Simultaneous demodulation technique for a multiplexed fiber Fizeau interferometer and fiber Bragg grating sensor system

We propose a demodulation technique for a multiplexed fiber Fizeau interferometer (FFI) and fiber Bragg grating (FBG) sensor system using the discrete wavelet transform with signal processing enhancements. This simple and flexible demodulation technique determines the cavity length of FFI and the Bragg wavelength of FBG simultaneously and is especially suited for quasi-static measurements. We demonstrate this demodulation technique by performing some strain measurements, and a strain resolution of 1.0 microepsilon and an accuracy of 2.6 microepsilon are obtained. The maximum cross-talk of the sensor system is 6% of the applied strains.     

利用成像光谱技术的光纤光栅多传感器复用

根据光纤光栅多传感器复用时信号的光谱特征，提出了采用成像光谱技术对复用信号进行解调的方案。在分析了成像光谱复用方案原理、推导了其测量分辨率及复用能力等主要性能指标的基础上，给出了验证实验系统及相应实验的结果。     

A simple technique for holographic multiplexing

A technique for holographic multiplexing is proposed which utilizes a combination of theta modulation and carrier frequency multiplexing. Twenty two binary transparent object were multiplexed with this technique and a resolution of 10 lines/mm with good diffraction efficiency was obtained. The technique can be used for studying the sequential events at discrete time intervals.     

Numerical simulations on the focus-shift multiplexing technique for self-referential holographic data storage

For increasing the data density of holographic data storage (HDS), combining more than two multiplexing techniques is effective. This is also true in self-referential holographic data storage (SR-HDS) that enables holographic recording purely with a single beam. In this paper, a focus-shift multiplexing technique is applied to \(xy\)-shift multiplexed SR-HDS, the feasibility of which has been shown in our previous work. The focus-shift multiplexing technique enables the multiplexing of datapages by slightly changing the focal length of the objective lens. However, the required focus-shift distance for multiplexing and the implementation method of the focus-shift have not been clarified. First, the focus-shift selectivity is investigated by the numerical simulations. In the case where the focus-shift multiplexing technique is applied to \(xy\)-shift multiplexed SR-HDS, the inter-page crosstalk properties are clarified to decide the recording layout that can achieve a low-crosstalk readout. Second, the technique of displaying an additional phase pattern onto the spatial light modulator (SLM) is introduced, which is a focus-shift method without any special optical components, such as varifocal lenses. Finally, we investigate the relationship between the accuracy of the focus-shift and the parameters of SLM.     

Multiplexed time-correlated single-photon counting

We review the technique of multiplexed time-correlated single-photon counting whereby multiple fluorescence decay curves are recorded in parallel by statistically time-sharing a single time-to-amplitude converter. Application of the multiplexing technique to measuring the fluorescence lifetime topography of a self-absorbing sample is demonstrated. Further possibilities are discussed for multiplexed optical fiber sensor networks with built-in intelligence for detecting and discriminating between different metal ions in solution.     

Orthogonal-reference-pattern-modulated shift multiplexing for collinear holographic data storage

A novel hybrid shift multiplexing method for collinear holographic data storage (CHDS) by using orthogonal reference patterns (RPs) is proposed, analyzed, and demonstrated. For this method, holograms are multiplexed by not only shifting the media but also using different RPs. Compared with the traditional method, the shift pitch for the hybrid method is substantially reduced because of the selectivity introduced by different RPs. The interpage cross talk due to Bragg mismatch and degeneracy for multiplexing holograms in the same volume by using orthogonal RPs is also attenuated by utilizing the shift selectivity of the hologram. A 1.5 μm shift pitch is experimentally achieved by using three amplitude RPs in a system that would be 4.5 μm with only one RP. This new method offers an alternative to significantly increase the data density and transfer rate of the CHDS system given that the media has ideal properties.     

Color holographic display based on azo-dye-doped liquid crystal (Invited Paper)

A multiplexed holographic display video has been achieved by using a passive azo-dye-doped liquid crystal （LC） cell. Holograms formed in this cell can be refreshed in the order of several milliseconds. By angular multiplexing technique, dynamically multiplexed holographic videos are realized. Moreover, the reconstructed RGB images are merged into a color image, which illustrates the possibility of a color holographic three-dimensional （3D） display by holographic multiplexing of the LC cell.     

Coherence-multiplexed, label-free biomolecular interaction analysis

This Letter describes an interferometric technique based on the principle of coherence multiplexing for multichannel, label-free biosensing applications. Multiple biosensors can be interrogated simultaneously with a single spectral-domain, phase-sensitive interferometer by coding the individual sensograms in coherence-multiplexed channels. The experimental results demonstrate the multiplexed quantitative biomolecular interaction of antibodies binding to antigen-coated functionalized biosensor chip surfaces. The described technique also applies to a variety of other distributed and multiplexed sensing applications besides biosensing.     

Distributed Bragg grating sensing with a direct group-delay measurement technique

A new method of distributed in-fiber Bragg grating sensing is proposed. A method is outlined by which the strain field imposed upon a Bragg grating sensor is obtained by measurement of the sensor's reflectivity and delay characteristics. The proposal is demonstrated by interrogation of two loaded samples. Strain distributions from these experiments are compared against a theoretical estimate. The data treatment is also discussed. Strain resolution is found to be +/-24 microepsilon, with a spatial resolution defined by a minimum spatial wavelength component of the coupling distribution of 1.65 mm.     

Multiplexing of encrypted data using fractal masks

In this Letter, we present to the best of our knowledge a new all-optical technique for multiple-image encryption and multiplexing, based on fractal encrypting masks. The optical architecture is a joint transform correlator. The multiplexed encrypted data are stored in a photorefractive crystal. The fractal parameters of the key can be easily tuned to lead to a multiplexing operation without cross talk effects. Experimental results that support the potential of the method are presented.     

A large capacity sensing network with identical weak fiber Bragg gratings multiplexing

A quasi-distributed optical fiber sensing network with large multiplexing capacity, which is based on identical weak fiber Bragg gratings, is proposed, theoretically analyzed and experimentally studied. The key technique is the demodulation technology named “Optical wavelength time-domain reflection (OWTDR),” which utilizes the optical power variation of reflected sensing signal in both time domain and wavelength domain. The influence of reflectivity of fiber grating, interval between adjacent gratings and transmission loss of delay fiber on the multiplexing capacity of sensing system are discussed. Analyzed results demonstrate that this sensing scheme can effectively increase the multiplexing capacity of sensing system up to 1000, implement multi-point synchronous measurement and reduce the cost of signal demodulation. 9 Identical weak fiber Bragg gratings with the same Bragg wavelength of 1536.651 nm, reflectivity of 6%, bandwidth of 0.07 nm are written in series to investigate the performance of the proposed scheme.     

Spatial domain multiplexing: A new dimension in fiber optic multiplexing

A novel multiplexing technique for fiber optic communications has been developed that supports multiple channels of optical energy inside an optical fiber by confining each individual channel to a unique spatial location. These channels can operate at exactly the same wavelength as well as differing wavelengths. The basic operating principle and experimental results for spatial domain multiplexed fiber optic communication systems is presented here. This technique adds a new dimension to currently available multiplexing schemes and has the potential to increase the bandwidth of existing and futuristic optical fiber systems by multiple folds.     

Performance Analysis of Duty-Cycle Division Multiplexing over Wavelength Division Multiplexing System

Abstract

Performance optimization of a duty-cycle division multiplexing system over 8- and 40-channel wavelength division multiplexing networks is reported in this article. The modified duty-cycle division multiplexing system with optical domain multiplexing using a dual-drive Mach–Zehnder modulator is simulated with two and three users per wavelength. Using conventional dispersion compensation, the 40 × 40-Gbps system with two and three users per channel can support 240 and 160 km of transmission distance, respectively. The dispersion management technique based on a chirped fiber Bragg grating is proposed for a 40 × 3 × 13.33-Gbps duty-cycle division multiplexing/wavelength division multiplexing system that allows double the transmission distance compared to conventional technique.     

40Gb/s光时分复用传输光纤光栅补偿色散研究

用精密扫描掩模法写入宽阻带啁啾光纤光栅,掩模板背面两端各10％长度处镀有按4阶高斯函数透过率的膜,写入的啁啾光栅的时延纹波最大值为20ps。为减少写入光纤光栅的偏振模色散,研制了新的低偏振模色散光纤光栅补偿写入法。采用补偿写入法前的平均微分群时延为9．1406 ps;采用补偿写入法后的平均微分群时延为0．1521 ps。并利用低偏振模色散光纤光栅对40Gb／s光时分复用系统在普通G．652光纤传输122km的色散进行了补偿实验,功率代价为1．5dB。     

Fiber Bragg grating-based self-referencing technique for wavelength-multiplexed intensity sensors

An amplitude-phase-conversion self-referencing technique for intensity-modulated photonic sensors that uses two different-wavelength fiber Bragg gratings is presented. With this technique, the system response has been demonstrated to be almost unafffected by network power variations as high as 90% of the total power launched by the source. We prove the multiplexing capability of this type of self-referenced fiber sensor by wavelength-division multiplexing two of them in a star network. A tunable fused biconical wavelength-division multiplexer is used for sensor addressing at the detection block, providing both good isolation and low cross-talk values.     

面向地壳形变观测的超高分辨率光纤应变传感系统

高分辨率光纤应变传感系统是地球物理学中地壳微弱形变观测的有力工具.相比于传统的地壳应变观测技术,光纤应变传感器具有测量分辨率高、抗干扰能力强、尺寸小、可复用、易于安装布设等特性,在建立新型地壳形变监测网络中具有很大的应用潜力.本文围绕面向地壳形变观测的纳应变级分辨率光纤应变传感器技术,阐述了应变传感原理与实现超高测量分辨率的机理,并详细介绍了扫频探测、Pound-Drever-Hall解调技术、边带探测、双回路锁定传感、传感器时分复用等技术及相应的传感器系统实现方案,最后,给出了超高分辨率光纤传感器在现场观测的实验结果与分析.     

调频连续波分布式光纤布拉格光栅复用系统

研究了利用调频连续波(FMCW)技术对分布式光纤布拉格光栅(FBG)复用系统进行寻址的基本原理;仿真分析了FBG传感器复用距离是系统最小分辨距离的整数倍或非整数倍时,对频谱信号的影响;搭建了基于FMCW的FBG复用系统实验平台,当传感距离1000m时,分别验证了不同扫描周期与复用系统差频信号的线性关系,及不同扫频范围与系统差频信号的线性关系。实验结果表明:FBG复用距离是系统最小分辨距离整数倍时,在测量距离1100 m范围内,系统测量最大误差为243 Hz,最大相对误差小于5%,可以实现FBG传感器的地址查询功能。     

光时分复用系统中单路时钟的提取

提出利用复用信号的时候不均匀性,采用主动光纤锁模激光器,直接从复用后的信号中提取出复用前的时钟光脉冲。考虑到电的时分复用与光的时分复用在机理上的一致性,故初步复用时分复用信号进行实验,成功地从时分复用信号中得到了复用前的时钟光脉冲。此处电的时分复用所得的结论适用于光的时分复用。     

Two-step holographic recording in photorefractive lithium niobate crystals using ultrashort laser pulses

We investigate non-volatile holographic data storage in photorefractive lithium niobate crystals. Infrared picosecond laser pulses are used to write holograms after sensitizing the crystal with blue light from a cw-laser. The dependence of the dynamic range and the photoconductivity on the pulse intensities and the recording wavelength is investigated in detail. The results can be explained by a two-center model if the mean intensity of the laser pulses is considered. We demonstrate that several fixed holograms can be multiplexed by employing the wavelength multiplexing technique.     

Monte Carlo simulations of multiplexed electronic grade CVD diamond for neutron detection

A novel and evolutionary multiplexing technique is introduced in this work where electronic grade single crystal chemical vapor deposition (CVD) diamond plates are multiplexed together in both a series and parallel configuration, sending electronic signals from each diamond plate to a single electronic acquisition system. Modeling of this novel multiplexing technique consisted of MCNPX simulations and significant post processing. The model developed allowed for the characterization of charge collection efficiency corrections to the location of charge creation to determine the effect of increasing detection medium size with respect to charge collection direction on the measured pulse height spectrum. This work was conducted to show that this technique is theoretically capable of replacing a single crystal diamond plate of similar size for use in neutron detection without the immediate need of advancing CVD diamond growth technologies. Further, this work indicates the expected pulse height evolution from a singular large single crystal diamond if such a crystal is produced in the future. The results of this work indicate that a 14.1 MeV neutron induced energy pulse of 8.4 MeV (due to the ¹²C(n,α_o)⁹Be reaction) in the pulse height spectrum has its energy resolution broadened by a factor of two to a total value of 0.225 percent for a multiplexed array with a thickness from 0.05 to 1 cm and an intrinsic detection efficiency of 25.4 percent for a 1 cm thick diamond crystal. It is also qualitatively discussed that the number of secondary neutron interactions with the diamond detector array may be about 5 percent. The results of this work indicate the capability of multiplexing diamond plates together for spectroscopic neutron detection with a combined intrinsic detection efficiency and energy resolution greater than any other diamond-based neutron detection system reported to date.