All-fiber actively Q-switched fiber laser tuned by a pair of temperature controlled fiber Bragg gratings

We report an all-fiber actively Q-switched erbium-doped fiber laser, where the linear laser cavity mirrors are composed of two fiber Bragg gratings (FBGs). The laser oscillation wavelength could be tuned by this pair of temperature controlled FBGs. The Q-switching is achieved by an all-fiber phase modulation device. Using this system, we could obtain stable Q-switched laser pulses output, which could be optimized by tuning the reflection wavelengths of the two FBGs to be adjacent to each other. Instead of being modulated by the FBG filter in high-speed oscillation, this fiber laser system is operating in the Q-switched regime using an all-fiber phase modulator, producing a more stable laser output spectrum.     

Passive compensation of the thermal drift of magnetostriction based Q-switched fiber lasers

The authors propose and demonstrate a method to compensate the thermal drift of magnetostriction based Q-switched fiber lasers, which is caused by the eddy currents induced in the Terfenol-D magnetostrictive actuators. The consequent wavelength detuning between the fiber gratings of the laser is passively compensated by the use of Monel 400 as thermal actuator of the non-modulated grating. A highly stable pulsed signal is achieved in the range of 1 Hz-5 kHz, with a wavelength detuning between gratings maintained below 10 pm. Furthermore, an optimization of the use of the pump power is proposed, utilizing part of it for simultaneously pumping a fiber optic based amplification stage.     

High power Q-switched Yb-doped photonic crystal fiber laser producing sub-10 ns pulses

We report on a Q-switched fiber laser producing pulse durations well below 10 ns by using a short-length ytterbium-doped rod-type photonic crystal fiber as gain medium. At repetition rates up to 100 kHz pulse energies up to 0.5 mJ and average powers in excess of 30 W have been obtained in single-transverse mode beam quality. The compact short pulse laser system possesses further power and energy scaling potential.     

High-average-power flashlamp-pumped Nd:Glass fiber-bundle laser

Flashlamp-pumped high-gain fiber-bundle lasers consisting of multimode phosphate glass fibers have been investigated. By optimizing the fiber number and the outcoupling reflectivity in dependence on the pump conditions, high single-pulse energies in excess of 1 J as well as high-average-power extraction up to 100 W at a pulse repetition frequency of 100 Hz could be obtained from slim fiber-bundle lasers. Fiber numbers in the range of 150–250 and reflectivities between 35% and 50% have been found to provide reliable performance.     

Doppler velocimetry using self-mixing effect in a short Er–Yb-doped phosphate glass fiber laser

Accurate and highly sensitive speed measurements have been successfully demonstrated by the optical feedback velocimetry technique using the self-mixing modulation effect in a double-clad Er–Yb-doped fiber laser. The sensitivity to back-scattered light has been investigated regarding the Doppler frequency shift or the target distance, and it has been shown that the velocimeter is still sensitive to a target located at 20 m and for speeds as high as 13 m s^–1.     

A global design of high power Nd-Yb co-doped fiber lasers

A global optimization method - niche hybrid genetic algorithm (NHGA) based on fitness sharing and elite replacement is applied to optimize Nd³⁺-Yb³⁺ co-doped fiber lasers (NYDFLs) for obtaining maximum signal output power. With a objective function and different pumping powers, five critical parameters (the fiber length, L; the proportion of pump power for pumping Nd³⁺, η; Nd³⁺ and Yb³⁺ concentrations, N_Nd and N_Yb and output mirror reflectivity, R_out) of the given NYDFLs are optimized by solving the rate and power propagation equations. Results show that dividing equally the input pump power among 808 nm (Nd³⁺) and 940 nm (Yb³⁺) is not an optimal choice and the pump power of Nd³⁺ ions should be kept around 10-13.78% of the total pump power. Three optimal schemes are obtained by NHGA and the highest slope efficiency of the laser is able to reach 80.1%.     

Tunable and high-energy Q-switched operation of an alexandrite slave ring laser

Narrow bandwith tunable Q-switched operation of an alexandrite oscillator was used for injection-locking of a high-energy alexandrite slave ring laser. Pulses with up to 600 mJ in energy over a 600 cm^–1 tuning range were obtained.     

A passively Q-switched Yb:YAG microchip laser

We present a diode-pumped passively Q-switched Yb:YAG microchip laser, using a semiconductor saturable absorber mirror. We obtained pulses with 1.1-μJ energy, 530-ps duration, 1.9-kW peak power, and a repetition rate of 12 kHz. The laser is oscillating in a single longitudinal mode. Received: 23 October 2000 / Published online: 7 February 2001     

High power diode-side-pumped rod Nd:GdVO4 laser

A compact high power diode-side-pumped Nd:GdVO₄ laser has been presented, which can generate an output power of 52 W at 1.063-μm for continuous-wave (CW) operation. The absorption characteristics of the Nd:GdVO₄ in different pump directions is measured, which were used to optimize the diode-side-pumped Nd:GdVO₄ laser head. The laser characteristics of both CW and Q-switched Nd:GdVO₄ and Nd:YAG in are compared and it was found that Nd:GdVO₄ may surpass Nd:YAG for high power laser application.     

Diode-pumped passively Q-switched mode-locked Nd:YLF laser with uncoated GaAs saturable absorber

We have demonstrated passively Q-switched mode-locked all-solid-state Nd:YLF laser with an uncoated GaAs wafer as saturable absorber and output mirror simultaneously. Q-switched mode-locking pulses laser with about 100% modulation depth were obtained. The average output power is 890 mW at the incident pump power of 5.76 W, corresponding to an optical slop efficiency of 20%. The temporal duration of mode-locked pulses was about 21 ps. At the Q-switched repetition rate of 30 kHz, the energy and peak power of a single pulse near the maximum of the Q-switched envelope was estimated to be about 1.6 μJ and 76 kW.     

Short pulse passively Q-switched Nd:GdYVO4 laser using a GaAs mirror

We report on a diode pumped passively Q-switched Nd:Gd_0.64Y_0.36VO₄ laser with a Cr⁴⁺:YAG saturable absorber. We show experimentally that by using an appropriately coated GaAs wafer as output coupler, the Q-switched pulse width can be significantly suppressed. Stable Q-switched pulse train with pulse width of 2.2 ns, peak power of 26.3 kW, repetition rate of 15.38 kHz have been obtained under an absorbed pump power of 8.54 W. The physical mechanism of pulse width narrowing by the GaAs wafer was also experimentally investigated.     

Q-Switched Large-Mode-Area Yb-Doped Fibre Laser Using GaAs as Saturable Absorber

A passive Q-switched large-mode-area Yb-doped fibre laser is demonstrated using a GaAs wafer as the saturable absorber. A high Yb doping concentration double-clad fibre with a core diameter of 30μm and a numerical aperture of 0.07 is used to increase the laser gain volume, permitting greater energy storage and higher output power than conventional fibres. The maximum average output power is 7.2W at 1080nm wavelength, with the shortest pulse duration of 580ns and the highest peak power of 161W when the laser is pumped with a 25W diode laser operating at 976nm. The repetition rate increases with the pump power linearly and the highest repetition rate of 77kHz is obtained in the experiment.     

SOA-based actively mode-locked fiber ring laser by forward injecting an external pulse train

An actively mode-locked fiber ring laser based on cross-gain modulation (XGM) in a semiconductor optical amplifier (SOA) is demonstrated to operate stably with a simple configuration. By forward injecting an easily-generated external pulse train, the mode-locked fiber laser can generate an optical-pulse sequence with pulsewidth about 6 ps and average output power about 7.9 mW. The output pulses show an ultra-low RMS jitter about 70.7 fs measured by a RF spectrum analyzer. The use of the proposed forward-injection configuration can realize the repetition-rate tunability from 1 to 15 GHz for the generated optical-pulse sequences. By employing a wavelength-tunable optical band-pass filter in the laser cavity, the operation wavelength of the designed SOA-based actively mode-locked fiber laser can be tuned continuously in a wide span between 1528 and 1565 nm. The parameters of external-injection optical pulses are studied experimentally to optimize the mode-locked fiber laser.     

Q-switched and mode-locked diode-pumped Nd:YAG laser with an LT-GaAs

Simultaneous Q-switching and mode-locking (QML) is accomplished in a diode-pumped Nd:YAG laser using low-temperature GaAs (LT-GaAs) as the saturable absorber, which also acts as an output coupler at the same time. The repetition rate of the Q-switched envelope increased from 25 to 40 kHz as the pump power increased from 2.2 to 6.9 W. The mode-locked pulses inside the Q-switched pulse envelope had a repetition rate of 714 MHz. A maximum average output power of 770 mW was obtained.     

Passively Q-switched diode-pumped Cr:YAG/Nd:GdVO4 monolithic microchip laser

The realization of high repetition rate passively Q-switched monolithic microlaser is a challenge since a decade. To achieve this goal, we report here on the first passively Q-switched diode-pumped microchip laser based on the association of a Nd:GdVO₄ crystal and a Cr⁴⁺:YAG saturable absorber. The monolithic design consists of 1 mm long 1% doped Nd:GdVO₄ optically contacted on a 0.4 mm long Cr⁴⁺:YAG leading to a plano-plano cavity. A repetition rate as high as 85 kHz is achieved. The average output power is approximately 400 mW for 2.2 W of absorbed pump power and the pulse length is 1.1 ns.     

Diode-pumped passively Q-switched Nd:LuVO4 laser at 916 nm

We demonstrate a passively Q-switched Nd:LuVO₄ laser at 916 nm by using a Nd, Cr:YAG crystal as the saturable absorber. As we know, it is the first time to realize the laser with a simple linear resonator. When the incident pump power increased from 14.6 W to 23.7 W, the pulse width of the Q-switched laser decreased from 24 ns to 21 ns. The pulse width was insensitive to the incident pump power in the experiment. The average output power of 288 mW with repetition rate of 39 kHz was obtained at an incident pump power of 22.5 W, with the optical-to-optical efficiency and slope efficiency 1.3% and 3.6%, respectively.     

Specialty Yb fiber amplifier for microchip Nd laser: Towards ∼1-mJ/1-ns output at kHz-range repetition rate

We demonstrate and optimize, for a mJ/ns release at the wavelength 1.064 μm, the operation of a compact laser system designed in the form of a hybrid, active-passive, Q-switched Nd³⁺:YAG/Cr⁴⁺:YAG microchip laser seeding an Yb-doped specialty multi-port fiber amplifier. As the result of the amplifier optimization, ∼1 mJ, ∼1 ns, almost single-mode pulses at a 1-10-kHz repetition rate are achieved, given by a gain factor of ∼19 dB for an 11-μJ input from the microchip laser. Meanwhile, a lower pulse energy, ∼120 μJ, but a much higher gain (∼25 dB) are eligible for the less powerful (0.35 μJ) input pulses.     

Double-ring cavity configuration of actively mode-locked multi-wavelength fiber laser with equally tunable wavelength spacing

A novel actively mode-locked multi-wavelength tunable fiber laser with equally increased or decreased wavelength spacing is presented. It is constructed using a double-ring cavity combined with an amplitude modulator and cascaded fiber Bragg gratings (FBGs). The cavity lengths for all FBGs are intrinsically identical due to the double-ring configuration, and simultaneous mode locking of multiple wavelengths is therefore achieved by applying only one mode-locking signal to the modulator. The FBGs are mounted on a organic plate with angles between adjacent gratings such that the forces applied to the FBGs have an equal force increment; thus, stretching or compressing the cascaded FBGs can achieve a wavelength tuning with equally increased or decreased wavelength spacing.This revised version was published online in March 2005. In the previous version, the published online date was missing     

Numerical study of the spiking instability caused by modulation frequency detuning in an actively mode-locked solid-state laser

We have studied both analytically and numerically the transient active mode locking in the case of a modulation frequency detuning. Analytical results for pulse width and position, extending previous works, are obtained within the frame of the stationary theory by assuming that a short pulse restores its shape after each round trip. Numerical evaluation leads to relaxation oscillations and change of the short-pulse shape. The results of both approaches agree with each other only for small detunings, when laser is operated in the steady state. For larger detunings the laser dynamics change dramatically, and the three operation modes observed earlier in experiments were demonstrated numerically: sequences of damped relaxation oscillations, deep periodic spiking and chaotic spiking. The periodic spiking can be used to increase the intensity of mode-locked pulses.     

Efficient passively Q-switched operation of a diode-pumped Nd:GGG laser with a Cr:YAG saturable absorber

The continuous-wave (cw) and passive Q-switching operation of a diode-end-pumped gadolinium gallium garnet doped with neodymium (Nd:GGG) laser at 1062 nm was realized. A maximum cw output power of 6.9 W was obtained. The corresponding optical conversion efficiency was 50.9%, and the slope efficiency was determined to be 51.4%. By using Cr⁴⁺:YAG crystals as saturable absorbers, Q-switching pulse with average output power of 1.28 W, pulse width of 4 ns and repetition rate of 6.2 kHz were obtained. The single-pulse energy and peak power were estimated to be 206 μJ and 51.6 kW, respectively. The conversion efficiency of the output power from cw to Q-switching operation was as high as 84.7%.