Resonant Raman spectra and first molecular hyperpolarizabilities of strongly charge-transfer molecules

The effect of vibrational structure on the frequency dependence of the first molecular hyperpolarizability of two thiophene-based charge-transfer chromophores is investigated. A time domain formulation is used to express the polarizability. The new expression includes the solvent-induced inhomogeneous distribution of electronic transition frequencies as well as the effect of the motion of solvent molecules that modulates the vibrational and electronic transition frequencies of the nonlinear optical molecule on which the first molecular hyperpolarizability depends. Resonance Raman scattering and one-photon absorption spectra of the chromophores are measured. By simultaneously fitting the experimental one-photon absorption spectrum and Raman cross sections of vibrational lines derived from resonance Raman scattering to a theoretical model, important parameters needed for the calculation of the first molecular hyperpolarizability are obtained. The first molecular hyperpolarizability is calculated as a function of frequency covering both nonresonance and two-photon resonance regions. The calculated result is compared with the measured hyperpolarizability as a function of frequency of the excitation laser. The resonance Raman-based analysis is shown to account reasonably well for the dispersion of the hyperpolarizability of the two charge transfer chromophores.     

Characterization of thin metastable vanadium oxide films by Raman spectroscopy

Thin films are potentiodynamically generated on vanadium in Ba²⁺/acetate electrolyte systems at high voltages. The influence of the anodic potential up to 400 V on the composition and structure of the about 500 nm thin anodic conversion films are investigated. Raman spectroscopy indicates that different film types depend on the electrochemical process parameters. The relationship between the Raman laser excitation power and the amorphous or microcrystalline film structure is also discussed. Beside metastable disordered structures the films contain crystalline phases of V₂O₅, V₄O₉ and barium vanadate, respectively. Received: 15 July 1997 / Revised: 16 February 1998 / Accepted: 21 February 1998     

Characterization of thin metastable vanadium oxide films by Raman spectroscopy

Thin films are potentiodynamically generated on vanadium in Ba²⁺/acetate electrolyte systems at high voltages. The influence of the anodic potential up to 400 V on the composition and structure of the about 500 nm thin anodic conversion films are investigated. Raman spectroscopy indicates that different film types depend on the electrochemical process parameters. The relationship between the Raman laser excitation power and the amorphous or microcrystalline film structure is also discussed. Beside metastable disordered structures the films contain crystalline phases of V₂O₅, V₄O₉ and barium vanadate, respectively.     

Raman scattering from thin polystyrene films on gold diffraction gratings

Raman spectra from gold-coated sinusoidal diffraction gratings overcoated with thin films of polystyrene have been examined using laser beams of several wavelengths. The angular and polarization dependence of the Raman spectral intensity is reported and is shown to correlate with variations in the zero-order grating reflectivity. Surface enhancement and multiple resonance effects in the Raman spectra are demonstrated.     

X-ray and Raman study of spray pyrolysed vanadium oxide thin films

Vanadium oxide thin films were prepared by spray pyrolysis using solutions of vanadium chloride (VCl₃) with different concentrations on glass substrates heated at 200 and 250 °C. The influence of substrate temperature (T_s) and solution concentration (molarity) on structural and vibrational properties is discussed by using X-ray diffraction and Raman spectroscopy. The results revealed that at 0.05 M and T_s = 200 °C, V₄O₉ thin films are obtained. At 250 °C, V₂O₅ phases with preferential orientation are observed and the films become polycrystalline when the molarity increases.     

Raman study of oriented ZnO thin films deposited by sol-gel method

ZnO films with preferred orientation along the (0 0 2) plane were successfully deposited by the sol-gel method using Zn(CH3COO)2.2H2O as starting material and inorganic precursor. A homogeneous and stable solution was prepared by dissolving the zinc acetate in a solution of ethanol and monoethanolamine. Thin films are obtained by spin-coating on glass substrates. ZnO films were obtained by preheating the spin-coated films at 300 degrees C for 10 min after each coating and postheating upto 550 degrees C for 2h. The as-deposited films are transformed into mono-oriented ZnO upon thermal treatment. The films consist of spongy particles aggregates with an uniform size and homogenous surface. The films aim to be used in optoelectronic devices. Raman spectroscopy from ZnO films and deposit solutions has been investigated. New Raman results of the deposit solution suggest that Zn-O bond forms first in solution and that these entities play the role of germs initiating the crystallization mechanisms during films annealing. Raman spectra of the annealed films show the presence of a compressive stress within the film structure.     

Raman spectra phthalocyanines

Raman spectra of amorphous phthalocyanine thin films have been studied. Theoretical and experimental correlations in polarization ratios are applied to vibrational assignments of symmetry species and to the problem of molecular orientation in thin solid films.     

Resonant Raman spectroscopy of PAH--Os self-assembled multilayers

We present a resonant Raman scattering study of (PAH--Os/PVS)n and (PAH--Os/GOx)m self-assembled multilayers (n=1-11 and m=1-3). These Os polymer multilayers can be used in electrodes as efficient molecular wires for biomolecular recognition. The Raman intensity dependence on the number of self-assembly cycles provides information on the deposition process. The spectra are identical to that observed for PAH--Os in aqueous solution, indicating that the PAH--Os metal complex structure is conserved in the multilayers. We observe at approximately 500 nm incoming and outgoing Raman resonances of osmium and bipyridine vibrational modes. These resonances are associated to the metal-to-ligand charge transfer (MLCT) transition. We study the evolution of these Raman modes as a function of the Os oxidation state during in situ electrochemistry. During the oxidation process, Os(II)-->Os(III), the Raman resonance related to the MLCT disappears and the bipyridine related modes harden by approximately 10 cm(-1). These results are correlated with optical transmission measurements which show the disappearance of the visible region absorption when the Os complex is oxidized. We also find partial quenching of the Raman mode intensity after in situ voltamperometric cycles which demonstrates the existence of photo-electro-chemical processes.     

Fourier-transform infrared and optical absorption spectra of 4-tricyanovinyl-N,N-diethylaniline thin films

Thin films of 4-tricyanovinyl-N,N-diethylaniline (TCVA) were prepared for the first time using thermal evaporation technique. The molecular structure and electronic transitions of TCVA films were investigated by Fourier-transform infrared (FTIR) and ultraviolet-visible (UV-vis) spectra. The observed vibrational wavenumbers in FTIR spectra were analysed and assigned to different normal modes of the molecule. UV-vis electronic absorption spectral measurements of TCVA films were analysed to obtain the electronic transitions and optical band gap (E(g)). Other important optical parameters such as molar extinction coefficient (varepsilon(molar)), the oscillator strength (f), and the electric dipole strength (q(2)) were also reported.     

Surface-enhanced Raman scattering characteristics of 4-nitrobenzenethiol adsorbed on palladium and silver thin films

Palladium is an important catalytic metal, and it is desirable to develop a surface-enhanced Raman scattering (SERS) technique to investigate the reagent and product species adsorbed on its surface. Unfortunately, Pt-group metals, e.g., Pt and Pd, have been commonly considered as non- or weak-SERS-active substrates. In this work, Ag and Pd thin films were deposited very efficiently and evenly onto the surface of glass substrates by using only corresponding metal nitrate salts (AgNO₃ and Pd(NO₃)₂) with butylamine in ethanolic solutions. In this process, pure ethanol was used for Ag deposition, while an ethanol–water (8:2) mixture was used for Pd deposition. The as-prepared Ag and Pd films exhibited SERS activity over a large area. The surface-induced photoconversion capabilities of these Ag and Pd films were then tested on 4-nitrobenzenethiol by means of SERS. It was found that at least under visible laser irradiation, the surface-catalyzed photoreaction occurs more readily on a Ag film than on a Pd film for the conversion of 4-nitrobenzenethiol to 4-aminobenzenethiol, even though Pd is known to be an important transition metal with high catalytic activity.     

Surface studies of polyimide thin films via surface-enhanced Raman scattering and second harmonic generation

Two polyimides having the same backbone chemical structure and different pendant side groups at the 2- and 2′-positions of the diamine, the six methylene units capped with 4-cyanobiphenyl end groups and trifluoromethyl, were synthesized (6FDA-6CBO and 6FDA-PFMB). Surface-enhanced Raman scattering and surface optical second harmonic generation measurements show that after rubbing the major change in 6FDA-PFMB surface appears in the orientation of the dianhydride, which was originally planar, but becomes tilted with respect to the surface plane. In the case of 6FDA-6CBO, rubbing also causes the originally planar 4-cyanobiphenyls to tilt away from the surface and assume an azimuthally anisotropic distribution.     

Structural characterization of thin films formed or changed on materials by micro Raman spectroscopy

Micro Raman spectroscopy is shown as a useful method of high spatial resolution in characterization of thin films on or in materials formed or changed as a result of external influences. Identification of black films in the glaze of porcelain, of impairing deposits on components of an ICP mass spectrometer and of tribologically stressed contacts of ADLC films or (Ti,Mo)(C,N) ceramics, respectively, are examples for application.     

Scanning angle Raman spectroscopy measurements of thin polymer films for thickness and composition analyses

Scanning angle (SA) Raman spectroscopy was used to measure the thickness and composition of polystyrene films. A sapphire prism was optically coupled to a sapphire substrate on which 6–12% (w/v) polystyrene in toluene was spin coated. Raman spectra were collected as the incident angle of the p-polarized, 785-nm excitation laser was varied from 56 to 70°. These angles span above and below the critical angle for a sapphire/polystyrene interface. The thickness of the polystyrene film was determined using a calibration curve constructed by calculating the integrated optical energy density distribution as a function of incident angle, distance from the prism interface and polymer thickness. The calculations were used to determine the incident angle where waveguide modes are excited within the polymer film, which is the angle with the highest integrated optical energy density. The film thicknesses measured by SA Raman spectroscopy ranged from less than 400 nm to 1.8 μm. The average percent uncertainty in the SA Raman determinations for all films was 4%, and the measurements agreed with those obtained from optical interferometery within the experimental uncertainty for all but two films. For the 1270-nm and 580-nm polystyrene films, the SA Raman measurements overestimated the film thickness by 5 and 18%, respectively. The dependence of the calibration curve on excitation polarization and composition of the polymer and bulk layers was evaluated. This preliminary investigation demonstrates that scanning angle Raman spectroscopy is a versatile method applicable whenever the chemical composition and thickness of interfacial polymer layers needs to be measured.     

Ultra thin films of nanocrystalline Ge studied by AFM and interference enhanced Raman scattering

Initial growth stages of the ultra thin films of germanium (Ge) prepared by ion beam sputter deposition have been studied using atomic force microscope (AFM) and interference enhanced Raman scattering. The growth of the films follows Volmer-Weber growth mechanism. Analysis of the AFM images shows that Ostwald ripening of the grains occurs as the thickness of the film increases. Raman spectra of the Ge films reveal phonon confinement along the growth direction and show that the misfit strain is relieved for film thickness greater than 4 nm. Dedicated to Professor C N R Rao on his 70th birthday     

Microprobe study of enhanced Raman scattering effect on WO3/Ag thin films

Enhanced Raman scattering effect on WO₃ thin films, sputtered on a silicon substrate coated-silver thin film, has been evidenced using the MOLE microprobe. The silver surface is very rough and the observed ERS effect seems to be due to the formation of tungsten bronze at the WO₃/Ag interface. Thermal treatment favours silver diffusion in the WO₃ film and the formation of silver tungstate.     

Resonance Raman spectra of n-methylthioacetamide

Rigorous resonance, as well as preresonance Raman spectra of N-methylthioacetamide and its N-deuterated compound are reported. The observed selectivity in the resonance intensity enhancement is discussed in relation to the potential energy distributions obtained by normal coordinate treatment. The structural change concerning the CN and CS bond lengths is suggested to accompany the π^* ← π electronic excitation.     

Raman spectra of inorganic ions

This paper contains the Raman spectra of 79 inorganic salts and sulphur which may be used as an aid in qualitative inorganic analyses. These were obtained some years ago by conventional Raman spectroscopy. No such collection exists and the order of the reference spectra is identical to those in a collection of IR spectra. A table of characteristic frequencies for 17 polyatomic ions is given. These data have increased relevance following the emergence of FT-Raman as a rapid and efficient modern technique.