Study on Chemisorption, Catalytic Behavior, and Stability of Supported Au Catalyst for the Propylene Epoxidation Reaction

The supported Au/TiO2 and Au/TiO2-SiO2 catalysts were prepared by deposition precipitation method. The TPD study reveals that propylene oxide competes with propylene to be adsorbed on the same adsorptive center-Tin site on the surface of the catalyst and that the adsorbing capacity of the catalyst for propylene oxide is larger than that for propylene. Catalytic behavior for propylene epoxidation with H2 and O2 was tested in a micro-reactor. Under typical conditions, the selectivity for propylene oxide is over 87%. The TG curves show that PO successive oxidation cause carbon deposition on the active center and deactivation of the Au catalysts. Because the amounts of Tin site decrease significantly, and consequently the separation between Tin sites increases, the Au/TiO2-SiO2 catalyst is more stable than Au/TiO2.     

The Effects of γ-Irradiation on the Electrokinetic and Thermal Behaviour of Zirconium Hydroxide

Zirconium hydroxide particles produced by rapid precipitation at pH 10.4, 7 or 2 were subjected toγ-irradiation up to a final dose of 20 MGy. The effects of the γ-irradiation were examined by X-ray powder diffraction, laser Raman spectroscopy, differential scanning calorimetry and microelectrophoretic measurements. It was found that γ-irradiation had no influence on the behaviour of zirconium hydroxide during calcination and subsequent cooling. The results of microelectrophoretic measurements showed that γ-irradiation influences the surface properties of zirconium hydroxide as a function of the precipitation pH. Zirconium hydroxide precipitated at pH 2 proved to be the most susceptible to γ-irradiation, while the sameγ-irradiation had very little (if any) effect on the surface properties of zirconium hydroxide precipitated at pH 10.5. After γ-irradiation, the electrophoretic mobility of zirconium hydroxide precipitated at pH 2 was increased at both low and high pH, thereby indicating an increase in its adsorption capacity. The analogy observed between the pH-dependence of the effects of γ-irradiation on the electrokinetic behaviour of zirconium hydroxide and the influence of ball-milling on the thermal behaviour of zirconium hydroxide [8] suggested that the susceptibility of amorphous zirconium hydroxide increases with decrease of the precipitation pH. This revised version was published online in July 2006 with corrections to the Cover Date.     

Effect of Metallic Additives on Structure and Catalytic Properties of Supported NiPB/SiO_2 Catalyst

Supportedamorphousalloycatalystshavereceivedmuchattentioninrecentyearsbecausetheyshowlargersurfacearea,higherthermalstabilityandsuperiorcatalyticproperties'-'ascomparedwithultra-fineorrapidlyquenchedmetalmetalloidamorphousalloys.Preparation,characterizationandcatalyticperformanceofsupportedNiBcatalysthavebeenreportedbyseveralresearchgroups,however,onlyonepreparationmethodofsupportedamorphousalloycatalystcontainingNiPwasproposed"'whichwasfoundbyustobeunabletodepositNiPsufficientlyontosupport.…     

Iodine Supported on 3-Aminopropyl Silica Gel as Efficient Catalyst for Acetylation of Alcohols under Solvent-free Conditions

3-Aminopropyl silica gel (I2/APSG) was found to catalyze the acetylation of alcohols and phenols efficiently with acetic anhydride. The reaction is mild and selective with high yields. A wide variety of alcohols and phenols are selectively converted into the corresponding acetates using I2/APSG under solvent-free conditions at room temperature.     

Preparation of Nano-Sized γ-Al2O3 Supported Iron Catalyst for Fischer-Tropsch Synthesis by Solvated Metal Atom Impregnation Methods

Two types of small iron clusters supported onγ-Al2O3-RT(dehydroxylated at room temperature) andγ-Al2O3-800 (dehydroxylated at 800℃) were prepared by solvated metal atom impregnation (SMAI) techniques. The iron atom precursor complex, bis(toluene)iron(0) formed in the metal atom reactor, was impregnated intoγ-Al2O3 having different concentrations of surface hydroxyl groups to study the effect of surface hydroxylation on the crucial stage of iron cluster formation. Catalysts prepared in this way were characterized by TEM, Mossbauer, and chemisorption measurements, and the results show that higher concentration of surface hydroxyl groups ofγ-Al2O3-RT favors the formation of more positively charged supported iron cluster Fen/γ-Al2O3-RT, and the lower concentration of surface hydroxyl groups ofγ-Al2O3-800 favors the formation of basically neutral supported iron cluster Fen/γ-Al2O3-800. The measured results also indicate that the higher concentration of surface hydroxyl groups causes the rapid decomposition of precursor complex, bis(toluene)iron(0), and favors the formation of relatively large iron cluster. Consequently, these two types of catalysts show different catalytic properties in Fischer-Tropsch reaction. The catalytic pattern of Fen/γ-Al2O3-RT in F-T reaction is similar to that of the unreducedα-Fe2O3 and that of Fen/γ-Al2O3-800 is similar to that of the reducedα-Fe2O3.     

Thermal Behaviour of Anhydrous α-, β- and γ-Cyclodextrin at Low Temperature

Heat capacities of anhydrous -and -cyclodextrin were measured by adiabaticcalorimetry between 10 K and 300 K. The thermalbehaviour of the two compounds exhibits significantdifferences. -Cyclodextrin shows an anomalousexcess heat capacity in the entire region between 70 Kand 210 K. In the case of -cyclodextrin, anendothermic effect is observed at 240K. This effect isanalysed through the study of the correspondingentropy change and discussed in terms ofintramolecular organization.Using the known heat capacity values of anhydrous-CD, a comparative analysis has been developed.For each cyclodextrin, the average behaviour of abound -D-glucopyranose has been calculated andcompared. From a thermodynamic point of view, thedegree of organization of the dehydrated macrocycliccompounds could be expressed as-CD -CD -CD.     

Facile tert‐Butoxycarbonylation of Alcohols,Phenols, and Amines using BiCl3 as a Mild and Efficient Catalyst

Facile tert‐butoxycarbonylation of alcohols, phenols, and amines is described by treatment of alcohols, phenols, and amines with di‐tert‐butyl dicarbonate in the presence of a catalytic amount of bismuth(III) chloride, a mild and efficient catalyst, at room temperature in excellent yields.     

Effect of Controlled Deactivation on the Properties of a Supported Nickel Catalyst in the Reactions of Liquid-Phase Hydrogenation of Carbon–Carbon Multiple Bonds

Russian Journal of General Chemistry - The effect of controlled deactivation of Ni/SiO2 catalysts in the reactions of liquid-phase reduction of the carbon–carbon double bond in maleic acid...     

Effect of the Size of Polyacrylamide-Stabilized Palladium Nanoparticles Supported on γ-Fe2O3 on Their Catalytic Properties in the Hydrogenation of Phenylacetylene

Theoretical and Experimental Chemistry - Hydrogenation catalysts derived from palladium nanoparticles varying in size supported on maghemite (γ-Fe2O3) were obtained by varying the...     

Silica‐Gel‐Supported Aluminium Chloride: A Stable,Efficient, Selective,and Reusable Catalyst for Tetrahydropyranylation of Alcohols and Phenols

A simple, effective, and highly chemoselective method to form 2‐tetrahydropyranyl ethers of alcohols and phenols in the presence of silica‐gel‐supported aluminium chloride as a heterogeneous Lewis acid catalyst is described. The catalyst can be easily recovered and reused without appreciable change in its efficiency.     

Preparation of a PEG‐Supported Ligand as Highly Stable Palladium Catalyst and Its Efficient Recyclability in the Heck Reaction

A reagent of NNN ligands immobilized on PEG has been prepared and coordinated to Pd(OAc)₂ to provide a highly efficient and recyclable catalysis system for the Heck reaction. The reaction works very well with this catalysis system, and no palladium black is observed during the reaction. The reagent and palladium can be recycled easily and do not show significant activity decay after being reused 10 times.     

Adsorption of chlorobenzene and benzene on γ-Al2O3/atl>

Adsorption of chlorobenzene and benzene on -Al₂O₃ was investigated in the 413--572 K temperature region at an adsorbate partial pressure ranging from 2 to 1000 Pa. The adsorption isotherms were measured and the isosteric heats and the entropy characteristics of adsorption were determined. The experimentally found and theoretically calculated entropy changes upon adsorption were compared. The mobility of the molecules of both adsorbates in the adsorption layer was limited with respect to that predicted by the ideal two-dimensional gas model. The mechanism of adsorption of benzene and chlorobenzene is discussed.     

Adsorption of proteins on γ-Fe2O3 and γ-Fe2O3/SiO2 magnetic materials

Russian Journal of Physical Chemistry A - γ-Fe2O3–SiO2 composites are synthesized via the coprecipitation of a γ-Fe2O3 magnetic carrier (with specific surface S = 17 m2/g and pore...     

Effect of nitrous acid on γ-ray radiolysis and radiolytic products of N,N-dimethylhydroxylamine

Journal of Radioanalytical and Nuclear Chemistry - N, N-dimethylhydroxylamine (DMHA) is a new salt-free reductant used in spent fuel reprocessing, this paper reports the effect of HNO2 on...     

Synthesis,characterization and magnetic properties of γ-Fe2O3 nanoparticles via a non-aqueous medium

Acicular shaped γ-Fe₂O₃ nanoparticles (major axis: 17±2 nm; minor axis: 1.7±1 nm) have been prepared using lauric acid as a non-aqueous medium. The products were investigated by IR, TG-DTA, XRD, Raman, SEM, TEM and magnetization measurements. For the preparation of pure γ-Fe₂O₃ nanoparticles, the suitable condition of the molar ratio of lauric acid to iron nitrate is set 2:1 and the appropriate temperature lies in the range 573–673 K. Besides, either pure α-Fe₂O₃ or a mixture of γ-Fe₂O₃ and α-Fe₂O₃ can also be obtained with the change of the molar ratio of lauric acid to iron nitrate. The experimental results indicate that the particle sizes, thermal stability and magnetic properties of the iron oxide strongly depend on the conditions in the preparation.     

Dielectric constants of acetonitrile, γ-butyrolactone,propylene carbonate,and 1,2-dimethoxyethane as a function of pressure and temperature

The dielectric constants of 1,2-dimethoxyethane, acetonitrile, -butyrolactone, and propylene carbonate were determined from capacitance measurements extrapolated to infinite frequency; ln are reported as a function of pressure up to 80 MPa at 15, 25, 35, 45°C and as a function of temperature in the range 10 to 50°C at 0.10133 MPa. The variation of ln with temperature or pressure can be expressed by a second order polynomial expression. The isothermal compressibilities of the solvents were determined at 25°C from sound velocities, densities, and heat capacities. A simple correlation can be established between ln /P and for most aprotic solvent.     

Complete Oxidation of Methane over Palladium Supported on Alumina Modified with Calcium,Lanthanum,and Cerium Ions

The activity and thermal stability of Pd/Al_2O_3 and Pd/(Al_2O_3 MO_x)(M=Ca,La,Ce) palladium catalysts in the reaction of complete oxidation of methane are presented in this study.The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide.Then they were impregnated with palladium nitrate solution.The catalysts with unmodified alumina had a high surface area.The activity and thermal stability of the alumina- supported catalyst was also very high.The introduction of calcium,lanthanum,or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method.These modifiers decreased the activity of palladium catalysts,and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al_2O_3.The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.     

Sorption of radiocobalt on a novel γ-MnO2 hollow structure: effects of pH, ionic strength, humic substances and temperature

A novel γ-MnO₂ hollow structure has been synthesized using a simple chemical reaction between MnSO₄ and KMnO₄ in aqueous solution without using any templates, surfactants, catalysts, calcination and hydrothermal processes. As an example of potential applications, γ-MnO₂ hollow structure was used as adsorbent in radionuclide ⁶⁰Co(II) treatment, and showed an excellent ability. The effect of pH, contact time, ionic strength, humic acid (HA)/fulvic acid (FA), and temperature was investigated using batch techniques. The results indicated that the sorption of ⁶⁰Co(II) on γ-MnO₂ was obviously dependent on pH values but independent of ionic strength. The presence of HA/FA enhanced the sorption of ⁶⁰Co(II) on γ-MnO₂ at low pH, whereas reduced ⁶⁰Co(II) sorption on γ-MnO₂ at high pH. The kinetic sorption of ⁶⁰Co(II) on γ-MnO₂ can be well fitted by the pseudo-second-order rate equation. The thermodynamic parameters (ΔH ⁰, ΔS ⁰, ΔG ⁰) were also calculated from the temperature dependent sorption isotherms, and the results suggested that the sorption of ⁶⁰Co(II) on γ-MnO₂ was a spontaneous and endothermic process. The sorption of ⁶⁰Co(II) on γ-MnO₂ was attributed to surface complexation rather than ion exchange.