Nafion修饰电极阴极溶出伏安法测定痕量钛

本文采用Ｎａｆｉｏｎ修饰玻碳电极阴极溶出伏安法测定痕量钛。研究了Ｎａｆｉｏｎ膜的有关特性和测定的佳化条件。当富集时间为１ｍｉｎ时，Ｔｉ（Ⅳ）浓度与峰电流在１．０～５０ｎｇ／ｍｌ范围内呈线性关系。本法应用于铝合金和白泥标样中钛的测定，结果满意。     

银微盘电极上碘离子的示差脉冲溶出伏安法

基于Ｉ能与Ａｇ生成难溶出化合物特性，在银微盘电极上研究了Ｉ的示差脉冲溶出伏安法（ＤＰＳＶ）。该法不需镀汞，不要搅拌，可在较稀稀的支持电解质溶液中实施。于０．０８ｍｏｌ／ＬＨＡｃ－ＮａＣ及０．０１ｍｏｌ／ＬＥＤＴＡ介质中，能检出１．００×１０＾－８ｍｏｌ／Ｌ的Ｉ，Ｉ的浓度为５．００×１０＾－６－－１．２０×１０＾－８ｍｏｌ／Ｌ范围与峰电流有良好的线性关系。该法用于自来水中Ｉ的测定，相对偏差为４．３％     

Nafion—玻碳修饰电极阴极溶出伏安法测定痕量铋的研究

研究并提出在HNO_3-NaCl-硫脲(Tu)体系中,Nafion/玻碳(Gc)修饰电极阴极溶出伏安法测定痕量鉍的方法。表明Tu具络合协同作用,使Nation阳离子交换能力提高。本法检出限为5×10~(-9)mol/L Bi~(3+)(td:5min),电极表面易于再生,文中研究了电极过程机理,计算得[Bi(Tu)_6]~(3+)在Nafion膜中的分配系数(K_D),扩散系数(D)和选择性系数(K_H~[Bi(Tu)_6~+]~(3+))分别为7.57×10~5,5.9×10~(-11)cm~2/s及3.39。     

阴极溶出伏安法测定异烟肼的研究

报道了吸附阴极溶出伏安法测定异烟肼。探讨了电极反应机理。在０．０１ｍｇｏｌ／Ｌ硼砂底液中，峰电位为－１．４０Ｖ。峰电流与异烟肼浓度在４．０＊１０＾－７－１．５＊１０＾－５ｍｏｌ／Ｌ范围内呈良好的线性关系，相关系为０．９９１３。该方法用于异烟肼片剂的测定，获得满意结果。     

Eastman-Kodak AQ膜修饰电极阴极溶出伏安法测定痕量铁

本文用热处理法成功地制备了性能稳定的Eastman-Kodak AQ/GC修饰电极,对Fe~(3+)/Fe~(2+)及其络合阳离子在该电极上的行为进行了研究。表明AQ膜对Fe~(3+)和Fe~(2+)具有相近的交换能力,可用于Fe~(3+)或Fe~(2+)及其总量的阴极溶出伏安法测定。线性范围分别为2.0×10~(-7)～2.2×10~(-5)mol/L(Fe~(3+))和5.0×10~(-7)～2.0×10~(-5)mol/L(Fe~(2+)),检出限为1.0×10~(-7)mol/L(Fe~(3+))。文中对电极反应和再生进行了探讨。     

头孢噻肟钠降解产物在银微电极上示差脉冲阴极溶出伏安法的测定

基于包噻肟钠（ＣＴＸ）在０．１０ｍｏｌ／Ｌ ＮａＯＨ溶液中水浴降解产物含有巯基（－ＳＨ），在ＰＨ４．５ＮａＡｃ－ＨＡｃ介质中，于奶微电极上产生－灵敏的吸附伏安还原峰，峰电位Ｅｐ＝－０．５５Ｖ（ｖｓ．ＳＣＥ）。示差脉冲溶出峰电流与ＣＴＸ浓度在１．０＊１０＾－７－１．０＊１０＾－５ｍｏｌ／Ｌ范围内呈线性关系，方法可应用于模拟样品ＣＴＸ的检测，令人满意。     

Electrochemical Behavior of 6-Mercapto-Purine at Hanging Copper Amalgam Dropping Electrode and Its Trace Determination by Differential Pulse Adsorption Cathodic Stripping Voltammetry

Abstract

The electrochemical behavior of 6-MP was studied by cyclic voltammetry at a hanging copper amalgam dropping electrode (HCADE). It was found that 6-MP could form a complex with the Cu(II) stripped from the HCADE, showing a new peak at ?0.19V in the medium of 0.1mol/L LiClO₄-0.5mol/L HClO₄ solution. The mechanism of the reaction was proposed. This new peak was sensitive and could be used for the determination of trace 6-MP by differential pulse adsorption cathodic stripping voltammetry (DPAdCSV). The linear range was from 3.6×10^?10 to 5.3×10^?6 mol/L, and the detection limit was about 1.2×10^?10 mol/L (S/N=3). The method was also successfully applied to the determination of 6-MP in pharmaceutical tablets.     

Cathodic Stripping Voltammetry Of Cerium

Abstract

The experimental conditions for the accumulation of cerium as insoluble Ce₃(PO₄)₄ on a platinum indicator electrode were studied. The determination of cerium down to 0.01% in oxides of other lanthanides is described.     

Determination of Manganese by Cathodic Stripping Voltammetry on a Microfabricated Platinum Thin–film Electrode

In this work, we report on the determination of trace manganese (Mn) using cathodic stripping voltammetry (CSV) using a microfabricated sensor with a Pt thin‐film working electrode. While an essential trace metal for human health, prolonged exposure to Mn tends to gradually impair our neurological system. The potential sources of Mn exposure make it necessary to monitor the concentration in various sample matrices. Previous work by us and others suggested CSV as an effective method for measuring trace Mn. The analytical performance metrics were characterized and optimized, leading to a calculated limit of detection (LOD) of 16.3 nM (0.9 ppb) in pH 5.5, 0.2 M acetate buffer. Further, we successfully validated Mn determination in surface water with ∼90% accuracy and >97% precision as compared with inductively coupled plasma mass spectrometry (ICP‐MS) “gold standard” measurement. Ultimately, with stable, accurate and precise electrochemical performance, this Pt sensor permits rapid monitoring of Mn in environmental samples, and could potentially be used for point‐of‐use measurements if coupled with portable instrumentation.     

银微盘电极上头孢氨苄降解产物的伏安行为及其应用

基于头孢氨苄降解产物中含有巯基，能与Ａｇ＾＋生成难溶化合物的特性，在银微盘电极上研究了ＣＥＸ降解产物的伏安行为，探讨了电极反应的机理。运用示差脉冲溶出伏安法，在０．１ｍｏｌ／Ｌ ＨＡｃ－ＮａＡｃ介质中，ＣＥＸ降解产物的还原峰电流与ＣＥＸ浓度于８．０×１０＾－８－７．０×１０＾－６ｍｏｌ／Ｌ范围内呈良好线性关系；检测限为１．０×１０＾０８ｍｏｌ／Ｌ；测定了头孢氨苄胶囊中ＣＥＸ含量为９２．０％，与药典     

Determination of Phosphate by Cathodic Stripping Voltammetry at a Glassy Carbon Electrode

Abstract

The oxidation of Fe(II) in the presence of phosphate results in a film of a sparingly soluble Fe(III) phosphate salt on a glassy carbon electrode. The reaction is used as the preconcentration step in a cathodic stripping method for phosphate. The recommended procedure yields working curves which are linear over single orders-of-magnitude down to 0.1 ppm, With a 40-minute preconcentration time, 40 ppb phosphate can be detected. The method is free of interference by chloride and sulfate.     

Determining Trace Concentrations of Copper in Water by Cathodic Film Stripping Voltammetry with Adsorptive Collection

Abstract

A technique is presented for the determination of trace concentrations of copper (II) in natural water samples by cathodic stripping voltammetry of a film of copper-catechol complex ions adsorbed on the hanging mercury drop electrode. The peak height of the copper-catechol reduction peak is linearly dependent upon the copper (II) concentration between 10^?10 and 10^?7 M. The detection limit of the technique is below 10^?10 M copper (II) for a collection time of 3 minutes, but the sensitivity can be further increased four-fold by collecting for 15 minutes. The sensitivity is reduced by high concentrations of competing trace metals and of surfactants, which necessitate the use of standard additions to the sample.