A new volumetric method for microdetermination of tellurium or mercury

Summary A volumetric method for the determination of tellurium(IV) or mercury(II) in the mg range is proposed by using the redox process. Reduction is effected by boiling with an excess of reducing sugar in alkali solution. The metals obtained are re-oxidised by means of ferric chloride solutions. The ferrous ions formed are titrated against a standard solution of ceric sulphate using N-phenyl anthranilic acid as indicator. The interference due to various cations has been investigated.

---

Zusammenfassung Ein neues oxydimetrisches Verfahren zur Bestimmung von Tellur(IV) oder von Quecksilber(II) im Milligrammaßstab wird vorgeschlagen. Die mit einem Überschuß von reduzierendem Zucker in alkalischem Milieu bei Siedehitze reduzierten Metalle werden mit Eisen(III)-chlorid reoxydiert. Das dabei entstandene Eisen(II) wird mit Cersulfat gegen N-Phenylanthranilsäure als Indikator titriert. Die Störung durch verschiedene Kationen wurde untersucht.

     

A new method for the deprotection of benzyl ethers or the selective protection of alcohols

A new selective method for the deprotection of benzyl ethers situated next to alcohols in the alpha, beta, or gamma position is presented which uses either NIS or DIB/I2 as a reagent. After initial formation of a hypoiodite intermediate, the reaction is believed to follow a radical pathway to resemble the Hoffman-Loffler-Freytag reaction. The formation of the intermediate hypoiodite is suggested on the basis of NMR studies. Depending on the substrate, the corresponding benzylidene derivatives or diols are isolated.     

A new synthetic method: Direct replacement of the nitro group by hydrogen or deuterium

The nitro group in tertiary or secondary aliphatic nitro compounds is replaced by hydrogen or deuterium on treatment with tributyltin hydride or tributyltin deuteride, respectively.     

A new glycosylation method part 3: study of microwave effects at low temperatures to control reaction pathways and reduce byproducts

The efficiency of microwave irradiation at low temperature for glycosylations is described. Although oligosaccharide synthesis usually requires reactive donors for glycosylations, which have leaving groups on the anomer positions, i.e., trichloroacetoimidates, halogenates, thioalkyl glycosides, etc., the suitable donors in our microwave supported synthesis of Lewis X oligosaccharide were very stable acetate derivatives. Regarding glycosylation with a fucosyl acetate donor and a glucosamine acceptor, microwave irradiation with simultaneous cooling improved yields. Moreover, further synthesis to Lewis X derivatives was achieved only with microwave irradiation at low temperatures. Without microwave irradiation, we could only obtain byproducts and none of the designed product at any reaction temperature.     

A new objective method to compare different color reactions for the detection of cyclic ureides.

Modifications of the Zwikker- and Parri color detection tests were examined and compared according to their ability to distinguish between nine different barbituric acids and hydantoins. These tests comprised the formation of complexes with cobalt(II) and copper(II) salts and organic amines. Using the color palette introduced herein, the evaluation of the tests could be reduced to a simple yes/no decision on the basis of only seven defined colors. Suitable components for the color tests could be selected from the thirty six modifications.     

A new analysis method with GC or GC-MS for the quick detection of pesticide residues in vegetables

A new analytical method for gas chromatography (GC) or GC-mass spectrometry (MS) using the direct sampling technique is described. This direct sampling technique, which bypasses the conventional complicated sample pretreatment process, is applicable to cases of fast detection of pesticide residues in foods and large-scale screening of samples by portable GC in field detection. By a direct sampling technique, the vegetable sample is ground into paste, and 30 mg is placed directly into the evaporating chamber for GC-MS identification and quantitation (by full-scan mode). The GC column used is an HP-5 (30.0-m x 250-microm x 0.25-microm, 5% phenyl methyl siloxane). Chlorpyrifos, bromophos, fenpropathrin, gamma-666, and pp'-DDT are chosen to represent organophosphorus, pyrethrins, and organochlorine pesticides because they are chief objects of the detection of pesticide residues in vegetables. Rape, a common and mass-consumed vegetable in China, is chosen as the sample in this study. The detection limits for these pesticides by the full-scan mode are all below the maximum pesticide residue limit of vegetables set by the Ministry of Agriculture of China, and the reproducibility of this method is acceptable. This analysis method is proven to be simple, quick, and reliable and is suitable for multipesticide residues analysis of vegetables. It can also be used in the analysis of vegetable components and signal chemicals.     

A new simple and convenient method for preparation of oligonucleotides containing a pyrene or a cholesterol moiety

Russian Chemical Bulletin - A new simple and convenient approach to the synthesis of oligonucleotides containing pyrene or cholesterol moieties is described. The approach does not require a special...     

A new experimental method to distinguish two different mechanisms for a category of oscillators involving mass transfer

We present new experimental evidence that further confirms that a combination of electrochemical reactions and diffusion–convection (ERDC) mass transfer accounts for the potential oscillations that appear under conditions of transport limited current. A typical example is given for the reduction of Fe(CN)₆³⁻ in alkaline solution accompanying periodic hydrogen evolution. No potential oscillations occur by simply replacing the hydrogen evolution with IO₃⁻ reduction as the second current carrier. That replacement removes only the convection mass transfer induced by the hydrogen evolution, and retains the negative differential resistance (NDR) from the Frumkin repulsive effect. The key role of hydrogen evolution is thus to restore the Fe(CN)₆³⁻ surface concentration after its depleting to zero by diffusion-limited reduction, rather than purely a second current carrier. Therefore, the other mechanism, which emphasizes the NDR from the Frumkin interaction due to electrostatic repulsion, is excluded because it does not have a direct connection with the oscillations. Moreover, a crossing cycle in cyclic voltammograms is a more convincible criterion for this category of electrochemical oscillators than the negative impedance.     

A new method to test the effectiveness of sunscreen ingredients in a novel nano-surface skin cell mimic

Photophysical properties of sunscreens are commonly studied in solvent media, which do not mimic the skin, or in complex artificial skin systems, which are difficult to handle. In an earlier study, we showed that polystyrene nanosphere suspensions mimic the mixed polarity environment of skin cell systems. This paper presents a new method to quantify the effectiveness of sunscreens in the polystyrene nanosphere environment. This method utilizes the intrinsic UV-B fluorescence of polystyrene nanospheres. We studied three UV-B sunscreens by this new method and compared their extinction coefficients with observed values in solvent. The values follow the trend observed in solvents, but the ratio of their extinction coefficient in solvent to the value obtained by this new method is 1.3-1.8 instead of 1. This difference might be caused by the mixed polarity or the microgeometry of the nanosphere system. Regardless of the difference in the extinction coefficients, this new system can be used to test hundreds of chemicals for their sunscreening potential in a cost-effective way. One marked advantage of this new method is its ability to test both hydrophobic and hydrophilic sunscreening chemicals in the same environment. This is virtually impossible for current solvent-based models, which require different solvents for hydrophobic and hydrophilic chemicals. The new method also allows the simultaneous evaluation of a host of photophysical properties of sunscreening chemicals.     

Metallobiochemistry of current environmental levels of trace metals: A new method of cyclotron production of48V for toxicological studies

No-carrier-added⁴⁸V at 37 Mbq (mCi) levels was produced at the JRC-Ispra cyclotron by (, n) reactions on a scandium target and used to label environmental and physiological levels of vanadium for metallobiochemical investigations. The radiochemical separation of⁴⁸V from Sc is very simple and rapid and involves a single chromatographic step after fast dissolution of the bombarded target. The yield of the separation and the radioisotopic purity of the separated⁴⁸V were nearly 100% A summary of the main results concerning different metabolic investigations on rats including absorption, retention, transfer of⁴⁸V from mothers to newborns, binding with enzymes as well as uptake by cell culture system is reported.At the time of this study visiting scientists at the^4,5Radiochemistry and³Functional Materials Divisions of the JRC-Ispra.     

A new method for the determination of plutonium and americium using high pressure microwave digestion and alpha-spectrometry or ICP-SMS

Plutonium and americium are radionuclides particularly difficult to measure in environmental samples because they are α-emitters and therefore necessitate a careful separation before any measurement, either using radiometric methods or ICP-SMS. Recent developments in extraction chromatography resins such as Eichrom^® TRU and TEVA have resolved many of the analytical problems but drawbacks such as low recovery and spectral interferences still occasionally occur. Here, we report on the use of the new Eichrom^® DGA resin in association with TEVA resin and high pressure microwave acid leaching for the sequential determination of plutonium and americium in environmental samples. The method results in average recoveries of 83 ± 15% for plutonium and 73 ± 22% for americium (n = 60), and a less than 10% deviation from reference values of four IAEA reference materials and three samples from intercomparisons exercises. The method is also suitable for measuring ²³⁹Pu in water samples at the μBq/l level, if ICP-SMS is used for the measurement.     

A new and simple method to determine trace levels of sulfonamides in honey by high performance liquid chromatography with fluorescence detection

A novel method for the simultaneous analysis at trace level of sulfonamides (sulfaguanidine, sulfanilamide, sulfacetamide, sulfathiazole, sulfapyridine, sulfachloropyridazine, sulfamerazine, sulfameter, sulfamethazine, sulfadoxine, sulfadiazine, sulfamonomethoxine, sulfadimethoxine) in honey is described. Methanol has been used in the sample treatment step to avoid the emulsion formation and to break the N-glycosidic bond between sugars and sulfonamides. The determination is carried out by liquid chromatography in gradient elution mode, with fluorescence detection after the on-line pre-column derivatization with fluorescamine. The influence of parameters such as the mobile phase composition, column temperature, pH or injection volume, on the separation has been taken into account and the derivatization step has also been optimized. Recoveries of the compounds on spiked honey samples ranged from 56% for sulfadoxine to 96% for sulfacetamide, with relative standard deviations below 10%. The quantitation limits are between 4 and 15 ng g⁻¹.     

A new method to evaluate the stability of the covalent compound: by the charges on the common atom or group

A new method of comparing and analyzing the electrostatic potential (ESP) charges of the common atom or group to evaluate and compare the stabilities of covalent compounds was introduced. That is, covalent compounds will become more stable when the electron acceptors accept adequate electrons and possess adequate negative charges, and the electron donors donate adequate electrons and possess adequate positive charges accordingly. All calculations were performed by density functional theory (DFT) and the general gradient approximation (GGA) method with the Beck-LYP hybrid functional and the DNP basis set in Acceryls' code Dmol3. Calculation results verified the method considering the molecular structure is well applied in the covalent molecule systems of hydrides, oxides, alkyl radicals, and nitro compounds. Furthermore, the method has good operability, for the charges can be easily obtained by simple calculation.     

A new one-Pot method for the synthesis of alpha-siloxyamides from aldehydes or ketones and its application to the synthesis of (-)-bestatin

A new one-pot method for the synthesis of alpha-siloxyamides is described. The three substrates, H-C(CN)(2)O-SiMe(2)t-Bu, aldehydes or ketones, and primary or secondary amines, are simply mixed in one portion in acetonitrile or ether; the alpha-siloxyamides are obtained within short peroids in excellent yields in many cases. As a demonstration of our method, the synthesis of (-)-bestatin was carried out.