Feasibility of screening large aqueous samples for thermally unstable pesticides using high efficiency packed column supercritical fluid chromatography with multiple detectors

Summary Nearly 100 pesticides were eluted with good peak shapes from silica columns using methanol/carbon dioxide mobile phases. The pesticides included organophosphorus, organochlorine, phenylurea, sulfonylurea, triazine, carbamate and phenoxyacid pesticides, demonstrating the wide applicability of SFC to pesticide analysis. A subset of 31 pesticides were on-line extracted from large water samples, typically 10 to 20 ml, but up to 100 ml. The extracts were separated on a 1.6 meter long column packed with 5 μm particles, then detected simultaneously with a photodiode array UV detector plus an electron capture (ECD) and a nitrogen-phosphorus (NPD) detector. Recovery, reproducibility, linearity, response factors and detection limits were determined. Detection limits from a 5 ml water sample were in the range of 100 to 500 parts per trillion (1/10¹²). Larger samples appear capable of lowering these limits to below 10 ppt.     

Feasibility of screening large aqueous samples for thermally unstable pesticides using high efficiency packed column supercritical fluid chromatography with multiple detectors

Summary Nearly 100 pesticides were eluted with good peak shapes from silica columns using methanol/carbon dioxide mobile phases. The pesticides included organophosphorus, organochlorine, phenylurea, sulfonylurea, triazine, carbamate and phenoxyacid pesticides, demonstrating the wide applicability of SFC to pesticide analysis. A subset of 31 pesticides were on-line extracted from large water samples, typically 10 to 20 ml, but up to 100 ml. The extracts were separated on a 1.6 meter long column packed with 5 μm particles, then detected simultaneously with a photodiode array UV detector plus an electron capture (ECD) and a nitrogen-phosphorus (NPD) detector. Recovery, reproducibility, linearity, response factors and detection limits were determined. Detection limits from a 5 ml water sample were in the range of 100 to 500 parts per trillion (1/10¹²). Larger samples appear capable of lowering these limits to below 10 ppt.     

Troubleshooting in the trace analysis of organochlorine pesticides in water samples

Summary As a consequence of the high toxicity of organochlorine pesticides their presence in water for human consumption is limited by legislation. To determine these compounds at trace levels, an extraction procedure and a highly sensitive analytical technique is necessary. In this work we have used laminar disks for the solid-phase extraction of 21 organochlorine pesticides from water. The analytical technique selected is gas chromatography with electron-capture detection. A solid-phase extraction procedure is proposed, and some problems has been encountered. Low recovery of some pesticides has been obtained, because of their adsorption by the walls of containers. To prevent this adsorption, addition of 20% methanol before the sampling step is proposed. Adsorption of pesticides by the organic matter present in water samples was also observed. Pesticides can be adsorbed by the membrane filters usually used to remove suspended particulate matter from water samples. Different kinds of filters have been tested, and the occurrence of the problem has been confirmed. The use of laminar disks in this work has overcome this problem.     

Analysis of organic pollutants in sewage by supercritical fluid extraction

Summary Analytical methods have been developed for the determination of organic pollutants of intermediate polarity in sewage. Water samples are first passed through a solid phase adsorption cartridge. The analytes are then extracted from the absorbent with supercritical CO₂ into a small volume of trapping solvent. Finally, the extracts are analyzed directly by capillary gas chromatography and gas chromatography-mass spectrometer. The various parameters (pressure, temperature, type and concentration of modifiers, trapping solvent, flow rate and volume of supercritical fluid and equilibrium time) influencing the efficiency of extraction were studied. Extraction efficiencies for the test compounds are >70%, and relative standard deviations are <4.6% (n=3). The methods established were applied to the analysis of sewage at the Lanzhou Wastewater Treatment Plant, China. 66 organic pollutants were detected, of which 15 compounds appeared in the list of priority pollutants suggested by the US EPA.     

Analytical supercritical fluid extraction of Chinese herbal medicines

Summary An analytical supercritical fluid extraction (SFE) technique, followed by GC/MS, was developed to separate and determine the volatile components in Chinese herbal medicine. Three kinds of herbs, frankincense, myrrh, andEvodia rutaecarpa were extracted and analyzed. The extraction was carried out using supercritical fluid CO₂ at 20 MPa and 50°C. The main factors affecting the efficiency and selectivity of the extraction are discussed. The results revealed the potential of supercritical fluid extraction as an analytical procedure for the study of medicinal plants.     

Supercritical fluid extraction of Kava lactones from Kava root and their separation via supercritical fluid chromatography

Summary Seven Kava lactones were extracted from Kava root using both pure and 15% ethanol modified CO₂. Most of the Kava lactones were extracted employing 100% CO₂ with an efficiency greater than 90% relative to conventional solvent extraction using organic solvents. Extraction efficiency did not increase significantly when using 15% ethanol-modified CO₂ as an extraction fluid. Separation of extracted Kava lactones was obtained using various packed columns and methanol-modified CO₂. An optimized separation was achieved using either an amino or protein C₄ column at 125 atm and 80°C. Semi-preparative separation of Kava lactones was also obtained using two columns connected in series.     

Headspace single-drop microextration for the detection of organotin compounds

The performance of single-drop microextraction (SDME), coupled with gas chromatography/mass spectrometry, was assessed for the determination of tributyltin compounds in water and solid samples. Experimental parameters impacting the performance of SDME, such as microextraction solvent and sampling and stirring time, were investigated. Analytical results obtained by SDME were compared with those generated by conventional solid phase microextraction (SPME) and liquid-liquid extraction (LLE) for the determination of TBT in PACS-2 sediment certified reference material (CRM).     

Determination of pesticides in soil samples by solid phase extraction disks

Summary A systematic study comparing the methodology and analytical results obtained in an investigation of seven pesticide residues (Molinate, Atrazine, Carbofuran, Pirimicarb, Prometryn, Malathion and Tetrachlorvinphos) in soil samples is reported. Solid-phase extraction (SPE) using glass columns and 47 mm disks of octyl and octadecyl-bonded silica was used in the pesticide analysis. The best extraction efficiency and clearest extracts are obtained with C₈ disks. The analyses were carried out by capillary gas chromatography with nitrogen and phosphorus detection. Recovery experiments were performed at ppb levels in spiked soil samples. The average recoveries of the compounds were 53–77%. Detection limits are between 5 and 30 ng g^–1 based on 5 g moist soil sample. The method was validated by comparing it with conventional liquid-liquid extraction.     

Quantitative analysis of polymer additives in low density polyethylene using supercritical fluid extraction/supercritical fluid chromatography

Analysis of low concentration polymer additives has been a challenging problem. The commonly used methods of analysis involve the initial extraction of polymer additives with solvents, often in a Soxhlet apparatus, followed by liquid, size exclusion, or gas chromatography. This paper describes the on-line super-critical fluid extraction (SFE)-supercritical fluid chromatographic (SFC) determination of different additives from low density polyethylene. Cryogenic collection was used as an interface between SFE and SFC to focus the extraction eluate before transfer to an analytical SFC column for quantitative analysis.     

Determination of pesticides in water samples by solid phase extraction and gas chromatography tandem mass spectrometry

A multiresidue method for the determination of more than 80 pesticides in water has been developed and validated. The proposed method is based on SPE followed by GC coupled to MS/MS. Different variables affecting SPE procedure, such as cartridges, sample volume and solvents were studied, and mass spectrometric conditions were optimised in order to increase selectivity and sensitivity. Calibration curves were linear over the range of 0.03-0.5 microg/L. Recoveries were in the range of 70-110% and repeatability was below 20% for the lowest calibration point. LODs ranged from 0.001 to 0.025 microg/L and LOQs from 0.003 to 0.076 microg/L. Finally, the method was successfully applied to the analysis of water samples from southeast of Spain.     

Analysis of some organochlorine pesticides in seafood samples by solid-phase extraction—Gas chromatography

Summary The use of the solid-phase extraction technique for the rapid sample preparation of organochlorine pesticides is described. Samples were simultaneously extracted, cleaned, and fractionated by the solid-phase extraction method and a further separation and determination of extracted fractions was carried out by gas chromatography with either an electron capture or a Hall electrolytic conductivity detector. The percent recovery of the extracted seven pesticides was compared to that of the conventional liquid-liquid extraction method. The analytical figures of merit., chromatograms, and statistic data are reported. The application of this method was demonstrated by a real fish sample determination with mass spectra for confirmation of Kepone detection.     

Comparison by capillary SFC and SFC-MS of soxhlet and supercritical fluid extraction of hamster feces

Components of hamster feces ranging from low molecular weight fatty acids through the expected range of triglycerides have been eluted in a single SFC run with simultaneous pressure and temperature programming. Temperature programming from 140°C to 240°C was required to provide optimum conditions for separation of the fatty acids and to move the elution region of the sterol esters away from that of the triglycerides. Data from chemical ionization and electron impact mass spectrometry of compounds separated by SFC were used to confirm identities suggested by retention measurements and to provide tentative identities of unknown compounds. SFC with flame ionization detection was used to compare Soxhlet extraction, off-line supercritical fluid extraction (SFE), and on-line SFE of the feces. Although samples obtained by Soxhlet extraction and SFE produced very similar chromatograms, SFE required far less time and consumed much smaller quantities of organic solvent.     

On-line coupled supercritical fluid extraction and chromatography for the determination of thiolcarbamate herbicides in soil matrix

Supercritical fluid extraction (SFE) was on-line coupled with supercritical fluid chromatography (SFC) for the determination of thiolcarbamate herbicides in soil matrix. Inert ODS-silica gel packings were used as a trap column for an interface between SFE and SFC and as an analytical column for the satisfactory separation of extracts. Thiolcarbamate herbicides could be extracted satisfactorily from the soil matrix, which had different characteristics. The results indicated that the proposed system was useful for the rapid determination of thiolcarbamate herbicides in soil matrices.     

Recent advances in sample introduction for supercritical fluid chromatography

New strategies for sample introduction in supercritical fluid chromatography are reviewed. Both open tubular and packed column systems are examined as the injection demands of each column type are addressed. In addition to advances made in solvent injection methods, supercritical fluid extraction (SFE) is discussed as a solventless injection technique for supercritical fluid chromatography.     

Direct coupling of capillary supercritical fluid chromatography with supercritical fluid extraction using modified carbon dioxide

Capillary supercritical fluid chromatography has been directly coupled with supercritical fluid extraction using modified carbon dioxide. The mixed fluids were prepared with a single pump on-line mixing system. The most important step in the SFE-SFC interface was the elimination of the modifier solvent. This was achieved by use of a coupled trap, 0.1 mm i.d. and 0.53 mm i.d. capillary tubing connected in series, with the collected solutes refocused on the second (0.53 mm i.d.) trap before transfer into the separation column. This enabled complete elimination of various modifier solvents and high efficiency collection of the solutes. The effect of the modifier on trapping efficiency was investigated using methanol, ethanol, dichloromethane, hexane, and toluene at a variety of concentrations. n-Eicosane was, for example, trapped quantitatively by modified carbon dioxide containing up to 13 % (w/w) methanol. The use of the technique has been demonstrated by selective extraction of n-paraffins, fatty acid methyl esters, and alcohols from a silica matrix; the effect of different modifiers on the extraction of a mixture of pesticides from soil has also been investigated.     

Multiresidue analysis of four pesticide residues in water dropwort (Oenanthe javanica) via pressurized liquid extraction, supercritical fluid extraction, and liquid-liquid extraction and gas chromatographic determination

The primary objective of this study was to simultaneously analyze the residues of the most commonly used pesticides, chlorpyrifos-methyl, endosulfan, EPN, and iprodione in the water dropwort, via accelerated solvent extraction (ASE), supercritical fluid extraction (SFE), and conventional solvent extraction (LLE) techniques. Residue levels were determined using GC with electron-capture detection (GC-ECD). The confirmation of pesticide identity was performed by GC-MS in a selected ion-monitoring (SIM) mode. In none of the ASE and SFE techniques were the extraction conditions optimized. Rather, the experimental variables were predicated on the author's experience. The ECD response for all pesticides was linear in the studied range of concentrations of 0.005-5.0 ppm, with correlation coefficients in excess of 0.9991. At each of the two studied fortification levels, the pesticides yielded recoveries in excess of 72% with RSDs between 1 and 19%. The LODs were achieved at a range of levels from 0.001 to 0.063 ppm, depending on the pesticide utilized. The LOQs, which ranged from 0.003 to 0.188 ppm, were lower than the maximum residue limits (MRLs) authorized by the Korean Food and Drug Administration (KFDA). All of the methods were applied successfully to the determination of pesticide residues in the real samples. It could, therefore, be concluded that any of the techniques utilized in this investigation might prove successful, given that the applied extraction conditions are wisely chosen.