变热物性非定常导热方程的一些显式解析解

各种变热物性（热传导系数、密度与比热为变数）的非定常导热方程的解析解在理论上是有意义的；而且它们对计算传热学也很有实用价值；可以作为标准解来校核各种数值计算以及用来启发发展各种计算技巧例如差分格式、网格生成等等。但已知的解析解很少。本文对直角座标下沿几何座标变热物性的非定常几何一元及二元的导热方程导出了一些代数显式解析解，其中有些解包含有任意函数，其实是无限多个解；可作为发展导热学理论及计算导热学之用．     

激光辐照金属/炸药复合介质温度场的数值模拟

 当激光辐照金属/炸药复合介质外表面时,在变物性及界面有接触热阻的条件下,用二维线性瞬态导焓方程,数值计算了介质内部温度场时空分布。作为特例,将常物性及无接触热阻下的数值解与相同条件下的二维线性瞬态导热方程的解析解相比较,结果表明数值法的计算程序及结果是可信的。     

多孔介质快速干燥过程热质耦合方程的代数显式解析解

对多孔介质快速干燥过程的传热与传质耦合方程组导出了两套代数显式解析特解。这些解首先可以作为计算传热传质学的标准解,用以检验数值计算的准确性、收敛性与稳定性等,还可以启发数值工作者改进计算技巧例如差分格式与网格生成技术等。当然,解析解还会有其相应的理论价值。     

MKdV方程的拟小波解

用拟小波方法求MKdV方程的数值解-先用拟小波离散格式离散空间导数，然后用四阶Runge-Kutta方法离散时间导数,对一个有精确解的实例ut+6u2ux+uxxx=0进行了数值计算-拟小波解与解析解完全重合，t=10000s时，二者也没有偏差- 关键词： MKdV方程 拟小波方法 孤子解     

干斜压大气拉格朗日原始方程组的半解析解法和非线性密度流数值试验

以差分方程代替微分方程给大气原始方程组求解带来了诸多难以解决的问题, 对于(半)拉格朗日模式来说质点轨迹的计算与Helmholtz方程的求解是两大难题. 本文通过对气压变量代换, 并在积分时间步长内将原始方程组线性化, 近似为常微分方程组, 求出方程组的半解析解, 再采用精细积分法求解半解析解. 半解析方法可同时计算风、气压和位移, 无需求解Helmholtz方程, 质点的位移采用积分风的半解析解得到, 相比采用风速外推的计算方法, 半解析方法更科学合理. 非线性密度流试验检验表明: 半解析模式能够清晰地模拟Kelvin-Helmholtz 切变不稳定涡旋的发生和发展过程; 模拟的气压场和风场环流结构与标准解非常相似, 且数值解是收敛的, 同时, 总质量和总能量具有较好的守恒性. 试验初步证明了采用半解析方法求解大气原始方程组是可行的, 为大气数值模式的构建提供了一个新的思路.     

几个到十几个电子的原子电离的弛豫过程

本文用牛顿迭代法求解了电离度方程,推导了在稳定条件下该方程的解析解。并把它们的数值结果与Saha方程的结果作了比较,当电离达到平衡时:(1)电离度方程的牛顿迭代法的数值结果与解析解的结果相同。(2)在一定的计算条件下,三种结果符合较好。     

超短脉冲激光烧蚀金属靶热分布的数值解与解析解

研究了超短脉冲激光烧蚀靶材的整个过程,对描述超短脉烧蚀过程热行为的双温度方程进行了分析简化,得出了超快激光烧蚀金属材料的解析解. 以铜靶材为例,对双温度模型的数值解与解析解做了对比分析,得到了靶材温度随时间和深度的变化规律,结果显示解析解的计算结果比较好的符合了数值解的计算结果.     

环形Josephson结中圆对称孤子解的微扰分析

本文用微扰方法,研究环形Josephson结中有扰动情形下sine-Gordon方程的圆对称孤子解,得到孤子的动力学方程的解析形式。所得的I—V曲线(第一零场台阶)与数值计算结果符合得很好。 关键词：     

基于局部基本解法的静电场仿真分析

将局部基本解方法应用于静电场问题的模拟与分析。局部基本解方法是利用控制方程的基本解,基于局部理论和移动最小二乘原理提出的一种无网格算法。相比于有限元和有限差分等传统网格类方法,该方法仅需离散节点,避免了复杂的网格剖分难题。作为一种半解析数值技术,物理问题的基本解被作为插值基函数建立数值离散模型,从而保证了算法的较高精度。此外,与具有全局离散格式的无网格方法相比,局部基本解法更适用于高维复杂几何和大尺度模拟。二维和三维数值试验表明,该方法具有实施方便灵活,计算精度高和计算速度快等优势。为静电场仿真研究开辟新的途径,拓展了局部基本解方法的应用领域。     

三维润滑问题的数值分析

本文求解了轴承的三维润滑问题。使用格林函数方法,将基本方程化为求解区边界上的积分方程。采用空间曲边三角形单元离散边界,并用六结点等参数无数值求解积分方程,确定了速度场,压力场和边界上的应力。算例与解析解比较表明有较高的精度。其它一些典型问题的计算也给出满意的结果,表明本文方法对数值分析这类问题的有效性。     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.     

Fiber Modal Index Measurements Based on Fiber Gratings

A novel method based on fiber gratings for measuring the effective indices of fiber modes is proposed. The effective index difference between the core mode and a cladding mode was obtained by analyzing the interference fringe of a pair of cascaded long-period fiber gratings. In order to extract the core mode index from the measured index difference, an index matching oil immersion method is proposed. By analyzing the interaction between the cladding mode and the oil applied on the cladding surface, the mode order and the effective index of the involved cladding mode might be calculated. Experimental results about the interference fringe shifts induced by the oil index and the oil-applied length are also presented.     

Optical Pulse Compression Schemes That Use Nonlinear Bragg Gratings

Nonlinear optical pulse compression of picosecond pulses typically requires long lengths of optical fiber and multiple components. Periodic structures, such as fiber Bragg gratings, are highly dispersive at wavelengths outside of the photonic bandgap. This implies that such gratings can be used as very short all-fiber compressors. In this paper a number of such compression schemes are reviewed involving uniform and nonuniform fiber Bragg gratings, relying on both soliton and nonsoliton compression principles. Experimental results supporting the corresponding underlying theory are also presented. Finally, an extension of one of the compression schemes is shown, which allows the generation of adjustable high-repetition rate soliton trains.