Determination of uranium in organic solutions by inductively coupled plasma atomic emission spectrometry

The determination of uranium in organic solutions by inductively coupled plasma atomic emission spectrometry is reported. The conditions for achieving plasma stability were determined as well as the optimum conditions (RF power, observation height and argon flow) of a spectrometer for analysis of U(II) 367.007 nm in three organic solvents, xylene, kerosine and benzene. The effects of RF power and observation height on signal-to-back-ground ratio and the detection limits are considered. Spectral interferences due to CN band are discussed.A part of this work was presented at the Second Karlsruhe International Conference on Analytical Chemistry in Nuclear Technology Karlsruhe, FRG, June 5–9, 1989.     

Film-forming capacity of alcoholic solutions of iron(III) chloride with acetylacetone

Processes in which film-forming solutions based on acetylacetonate and iron(III) chloride are produced were subjected to a physicochemical study. Spectrophotometry and IR and UV spectroscopies were used to analyze the composition of the complex in propanol-2 and ethanol.     

Sorption of iron(III) and iron(II) from acidic chloride solutions by polyether and polyester type polyurethane foams

Summary Iron(III) is sorbed by polyether type open-cell polyurethane foams from HCl solutions of 4 mol/l or higher. The capacity of the foams is around 50 mg·l^–1. The iron (III) sorbed can be eluted from the foam with 0.01 mol/l HCl or distilled water. An optimization of the sorption conditions showed that the process can be used for analytical applications. The polyurethane foam sorbents examined did not sorb iron(II). The mechanism of sorption by polyether foams seems to follow a mechanism similar to that of the extraction of iron(III) by etheric solvents.     

Degradation of tributyltin chloride in water photoinduced by iron(III)

The degradation of tributyltin chloride (TBT) photoinduced by iron(III) was investigated. Upon irradiation at λ_excitation >300 nm a photoredox process was observed, yielding iron(II) and ^·2OH radicals. The disappearance of TBT was proved to involve only an attack by ^·2OH radicals: the quantum yield of TBT disappearance was determined. A wavelength effect was observed; the shorter the excitation wavelength, the higher the rate of TBT disappearance. Most of the photoproducts were identified and the mechanism of degradation was elucidated. The main route to degradation is a stepwise debutylation of TBT to di‐ and mono‐butyltin with final formation of inorganic tin. The complete mineralization of TBT was achieved with long irradiation times, leading to innocuous inorganic tin. Copyright © 1999 John Wiley & Sons, Ltd.     

Intradiffusion and viscosity measurements in acidified iron(III) chloride solutions at 25°C

Intradiffusion of species in acidified (using eithe hydrochloric or perchloric acid) iron(III) chloride solutions has been studied using labeled iron(III), chloride and water. Comparison with data for iron(III) perchlorate has enabled the influence of complexed species upon the diffusion to be ascertained. The chloro-iron species formed have larger diffusion coefficients than the free iron(III) ion as would be expected from their lower net charge. Simple diffusion models have been employed to enable estimates of the diffusion of the complexed species and of the free chloride diffusion coefficients to be obtained. These are discussed in relation to literature data for similar systems. In addition esitmates of the effective hydration of the iron(III) species in solutions have been obtained from the diffusion data. These are discussed in relation to two other trivalent metal salt systems, chromium chloride and lanthanum chloride; the overall hydration of the three cations is virtually identical.     

Iodine(III)-mediated ethoxychlorination of enamides with iron(III) chloride

The combination of (diacetoxyiodo)benzene and iron(III) chloride in ethanol allows the efficient regioselective ethoxychlorination of a broad range of enamides. Mechanistic studies tend to rule out the involvement of free radical species and point towards the implication of a mixed [chloro(ethoxy)iodo]benzene intermediate.     

Speciation of arsenic(III) and arsenic(V) by inductively coupled plasma-atomic emission spectrometry coupled with preconcentration system

A novel and simple flow-based method was developed for the simultaneous determination of As(III) and As(V) in freshwater samples. Two miniature columns with a solid phase anion exchange resin, placed on two 6-way valves were utilized for the solid-phase collection/concentration of arsenic(III) and arsenic(V), respectively. As(III) could be retained on the column after its oxidation to As(V) species with an oxidizing agent. The collected analytes were then sequentially eluted by 2 M nitric acid and introduced into ICP-AES. Potassium permanganate was examined as potential oxidizing agent for conversion of As(III) to As(V). The standard deviation of the analytical signals (peak height) for the replicate analysis (n = 5) of 0.5 μg l⁻¹ solution were 3 and 5% for As(III) and As(V), respectively. The limit of detection (3σ) for both As(III) and As(V) were 0.1 μg l⁻¹. The proposed system produced satisfactory results on the application to the direct analysis of inorganic arsenic species in freshwater samples.     

Isotope measurements in uranium using a quadrupole inductively coupled plasma mass spectrometer (ICPMS)

A series of measurements were carried out to establish the reliability associated with isotope ratio (235/238) measurements on uranium samples using a quadrupole inductively coupled plasma mass spectrometer (ICPMS). Figures of merit related to the isotopic measurements were determined using non certified as well as certified materials provided by the New Brunswick Laboratory (NBL). The experimental results showed that repeatability is around 0.5% while reproducibility was calculated as 0.27%. Mass discrimination was determined as 0.03% per mass unit and the system linearity check over five orders of isotope ratios yielded a mass discrimination factor (K factor) of 1.0002±0.0081 (0.81%, 2s). The mean error of measurement obtained from six different certified reference materials was 0.77%.     

Extraction of iron(III) with diphenyl-2-pyridylmethane dissolved in benzene from aqueous chloride solutions

The mechanism of extraction has been investigated by partition, slope analysis and loading-ratio data. The results obtained give a picture of the mechanism of extraction of FeCl ₄ ⁻ ions in relation to the hydration and solvation of the compound extracted. The possible formula of the extracted species is (DPPM)₃H₃O⁺(H₂O)_n−FeCl ₄ ⁻ . In dilute aqueous hydrochloric acid systems the influence of the concentration of a number of salts with cations of different electrical potentials (Ze/r), on iron(III) extraction, has been studied. Splitting of the organic phases occurs at high acid and/or high salt concentrations. The phenomenon is explained on the basis of the variability of the hydration number. Investigations have been made to understand the parameters controlling the extraction of the metal and its is shown that the extraction offers a simple, fast and selective separation method of iron from solutions.     

The determination of uranium in rocks by inductively coupled plasma-optical emission spectrometry

A method for the determination of uranium in rock samples by emission spectrometry is presented. The rock is dissolved and the uranium content determined by nebulizing the solution into an inductively coupled-plasma optical excitation source. Various spectral lines were investigated. The uranium emission at 378.28 nm -was chosen because of its relative freedom from matrix element spectral interferences. For this emission, a practical detection limit of 0.1 p.p.m. in solution was achieved by optimizing source parameters (power, flow-rate, observation height). Results are compared with those obtained by a number of other techniques.     

Determination of impurities in uranium oxide by inductively coupled plasma mass spectrometry (ICPMS) by the matrix matching method

An analytical procedure was developed to determine the concentration of some elements regarded as trace impurities in nuclear fuel using inductively coupled plasma mass spectrometry (ICPMS) associated to the matrix matching method. The assessment of this approach was carried out using a set of certified reference materials produced by the New Brunswick Laboratory (NBL). Eighteen out of the twenty-four elements in the reference materials could be easily determined. It was found that the mean values for reproducibility and accuracy were 5.0% and 15.0%. The remaining six elements provided mean values of 11.0% and 37.0%, respectively. They could not be adequately determined due to the effects of analyte signal suppression and spectral interference.     

Interphase transport of iron(III) chloride by means of macrocyclic ligands

A study has been made for the first time of the transport of an iron(III) salt through a dichloroethane liquid membrane involving, by means of macrocyclic compounds containing donor oxygen, nitrogen, and sulfur atoms as well as certain functional groups in the ring. It has been established that the membrane transport of Fe(III) ions is determined to an appreciable extent by the properties of the anion of the salt.Translated from Teoreticheskaya i Éksperimental'naya Khimiya, Vol. 22, No. 2, pp. 174–180, March–April, 1986.The authors express their deep gratitude to E. S. Levchenko for kindly supplying dithia-18-crown-6 and to A. G. Kol'chinskii and V. V. Pavlishchuk for preparing the DAADEN ligand.     

Determination of iron(III) ions in aqueous solutions by secondary-emission mass spectrometry

Model aqueous solutions containing micro impurities of iron(III) are studied by secondary-emission mass spectrometry. The possibility of using this method for the analysis of rain deposits and samples of atmospheric aerosols is discussed.     

Recent advances in iron(III) chloride catalyzed synthesis of heterocycles

Heterocyclic compounds particularly five, six and seven membered ring containing heterocycles are the most abundant which constitute a staggeringly diverse and important class of molecules that occur ubiquitously in a variety of synthetic drugs, bioactive natural products, pharmaceuticals and agrochemicals. Owing to the glorious past and impressive present of the biologically active heterocyclic scaffolds, these skeletons have long been a subject of immense interest. Hence, substantial efforts have been made to the development of new and innovative synthetic strategies for the synthesis of these heterocycles involving use of different metal catalysts, organic and inorganic reagents etc. Among the different types of metal catalysts used, iron catalysts are one of the cheap and easily available. In recent time, several new and innovative iron(III) chloride catalyzed synthesis of heterocycles with structural diversity are coming in the forefront of the literature by the scientific community. This review highlights the advancements made so far by iron(III) chloride for the synthesis of different assemblies of small heterocycles covering the year 2014–2018.     

Photoinduced degradation by iron(III): removal of triphenyltin chloride from water

The photoredox process taking place in iron(III) aquacomplexes was used to cause the complete degradation of triphenyltin (TPT). TPT elimination was proved to come only from attack by hydroxyl radicals generated upon irradiation at 365 nm of Fe(H₂O)₅OH²⁺, the iron(III) species present under the experimental conditions ([Fe(III)] in the range (3–6) × 10^?4 mol l^?1). The first step is the formation of an adduct between hydroxyl radicals and the benzene ring. The main process is a stepwise dephenylation of the starting TPT. Hydroxylated phenyltin derivatives were also formed, but only as minor photoproducts. The process was shown to be efficient with artificial light as well as with solar light. Copyright © 2001 John Wiley & Sons, Ltd.     

Adsorption of As(III) from aqueous solutions by iron oxide-coated sand

Arsenic is a toxic element and may be found in natural waters as well as in industrial waters. Leaching of arsenic from industrial wastewater into groundwater may cause significant contamination, which requires proper treatment before its use as drinking water. The present study describes removal of arsenic(III) on iron oxide-coated sand in batch studies conducted as a function of pH, time, initial arsenic concentration, and adsorbent dosage. The results were compared with those for uncoated sand. The adsorption data fitted well in the Langmuir model at different initial concentration of As(III) at 20 g/l fixed adsorbent dose. Maximum adsorption of As(III) for coated sand is found to be much higher (28.57 microg/g) than that for uncoated sand (5.63 microg/g) at pH 7.5 in 2 h. The maximum As(III) removal efficiency achieved is 99% for coated sand at an adsorbent dose of 20 g/l with initial As(III) concentration of 100 microg/l in batch studies. Column studies have also been carried out with 400 microg/l arsenic (pH 7.5) by varying the contact time, filtration rate, and bed depth. Results of column studies demonstrated that at a filtration rate of 4 ml/min the maximum removal of As(III) observed was 94% for coated sand in a contact time of 2 h. The results observed in batch and column studies indicate that iron oxide-coated sand is a suitable adsorbent for reducing As(III) concentration to the limit (50 microg/l) recommended by Indian Standards for Drinking Water.     

Titrimetric determination of uranium (IV) with iron (III) using redox indicators

Summary Conditions have been established for the use of methylene blue, thionine and variamine blue as redox indicators in the titrimetric determination of uranium(IV) with iron(III) in an inert atmosphere at 98–100° C. Under the conditions prescribed, the method gives results with an accuracy of ±0.4%. The advantages of this method are discussed for the determination of uranium(IV) in the presence of iron(II).Methylene blue and thionine are more satisfactory than variamine blue, because variamine blue is not sufficiently stable at the necessary temperature, especially in hydrochloric acid medium.

---

Zusammenfassung Die volumetrische Bestimmung von Uran(IV) mit Eisen(III) kann mit Hilfe von Methylenblau, Thionin oder Variaminblau als Redox-indicatoren in inerter Atmosphäre bei 98–100° C durchgeführt werden. Das Verfahren liefert unter den beschriebenen Bedingungen auf ±0,4% genaue Ergebnisse und ist besonders vorteilhaft für die Uran(IV)-be-stimmung in Gegenwart von Eisen(II). Variaminblau ist ungünstiger als die beiden anderen Indicatoren, da es bei der erforderlichen Tem-peratur nicht genügend stabil ist, besonders in salzsaurem Medium.

     

Kinetics of iron(III) chloride extraction with n-tributyl phosphate

The equilibrium and rate of solvent extraction of FeCl₃ complexes from HCl solutions into benzene solutions of tributyl phosphate (TBP) has been studied. The extracted species was found to be FeCl₃·3TBP. The results show that the extraction is first order in both Fe(III) and TBP. The rate constant of adduct formation equals ～1.24M min^?1. The reaction order is zero for the aqueous phase acidity. The rate-controlling steps are discussed in the light of the results.