Alternating and Random Copolymers of Vinyl Acetate and Maleic Anhydride

Alternating copolymers of vinyl acetate (VAc) and maleic anhydride (MA) are produced preferentially when VAc and MA are copolymerized at moderate temperatures while random copolymers are produced at temperatures above 90°C. A charge-transfer complex (CTC) of VAc/MA exists at moderate temperatures but does not exist at temperatures above 90°C.     

Mechanism of Alternating Copolymerization of Vinyl Acetate and Maleic Anhydride

Vinyl acetate and maleic anhydride are known to give 1:1 alternating copolymerization regardless of the monomer feed composition. The existence of a charge transfer complex between the comonomers has been shown and its equilibrium constant determined.

The mechanism has been discussed, starting from a study of the copolymerization rate when varying the solvent, the temperature, and the concentration of comonomers.     

Copolymerization of 2,3-Dihydropyran and Ethyl Vinyl Ether with Maleic Anhydride

2,3-Dihydropyran (DHP) and ethyl vinyl ether (EVE) were co-polymerized with maleic anhydride (MA) with benzoyl peroxide at 60°C, and 1:1 alternating copolymers were obtained. The rates were maximum at 1:1 monomer composition. Spontaneous copolymerization and solvent effect on the rate were observed in the copolymerization of DHP with MA, in which initial rates were slower in more polar solvents. Participation of charge transfer complex was considered. EVE copolymerized rapidly with MA, reaching the theoretical limiting conversion of 1:1 alternating copolymerization. Although DHP-MA comonomer pair and EVE-MA comonomer pair formed similar 1:1 charge transfer complexes, DHP copolymerized slowly with MA to produce a low molecular weight copolymer, and the limiting conversion was much lower than the theoretical one. To explain these, degradative chain transfer to DHP monomer is proposed as the initial rate of DHP-MA copolymerization is proportional to the initiator concentration to the power 1.1. Q and e values of DHP were calculated to be 0.013 and -0.93, respectively, from the monomer reactivity ratios of copolymerization of DHP with acrylonitrile [r₁ (DHP)=0.003 ± 0.006 and r₂ (AN)=3.6 ± 0.3].     

Photo-induced Living Cationic Copolymerization of Isobutyl Vinyl Ether and Vinyl Ether with Carbazolyl Groups

In this work, a fluorescent monomer 2-（9-carbazolyl） ethyl vinyl ether（CEVE） was synthesized in our lab, and its photo-induced living cationic copolymerization behavior with isobutyl vinyl ether（IBVE） was investigated in detail using diphenyliodonium chloride（DPICl）/2,2-dimethoxy-2-phenylacetophenone（DMPA） and zinc bromide（Zn Br2） initiating system in dichloromethane solution at 5 °C, -5 °C, and -15 °C, respectively. The living nature of this copolymerization system was confirmed by adding fresh comonomer method after the copolymerization almost finished. In addition, the obtained fluorescent copolymer poly（IBVE-co-CEVE） has a low glass transition temperature（Tg）, below -10 °C.     

“Superpermeability” and “pumping” of atomic hydrogen through palladium membranes

Permeation of atomic as well as molecular hydrogen through palladium membranes has been investigated experimentally in the temperature range from room temperature to 200 °C and at a higher incident flux of hydrogen atoms on palladium surface than in previous studies. The results demonstrate that phenomena of ‘superpermeability’ and ‘pumping’ of atomic gases through metal membranes are of a common nature. A theoretical model based on chemical thermodynamics and diffusion theory adequately describes the quantitative relationships observed in experiments. It was found that permeability of atomic hydrogen depends strongly on the magnitude of surface incident flux and membrane temperature.