用于高速数据通信的梯度塑料光纤

概述了梯度塑料光纤的开发历史和现状。从应用于高速数据通信的角度 ,介绍了聚甲基丙烯酸甲酯(PMMA)、全氘化和全氟化梯度塑料光纤的损耗、带宽、稳定性和寿命。详细介绍了梯度塑料光纤的损耗光谱和损耗机制 ,介绍了制作梯度塑料光纤的界面凝胶聚合技术和两种扩散法 ,分析了梯度塑料光纤的制作方法同折射率剖面和带宽的关系 ,讨论了梯度塑料光纤的稳定性同掺杂物质的关系。同时介绍了高稳定性梯度塑料光纤的研究进展及今后的发展动向     

Soliton-based ultra-high speed optical communications

Multi-terabit/s, ultra-high speed optical transmissions over several thousands kilometers on fibers are becoming a reality. Most use RZ (Return to Zero) format in dispersion-managed fibers. This format is the only stable waveform in the presence of fiber Kerr nonlinearity and dispersion in all optical transmission lines with loss compensated by periodic amplifications. The nonlinear Schrödinger equation assisted by the split step numerical solutions is commonly used as the master equation to describe the information transfer in optical fibers. All these facts are the outcome of research on optical solitons in fibers in spite of the fact that the commonly used RZ format is not always called a soliton format. The overview presented here attempts to incorporate the role of soliton-based communications research in present day ultra-high speed communications.     

用于快速人脸识别的光学协处理器

设计了一种用于快速人脸识别的光学协处理器。提出正负图像组合编码方法，一步实现了通常需要三步的数学形态学击中击不中变换，提高了识别速度。改进传统的识别判据，改善了识别效果。采用一个液晶投影板同时显示待识别图像和参考图像，简化了结构。给出了实验结果。     

LED for high data rate,optical communications

The frequency response of light emitting diodes (LED's) in an edge, as opposed to surface, configuration is examined. We find that the frequency response is not limited by parasitic space charge capacitance, and thus, modulation frequencies in excess of 200 MHz can easily be obtained. If the internal heterojunction geometry is suitably arranged, it is possible to minimize coupling losses into low numerical aperature fibers so that these LED's are attractive sources for optical communications systems utilizing high data rates. Output power in excess of 1 mW at drive currents of ～200 mA is typical.     

高速光脉冲的测量方法

 综述了目前国际上公认的测量高速光脉冲的几种方法，主要包括电光条纹相机（SC）、快速脉冲取样、二次谐波产生（SHG）、频率分辨光学门（FROG）以及光谱相位干涉直接电场重建（SPIDER）等。详细地阐述和分析了这些方法的原理、特点、适用范围以及它们的研究现状。     

An efficient fault localization or detection mechanism for high speed optical networks

Optical burst switching (OBS) has been considered as the gate through which the envisaged world of optical Internet will be conquered by implementing Internet Protocol (IP) software directly over a wavelength-division-multiplexing (WDM) optical layer (IP/WDM). The main feature for designing next generation optical networks is protecting and restoring high capacity WDM networks from the failures. Quick detection, identification and restoration make networks more strong and consistent even though the failures cannot be avoided. Hence, it is necessary to develop fast, efficient and dependable fault localization or detection mechanisms. In this paper, an efficient scheme for OBS networks has been proposed to provide fast restoration of links with minimum delay as well as blocking probability. By simulation results, it is shown that the proposed OBS scheme achieve less blocking probability and delay while getting higher throughput in comparison to conventional schemes.     

高速光脉冲的测量方法

综述了目前国际上公认的测量高速光脉冲的几种方法,主要包括电光条纹相机（SC）、快速脉冲取样、二次谐波产生（SHG）、频率分辨光学门（FROG）以及光谱相位干涉直接电场重建（SPIDER）等。详细地阐述和分析了这些方法的原理、特点、适用范围以及它们的研究现状。     

基于高速移动通信的虚拟天线阵列理论研究

在高速移动通信中, 多普勒频移对通信性能产生严重的影响, 通常需要对接收信号的多普勒频移进行估计并进行补偿. 本文研究在对单个天线接收的高速移动通信信号进行频移估计和补偿的基础上产生多路无频偏的信号, 并虚拟为天线阵列的输出以提高系统的接收增益. 首先讨论了“均匀时间采样”和“均匀相位采样”的关系, 并根据两者之间的关系提出了补偿多普勒频移和虚拟天线阵列的算法, 即对采样信号进行插值、均匀相位抽取以后, 再进行均匀时间采样. 然后分析了算法对高速移动通信系统性能的改善作用, 并提出了算法的硬件实现结构. 通过数值仿真验证了算法的干扰抑制能力和误码性能, 结果表明本文提出的虚拟天线阵列算法能够改善飞机、高铁上的高速移动通信系统的性能.     

A novel optical burst switching architecture for high speed networks

A novel optical burst switching （OBS） high speed network architecture has been proposed. To verify its feasibility and evaluate its performance, just-enough-time （JET） signaling has been considered as a high performance protocol. In the proposed architecture, to avoid burst losses, firstly, a short-prior- confirmation-packet （SPCP） is sent over the control channel that simulates the events that the actual packet will experience. Once SPCP detects a drop at any of the intermediate nodes, the actual packet is not sent but the process repeats. In order to increase network utilization, cost effectiveness and to overcome some limitations of conventional OBS, inherent codes （e.g., orthogonal optical codes （OOC））, which are codified only in intensity, has been used. Through simulations, it shows that a decrease in burst loss probability, cost effectiveness and a gain in processing time are obtained when optical label processing is used as compared with electronic processing.     

Arbitrary chirped fiber Bragg gratings on application of filtering for optical communications

This paper presents an analysis of how to obtain narrow transmission band in the centre of the spectrum of the arbitrary chirped fiber Bragg grating (ACFBG). Grating chirp coefficient and refractive index profile are the critical parameters in contributing to performance of fiber Bragg grating. The reflection spectra and transmission band were analyzed with different refractive index profile. Apodization techniques are used to get optimized reflection spectra. The simulations are based on solving coupled mode equations by transfer matrix method that describes the interaction of guided modes.     

A scheme of optical interconnection for super high speed parallel computer

An optical cross connection network which adopts coarse wavelength division multiplexing (CWDM) and data packet is introduced. It can be used to realize communication between multi-CPU and multi-MEM in parallel computing system. It provides an effective way to upgrade the capability of parallel computer by combining optical wavelength division multiplexing (WDM) and data packet switching technology. CWDM used in network construction, optical cross connection (OXC) based on optical switch arrays, and data packet format used in network construction were analyzed. We have also done the optimizing analysis of the number of optical switches needed in different scales of network in this paper. The architecture of the optical interconnection for 8 wavelength channels and 128 bits parallel transmission has been researched. Finally, a parallel transmission system with 4 nodes, 8 channels per node, has been designed.     

Generation of high order multi-bound solitons and propagation in optical fibers

We demonstrate experimental generation of multi-bound solitons of up to sextuple in an active FM mode-locked fiber ring laser operating under power saturation in the locking state. The ring laser consists of two booster optical amplifiers operating in saturation regime, an electro-optic phase modulator driven by a sinusoidal electrical wave and a length of dispersive fiber. The periodic phase modulation generates phase chirp of the generated lightwaves in the ring laser. The chirped phase state plays an important role in the phase matching condition for mode-locking as well as the stabilization and the determination of the bound states of multi-solitons. The formation of such high order multi-bound solitons is explained based on the chirping of the phase and the behavior of the optical pulse sequence in the near field region of the dispersive fiber. The propagation of these multi-bound solitons through single mode optical fibers is observed. Experimental and simulation results of bound solitons have been shown to follow similar trends.The propagation of these multi-bound solitons through single mode optical fibers is described. Their mutual interaction through such quadratic phase media shows the influence of the quadratic phase property on the differential phase of individual solitons of the bound group. Simulated results confirm the evolution of the bound solitons over dispersive single mode optical fibers.     

Compact optical duplicate system for satellite-ground laser communications: application of averaging effects

In recent years, there has been considerable interest in satellite-ground laser communication due to an increase in the quantity of data exchanged between satellites and the ground. However, improving the quality of this data communication is necessary as laser communication is vulnerable to air fluctuation. We first verify the spatial and temporal averaging effects using light beam intensity images acquired from middle-range transmission experiments between two ground positions and the superposition of these images using simulations. Based on these results, we propose a compact and lightweight optical duplicate system as a multi-beam generation device with which it is easy to apply the spatial averaging effect. Although an optical duplicate system is already used for optical correlation operations, we present optimum design solutions, design a compact optical duplicate system for satellite-ground laser communications, and demonstrate the efficacy of this system using simulations.     

Nonlinear compression of optical solitons

In this paper, we consider nonlinear Schrödinger (NLS) equations, both in the anomalous and normal dispersive regimes, which govern the propagation of a single field in a fiber medium with phase modulation and fibre gain (or loss). The integrability conditions are arrived from linear eigen value problem. The variable transformations which connect the integrable form of modified NLS equations are presented. We succeed in Hirota bilinearzing the equations and on solving, exact bright and dark soliton solutions are obtained. From the results, we show that the soliton is alive, i.e. pulse area can be conserved by the inclusion of gain (or loss) and phase modulation effects.     

高速Cameralink视频信号的光纤传输系统设计

针对目前常用的Cameralink视频信号的光纤传输方案系统结构过于复杂的问题,提出一种基于MAX9249/MAX9268的Cameralink视频信号的光纤传输方案。在发送端利用MAX9249实现Cameralink视频信号解串行化、编码、串行化,得到光模块驱动信号CML;在接收端利用MAX9268实现CML信号解串行化、解码、串行化,得到Cameralink视频信号,并对光收发模块的设计与选型作了详细阐述。用示波器抓取发送端和接收端高速串行信号的眼图,结果比较清晰,眼睛张开度大,发送端的Q因子为24.46,满足发送端大于12的要求,接收端Q因子为8.13,满足接收端大于6的要求。计算机采集的实时画面,经过10 min传输无明显可视的像素噪点,验证了该传输方案的可行性和有效性。     

高密度光学头中力矩器的运动串扰分析与抑制

力矩器多维运动之间的串扰是影响其动态特性和光斑质量的关键因素。建立了力矩器的空间受力分布模型,提出了聚焦、循迹、倾斜三个方向串扰度的概念,用数值方法计算并分析了力矩器的运动串扰现象,得到了串扰度与力矩器结构参数的关系。分析结果表明,串扰度与永磁铁和聚焦线圈的结构参数密切相关,合理选择结构参数可有效降低串扰度,可提高力矩器的动态性能。     

Superlattice avalanche photodiodes for optical communications

This paper reviews the research into and development trends to date of high-speed high-sensitivity semiconductor superlattice (SL) avalanche photodiodes (APDs) for use in 1.3 to 1.55m wavelength optical communications. We focus on three types of SL-APDs based on an InAlGaAs-well/InAlAs-barrier structure. The first is an InAlGaAs/InAlAs polyimide-coated mesa-structure SL-APD with a high gain-bandwidth product of over 120GHz and a low multiplied dark current of a few tens of nano-amperes. Its reliability has been measured to be over 105h at 50°C. The second is a planar-structure SL-APD with a new titanium-implanted guard-ring; this structure has a longer lifetime than the mesa structure. The third is a large-receiving-area SL-APD integrated with a monolithic lens for eye-safety 1.5m wavelength optical measurement systems.     

A novel multilevel coding technique for high speed optical fiber communication systems

This paper delineates a novel coding technique, a combination of coding and multiplexing technique, known as mapping multiplexing technique (MMT). A mapping algorithm is used to multiplex four channels, each of which running at 10 Gbit/s. Up to four bits per symbol at a symbol rate of 10 Gboud was successfully transmitted over a single wavelength. Compare to the conventional return to zero (RZ) and none-return to zero (NRZ)-time division multiplexing (TDM) more than 75% and 50% reduction in the spectral width are achieved, respectively. Calculated chromatic dispersion tolerance of ±130 ps/nm is achieved for the 40 Gbit/s MMT transmission system at the expense of ∼2 dB degradation in the receiver sensitivity (compared to NRZ) due to an increase in the number of levels and in the signal dependency of signal-spontaneous beat noise. In comparison with conventional 4-ary system, the proposed system depicts ∼6.5 dB improvement in terms of receiver sensitivity.