A comparison of analytical methods for the quantification of a reactive β-cyclodextrin fixed onto cotton yarns

Cotton yarns bobbins were treated in a water bath with different concentrations of a reactive β-cyclodextrin derivative. To quantify the amount of cyclodextrin fixed on the fiber different analytical methods were tested but none of them was reliable enough in the concentration range under investigation. Therefore, a new analytical method, fast and effective, was developed. From the measurement of cyclodextrin bath exhaustion, the amount of cyclodextrin chemically fixed and that physically adsorbed on the textile substrate was estimated. Two washing cycles were carried out to investigate the cyclodextrin washing fastness.     

Current analytical methods for plant auxin quantification – A review

Plant hormones, and especially auxins, are low molecular weight compounds highly involved in the control of plant growth and development. Auxins are also broadly used in horticulture, as part of vegetative plant propagation protocols, allowing the cloning of genotypes of interest. Over the years, large efforts have been put in the development of more sensitive and precise methods of analysis and quantification of plant hormone levels in plant tissues. Although analytical techniques have evolved, and new methods have been implemented, sample preparation is still the limiting step of auxin analysis. In this review, the current methods of auxin analysis are discussed. Sample preparation procedures, including extraction, purification and derivatization, are reviewed and compared. The different analytical techniques, ranging from chromatographic and mass spectrometry methods to immunoassays and electrokinetic methods, as well as other types of detection are also discussed. Considering that auxin analysis mirrors the evolution in analytical chemistry, the number of publications describing new and/or improved methods is always increasing and we considered appropriate to update the available information. For that reason, this article aims to review the current advances in auxin analysis, and thus only reports from the past 15 years will be covered.     

Micromechanical Analysis of Thermoplastic – Thermoset Interphase

The interfacial shear strength of a pull out model between a thermoplastic fiber and thermoset matrix was analyzed. The method to analyze the interfacial quality in this kind of composite was Photoelasticity. The interfacial shear strength was measured localizing the isocromatic fringes. The Isochromatic fringe corresponds to the points along the specimen in which the principal stresses have the same value.     

Pharmaceuticals in groundwaters analytical methods and results of a monitoring program in Baden-Württemberg, Germany.

In this paper, analytical methods for the trace-level determination of 60 pharmaceuticals in aqueous samples are presented. The list of compounds amenable to the methods comprises analgesics, antiphlogistics, antirheumatics, beta-blockers, broncholytics, lipid-lowering agents (or their metabolites), antiepileptics, vasodilators, tranquillizers, antineoplastic drugs, iodinated X-ray contrast media, and antibiotics of different kind, mainly sulfonamides, macrolides, and penicillins. All methods are based on automated solid-phase extraction followed by GC-MS (after derivatization of the acid compounds) or HPLC-electrospray ionization MS-MS. After an intense validation, which included the determination of performance data according to the German standard method DIN 32645 (limit of detection, limit of identification, limit of determination), the determination of linearity, recovery, and repeatability and the study of matrix effects, the analytical methods were applied within a monitoring program on the occurrence of pharmaceuticals in groundwaters of Baden-Württemberg. During this monitoring program, it was found that several of the compounds under investigation could be detected in groundwaters and their occurrence could be traced back to an impact of municipal or industrial waste water.     

Selectivity – the hallmark of an analytical chemist: the current situation in the analytical sciences

In the scientific analytical chemical literature there is a problem in that there is a mix up of the two terms ”selectivity” and ”specificity” as indicators of the degree of interferences in analytical methods. This article gives an overview of the situation in the field of analytical sciences and ends with some recommendations in favour of using the term ”selectivity” only.     

Complementary analytical methods for the phytochemical investigation of ‘Jardin de Granville’, a rose dedicated to cosmetics

‘Jardin de Granville’ is a new hybrid rose variety dedicated to cosmetic applications. To perform an exhaustive molecular investigation of the non-volatile secondary metabolites in this cultivar, a global approach was developed, combining four chromatographic techniques (HPTLC, HPLC-DAD-ELSD, UHPLC-HRMS and GC–MS). This approach afforded an on-line phytochemical fingerprinting of four plant organs of ‘Jardin de Granville’. Despite the wide diversity of molecular families and the pronounced differences in polarity between the molecules, this analytical strategy enabled an overview of the molecular composition of each sample to be rapidly obtained by HPTLC and HPLC and the molecular content to be correctly identified thanks to coupling with mass spectrometry. Polyphenols were identified in the EtOH/H₂O extracts; triterpenes, chlorophyll derivatives and lipids were characterized in the EtOAc extracts, and the fatty acids squalene, α-tocopherol and β-sitosterol were highlighted in the heptane extracts.     

Analysis of Complex Molecular Systems: The Impact of Multivariate Analysis for Resolving the Interactions of Small Molecules with Biopolymers – a Review

This review is focused on the impact of chemometrics for resolving data sets collected from investigations of the interactions of small molecules with biopolymers. These samples have been analyzed with various instrumental techniques, such as fluorescence, ultraviolet–visible spectroscopy, and voltammetry. The impact of two powerful and demonstrably useful multivariate methods for resolution of complex data—multivariate curve resolution–alternating least squares (MCR–ALS) and parallel factor analysis (PARAFAC)—is highlighted through analysis of applications involving the interactions of small molecules with the biopolymers, serum albumin, and deoxyribonucleic acid. The outcomes illustrated that significant information extracted by the chemometric methods was unattainable by simple, univariate data analysis. In addition, although the techniques used to collect data were confined to ultraviolet–visible spectroscopy, fluorescence spectroscopy, circular dichroism, and voltammetry, data profiles produced by other techniques may also be processed. Topics considered including binding sites and modes, cooperative and competitive small molecule binding, kinetics, and thermodynamics of ligand binding, and the folding and unfolding of biopolymers. Applications of the MCR–ALS and PARAFAC methods reviewed were primarily published between 2008 and 2013.     

Analysis of decomposition processes of ausferrite in copper–nickel austempered ductile iron

Analysis of thermal decomposition processes of the ausferrite obtained during simulation of austempering heat treatment was performed on austempered ductile iron (ADI). The analysis method consisting in investigation of inverse phase transformations was applied. The material with specified phase composition and well-defined thermophysical properties, both resulting from the conducted heat treatment cycle, was heated under controlled conditions and the thermal effects—enthalpy change and volume change were recorded by means of differential scanning calorimetry (DSC) and differential dilatometry. The process of ausferrite decomposition in the range of 100–800 °C was discussed; the identification scheme and temperature sequence of phase transformations accompanying the ausferrite decomposition were established. The elaborated decomposition scheme allows selection of the ADI heat treatment and its optimization by means of the non-isothermal thermal analysis methods.     

Gender Diversity in a STEM Subfield – Analysis of a Large Scientific Society and Its Annual Conferences

Speaking engagements, serving as session chairs, and receiving awards at national meetings are essential stepping stones towards professional success for scientific researchers. Studies of gender parity in meetings of national scientific societies repeatedly uncover bias in speaker selection, engendering underrepresentation of women among featured presenters. To continue this dialogue, we analyzed membership data and annual conference programs of a large scientific society (>7000 members annually) in a male-rich (~70% males), technology-oriented STEM subfield. We detected a pronounced skew towards males among invited keynote lecturers, plenary speakers, and recipients of the society’s Senior Investigator award (15%, 13%, and 8% females, respectively). However, the proportion of females among Mid-Career and Young Investigator award recipients and oral session chairs resembled the current gender distribution of the general membership. Female members were more likely to present at the conferences and equally likely to apply and be accepted for oral presentations as their male counterparts. The gender of a session chair had no effect on the gender distribution of selected applicants. Interestingly, we identified several research subareas that were naturally enriched (i.e., not influenced by unequal selection of presenters) for either female or male participants, illustrating within a single subfield the gender divide along biology-technology line typical of all STEM disciplines. Two female-enriched topics experienced a rapid growth in popularity within the examined period, more than doubling the number of associated researchers. Collectively, these findings contribute to the contemporary discourse on gender in science and hopefully will propel positive changes within this and other societies.

Open image in new window

Graphical abstract ?

     

CMMSE: analysis and comparison of some numerical methods to solve a nonlinear fractional Gross–Pitaevskii system

Journal of Mathematical Chemistry - In this work, we introduce and theoretically analyze various computational techniques to approximate the solutions of solve a fractional extension of a double...     

Liquid chromatography with triple-quadrupole and quadrupole-time-of-flight mass spectrometry for the determination of micro-constituents – a comparison

The potential of liquid chromatography with triple-quadrupole mass spectrometry (LC-QqQ MS) was compared to that of quadrupole time-of-flight mass spectrometry (LC-Q-ToF MS) for the determination of microconstituents. Three applications were studied: (1) the ng/l quantification of five human drugs in surface water and waste-water effluents; (2) the quantification and confirmation of three corticosteroids in bovine urine at concentrations of 1–100 g/l, and; (3) the confirmation of nicotine in rat plasma. In all cases, the criteria of the EU Commission Decision 2002/657/EC were followed (for confirmation analysis two MS/MS ions were monitored, and the ratio of their abundances were calculated and compared with those of standards). With both techniques fully satisfactory results were obtained in almost all instances. That is, unequivocal confirmation according to the most stringent EU criteria, those for illegal compounds, was possible.One main advantage of LC-Q-ToF MS is that for identification and confirmation purposes, full MS/MS spectra are available after a single injection: no second injection, as required with QqQ MS, is needed. As well as the increased efficiency, the enhanced selectivity due to the impressive mass selectivity of LC-Q-ToF MS must be emphasized, which allows accurate masses of fragment ions to be calculated. Method characteristics such as linear dynamic range and repeatability were found to be essentially the same for both techniques, but LC-QqQ MS has the advantage that its detection limits are somewhat lower.     

Certified reference materials in analytical chemistry – A century of NIST contribution

Over the course of its first 100 years, the National Institute of Standards and Technology (NIST) has made numerous contributions to advancing the science and practice of analytical chemistry. Contributions to fundamental constants and reference data, such as determination of the Faraday, Avagadro’s number, and atomic masses, began at almost the beginning of the new institution when it was formed in 1901. Instrumentation development, improvement, and reproducible methods for its use have also been an important part of the NIST effort. This paper will describe what may be the organization’s most important and certainly its most unique contribution; namely, certified reference materials. Ultimately these certified reference materials would become known at NIST as standard reference materials (SRMs). It is a contribution that now has been mirrored around the world with reference materials being certified in at least 25 countries and routinely applied in more than twice that number. The result has been more accurate analyses of materials that impact our safety, health, and well-being. Received: 22 November 2000 Accepted: 22 November 2000     

Wastewater-based epidemiology to assess human exposure to personal care and household products – A review of biomarkers,analytical methods,and applications

Humans are nowadays exposed to numerous chemicals in our day-to-day life, including parabens, UV filters, phosphorous flame retardants/plasticizers, bisphenols, phthalates and alternative plasticizers, which can have different adverse effects to human health. Estimating human’s exposure to these potentially harmful substances is, therefore, of paramount importance. Human biomonitoring (HBM) is the existing approach to assess exposure to environmental contaminants, which relies on the analysis of specific human biomarkers (parent compounds and/or their metabolic products) in biological matrices from individuals. The main drawback is its implementation, which involves complex cohort studies. A novel approach, wastewater-based epidemiology (WBE), involves estimating exposure from the analysis of biomarkers in sewage (a pooled urine and feces sample of an entire population). One of the key challenges of WBE is the selection of biomarkers which are specific to human metabolism, excreted in sufficient amounts, and stable in sewage. So far, literature data on potential biomarkers for estimating exposure to these chemicals are scattered over numerous pharmacokinetic and HBM studies. Hence, this review provides a list of potential biomarkers of exposure to more than 30 widely used chemicals and report on their urinary excretion rates. Furthermore, the potential and challenges of WBE in this particular field is discussed through the review of pioneer WBE studies, which for the first time explored applicability of this novel approach to assess human exposure to environmental contaminants. In the future, WBE could be potentially applied as an “early warning system”, which could promptly identify communities with the highest exposure to environmental contaminants.     

Recent advancements in analytical methods of phosphodiesterase 5 inhibitors and their metabolitesEI北大核心CSCD

磷酸二酯酶5抑制剂(PDE5i)用于治疗勃起功能障碍和肺动脉高压等疾病。因PDE5i类药物种类繁多,理化性质各异,在体内代谢迅速且具有多种代谢途径,故生物样本检验难度大。本文介绍了PDE5i类药物及其代谢物,总结了生物样本中该类物质的沉淀蛋白法、液-液萃取法、固相萃取法和固相微萃取法等前处理方法,综述了高效液相色谱法、液相色谱质谱联用法、荧光光谱法和电化学分析法等检测方法,展望了PDE5i及其代谢物分析的未来发展方向,以期为PDE5i的药物监测和法庭科学毒物检验提供参考。     

Determination and identification of synthetic cannabinoids and their metabolites in different matrices by modern analytical techniques – a review

Synthetic cannabinoids have gained popularity due to their easy accessibility and psychoactive effects. Furthermore, they cannot be detected in urine by routine drug monitoring. The wide range of active ingredients in analyzed matrices hinders the development of a standard analytical method for their determination. Moreover, their possible side effects are not well known which increases the danger.     

Recombination in complex systems – an analytical approach

A new analytical model is proposed to describe the kinetics of trapping and recombination of charge carriers in complex systems with an arbitrary spatial distribution of traps and recombination centres. The structural properties of a material are described by two functions Γ_m and Γ_n irrespective of the thermal history of the sample. A simple method is proposed to determine the function Γ_m from simultaneous thermoluminescence (TL) and thermally stimulated conductivity (TSC) measurements.