Influence of a structurally damaged surface layer of the hexagonal crystal on the dispersion and attenuation of Rayleigh surface acoustic waves

Analytical expressions for the dispersion of the phase velocity and the inverse attenuation length of Rayleigh waves are derived with allowance made for a thin (as compared to the length of the surface wave) isotropic damaged surface layer that is contiguous with vacuum and located on the surface of a hexagonal crystal with the sixfold axis perpendicular to the surface. It is demonstrated that, in the limit of long wavelengths (as compared to the characteristic inhomogeneity size), which is of greatest interest for experimenters, the change in the dispersion of the phase velocity of Rayleigh waves is proportional to the second power of the frequency, whereas the inverse attenuation length of Rayleigh waves is proportional to the fifth power of the frequency. The inverse attenuation length of the Rayleigh wave is calculated numerically. The calculation method previously proposed by one of the authors (Kosachev, 1998) is generalized to the case of an isotropic damaged layer on an anisotropic (hexagonal) substrate.     

Dispersion and attenuation of surface shear acoustic waves with horizontal polarization on the free statistically rough surface of the hexagonal crystal

Expressions for dispersion of the phase velocity and inverse damping depth of surface acoustic waves with shear horizontal polarization are derived in an analytical form within perturbation theory using the modified mean-field method for the Z-cut hexagonal crystal with a free statically rough surface. Both two-and one-dimensionally rough surfaces are considered. The one-dimensionally rough surface is considered as a special case of the two-dimensionally rough surface. It is shown that shear surface waves with horizontal polarization cannot exist on the flat surface of the Z-cut hexagonal crystal. The derived expressions are studied analytically and numerically in the entire frequency range accessible in perturbation theory. The long-wavelength limit (most interesting from the experimental point of view) is considered, where the wavelength is much longer than the roughness correlation radius. The conditions for the existence of SH-polarized waves are determined for both roughness types. It is shown that dispersion and attenuation of SH polarized waves are qualitatively similar in character to those we considered previously for an isotropic medium.     

Dispersion and attenuation of surface acoustic waves of shear horizontal polarization on a free surface of a hexagonal crystal with a structurally damaged isotropic surface layer

The phase velocity dispersion and the inverse attenuation length of surface acoustic waves of shear horizontal polarization propagating along a free flat (smooth) surface of a hexagonal crystal (Z cut) in the presence of a thin (compared to the wavelength) structurally damaged surface layer are found in the analytical form. It is shown that, in the long-wavelength limit (the wavelength is large compared to the characteristic size of layer inhomogeneities), which is of the greatest interest to experimenters, the change in the phase velocity dispersion and the change in the inverse attenuation length are proportional to the third and sixth powers of the wave frequency, respectively. The inverse attenuation length is numerically calculated.     

Reflection and refraction of bulk acoustic waves in piezoelectrics under uniaxial stress

Basic equations that describe the conditions of reflection and refraction of bulk acoustic waves at the boundary between acentric crystalline media under uniaxial stress are presented. The effect of uniaxial stress on the anisotropy of reflection and refraction of bulk acoustic waves is numerically analyzed for boundaries of the crystal-vacuum, piezoelectric crystal-piezoelectric crystal, and piezoelectric crystal-elastic isotropic medium types.     

Nearly backward reflection of bulk acoustic waves at grazing incidence in a TeO2 crystal

Reflection of bulk acoustic waves in a TeO₂ acoustooptic single crystal is studied for the case of a grazing incidence on the free crystal-vacuum boundary. The propagation and reflection of elastic waves is considered in the XOY plane of the material cut out in the form of a rectangular prism. An extraordinary case of reflection at the grazing incidence, when the energy flow of one of the two reflected waves in the crystal is directed opposite to that of the incident wave, is studied. It is shown that the transformation of the incident elastic energy into the energy of the backward-reflected wave can occur with an efficiency close to 100% and can be observed in a wide range of crystal cut angles. An abrupt change of the reflection coefficients in the vicinity of the critical angle is predicted.     

Reflection and refraction of surface acoustic waves by a periodic domain structure

Reflection and refraction of surface acoustic waves by a periodic domain structure formed in lithium niobate is studied. A second harmonic generation is observed. A mechanism underlying the linear and nonlinear interactions of acoustic waves with a periodic domain structure is proposed.     

Visualization of inverse phase velocity surfaces of bulk and surface acoustic waves

Diffraction of light by ultrasound has been used to study complete cuts of the inverse phase velocity surfaces for both bulk and surface acoustic waves in lithium niobate.     

Reflection and mode conversion of surface acoustic waves studied by scanning acoustic force microscopy

We present measurements of the reflection and mode conversion of surface acoustic waves (SAWs) by scanning acoustic force microscopy (SAFM). The SAFM offers a unique combination of high lateral resolution and high sensitivity towards acoustic modes of all polarizations. Since a SAW mixing experiment of two waves can be performed even if the amplitude difference between both waves is 40 dB, wavefields of extremely small amplitudes can be investigated. Using SAFM, the reflection of SAWs from a metallic wedge is investigated with submicron lateral resolution. We are able to identify two reflected wave modes, a Love and a non-coupling Rayleigh mode, by measuring their phase velocities. Received: 4 December 2000 / Accepted: 6 December 2000 / Published online: 9 February 2001     

Solitary surface acoustic waves and bulk solitons in nanosecond and picosecond laser ultrasonics

Recent achievements of nonlinear acoustics concerning the realization of solitons and solitary waves in crystals and their surfaces attained by nanosecond and picosecond laser ultrasonics are discussed and compared. The corresponding pump-probe setups are described, which allow an all-optical contact-free excitation and detection of short strain pulses in the broad frequency range between 10 MHz and about 300 GHz. The formation of solitons in the propagating longitudinal strain pulses is investigated for nonlinear media with intrinsic lattice-based dispersion. The excitation of solitary surface acoustic waves is realized by a geometric film-based dispersion effect. Future developments and potential applications of nonlinear nanosecond and picosecond ultrasonics are discussed.     

Dispersion and attenuation of Rayleigh waves at a one-dimensional random roughness of the free surface of a hexagonal crystal

Analytical expressions are derived for dispersion and attenuation of Rayleigh waves propagating along the statistically rough free surface of a hexagonal crystal (Z cut). The roughness under consideration is one-dimensional (the profile function of the roughness depends on one coordinate) and has the form of hollows of a random lattice. The results obtained earlier in the solution of an analogous problem for a two-dimensional roughness are used in the one-dimensional case. The relationships derived for the dispersion and attenuation of Rayleigh waves are treated analytically and numerically over the entire range of frequencies acceptable in the framework of the perturbation theory. It is shown that the dispersion and attenuation of Rayleigh waves are qualitatively similar to those observed in an isotropic medium.     

声波在水-含气沉积物界面的反射

含气泡海洋沉积物的声学特性是海底探测的重要问题。为了研究气泡存在对水-含气沉积物界面声反射系数的影响,本文基于气泡振动修正的Biot波动方程推导了气泡存在修正的Biot弹性模量,并结合水-沉积物界面的“开孔”边界条件推导了声波从水入射到水-含气沉积物界面的反射系数。数值分析表明气泡的振动导致反射系数呈现显著的频率特性。在气泡共振频率附近,由于气泡的共振引发的强散射和强衰减,使得反射系数很大,无论以何种角度入射,声波都很难进入含气泡的沉积物。本文研究结果表明,气泡半径、含量、声波频率以及入射角度都是影响水-含气沉积物界面反射系数的主要因素。     

Time delay temperature behaviour of surface acoustic waves propagation on crystal substrate

A method is described for the computation of the time delay temperature behaviour for surface acoustic waves propagated in a surface layer of piezoelectric crystals. The linear field equations for small vibration superposed on thermally induced deformation were employed in the determination of the time delay temperature behaviour. The computed time delay temperature dependence of the surface acoustic waves propagated in the digonal axis direction on the ZX-cut quartz plate is given as an example.     

Quasi-steady-state surface acoustic waves at a rough solid surface

Sound propagation along an inhomogeneous solid-vacuum interface is considered. The frequency-wavenumber relation has been obtained for the transverse-polarized surface wave and the range of existence of this wave has been analyzed. The surface roughness is shown to produce additional damping.     

Imaging of surface acoustic waves

A new experimental method has been devised that directly determines the group velocities of surface acoustic waves. A point source and a point detector are employed to measure the ultrasonic transmission across a solid surface as a continuous function of the propagation direction. Results for single pulses give the times-of-flight for both Rayleigh surface waves (RSW's) and pseudo-surface-waves (PSW's). Calculations and measurements of the group velocities of the surface waves on silicon show some unanticipated behavior: fluid loading qualitiatively changes the group velocity curves for both RSW and PSW. In particular, the RSW branch gains an additional component which we denote here as an induced Rayleigh wave (IRW). If a wave train is employed in the experiment, the analog of phonon focusing is observed for the ultrasonic waves, modified by internal-diffraction effects. Systematic measurements of the wave intensities on silicon as a function of propagation distance are consistent with expected acoustic losses into the surrounding water: the attenuation length of a wave depends on the mode and frequency. A survey of surface-wave images on other crystals is included in this study.     

海底沉积物上的声反射

本文将海底沉积物视为一种紧密的湿颗粒介质。声波在其中传播时将出现两个膨胀波和一个旋转波。考虑到这些特征,再假设海水与沉积物的界面是平的,导出了平面声波在其上的反射系数的表达式。文中就松散颗粒介质的情况对反射系数进行了简化,得出了前人用唯象理论所获得的结果。文末将理论与实验结果进行了比较,两者的一致性较好。     

Propagation of acoustic waves in the woodpile sonic crystal with a defect

Acoustic wave propagation in a woodpile sonic crystal with a defect is studied theoretically and experimentally. The woodpile sonic crystal is composed of polymethyl methacrylate square rods which orthogonally stacked together, and it is embedded in air background. Defects are created by varying the width and positions of the middle rods in the periodic structure. Defect bands and transmission spectra are calculated by using the finite element method with the periodic boundary condition and the Bloch–Floquet theorem. Frequencies of defect bands are strongly dependent on the width and positions of the middle rods in the periodic structure. The experimental transmission spectra of the woodpile sonic crystals with a defect are also presented and compared with the numerical results. The defect mode properties of the woodpile sonic crystal with a defect can be applied to design novel acoustic devices for filtering sound and trapping sound in defects.     

On the density of surface acoustic waves and surface thermodynamics in a piezoelectric

Piezoelectricity introduces new modes and modifies part of the elastic vibrational spectrum for both bulk and surface waves. This has a direct bearance on surface thermodynamics. A simple phenomenological model is studied analytically and exactly. This bears out the basic physics involved and allows for a quick and easy estimate of the changes to be expected, which turn out to be substantial.     

Laser-generated surface acoustic waves in a ring-shaped waveguide resonator

Surface acoustic wave (SAW) waveguide resonator is formed by a ring-shaped strip of copper 10 μm wide and ∼130 μm in diameter embedded into a 0.8 μm thick layer of silica on a silicon wafer. SAWs are excited at one side of the copper ring by a short laser pulse focused into a spatially periodic pattern and detected via diffraction of the probe laser beam overlapped with the excitation spot. SAW wavepackets with central frequency 460 MHz travel around the ring and are detected each time they make a full circle and pass trough the probe spot. Potential applications of ring resonators for SAWs are discussed.     

Focussed surface acoustic waves on an anisotropic crystal, studied by optical probing

Efficient focussing of surface acoustic waves has been achieved using a properly shaped gold film deposit on the −22.3° rotated Y-cut surface of quartz. The acoustic wave field was studied with laser probing techniques. A more than threefold increase in intensity and a tenfold decrease in beam width was observed at the focal point. The focussing action was obtained with the elastic wave equivalent of the Fresnel phase-reversal zone plate of optics. The multiple foci of this device allowed a simultaneous generation of acoustic waves in nearly all directions on the surface. Consequently, the surface wave velocity anisotropy could be determined completely. The experimental results are in very good agreement with the calculated velocity anisotropy. Electromagnetic diffraction theory is adopted to the two dimensional anisotropic system to analyse the performance of the focussing device.     

Scattering of bulk acoustic waves with different polarizations on a statistically rough free surface of a solid at oblique incidence

In the first Born approximation of the perturbation theory by a Green's function method developed by Maradudin, Mills [7] and Kosachev, Lokhov, Chukov [8,9] the problem of scattering bulk acoustic waves with different polarizations at oblique incidence on a statistically rough free boundary of an isotropic solid was solved. When the correlation function of the surface roughness is of a Gaussian form, the expressions for the transformation energy factor of the incident wave in the scattered volume and surface Rayleigh waves with respect to polarization, frequency and grazing angle of the incident wave as well as the roughness parameters and the Poisson coefficient of the medium were obtained. These results are helpful in accounting for the experiments on residual losses [15–17].