EXAFS study of Zn sorption mechanisms on hydrous ferric oxide over extended reaction time

The sorption species and coordination environment of zinc sorbed on to hydrous ferric oxide (HFO) did not change for aging times up to six months. At an initial concentration of 10(4-) M, Zn formed innersphere surface complexes on the surface of HFO. Zn was tetrahedrally coordinated with oxygen atoms at ZnO bond distance of approximately 1.94-1.97 A with coordination number of approximately 3.8-4.7. In the second shell Zn appeared to be coordinated with Fe with a bond distance of approximately 3.42-3.49 A. At an initial concentration of 10(3-) M, both innersphere and polynuclear complexes were feasible sorption products. The first shell was tetrahedrally coordinated with about four oxygen atoms at a bond distance of 1.96 A. The second shell could be attributed to either ZnFe or ZnZn correlations with almost the same bond distance of 3.42-3.44 A.     

The effect of gamma-ray irradiation on the sorptive properties of hydrous SiO2 and ZrO2

The sorption capacities of hydrous SiO₂ and ZrO₂ for the Zn(ammine) ion have been observed to increase on irradiation with γ-rays, by ca. 4.1 and 3.8%, respectively. The rates of sorption increase differently in the irradiated exchangers, depending upon their characteristic natures; e. g. when the external concentration of the Zn(ammine) solution is 0.2M, the increase in the F value due to irradiation is more striking in the case of SiO₂ than for ZrO₂. On the other hand, at a lower external concentration of the Zn(ammine) solution (0.01M), the increase in the F value, particularly during the first five minutes, is more significant for ZrO₂.     

Characterization of the pores in hydrous ferric oxide aggregates formed by freezing and thawing

Hydrous ferric oxides (HFO) are efficient sorbents for inorganic and organic pollutants and therefore have great potentials in environmental science and engineering applications. Freezing and thawing of HFO suspensions leads to the formation of dense HFO aggregates. It facilitates the handling and increases the drying rate of HFO. In this study, we used a combination of pycnometry, gas adsorption (N(2) gas, water vapor), and small-angle neutron scattering (SANS) to characterize the porosity and pore size distribution of dense HFO aggregates formed by freezing dialyzed HFO suspensions at -25 degrees C and thawing them at room temperature. The crystallinity of the HFO, which was a 2-line ferrihydrite, was not affected by this treatment. Wet sieving and laser diffraction analysis showed that the dense HFO aggregates had a unimodal size distribution with an average diameter of 235+/-35 microm. Increasing the freezing rate by cooling with liquid N(2) (-196 degrees C) resulted in much smaller aggregates with an average diameter of 20 microm. Adding NaNO(3) electrolyte to the HFO suspensions prior to freezing also resulted in the formation of smaller aggregates. The dense HFO aggregates formed at -25 degrees C had a porosity of 0.73+/-0.02 ll(-1). SANS revealed a unimodal size distribution of pores, with an average pore diameter of 2.0 nm. The diameter of the HFO crystallites was estimated by transmission electron microscopy to be 1.9+/-0.5 nm. Geometrical considerations taking into account the unit particle and average pore size suggest that the crystallites retain 1-2 layers of hydration water during the coagulation induced by freezing. Analysis by N(2) gas adsorption showed that drying the dense HFO aggregates induced a reduction in porosity by about 25% and shifted the pore size distribution to smaller diameters. Rewetting during water vapor adsorption did not induce significant changes of the aggregate structure. The specific surface area of the dry HFO aggregates was between 320 and 380 m(2)g(-1).     

Certain micro-chemical separations using hydrous ferric oxide as a selective sorbent

Traces of cadmium from relatively high amounts of nickel and copper can be separated by the selective sorption of the cadmium ethylenediamine complex on hydrous ferric oxide. A batch chromatographic technique has been elaborated on this basis.     

Effect of in-situ γ-radiation on the sorption properties of hydrous oxides

Sorption of Li⁺, Cs⁺ and Sr²⁺ on hydrous titanium oxide and magnetite as a function of pH in the presence and absence of -rays has been studied. pH-titrations of the irradiated hydrous oxides have also been carried out. It has been shown that the sorption characteristics of these oxides are not altered by -irradiation and the uptake of metal ions is governed by the equilibrium pH of the solution. Certain physical changes observed on irradiating of the hydrous oxide samples in water are discussed.     

Effect of phosphate on phenanthrene sorption in soils

Phosphate is ubiquitous in the environment. However, its impact on sorption of hydrophobic organic compounds in soils has received little attention. Some effects of phosphate on phenanthrene sorption were investigated in this study using two Chinese soils with contrasting properties. The presence of phosphate significantly decreased the capacity and increased the nonlinearity of phenanthrene sorption in the soils, and this sorption-inhibiting effect was more significant at high phosphate concentration. The influence of phosphate on phenanthrene sorption in the soils was governed by the release of dissolved organic carbon (DOC), particularly higher-molecular-weight and highly aromatic DOC, which tended to be enhanced in the presence of phosphate (p<0.01) as evidenced by size exclusion chromatography and specific UV absorbance analysis. Atomic force microscopy and ζ potential analysis reveal that the ringed microaggregates of DOC were disrupted into larger condensed microaggregates and the solid interfaces tended to be more hydrophilic in the presence of phosphate which also inhibited the accumulation of phenanthrene in the soils. This study for the first time points to an important role of phosphate in the sorption of phenanthrene in soils and provides substantial evidence for the mechanisms involved using a combination of microscopic and chromatographic techniques.     

Effect of gamma-ray irradiation on the mechanical strength of polystyrene-ferrocene composite

Thin films of polystyrene-ferrocene (PS---Fe) composite were irradiated with various doses of gamma irradiation ranging from 4·1 to 25·3 Mrad. The Vickers hardness number (H_v) was calculated for pure and irradiated specimens. It was used to analyse mechanical strength at a saturation load of 100 g. The mechanical strength was found to increase with irradiation dose up to 12 Mrad. Brittleness of the composite PS-Fe was found to occur at a higher dose of 25 Mrad as compared to 15 Mrad for polystyrene. Further, fracture toughness, brittleness index and yield strength were calculated for various irradiated specimens consequent to crack propagation in the specimens.     

Mechanism of metal-ion sorption on hydrous metal oxides

A model for treating the sorption of metal ions on hydrous metal oxides was established based on the assumptions that these materials are weakly acidic cation exchangers and have a discrete exchanger phase. The experimental results of the sorption of metal ions on the hydrous niobium(V) and tin(IV) oxides are found to be consistent with the formulas derived from the model by considering that the charge balance and the mass action law hold in the exchanger phase and cations are sorbed by the distribution between this phase and the bulk aqueous phase.     

Electrical conductivity and chemical reactivity of hydrous ferric oxides

Hydrous ferric oxide was synthesised under alkaline conditions, aged in distilled water and calcined. Characterisation was attempted through x-ray, differential thermal analysis, thermogravimetric and infrared analyses. Electrical conductivity was measured and chemical reactivity towards hydrazine investigated. It was found that ageing as well as calcination facilitated crystallisation toa-Fe₂O₃ and thereby decrease the reactivity, which in turn appears to be strongly influenced by the three types of water,viz. absorbed, bound and crystallisation.     

Sorption kinetics of strontium in porous hydrous ferric oxide aggregates I. The Donnan diffusion model

Sorption of ions by hydrous ferric oxide (HFO) often shows a fast initial sorption reaction followed by a much slower sorption process. The second step is diffusion-controlled and can continue for days or months before equilibrium is reached. In this paper, we demonstrate that the diffusion rate may be explained by electrostatic interactions. The internal and external surfaces of HFO are generally positively charged and therefore repel cations. This can result in extremely low cation concentrations in pores, and therefore a significant reduction in pore diffusion rate. The theory is demonstrated here for sorption of Sr(2+) in HFO aggregates. The ion concentrations in the pore space are calculated using a Donnan model and diffusion is calculated from the Donnan concentration and potential gradients. This diffusion model is compared with nonelectrostatic pore diffusion, which does not take electrostatic interactions into account. The Donnan model predicts very low concentrations of Sr(2+) in the pores and diffusion rates that are up to 8000 times lower than predicted with a nonelectrostatic model.     

Effect of gallium oxide dopants on electrophysical and sorption properties of zinc oxide

The effect of gallium oxide dopants (0.1–0.3 at.% Ga) on the electrophysical and sorption properties of ZnO was studied in the temperature range from 19 to 350 °C. The introduction of the dopant increasing the conductivity of ZnO is accompanied by a change in the amounts of SO₂ and Cl₂ sorbed and the reactivity of zinc oxide. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 2, pp. 266–270, February, 1999.     

Effect of lithium oxide dopants on electrophysical and sorption properties of zinc oxide

The effects of lithium oxide dopants (0.5–0.8 at. % Li) on the electrophysical and sorption properties of ZnO were studied in the temperature range from 150 °C to 410 °C. The introduction of lithium increases the activation energy of the conductivity of ZnO, decreases its conductivity, and increases the amount of S0₂ sorbed. Two forms of chemisorbed SO₂ (donor and acceptor) are observed on the surface.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1096–1100, May, 1996.     

Ni(II) complexation to amorphous hydrous ferric oxide: an X-ray absorption spectroscopy study

Ni(II) sorption onto iron oxides and in particular hydrous ferric oxide (HFO) is among the important processes impacting its distribution, mobility, and bioavailability in environment. To develop mechanistic models for Ni, extended X-ray absorption fine structure (EXAFS) analysis has been conducted on Ni(II) sorbed to HFO. Coprecipitation revealed the formation of the metastable alpha-Ni(OH)(2) at a Ni(II) loading of 3.5 x 10(-3) molg(-1). On the other hand, Ni(II) formed inner-sphere mononuclear bidentate complexes along edges of FeO(6) octahedra when sorbed to HFO surfaces with Ni-O distances of 2.05-2.07 A and Ni-Fe distances of 3.07-3.11 A. This surface complex was observed by EXAFS study over 2.8 x 10(-3) to 10(-1) ionic strength, pH from 6 to 7, a Ni(II) loading of 8 x 10(-4) to 8.1 x 10(-3) molg(-1) HFO, and reaction times from 4 hours to 8 months. The short- and long-range structure analyses suggest that the presence of Ni(II) inhibited transformation of the amorphous iron oxide into a more crystalline form. However, Ni(2+) was not observed to substitute for Fe(3+) in the oxide structure. This study systematically addresses Ni(II) adsorption mechanisms to amorphous iron oxide. The experimentally defined surface complexes can be used to constrain surface complexation modeling for improved prediction of metal distribution at the iron oxide/aqueous interface.     

Specific surface chemical interactions between hydrous ferric oxide and iron-reducing bacteria determined using pK(a) spectra

A modified regularized least squares pK(a) spectrum approach is applied to determine disassociation constants and proton binding site concentrations on bacteria, hydrous ferric oxide (HFO), and bacteria/HFO composite surfaces. This involves fitting experimental acid-base titration data to a continuous binding site model for a chemically heterogeneous surface with a variety of reactive groups yielding a pK(a) spectrum. The modified parameter fitting method optimizes simultaneously for both smoothness of the pK(a) spectrum and goodness of fit, whereas other methods optimize for goodness of fit given a fixed smoothness factor. Uncertainty estimates in pK(a) spectra were made by taking the mean and standard deviation of the spectra from replicate titration data. Titration of Shewanella putrefaciens strain CN32, a facultative iron-reducing bacterial species, demonstrate five types of binding sites consistent with known cell surface groups on bacteria, with mean pK(a) values of 3.62, 4.97, 6.92, 8.22, and 9.97. Composite surfaces formed by precipitation of HFO onto bacteria surfaces were also titrated. These surfaces no longer yielded low pK(a) sites in pK(a) spectra, indicating that ferric iron interacts with the bacteria via carboxylic (low pK(a)) sites during precipitation. In addition, mechanically mixed HFO bacterial samples also showed removal of carboxylic binding sites, suggesting that solid phase HFO interacts directly with carboxylic sites on bacterial cells. Moreover, the pK(a) spectra for HFO bacterial composites were not dependent on how the composite was formed; the mechanically mixed or surface-precipitated samples exhibited very similar binding site distributions. The determined pK(a) spectra imply that the overall binding mechanism for bacteria interactions with HFO involve carboxylic groups on the bacteria binding to the most basic sites on the HFO surface in approximately 1:1 stoichiometry.     

Thermal and sorption behavior of polyacrylonitrile supported hydrous titanium dioxide

Summary Modification of the physico-chemical properties of hydrous titanium dioxide (TiO₂) was conducted by using binding polyacrylonitrile (PAN) for the preparation of larger size particles having higher granular strength. The thermal behavior of the obtained composite has been studied by thermogravimetric and differential thermal analysis (TG/DTA). Sorption behavior of the TiO₂-PAN composite for removal of some hazardous radionuclides has been studied at different conditions such as, pH, contact time, ion concentrations and reaction temperature as well as the drying temperature. The effects of interfering ions as well as some complexing agents on the distribution ratio of the sorption process have been determined. As a result of the obtained data the optimum conditions for the removal of the studied radionuclides were recommended.     

Effect of phosphate on sorption of Eu(III) by montmorillonite

Eu(III) sorption by Na-montmorillonite, the principal component of bentonite, has been studied in absence and presence of phosphate under varying experimental conditions of pH, metal ion, phosphate and sorbent concentration. The sorption edge was found to shift to high pH with decreasing sorbent concentration indicating site heterogeneity on the clay. Eu(III) sorption by Na-montmorillonite was found to increase in presence of phosphate at lower sorbent concentration of 0.5 g/L while at higher sorbent loading no effect of phosphate was observed. ATR–FTIR spectroscopy has been used to understand transition from surface complexation to surface precipitation with decreasing sorbent concentration.