共查询到20条相似文献,搜索用时 15 毫秒
1.
The characteristics of Z- cut LiNbO3 optical modulators with novel complex electrode are discussed by using the finite element method (FEM) and studied experimentally in this paper. The travelling wave electrode consists of upper and lower parts. It can easily realize phase velocity matching between microwave and optical wave and drastically reduce microwave electrode loss. An electrooptic modulator with larger than 100 GHz bandwidth and half wave voltage 6 V is designed, fabricated and measured. Vπ is 5.1 V and the attenuation coefficient a0 is 0.3 dB/(cm· GHz1/2 ). The experimental results show that the modulator has great potentiality for expanding bandwidth. 相似文献
2.
3.
4.
5.
用连续波电光检测技术进行LiNbO3定向耦合波导调制器的场分布测量 总被引:2,自引:1,他引:1
本文介绍一种新颖的无损伤检测技术——连续波电光检测技术(OWEOP)对LiNbO_3定向耦合波导调制器模拟样品内场分布进行各种测量所获得的实验结果。采取了背射和端射两种测量方式,测出了波导电极条下,电极间隙区以及电极中断区电场的分布,并对实验结果进行了讨论。 相似文献
6.
7.
Cr:LiNbO_3PlanarWaveguide¥ZHUShengxiang;JIANGXuyang;QIUYuanwu(PohlInstitute,TongjiUniversity,shanghai200092)WUYongjian;XUZhen?.. 相似文献
8.
9.
10.
高掺镁LiNbO3晶体折射率温度系数的表示式 总被引:2,自引:0,他引:2
推导了掺5mol%MgO的LiNbO3晶体折射率温度系数的表示式。利用这些表示式可以计算293~428K温度和0.5398μm~1.3414μm波长范围内的折射率温度系度,结果表明:计算值和实验值的最大相对偏差是12%,用具有最大相对偏差的折射率温度系数的计算值,计算1.0795μm波长的非临界相位匹配温度,其值为382.4K,它与实验值仅差6K。因此,本文得到的表示式,对于采用这种晶体,设计在上 相似文献
11.
WANG Bao 《Chinese Journal of Lasers》1994,3(2):143-150
Measurementsofrefractiveindexprofilesofproton-exchangedLiNbO_3waveguidesusingTE-TMmodeconversionWANGBao(InstituteofOpticalCAD?.. 相似文献
12.
Single-ModeCW532nmOutputof1.3WbyInternalFrequencyDoublingwithTi:MgO:LiNbO_3¥LIJian;WULing-An(InstituteofPhysics,AcademiaSinic?.. 相似文献
13.
利用折射率椭球基本理论对线性电光效应进行了分析,对单轴晶体铌酸锂电光相位调制器的温度特性进行了研究。通过计算机进行数值模拟计算,分析了加电场时光通过LiNbO3电光调制器后出射光的相位变化与温度间的关系,得出在横向和纵向调制中温度对相位改变的影响。研究发现,无论在横向还是在纵向调制下,入射光偏振方向不同但其各自受温度影响的相位变化趋势大体一致,即随着晶体中温度的增加而增大。计算结果表明,LiNbO3电光调制的最佳使用方案为:电场沿x主轴方向施加,入射光偏振方向为感应主轴x’方向,且LiNbO3电光调制器粟用横向相位调制方式。 相似文献
14.
介绍了铌酸锂调制器在1550nm有线电视(CATV)外调制发射机中的功能及其结构,调制器集成了高频相位调制器、模拟强度调制器和无源3dB耦合器在同一芯片上。分析了CATV调制器的关键技术和解决方案,采用了新颖的非平行电极、磨凹芯片背面的结构和阻抗变换方案。设计制作的模拟强度调制器获得了优于±0.5dB平坦的响应和小于-20dB的电反射。基于工艺容差和BPM软件模拟优化设计的3dB耦合器使器件得到大于30 dB的开关消光比。 相似文献
15.
从光折变效应的单中心模型和载流子的光伏迁移机理出发给出了高斯片光在LiNbO3:Fe晶体中导致的折射率变化分布的解析表达式 .利用片光以“三明治”辐照方式在LiNbO3:Fe晶体中写入了平面光波导结构 .用切片干涉法测量了波导区的折射率分布 ,并对波导进行了简单的导光测试 .根据射线方程以及波导的折射率分布对光写入波导的导光特性进行了模拟计算分析 .研究结果表明 ,在LiNbO3:Fe晶体中光写入光波导是可行的 相似文献
16.
研究了不同锂含量的双掺铁锰铌酸锂晶体的紫外光致吸收特性,结果表明,同成分晶体的紫外光致吸收系数较低,随着锂含量的增加,晶体的紫外光致吸收系数逐渐增大,当晶体中的锂含量达到49.57mol%附近时,紫外光致吸收系数达到最大值4.20 cm-1,进一步增加晶体中的锂含量,饱和光致吸收系数开始下降。在此基础上,提出了近化学计量比双掺铁锰铌酸锂晶体的双色非挥发全息存储的三中心模型,即随着晶体锂含量的增加,双掺铁锰晶体的光折变中心除了Fe2+/Fe3+,Mn2+/Mn3+外,还将增加双极化子/小极化子中心。 相似文献
17.
减小Ce:Fe:LiNbO3晶片的厚度,扩大泵浦光束直径,时由光爬行应晶体产生衍射自增强。单光束辐照Ce:Fe:LiNbO3晶体时,出现变偏振现象等各向异性自衍射。本文对上述现象的形成机理进行了探讨。 相似文献
18.
The analysis, design, realization, and measurements of a novel intensity modulator are reported. The operating principle is based on mode coupling between a passive low-loss SiON waveguide and an electro-optic high-loss polymer waveguiding structure. Matching the waveguides is critical and results in severe demands for the technology. Extended simulations by the Coupled Mode Theory, the Leaky Wave Model, and Finite Difference Beam Propagation Method resulted in the design of several modulator structures. After realization, modulation could be demonstrated at 632 nm and at 1523 nm using lossy waveguiding modes and surface plasmon modes. 相似文献
19.
We have proposed a novel noncontact ultrasonic motor based on
non-symmetrical electrode driving. The configuration of this
electrode and the fabrication process of rotors are presented. Its vibration
characteristics are computed and analysed by using the finite element
method and studied
experimentally. Good agreement between them is obtained. Moreover,
it is also shown that this noncontact ultrasonic motor is operated in
antisymmetric radial vibration mode of $B_{21}$ mode. The maximum revolution
speed for three-blade and six-blade rotors are 5100 and 3700\,r/min at an
input voltage of 20V, respectively. Also, the noncontact high-speed
revolution of the rotors can be realized by the parts of I, III of the
electrode or
II, IV of the electrode. The levitation distance between the stator and
rotor is
about 140$\mu $m according to the theoretical calculation and the experimental
measurement. 相似文献
20.
Abstract The analysis, design, realization, and measurements of a novel intensity modulator are reported. The operating principle is based on mode coupling between a passive low-loss SiON waveguide and an electro-optic high-loss polymer waveguiding structure. Matching the waveguides is critical and results in severe demands for the technology. Extended simulations by the Coupled Mode Theory, the Leaky Wave Model, and Finite Difference Beam Propagation Method resulted in the design of several modulator structures. After realization, modulation could be demonstrated at 632 nm and at 1523 nm using lossy waveguiding modes and surface plasmon modes. 相似文献