氢气稀释比例对多晶硅薄膜微观结构和沉积特性的影响

利用电感耦合等离子体增强化学气相沉积法(ICP-PECVD)直接在普通玻璃衬底上低温沉积多晶硅薄 膜,主要研究了不同氢气稀释比例对薄膜沉积特性和微观结构的影响。采用 X 射线衍射仪(XRD)、拉曼光谱仪和 扫描电子显微镜(SEM)表征了在不同氢气比例条件下所制备多晶硅薄膜的微结构、形貌,并对不同条件下样品的 沉积速率进行了分析。实验结果表明：随着混合气体中硅烷比例的增加,薄膜的沉积速率不断增加;晶化率先增 加,后减小;当硅烷含量为4.8%时,晶化率达到最大值67.3%。XRD 和 SEM 结果显示多晶硅薄膜在普通玻璃衬 底上呈柱状生长,且晶粒排列整齐、致密,这种结构可提高载流子的纵向迁移率,有利于制备高效多晶硅薄膜太阳能电池。     

΢�����ӻ�������������廯ѧ����������Ʊ��ྦྷ�象Ĥ

利用微波电子回旋共振等离子体增强型化学气相沉积(ECR-PECVD)采用一步法直接在K9玻璃上低温沉积制备了多晶硅薄膜.研究了不同实验参数对薄膜沉积的影响,采用X射线衍射(XRD)、拉曼光谱、扫描电子显微镜(SEM)等实验分析方法对不同条件下制备的样品进行了晶体结构和表面形貌分析,并讨论了多晶硅薄膜沉积的最佳条件.实验结果表明,玻璃衬底上多晶硅薄膜呈柱状生长,并有一定厚度的非晶孵化层;较高氢气比例和衬底温度有利于结晶,薄膜的结晶率达到了62％;晶粒团簇的最大尺寸约为500nm.     

原子层沉积方法制备核-壳型纳米材料研究

采用原子层沉积方法在碳黑纳米颗粒表面分别沉积Al₂O₃, ZnO, TiO₂和Pt, 成功制备出核-壳型纳米材料. 通过高分辨率透射电子显微镜、X射线光电子能谱仪、 能谱仪对材料的表面形貌、晶体结构、薄膜成分进行了表征和分析. 结果表明, 原子层沉积方法是制备核壳型纳米材料的理想方法. 此外, 还分析了采用原子层沉积方法沉积不同材料, 所生长的薄膜材料有单晶、多晶、非晶等多种存在形式的形成原因. 关键词： 原子层沉积 核-壳型纳米材料 碳黑纳米颗粒     

溶胶-凝胶-蒸镀法制备高性能FTO薄膜

以SnCl_4·5H_2O为锡源,SnF_2为氟源,采用溶胶-凝胶-蒸镀法制备F掺杂的SnO_2透明导电氧化物薄膜(FTO薄膜).通过正交实验研究确定最佳反应温度、反应时间和蒸镀温度等制备条件.主要研究元素F的掺杂和膜的结构对FTO薄膜性能的影响,并采用傅里叶变换红外光谱仪、热重-差热分析、X射线衍射、高分辨透射电子显微镜和扫描电子显微镜等进行样品的性能表征.研究结果表明,当反应温度50?C、反应时间5 h、烧结(蒸镀)温度600?C、镀膜次数1次、而F/Sn=14 mol%时,FTO薄膜性能指数ΦTC最大,综合光电性能最优,表面电阻为14.7?·cm-1,平均透光率为74.4%.FTO薄膜内颗粒的平均粒径为20 nm,呈四方金红石型结构,F的掺入替代了部分的O,形成了SnO_(2-x)F_x晶体结构.F的掺杂量是影响FTO薄膜的主要因素,F过多或过少均不利于SnO_(2-x)F_x晶体的生长;FTO薄膜的结构、颗粒形状、大小等三维信息也是影响薄膜性能的因素,主要表现为分形维数越小,薄膜表面越平整,势垒越低,导电性能越好.     

等离子增强原子层沉积低温生长GaN薄膜

采用等离子增强原子层沉积技术在低温下于单晶硅衬底上成功生长了Ga N多晶薄膜,利用椭圆偏振仪、低角度掠入射X射线衍射仪、X射线光电子能谱仪对薄膜样品的生长速率、晶体结构及薄膜成分进行了表征和分析.结果表明,等离子增强原子层沉积技术生长Ga N的温度窗口为210—270?C,薄膜在较高生长温度下呈多晶态,在较低温度下呈非晶态;薄膜中N元素与大部分Ga元素结合成N—Ga键生成Ga N,有少量的Ga元素以Ga—O键存在,多晶Ga N薄膜含有少量非晶态Ga_2O_3.     

Effects of precursors on nucleation in atomic layer deposition of HfO2

Atomic layer deposition of hafnium dioxide (HfO₂) on silicon substrates was studied. It was revealed that due to low adsorption probability of HfCl₄ on silicon substrates at higher temperatures (450–600 °C) the growth was non-uniform and markedly hindered in the initial stage of the HfCl₄–H₂O process. In the HfI₄–H₂O and HfI₄–O₂ processes, uniform growth with acceptable rate was obtained from the beginning of deposition. As a result, the HfI₄–H₂O and HfI₄–O₂ processes allowed deposition of smoother, more homogeneous and denser films than the HfCl₄–H₂O process did. The crystal structure developed, however, faster at the beginning of the HfCl₄–H₂O process.     

Probing thermal properties of vanadium dioxide thin films by time-domain thermoreflectance without metal film

Vanadium dioxide(VO_2) is a strongly correlated material, and it has become known due to its sharp metal–insulator transition(MIT) near room temperature. Understanding the thermal properties and their change across MIT of VO_2 thin film is important for the applications of this material in various devices. Here, the changes in thermal conductivity of epitaxial and polycrystalline VO_2 thin film across MIT are probed by the time-domain thermoreflectance(TDTR) method.The measurements are performed in a direct way devoid of deposition of any metal thermoreflectance layer on the VO_2 film to attenuate the impact from extra thermal interfaces. It is demonstrated that the method is feasible for the VO_2 films with thickness values larger than 100 nm and beyond the phase transition region. The observed reasonable thermal conductivity change rates across MIT of VO_2 thin films with different crystal qualities are found to be correlated with the electrical conductivity change rate, which is different from the reported behavior of single crystal VO_2 nanowires. The recovery of the relationship between thermal conductivity and electrical conductivity in VO_2 film may be attributed to the increasing elastic electron scattering weight, caused by the defects in the film. This work demonstrates the possibility and limitation of investigating the thermal properties of VO_2 thin films by the TDTR method without depositing any metal thermoreflectance layer.     

薄膜硅/晶体硅异质结电池中本征硅薄膜钝化层的性质及光发射谱研究

本文采用甚高频等离子体化学气相沉积技术 (VHF-PECVD) 制备薄膜硅/晶体硅异质结电池中的本征硅薄膜钝化层, 光发射谱 (OES) 测量技术研究了硅薄膜沉积过程中等离子体发光谱随时间的变化. 结果表明: 在实验优化条件下等离子体发光谱很快达到稳定 (大约25 s), 并且SiH^*/H_α^* 的比值随时间变化较小, 避免了生长过程中硅薄膜结构的不均匀性, 这主要是SiH₄没有完全耗尽避免了SiH₄的反向扩散. 进一步研究了沉积参数对稳态发光谱和硅薄膜性质的影响, 结果表明: 随着硅烷浓度增加, H_α^*峰强度减小, SiH^*峰强度增加, 薄膜从微晶转变成非晶, 非晶硅薄膜钝化效果好; 随着沉积气压增大, H_α^*和 SiH^*峰强度先增加后减小, 高气压下H_α^*和 SiH^*峰强度下降主要是反应前驱物的聚合形成高聚合物, 不利于形成高质量的硅薄膜, 因此钝化效果下降; 随着反应功率密度增加, H_α^*和 SiH^*峰强度增大, 当功率密度为150 mW/cm² 趋于饱和, 硅薄膜的致密度和钝化效果也开始下降, 50 mW/cm²的低功率密度下硅薄膜钝化效果差可能是由于原子H 浓度低, 不能完全钝化单晶硅表面的悬挂键. 关键词： 薄膜硅 异质结 光发射谱 钝化     

H_2气氛退火处理对Nb掺杂TiO_2薄膜光电性能的影响

采用电子束沉积方法,以钛酸锶(SrTiO3)为衬底制备铌(Nb)掺杂TiO2薄膜并研究后续H2气氛退火处理对其薄膜样品光电性能的影响.结果发现H2气氛热退火处理能有效改善Nb掺杂TiO2薄膜的导电率,最佳电阻率达到5.46×10-3Ω·cm,在可见光范围内的透光率为60%—80%.导电性能的改善与H2气氛退火处理后多晶薄膜的晶粒尺寸变大和大量的氧空位形成及H原子掺杂有关.     

Influence of different deposition potentials on morphology and structure of CdSe films

Cadmium selenide (CdSe) thin films have been electrodeposited on the titanium or ITO substrate in an electrolyte containing CdSO₄ and H₂SeO₃ at pH = 2.50 and temperature 298 K. Influence of different deposition potentials on the surface morphology and crystal structure of CdSe films has been discussed. Compared with other deposition potentials (−0.65, −0.71 and −0.72 V versus SCE), the nearly stoichiometric CdSe nanocrystalline films with smaller grain sizes of 80 nm were obtained from 0.25 M CdSO₄ + 0.25 mM H₂SeO₃ + 0.25 M Na₂SO₄ solution at deposition potential of −0.70 V versus SCE. X-ray diffraction, atomic force microscope and scanning electron microscope were used to measure structure and morphology of CdSe films. The results indicated that the electrodeposited films were the smooth, compact and uniform at deposition potentials of −0.70 V versus SCE.