Separation of lead sulphate from barium sulphate in their determination in glass

The conventional method for separation of lead from a combined lead and barium sulphate precipitate by extraction with ammonium acetate has been critically studied. The results show that quantitative separation of lead is possible only when the molar concentration ratio of barium to lead is 4.2 or above, but at ratios below 4.2 the method fails because of the formation of a solid solution of lead and barium sulphates which is maximal at initial mole-ratio 0.42. The lead in the solid solution, however, forms a strong soluble complex with EDTA and can be quantitatively separated. Based on this, a gravimetric method has been worked out for determination of lead and barium in glass.     

X-ray fluorescence analysis of rare earth elements in rocks using low dilution glass beads.

Major and trace elements (Na, Mg, Al, Si, P, K, Ca, Ti, Mn, Fe, Rb, Sr, Y, Zr, La, Ce, Pr, Nd, Sm, Gd, Dy, Th and U) in igneous rocks were assayed with fused lithium borate glass beads using X-ray fluorescence spectrometry. Low dilution glass beads, which had a 1:1 sample-to-flux ratio, were prepared for determination of rare earth elements. Complete vitrification of 1:1 mixture required heating twice at 1200 degrees C with agitation. Extra pure reagents containing determinants were used for calibrating standards instead of the rock standard. The calibration curves of the 23 elements showed good linearity. Furthermore, the lower limits of detection corresponding to three times the standard deviation for blank measurements were 26 mass ppm for Na2O, 6.7 for MgO, 4.5 for Al2O3, 4.5 for SiO2, 18 for P2O5, 1.1 for K2O, 4.0 for CaO, 3.9 for TiO2, 1.6 for MnO, 0.8 for Fe2O3, 0.5 for Rb, 0.2 for Sr, 0.4 for Y, 0.5 for Zr, 3.3 for La, 6.5 for Ce, 2.7 for Pr, 2.1 for Nd, 1.7 for Sm, 0.7 for Gd, 2.7 for Dy, 0.5 for Th, and 0.6 for U. Using the present method, we determined the contents of these 23 elements in four rhyolitic and granitic rocks from Japan.     

Analytical methods and problems related to the determination of organotin compounds in marine sediments

The determination of organotin compounds in bottom sediments is a complex process that requires a number of analytical steps, i.e. sample collection, transport and storage; extraction of analytes from sediment; derivatization; extract purification; enrichment; and the final chromatographic measurement. The whole process is time and labour consuming, and subject to securing sample representativeness. In this review the most frequently encountered problems and the examples of possible analytical solutions are presented, which encompass the specific steps of speciation analysis of these toxic compounds.     

On the microporous structure of glass beads

Summary Glass beads of controlled porosity are interesting packings for chromatography. They are used as molecular sieves and they can constitute the starting point for the production of packings with a chemically bonded phase. From the practical point of view it would be desirable to known the methods for obtaining porous glass beads of strictly defined structure. In this communication attention will be drawn to the occurrence of microporous structure in glass beads, which is an unfavourable phenomenon from the standpoint of chromatography. Moreover, a method allowing us to remove the microporosity will also be discussed.     

Rapid micro combustion methods for the determination of elements in organic compounds

Summary Advantages of the rapid combustion process for the micro determination of carbon and hydrogen, sulphur, and halogen are discussed, and methods for their estimation are described which have been adopted for routine analysis.

---

Zusammenfassung Die Vorteile eines raschen Verbrennungsvorganges für die Mikrobestimmung von Kohlenstoff, Wasserstoff, Schwefel und Halogen werden beschrieben. Methoden für deren quantitative Bestimmung, die sich besonders für Serienanalysen bewährt haben, werden mitgeteilt.

---

Résumé On discute les avantages du procédé rapide de combustion pour le microdosage du carbone, de l'hydrogène, du soufre et des halogènes et l'on décrit les méthodes pour leur dosage qui ont été adaptées dans les analyses en série.

---

---

With 5 Figures.     

Relationships between the molar volumes of mixtures of elements and their compounds

The molar volumes of stoichiometric mixtures of Group I–III metals and Group V–VII nonmetals are compared with the molar volumes of MX compounds. The derivatives of the B-subgroup metals have the molar volumes larger than the mixtures. The compounds of A-subgroup metals have smaller volumes than the mixtures. A crystal-chemical interpretation of this fact is advanced.     

XAS study on copper red in ancient glass beads from Thailand

Glass has been used in ornaments and decorations in Thailand for thousands of years, being discovered in several archeological sites and preserved in museums throughout the country. To date only a few of them have been examined by conventional methods for their compositions and colorations. In this work we report for the first time an advanced structural analysis of Thai ancient glass beads using synchrotron X-ray absorption spectroscopy (XAS) and energy-dispersive X-ray (EDX) spectrometry. Four samples of ancient glass beads were selected from four different archeological sites in three southern provinces (Ranong, Krabi and Pang-nga) of Thailand. Archaeological dating indicated that they were made more than 1,300 years ago. A historically known method for obtaining a red color is to add compounds containing transition elements such as gold, copper, and chromium. For our samples, EDX spectrometry data revealed existing fractions of iron, copper, zinc, and chromium in ascending order. Thus, copper was selectively studied by XAS as being potentially responsible for the red color in the glass beads. K-shell X-ray absorption near-edge structure (XANES) and extended X-ray absorption fine structure (EXAFS) of copper were recorded in fluorescence mode using an advanced 13-element germanium detector. Comparisons with XANES spectra of reference compounds identified two major forms of copper, monovalent copper and a metallic cluster, dispersed in the glass matrix. The cluster dimension was approximated on the basis of structural modeling and a theoretical XANES calculation. As a complement, EXAFS spectra were analyzed to determine the first-shell coordination around copper. XAS was proven to be an outstanding, advanced technique that can be applied to study nondestructively archaeological objects to understand their characteristics and how they were produced in ancient times.     

Analytical control of silica glass production. Voltammetric determination of titanium and iron in raw materials and silica glass samples

Adsorptive stripping voltammetric (AdSV) methods are presented for the determination of titanium and iron in quartz and silica glass samples obtained after pressure decomposition. Mandelic acid and catechol were used as complexing agents for titanium and iron, respectively. The method for titanium determination is based on the catalytic effect of chlorate ions. An insoluble residue remaining after decomposition of quartz and silica glass samples in HF+H₂SO₄ mixture was checked by energy-dispersive X-ray analyses. ET-AAS was applied as a reference method to AdSV measurements.     

Analytical control of silica glass production. Voltammetric determination of titanium and iron in raw materials and silica glass samples

Adsorptive stripping voltammetric (AdSV) methods are presented for the determination of titanium and iron in quartz and silica glass samples obtained after pressure decomposition. Mandelic acid and catechol were used as complexing agents for titanium and iron, respectively. The method for titanium determination is based on the catalytic effect of chlorate ions. An insoluble residue remaining after decomposition of quartz and silica glass samples in HF+H2SO4 mixture was checked by energy-dispersive X-ray analyses. ET-AAS was applied as a reference method to AdSV measurements.     

An application of silaned glass beads to the preconcentration and spectrophotometric determination of traces of phosphorus with molybdate

Silaned glass beads are applied to the preconcentration and spectrophotometric determination of phosphorus as the phosphomolybdenum blue complex. Traces of phosphorus in water are collected as a phosphomolybdenum blue complex on a column of the beads. The phosphomolybdenum blue is eluted with N,N-dimethylformamide and the absorbance of the eluate continuously monitored at 700 nm. The height of the very sharp peak obtained is proportional to the amount of phosphorus present and 0.1-0.5 mug of phosphorus in a 10-ml sample can be determined reproducibly. Interference from arsenate is eliminated by addition of a reducing agent. High concentrations of silica cause a small positive error. This method is applicable to the analysis of river water and sea-water samples.     

High-performance liquid chromatographic determination of colouring matters in historical garments from the Holy Mountain of Athos

This work is probably the first attempt to identify the organic colouring materials contained in post-Byzantine textiles, from the Holy Mountain of Athos. Samples extracted from seven ecclesiastical garments (15th–19th century) are investigated by high performance liquid chromatography with UV-Vis diode array detection. The detection limits for alizarin, purpurin, carminic acid, laccaic acid A, luteolin, apigenin, genistein, fisetin, sulfuretin, ellagic acid, indigotin and indirubin are found to be within 0.002–0.029 μg mL⁻¹. The following organic dyes are identified in the extracts: dyer’s broom (Genista tinctoria L.), young fustic (Cotinus coggygria Scop.), an indigoid dye source either indigo (Indigofera species) or woad (Isatis tinctoria L.), madder, cochineal and lac dye (Kerria lacca Kerr). Furthermore, the identification of a brazilein derivative indicates the presence of a Caesalpinia dye source in the samples. Correspondence: Ioannis Karapanagiotis, Ormylia Art Diagnosis Center, Sacred Convent of the Annunciation, Ormylia, GR-63071 Chalkidiki, Greece     

Analytical procedure for determination of the time profile of eprinomectin excretion in sheep faeces

An analytical procedure has been introduced to enable study of the time profile of eprinomectin excretion in sheep faeces. Eprinomectin was extracted from sheep faeces with acetonitrile, the extract was cleaned by solid-phase extraction (SPE), and, after derivatization by reaction with N-methylimidazole, trifluoroacetic anhydride, and acetic acid, eprinomectin was analysed by high-performance liquid chromatography (HPLC) with fluorescence detection. The method has a low detection limit (1.0 ng g⁻¹ of moist sheep faeces), a low quantification limit (2.5 ng g⁻¹ of moist sheep faeces), good recovery (in the range 78.8 to 87.1%), and good reproducibility (RSD<10%). The method was used to study the time-profile of excretion of eprinomectin in sheep faeces after a single topical administration of 0.5 mg kg⁻¹ b.w. of the drug. Because of its good recovery, precision, and sensitivity, the method has also proved applicable to further ecotoxicological studies of eprinomectin. Figure Autochthonous Slovenian dairy breed sheep – Istrian Pramenka     

Analytical characterization of some pyrazolones and their copolymers with some vinyl compounds

Some new pyrazolones have been synthesized and their copolymers with styrene, methylmethacrylate and methacrylic acid prepared. The pyrazolones and their styrene and methylmethacrylate copolymers are insoluble in water but form chelate complexes with some alkaline-earth and transition metal ions. The water-soluble methacrylic acid copolymers do not form complexes with these elements, however, probably because of hydrogen-bonding of the chelating groups to the methacrylic acid carboxyl groups. Special attention was paid to the complexation of Au(III), which was assumed to proceed mainly through the nitrogen atoms of the pyrazolone ring.     

Analytical chemistry in the discovery of the elements

After a brief introduction to the evolution of the philosophy of matter over the centuries to arrive at the actual concept of chemical elements and “chemical matter” a historical overview is presented on the discovery of new elements within the 17–20th centuries, associated with the development and progress of chemical analysis and analytical chemistry. Some specific details are included in connection with imaginative theories, controversies on precedence of discovery, and spurious discoveries and their discoverers. 16 new elements were discovered in the 18th c., 51 in the 19th c. and 26 in the present c. The influence of some chemical schools, the incidence of conjunctural circumstances, the difficulties implied by some discoveries, serendipitous and fictitious discoveries, etc. are considered focusing on specially remarkable cases of historic interest. Historical and actual controversies related to naming of new elements are briefly considered. Received: 20 February 1996 / Accepted: 21 May 1996     

Extractive concentration of platinum-group elements and their determination by atomic-absorption spectrophotometry

The extraction of Pt, Pd, Ir, Rh, Ru, Ag, Au, Co, Cu, Ni and Fe with n-octylaniline has been investigated. Noble metals are extracted 10(3)-10(4) times better than Cu, Ni, Co and Fe. A method of determination of Pt, Pd, Ir, Rh and Ru is proposed. They are first separated from Cu, Ni, Co and Fe by means of extraction (and then determined, in either the aqueous or organic phase, by atomic-absorption spectrophotometry. The atomic absorption of platinum metals (with the exception of Pd) is affected by other elements of the platinum group and by non-noble metals. La(NO(3))(3) and Nd(NO(3))(3) lower the limit of detection for Pt, Rh, Ir and Ru and inhibit the effect of Co, Cu, Ni, Fe, Bi, Zn, Na, etc. on their determination. Lanthanum and neodymium chlorides and sulphates produce a similar effect but only on the determination of Pt and Rh. The coefficient of variation of the determination, in both phases, is within 2-6.8%.     

Analytical determination of non-born—oppenheimer matrix elements between different molecular electronic states

Matrix elements for the nonadiabatic correction between different adiabatic Born—Oppenheimer (ABO) states are discussed in terms of a generating function (nonadiabatic coupling function, NAF) which was introduced earlier. Recursion relations are derived for the case where different vibronic states are coupled via a single non-totally symmetric mode. The formalism is applied to the estimation of non-Born—Oppenheimer coupling between vibronic states of pyrazine.     

Ultrasound-assisted emulsification microextraction of organolead and organomanganese compounds from seawater, and their determination by GC-MS

We describe a simple method for the simultaneous determination of organolead and organomanganese compounds in seawater samples. It is based on ultrasound-assisted emulsification microextraction. Trimethyllead, triethyllead, tetraethyllead, cyclopentadienylmanganese tricarbonyl and its methyl derivative were separated and determined using gas chromatography and mass spectrometry. Trimethyllead and triethyllead were derivatized with sodium tetraphenylborate before being submitted to the preconcentration step. Detection limits ranged from 7.0 to 41 ng L^?1 depending on the compound. Recoveries ranged from 84 to 118 %, depending on the compound and the sample analyzed. Seawater samples were collected at different sites of the Cartagena Bay and none of the target analytes were found at levels above the corresponding detection limits.