的4.468 mm下降到校正后的0.299 mm;标准方差（SDEV）由校正前的2.986 mm下降到校正后的0.087 mm。该系统达到了设计目标。     

Propagation of a Lorentz-Gauss beam through a misaligned optical system

Based on the generalized integral formula and the convolution theorem of the Fourier transform, an analytical propagation formula of a Lorentz-Gauss beam passing through a misaligned paraxial optical system is derived. As numerical examples, the propagation properties of a Lorentz-Gauss beam through a misaligned thin lens with the lateral displacement and the angle displacement are graphically illustrated, respectively. The influences of the lateral displacement and the angle displacement of the misaligned thin lens on the normalized light intensity and the phase distributions are also examined, respectively.     

Angular momentum density of a Gaussian vortex beam

The Gaussian vortex beam is assumed to be linearly polarized.The analytical expression of the electric field of a linearly polarized Gaussian vortex beam propagating in free space is derived by using the vectorial Rayleigh-Sommerfeld integral formulae.The propagating magnetic field of the linearly polarized Gaussian vortex beam is presented by taking the curl of the electric field.By employing the electromagnetic field of the linearly polarized Gaussian vortex beam beyond the paraxial approximation,the analytical expression of the angular momentum density of the linearly polarized Gaussian vortex beam is derived.The three components of the angular momentum density of a linearly polarized Gaussian vortex beam are demonstrated in the reference plane.The effects of the linearly polarized angle and the topological charge on the three components of the angular momentum density are investigated.To acquire the more longitudinal angular momentum density requires such an optimal choice that the linearly polarized angle is set to be zero and the topological charge increases.This research is useful to the optical trapping,the optical guiding,and the optical manipulation.     

One-dimensional beam ordering of protons in a storage ring

The ordering of protons has been observed at a new storage ring, S-LSR, at Kyoto University. Abrupt jumps in the momentum spread and the Schottky noise power were observed for protons for the first time at a particle number of approximately 2000, upon applying electron cooling with electron currents of 25, 50, and 100 mA. The transition temperature was 0.17 and 1 meV in the longitudinal and transverse directions, respectively. The transverse temperature of the proton beam was much below that of electrons at the transition, which played an essential role in the ordering of protons.     

Numerical simulation of a Gaussian beam profile passing through a Kerr medium

The circular Gaussian beam shape has been simulated by numerical evaluation on beam shape based on z-scan method through beam radius. This method is useful in many studies such as z-scan experiments. The validity of the relation between peak and valley separation in close aperture data and the diffraction length of the beam has been investigated by this method for some real cases. The results are in good agreement with the experimental studies.     

光学渡越辐射电子束发散角二维拟合数值分析

光学渡越辐射具有良好的方向性,通过对光学渡越辐射空间分布曲线进行拟合可以对束流发散角进行计算。采用理论计算的方法,分析了电子入射到金属-介质界面时,入射角变化对光学渡越辐射二维空间分布的影响。计算分析表明,光学渡越辐射在特定偏振方向上的分布并不仅仅由电子束在该方向的发散角分量决定,同时还受到其他方向发散角分量的影响。计算对比了电子束散角一维分布和二维分布模型下光学渡越辐射空间分布的差异。结果表明,采用一维分布模型拟合计算的电子束均方根发散角存在偏差,较二维分布拟合结果偏小。